Fine Particle Collection Efficiency Related to Pressure Drop,Scrubbant and Particle Properties,and Contact Mechanism

Collection efficiencies are shown for control of fine particles in venturi scrubbers (1) as a function of pressure drop, and (2) as a function of throat area and liquid to gas ratio. A relationship of pressure drop to throat area, gas density, throat velocity, and liquid to gas ratio is given and is used to provide a method for estimating efficiency knowing only these scrubber design parameters. The effect of charged particles and of surface active agents on collection efficiency are discussed briefly.     

Effect of the Pittsburgh Air Pollution Episode upon Pulmonary Function in School Children

Due to increasing atmospheric concentrations of participates, five of Allegheny County’s seven monitoring areas were placed on first stage air pollution alert by November 18,1975. The Liberty Borough area reached second stage alert, and then emergency stage the morning of November 19. An investigation was mounted to determine whether these emergency levels of par-ticulates had an effect upon the pulmonary function of school children sufficiently severe that it would require several days for pulmonary function to return to normal. Beginning November 20 in two schools and November 21 in four additional schools, the three-quarter second forced expiratory volume (FEV.75) and the forced vital capacity (FVC) of approximately 270 parochial school children in fourth, fifth, and sixth grades were tested daily through November 26. Two schools, approximately 80 children, were in control areas; the remaining children were exposed to high or very high levels of particulate air pollution with significant levels of sulfur oxides. If a severe effect of pollution on pulmonary function occurred, one would expect daily measurements to tend upward in children in the four schools in polluted areas and to remain more or less steady in the two control areas. Analyses of the data yielded no indications of such an effect of air pollution upon the lung function of the school children studied. Pulmonary function values declined very slightly in all six schools over the study period. Unexplained variability over a weekend was observed.     

Specifying Venturi Scrubber Throat Length for Effective Particle Capture at Minimum Pressure Loss Penalty

A simplified equation for specifying the optimum minimum length for commercial venturi scrubber throats is presented in this paper. This theoretical correlation is derived using an optimum velocity ratio (velocity of collector droplet at end of venturi throat to velocity of gas in throat) and is a function of throat gas velocity and liquid to gas ratio. This velocity ratio establishes the minimum throat length and is based on available literature data. Predicted venturi scrubber particle collection for throats specified by this procedure compare favorably with reported commercial venturi collection efficiencies and with modeled venturi efficiencies over the practical range of venturi scrubber operation.     

Industrial Pollution Prevention

The 1992 A&WMA Critical Review was authored by Harry Freeman and members of his staff at the Pollution Prevention Research Branch, Risk Reduction Engineering Laboratory, U.S. Environmental Protection Agency in Cincinnati, Ohio. Mr. Freeman presented the paper "Industrial Pollution Prevention," at the Critical Review session held during the 85th Air & Waste Management Association Annual Meeting in Kansas City, Missouri. Prepared discussions and invited comments presented during the session are published here, as well as closing remarks by Mr. Freeman.     

Measurement of Hydrocarbon Emissions Fluxes from Refinery Wastewater Impoundments Using Atmospheric Tracer Techniques

Sulfur hexafluoride (SF6) tracer was used in a series of the experiments to simulate emissions of benzene, toluene, ethyl-benzene, and xylenes (BTEX) from a refinery wastewater basin. The ratio of the measured tracer release to the ambient tracer concentration established a dilution factor which was then used to calculate the mass flux of BTEX from the wastewater basin using the ambient BTEX concentration data. Measured fluxes of BTEX varied from 7 g/min to 70 g/min.

The CHEMDAT7 air emissions model was then used to predict emissions for comparison with the emissions measured using the tracer flux simulation. CHEMDAT7 typically overpredicted total measured BTEX emissions by factors of twelve to seventeen. The degree of overprediction varied both by the individual compound and the module of CHEMDAT7 used to predict emission fluxes.     

Determination of organochlorine and organophosphorus pesticide residues in low moisture,nonfatty products using a solid phase extraction cleanup and gas chromatography

Abstract

A multiresidue solid‐phase extraction (SPE) method for the isolation and subsequent gas Chromatographie determination of organochlorine and organophosphorus pesticide residues in low‐moisture, nonfatty products is described. Residues are extracted from samples with an acetonitrile/water mixture. Cleanup of the extract is performed using graphitized carbon black and anion exchange SPE columns, and analysis is performed by gas chromatography with Hall electrolytic conductivity and flame photometric detection. Recovery data was obtained by fortifying corn, oats and wheat with pesticides. The average recoveries were 79–123% for eight organochlorine and 51–122% for 28 organophosphorus pesticide residues. The limit of quantitation for chlorpyriphos was 0.05 ppm using the Hall electrolytic conductivity detector and <0.005 ppm using the flame photometric detector.     

Chronic and episodic acidification of Adirondack streams from acid rain in 2003-2005

Limited information is available on streams in the Adirondack region of New York, although streams are more prone to acidification than the more studied Adirondack lakes. A stream assessment was therefore undertaken in the Oswegatchie and Black River drainages; an area of 4585 km(2) in the western part of the Adirondack region. Acidification was evaluated with the newly developed base-cation surplus (BCS) and the conventional acid-neutralizing capacity by Gran titration (ANC(G)). During the survey when stream water was most acidic (March 2004), 105 of 188 streams (56%) were acidified based on the criterion of BCS < 0 microeq L(-1), whereas 29% were acidified based on an ANC(G) value < 0 microeq L(-1). During the survey when stream water was least acidic (August 2003), 15 of 129 streams (12%) were acidified based on the criterion of BCS < 0 microeq L(-1), whereas 5% were acidified based on ANC(G) value < 0 microeq L(-1). The contribution of acidic deposition to stream acidification was greater than that of strongly acidic organic acids in each of the surveys by factors ranging from approximately 2 to 5, but was greatest during spring snowmelt and least during elevated base flow in August. During snowmelt, the percentage attributable to acidic deposition was 81%, whereas during the October 2003 survey, when dissolved organic carbon (DOC) concentrations were highest, this percentage was 66%. The total length of stream reaches estimated to be prone to acidification was 718 km out of a total of 1237 km of stream reaches that were assessed.     

Leachability of printed wire boards containing leaded and lead-free solder

Due to environmental concerns and regulatory initiatives, electronics manufacturers are replacing the tin/lead solder commonly used on printed wire boards (PWBs) with alternative solders. To determine the potential waste management impacts of the alternative solders versus the tin/lead solder, two leaching tests on PWBs manufactured with five alternative types of solder were performed: the toxicity characteristic leaching procedure (TCLP) and the synthetic precipitation leaching procedure (SPLP). These tests are commonly used in the US regulatory community to assess pollutant leachability in different disposal scenarios. The article discusses the application and limitations of these tests. The five types of solders investigated were 63Sn/37Pb, 99.3Sn/0.7Cu, 95.5Sn/4Ag/0.5 Cu, 96Sn/2.5Ag/1Bi/0.5Cu, and 42Sn/1Ag/57Bi. The leaching tests were conducted on four PWB sections, each with a unique configuration and solder density. The largest lead concentrations were observed from the PWBs containing Sn/Pb solder, with concentrations exceeding the hazardous waste toxicity characteristic (TC) in TCLP leachates. Silver, the other regulated element used in the solders, was rarely detected, with none of the samples exceeding the TC limit for silver. High copper concentrations were observed and were determined to result from the PWB itself, not from the copper-containing solders.