电法填埋场渗漏检测供电电极接地电阻研究

采用电法进行垃圾填埋场渗漏检测时,供电电极的接地电阻对回路电流起决定性作用.分别推导了半球状供电电极和圆柱状供电电极的接地电阻表达式,并对影响接地电阻大小的主要因素进行了分析和试验验证.结果表明:①电极的接地电阻主要由电极附近的土壤电阻决定;②随着电极埋深的增加,电极的接地电阻减少,但当埋深超过40 cm时,随着电极埋深的增加,电极接地电阻的减小趋势变缓;③随着电极直径的增加,电极的接地电阻减少.实际应用中,电极的埋深和直径应尽可能大一些,但电极直径较大时,电极质量也会显著增加,给操作带来不便.因此,可将电极直径定为10～15 cm.此外,由于土壤一般为颗粒状,这使得土壤和电极不能完全接触,为降低接地电阻,可对电极附近的土壤进行浇水.      

电液压脉冲放电等离子体降解TNT废水的研究

用电液压脉冲放电等离子体实验平台和大容量反应器对TNT废水进行处理,在放电电压为24-48kV,废水体积为7-12L,TNT初始浓度为41.67-90mg·l-1,电极为尖-尖式,间距为3-8mm的条件下,增加放电次数、升高放电电压和增加电极绝缘层长度都能提高TNT降解率,而提高溶液的电导率会降低TNT降解率.在一定的放电电压下,电极间距有一个最佳值;投加铁屑可明显提高TNT降解率,投加铁屑时,G值最高可达1.34×10-1 molecules·h-1·eV-1.     

氨法脱硫技术在烧结烟气治理领域应用研究

LS氨法烟气脱硫技术是一种在传统基础上进行改进的湿法烟气脱硫技术。以66 m2烧结机烟气治理方案为例,分析LS氨法烟气脱硫技术各项技术指标,同时对该方法脱硫技术特点、经济运行进行全面分析。通过论述得出结论,LS氨法烟气脱硫技术是一种适合于冶金行业烧结机烟气治理的一项湿法技术。     

六氯苯和重金属复合污染沉积物的电动力学修复研究

以某化工厂排污沟渠中受六氯苯(hexachlorobenzene,HCB)、锌和镍复合污染的实际沉积物为对象,研究非离子表面活性剂OP-10对沉积物中污染物的增溶解吸效果和电动力学修复污染物的强化迁移效果。解吸实验结果表明:OP-10对HCB增溶解吸效果较好,对重金属离子的解吸有一定的促进作用。电动力学修复发现,随电渗析流进入沉积物中的OP-10很快的吸附在靠近阳极沉积物上,从而阻碍了助剂的输送并影响HCB的迁移,而靠近阴极区域沉积物中的有机质迁移会促进HCB的去除。沉积物pH变化引起的重金属沉淀是制约锌迁移的主要因素。镍的整体迁移效果不明显。     

一体化膜生物反应器处理低C/N污水试验研究

研究一体化连续流间歇曝气膜生物反应器(IMBR)处理低C/N城市污水的工艺效能。试验结果表明:反应器在曝气2 h、搅拌2 h的运行模式下,对COD、NH4+-N、TN和SS的平均去除率分别达到了87%,83.4%,75.4%和97.81%,各出水质量浓度平均值分别为17.5,4.59,7.63和2 mg/L,出水水质达到了GB/T18920-2002《城市污水再生利用城市杂用水水质》标准。     

隧道废气环境影响评价方法及影响预测

以天津某隧道工程环评为例,介绍了隧道NOX排放量的计算方法;采用高斯模式预测了风塔下风向NO2扩散浓度,计算结果表明在排放口下风向129 m范围内、空间69～73 m高度范围内NO2浓度超标;采用TOP模式预测了峒口下风向NO2的扩散浓度,计算结果表明峒口下风向30 m范围内NO2浓度超标;提出了隧道工程废气污染控制措施。     

Combustion and inorganic bromine emission of waste printed circuit boards in a high temperature furnace

High temperature combustion experiments of waste printed circuit boards (PCBs) were conducted using a lab-scale system featuring a continuously-fed drop tube furnace. Combustion efficiency and the occurrence of inorganic bromine (HBr and Br₂) were systematically studied by monitoring the main combustion products continuously. The influence of furnace temperature (T) was studied from 800 to 1400 °C, the excess air factor (EAF) was varied from 1.2 to 1.9 and the residence time in the high temperature zone (RT_HT) was set at 0.25, 0.5, or 0.75 s.Combustion efficiency depends on temperature, EAF and RT_HT; temperature has the most significant effect. Conversion of organic bromine from flame retardants into HBr and Br₂ depends on temperature and EAF. Temperature has crucial influence over the ratio of HBr to Br₂, whereas oxygen partial pressure plays a minor role. The two forms of inorganic bromine seem substantially to reach thermodynamic equilibrium within 0.25 s. High temperature is required to improve the combustion performance: at 1200 °C or higher, an EAF of 1.3 or more, and a RT_HT exceeding 0.75 s, combustion is quite complete, the CO concentration in flue gas and remained carbon in ash are sufficiently low, and organobrominated compounds are successfully decomposed (more than 99.9%).According to these results, incineration of waste PCBs without preliminary separation and without additives would perform very well under certain conditions; the potential precursors for brominated dioxins formation could be destroyed efficiently. Increasing temperature could decrease the volume percentage ratio of Br₂/HBr in flue gas greatly.     

Thermal conversion of municipal solid waste via hydrothermal carbonization: comparison of carbonization products to products from current waste management techniques

Hydrothermal carbonization (HTC) is a novel thermal conversion process that may be a viable means for managing solid waste streams while minimizing greenhouse gas production and producing residual material with intrinsic value. HTC is a wet, relatively low temperature (180-350 °C) thermal conversion process that has been shown to convert biomass to a carbonaceous residue referred to as hydrochar. Results from batch experiments indicate HTC of representative waste materials is feasible, and results in the majority of carbon (45-75% of the initially present carbon) remaining within the hydrochar. Gas production during the batch experiments suggests that longer reaction periods may be desirable to maximize the production of energy-favorable products. If using the hydrochar for applications in which the carbon will remain stored, results suggest that the gaseous products from HTC result in fewer g CO(2)-equivalent emissions than the gases associated with landfilling, composting, and incineration. When considering the use of hydrochar as a solid fuel, more energy can be derived from the hydrochar than from the gases resulting from waste degradation during landfilling and anaerobic digestion, and from incineration of food waste. Carbon emissions resulting from the use of the hydrochar as a fuel source are smaller than those associated with incineration, suggesting HTC may serve as an environmentally beneficial alternative to incineration. The type and extent of environmental benefits derived from HTC will be dependent on hydrochar use/the purpose for HTC (e.g., energy generation or carbon storage).     

TiO2介孔球的合成及其对双酚A的光催化降解

以不同的含钛化合物作为原料,在无模板条件下经一步溶剂热法合成了两种TiO2介孔球——TiO2-1和TiO2-2。对两种TiO2介孔球的形貌进行了表征,结果表明:TiO2-1和TiO2-2粒径分别为5.7 nm和8.0 nm;比表面积分别为159.4 m2/g和128.3 m2/g;孔径约为4.0 nm和5.0 nm。采用P25型TiO2、TiO2-1和TiO2-2对双酚A溶液进行光催化降解反应。在催化剂加入量为0.5 mg/L的条件下降解60 min,双酚A去除率分别为76.3%,99.7%,98.5%。TiO2-1和TiO2-2的光催化效果优于P25型TiO2,且TiO2-1的光催化效果更好。     

大型垃圾填埋场垃圾稳定化研究

本文对大型垃圾填埋场内不同填埋时间垃圾四个组分 (总糖、有机质、生物可降解物和粗纤维 )含量进行了分析 ,并对各指标随填埋时间的变化趋势进行了讨论。结果表明 :在试验场封场后不久 ,垃圾取样均匀性不能保证 ,各指标随时间变化波动很大 ;封场 71 8d后 ,各指标随时间变化呈现一定的规律性 ,垃圾的生物可降解物含量变化能较好地反映垃圾的降解规律。