Soil Lead and Other Metal Levels in Industrial, Residential and Nature Reserve Areas in Singapore

The use of pressure feedback microwave digestion technique has permitted rapid and efficient digestion of soil and sediment samples. The evaluation of different acid mixtures to digest soil samples were studied by mixed-level orthogonal array design. The selected acid mixture of HCl-HNO3-HF was employed in the survey of Pb, Zn, Cu, Cr and Mn in soil samples. Surface soil samples were collected from industrial, residential and nature reserve areas in Singapore. The five metal concentrations were determined by flame atomic absorption spectrometry and graphite furnace atomic absorption spectrometry. The lead and other metal contents in NBS SRM 1645, NIES CRM No. 2 and NRCC BCSS-1 sediment standard references were determined concurrently with the survey samples. Five measured metal loading on the surface soils was in the order: industrial area > residential area > nature reserve area. The trace metal concentrations in surface soil from areas of heavy traffic are higher than those from residential areas. The main sources of trace metal pollution are vehicular exhaust and industrial activities.     

粗苯污染事故应急处理

针对一次苯泄漏事故的应急处理过程、方法进行论述与总结，并分析了事故现场周围地表、地下水中苯污染浓度的变化情况，提出了该类事故的应急措施，以此作为处理同类事故的参考和依据。     

Documentation of cumulative impacts in environmental impact statements

The National Environmental Policy Act (NEPA) of 1969 and the Council on Environmental Quality (CEQ) regulations in the United States require federal agencies to apply an environmental impact assessment (EIA) in decision-making related to their actions. One aspect requires an examination of direct, indirect and cumulative impacts (CIs). Historically, cumulative impact assessment (CIA) has been given limited attention in EIA and resultant environmental impact statements (EISs), not because of its lack of importance, but owing to limitations in methodologies and procedures, including documentation consistency. The objectives of this study were to identify deficiencies in the documentation of CIs and CIA in EISs and to formulate appropriate recommendations (potential solutions) related to such deficiencies. The study involved the systematic review of 33 EISs (11 each from the U.S. Department of Agriculture: Forest Service, the U.S. Army Corps of Engineers, and the U.S. Department of Transportation: Federal Highway Administration). The results indicate that improvements have been made in documentation practices since 1990; however, inconsistencies and inadequacies still exist. Therefore, the following recommendations were developed: (1) CIs should be reported in a separate part of the “Environmental Consequences” section, and they should be addressed for each pertinent environmental resource; (2) a summary of CIs should be included; (3) any CIs considered not significant should be mentioned plus the reason(s) for their non-significance; (4) spatial and temporal boundaries addressed within the CIA process should be defined for pertinent environmental resources; and (5) utilized guidelines and methodologies should be described.     

Overstory mortality as an indicator of forest health in California

The interagency Forest Health Monitoring Program involves a network of about 4200 forest plots on a triangular grid across the United States. We present data on recent mortality of trees 27.9 cm diameter from the first three years of measurements in California (1992–1994). Three plot designs were used to collect data representative of a 1-ha stand at each site; the designs differed primarily in total area sampled (0.067, 0.4 and 1.0 ha). Approximately 50 sites were visited each year yielding a total of about 150. Field tallies showed few cases of recent mortality in the smallest plot size. Cumulative distribution functions of recent dead tree densities in the 0.067-ha plots differed significantly from those generated by tallies from entire 1-ha stands. We conclude that an area of 0.067 ha is unsuitable to assess and monitor overstory mortality in Pacific Coast forests.The U.S. government right to retain a non-exclusive, royalty free licence in and to any copyright is acknowledged.     

Chlorobiphenyl contaminants at Pladda and Garroch Head in the Firth of Clyde in relation to sewage sludge input

Sewage sludge dumped at Garroch Head in the Firth of Clyde contains significant quantities of chlorinated hydrocarbons, such as polychlorinated biphenyls (CBs). These compounds are lipophilic and resistant to degradation. They accumulate in the biota either from the water column or through the food chain, particularly in tissue with a high lipid content. Bottom dwelling fish, such as plaice, in the vicinity of the dump site will accumulate CBs from their environment. Eighteen of the 209 CBs were measured in plaice livers from the Garroch Head dump site and from Pladda, a site reasonably remote from the dump site but also in the Clyde, over a 7 year period prior to the cessation of dumping in December 1998. Concentrations of the congeners in the liver of fish caught at the dump site were, in general, higher than those in the liver of fish caught at Pladda. Concentrations in the plaice livers for the sum of 18 CBs ranged from 1611 to 8471 micrograms kg-1 lipid for Garroch Head samples and from 336.9 to 2635 micrograms kg-1 lipid for samples from Pladda. The data were evaluated using principal component analysis (PCA). Pattern analysis was undertaken by normalising to the recalcitrant CB 153. Livers from the dump site were found to have a higher proportion of the lower chlorinated CBs. CB patterns were similar at the Garroch Head dump site from year to year, but multivariate techniques showed that there were differences in pattern when normalised to CB 153.     

A ten channel fibre-optic device for distributed sensing of underground hydrocarbon leakage

With millions of fuel storage tanks and oil pipelines installed around the world, there is inevitably frequent leakage of potentially hazardous hydrocarbons. As many of these installations are below ground, it can often be many years before the extent of the leak is discovered. We have previously reported the development of a sensor for the detection of such subterranean leaks, using infrared reflectometry to interrogate a hydrocarbon sensitive membrane. However, a single sensor cannot provide any information about the flow rate or direction of the leak. This paper describes the extension of the technology to a multi-channel distributed sensing system, using optical fibres capable of distributing the sensors over large subterranean areas. Results are reported from the evaluation of the device, which consisted of monitoring the movement of different hydrocarbons (gasoline, diesel and insulating oil) through a vertical sand-filled vessel.     

Determination of n-alkanes and polycyclic aromatic hydrocarbons in atmospheric particulate and vapour phases in Oviedo, Spain, by GC-MS

A GC-MS procedure for the determination of hydrocarbons in air samples from Oviedo, Spain, was developed. Air hydrocarbons were sampled with a high volume sampler equipped with a holder containing a glass fiber filter, to trap the particulate phase, and two polyurethane foams to capture hydrocarbons of the vapour phase. Compounds were extracted with CH2Cl2 by Soxhlet extraction and then fractionated using column chromatography with alumina silica. Analyses of the fractions were performed by GC-MS in the electron ionization mode. PAHs and n-alkanes were the compounds examined in this work. Samples collected in the vicinity of the Faculty of Chemistry (a semi-urban area) were analysed. The total concentration of PAHs in the air samples analysed ranged from 28 to 76 ng m(-3). The total concentration of n-alkanes and PAHs in the vapour phase exceeded the concentration in the particulate phase in the samples analysed.     

A novel sensor for monitoring leakage of petroleum and other liquid hydrocarbons into soil environments

This paper describes the use of a potentially implantable infrared reflectometer for the qualitative detection of petroleum and a number of other hydrocarbon solvents. A rugged, low-power, re-useable sensor was evaluated in the laboratory for its ability to detect petrol in soil. A hydrophobic fluoropolymer was used as the sensing surface due to its high selectivity for petroleum hydrocarbons. The photocurrent reflected by this surface from a near IR source was measured to test for petroleum saturation within the membrane, which in turn was an indicator of petroleum in the surrounding soil. The simplicity in the sensor design enabled a stable, low cost detection method for petroleum and other hydrocarbons, ideal for use in sub-surface applications.     

Indoor and outdoor formaldehyde concentrations in homes in residential areas in Greater Cairo

Indoor and outdoor measurements of formaldehyde were conducted at seven flats located in residential areas in Greater Cairo, during spring and summer seasons 1999. The mean daytime formaldehyde concentrations in kitchens, bedrooms and living rooms were 89, 100 and 100 ppb, respectively, in the seven flats. Significant positive correlations were found between the concentrations of formaldehyde found in these three rooms. On the other hand, no significant differences were found between the mean formaldehyde concentrations in these three rooms. The maximum mean concentration of formaldehyde (147 ppb) was recorded in a new flat, while the minimum concentration (43 ppb) was observed in an old flat. The maximum hourly and daytime concentrations were 350 and 225 ppb, respectively. Air temperature, relative humidity and the age of the flat are factors affecting the emission and concentration of formaldehyde. The maximum indoor and outdoor formaldehyde concentrations were recorded during the summer season. During the spring, 38% of the samples indicated that the concentration of formaldehyde in the seven flats exceeded 0.1 ppm, the American Society of Heating, Refrigerating, and Air Conditioning Engineers' (ASHRAE) standard; in the summer, this figure increased to 53%.