Particulate matter emission rates from beef cattle feedlots in Kansas-reverse dispersion modeling

Open beef cattle feedlots emit various air pollutants, including particulate matter (PM) with equivalent aerodynamic diameter of 10 microm or less (PM10); however limited research has quantified PM10 emission rates from feedlots. This research was conducted to determine emission rates of PM10 from large cattle feedlots in Kansas. Concentrations of PM10 at the downwind and upwind edges of two large cattle feedlots (KS1 and KS2) in Kansas were measured with tapered element oscillating microbalance (TEOM) PM10 monitors from January 2007 to December 2008. Weather conditions at the feedlots were also monitored. From measured PM10 concentrations and weather conditions, PM10 emission rates were determined using reverse modeling with the American Meteorological Society/U.S. Environmental Protection Agency Regulatory Model (AERMOD). The two feedlots differed significantly in median PM10 emission flux (1.60 g/m2-day for KS1 vs. 1.10 g/m2-day for KS2) but not in PM10 emission factor (27 kg/1000 head-day for KS1 and 30 kg/1000 head-day KS2). These emission factors were smaller than published U.S. Environmental Protection Agency (EPA) emission factor for cattle feedlots.     

Analysis and comparison of inertinite-derived adsorbent with conventional adsorbents

To increase U.S. petroleum energy-independence, the University of Texas at Arlington (UT Arlington) has developed a coal liquefaction process that uses a hydrogenated solvent and a proprietary catalyst to convert lignite coal to crude oil. This paper reports on part of the environmental evaluation of the liquefaction process: the evaluation of the solid residual from liquefying the coal, called inertinite, as a potential adsorbent for air and water purification. Inertinite samples derived from Arkansas and Texas lignite coals were used as test samples. In the activated carbon creation process, inertinite samples were heated in a tube furnace (Lindberg, Type 55035, Arlington, UT) at temperatures ranging between 300 and 850 degrees C for time spans of 60, 90, and 120 min, using steam and carbon dioxide as oxidizing gases. Activated inertinite samples were then characterized by ultra-high-purity nitrogen adsorption isotherms at 77 K using a high-speed surface area and pore size analyzer (Quantachrome, Nova 2200e, Kingsville, TX). Surface area and total pore volume were determined using the Brunauer Emmet, and Teller method, for the inertinite samples, as well as for four commercially available activated carbons (gas-phase adsorbents Calgon Fluepac-B and BPL 4 x 6; liquid-phase adsorbents Filtrasorb 200 and Carbsorb 30). In addition, adsorption isotherms were developed for inertinite and the two commercially available gas-phase carbons, using methyl ethyl ketone (MEK) as an example compound. Adsorption capacity was measured gravimetrically with a symmetric vapor sorption analyzer (VTI, Inc., Model SGA-100, Kingsville, TX). Also, liquid-phase adsorption experiments were conducted using methyl orange as an example organic compound. The study showed that using inertinite from coal can be beneficially reused as an adsorbent for air or water pollution control, although its surface area and adsorption capacity are not as high as those for commercially available activated carbons. Implications: The United States currently imports two-thirds of its crude oil, leaving its transportation system especially vulnerable to disruptions in international crude supplies. UT Arlington has developed a liquefaction process that converts coal, abundant in the United States, to crude oil. This work demonstrated that the undissolvable solid coal residual from the liquefaction process, called inertinite, can be converted to an activated carbon adsorbent. Although its surface area and adsorption capacity are not as high as those for commercially available carbons, the inertinite source material would be available at no cost, and its beneficial reuse would avoid the need for disposal.     

Factors diminishing the effectiveness of phosphorus loading from municipal effluent: critical information for TMDL analyses

Factors that diminish the effectiveness of phosphorus inputs from a municipal wastewater treatment facility (Metro) in contributing to phosphorus levels and its availability to support algae growth in a culturally eutrophic urban lake (Onondaga Lake, NY) were characterized and quantified. These factors included the bioavailability and settling characteristics of particulate phosphorus from this effluent, the dominant form (70%) of phosphorus in this input, and the plunging of the discharge to stratified layers in the lake. Supporting studies included: (1) chemical and morphometric characterization of the phosphorus-enriched particles of this effluent, compared to particle populations of the tributaries and lake, with an individual particle analysis technique; (2) conduct of algal bioavailability assays of the particulate phosphorus of the effluent; (3) conduct of multiple size class settling velocity measurements on effluent particles; and (4) determinations of the propensity of the discharge to plunge, and documentation of plunging through three-dimensional monitoring of a tracer adjoining the outfall. All of these diminishing effects were found to be operative for the Metro effluent in Onondaga Lake and will be integrated into a forthcoming phosphorus "total maximum daily load" analysis for the lake, through appropriate representation in a supporting mechanistic water quality model. The particulate phosphorus in the effluent was associated entirely with Fe-rich particles formed in the phosphorus treatment process. These particles did not contribute to concentrations in pelagic portions of the lake, due to local deposition associated with their large size. Moreover, this particulate phosphorus was found to be nearly entirely unavailable to support algae growth. While substantial differences are to be expected for various inputs, the effective loading concept and the approaches adopted here to assess the diminishing factors are broadly applicable.     

Investigating phosphorus limitation in a fixed bed filter with phosphorus and nitrogen profile measurements

In 2000, the European Union adopted the European Water Framework Directive (WFD) (European Commission, 2000). The WFD focuses on increasingly stringent nutrient standards including ultra low nitrogen (< 2.2 mg N-total/L) and phosphorus concentrations (< 0.15 mg total phosphorus/L) in receiving surface waters and in relevant point sources like wastewater treatment plant (WWTP) effluent. Expansion of WWTPs with advanced post-treatment processes, like effluent filtration, is widely proposed to meet possible future effluent discharge standards. When combining biological nitrate-nitrogen and chemical phosphorus removal in one filter, phosphorus limitation in the denitrifying process may occur. This study investigated where in the filter bed and under which conditions phosphorus limitation occurs. Profile measurements for nitrate, nitrite, and orthophosphorus (PO4-P) combined with chemical oxygen demand (COD) and 02 were conducted. Results showed that the required PO4-P/NOx-N ratio is approximately 0.006 mg/mg after phosphorous precipitation and flocculation. Profile measurements have proven to be an applicable and useful tool. It showed how nitrate and orthophosphorus are removed through the filter bed based on the PO4-P/NOx-N ratio. When orthophosphorus is removed more rapidly and efficiently compared to nitrate, the PO4-P/NOx-N ratio decreases. When PO4-P/NOx-N ratio thresholds are approximately 0.006 mg/mg for a certain period of time and water temperatures varied significantly, orthophosphorus limitation may occur. Changing the filter-bed configuration or decreasing the coagulant dosage can prevent limitation of the denitrifying process because of a phosphorous shortage.     

Effective communication about complex environmental issues: Perceived quality of information about carbon dioxide capture and storage (CCS) depends on stakeholder collaboration

This experimental research addresses the effectiveness of communication about complex environmental issues, depending on whether the same information is provided by multiple collaborating or by individual organizations (i.e., stakeholders). The information provided pertains to carbon dioxide capture and storage (CCS) technology, as an example of a complex environmental issue. In Studies 1 (N = 75) and 2 (N = 66) we found that participants perceived factual information from collaborating stakeholders to be of higher quality than when the same information was provided by individual stakeholders. As predicted, the expectation of diverse perspectives being represented in the collaborative information mediated this effect. In addition, in Study 3 (N = 79) the perceived dissimilarity of collaborating stakeholders was shown to be an important precondition for the collaboration effect observed in Studies 1 and 2. Finally, these studies indicate that occasional collaboration between different stakeholders does not necessarily harm the perceived credibility of each individual stakeholder.     

Long-Term Community Dynamics of Small Landbirds with and Without Exposure to Extensive Disturbance from Military Training Activities

Military training activities are known to impact individual species, yet our understanding of how such activities influence animal communities is limited. In this study, we used long-term data in a case study approach to examine the extent to which the local small landbird community differed between a site in northeast Kansas that experienced intensive disturbance from military training activities (Ft. Riley Military Installation) and a similar, nearby site that experienced minimal human disturbance (Konza Prairie Biological Station). In addition, we characterized how the regional pool of potential colonizers influenced local community dynamics using Breeding Bird Survey data. From 1991 to 2001, most species of small terrestrial landbirds (73%) recorded during breeding surveys were found at both sites and the mean annual richness at Ft. Riley (39.0 ± 2.86 [SD]) was very similar to that of Konza Prairie (39.4 ± 2.01). Richness was maintained at relatively constant levels despite compositional changes because colonizations compensated local extinctions at both sites. These dynamics were driven primarily by woodland species that exhibited stochastic losses and gains and were present at a low local and regional abundance. Our results suggest that military training activities may mimic natural disturbances for some species in this area because the small landbird community did not differ markedly between sites with and sites without extensive human disturbance. Although our results suggest that military training is not associated with large changes in the avian community, additional studies are needed to determine if this pattern is found in other ecological communities.     

Mobility of radium and trace metals in sediments of the Winterbeek: Application of sequential extraction and DGT techniques

For several decades, phosphate ores containing ²²⁶Ra as well as several trace metals have been processed in Belgium to produce calcium phosphate for use in cattle food. The waste water is discharged in two small rivers, the Laak and the Winterbeek.In this study, the levels of ²²⁶Ra and trace metals in surface water and sediments of the Winterbeek were investigated and the mobility of these compounds was assessed using DGT (Diffusive Gradient in Thin Films) and sequential extraction techniques.The concentrations of ²²⁶Ra and trace metals in water and sediment indicate a decreasing trend in inputs to the Winterbeek.The mobility of ²²⁶Ra, assessed by DGT, is related to the reductive mobilization of Fe. The sequential extraction technique shows that at some stations an important fraction of ²²⁶Ra is found to labile sediment phases.Diffusive ²²⁶Ra sediment fluxes, are however, relatively small and have only a minor contribution to the water column concentration of ²²⁶Ra.