Rapid metal extractability tests from polluted mining soils by ultrasound probe sonication and microwave-assisted extraction systems

Ultrasonic probe sonication (UPS) and microwave-assisted extraction (MAE) were used for rapid single extraction of Cd, Cr, Cu, Ni, Pb, and Zn from soils polluted by former mining activities (Mónica Mine, Bustarviejo, NW Madrid, Spain), using 0.01 mol L^?1 calcium chloride (CaCl₂), 0.43 mol L^?1 acetic acid (CH₃COOH), and 0.05 mol L^?1 ethylenediaminetetraacetic acid (EDTA) at pH 7 as extracting agents. The optimum extraction conditions by UPS consisted of an extraction time of 2 min for both CaCl₂ and EDTA extractions and 15 min for CH₃COOH extraction, at 30% ultrasound (US) amplitude, whereas in the case of MAE, they consisted of 5 min at 50 °C for both CaCl₂ and EDTA extractions and 15 min at 120 °C for CH₃COOH extraction. Extractable concentrations were determined by inductively coupled plasma atomic emission spectrometry (ICP-AES). The proposed methods were compared with a reduced version of the corresponding single extraction procedures proposed by the Standards, Measurements and Testing Programme (SM&T). The results obtained showed a great variability on extraction percentages, depending on the metal, the total concentration level and the soil sample, reaching high values in some areas. However, the correlation analysis showed that total concentration is the most relevant factor for element extractability in these soil samples. From the results obtained, the application of the accelerated extraction procedures, such as MAE and UPS, could be considered a useful approach to evaluate rapidly the extractability of the metals studied.     

Application of Pesticide Sprays to Fresh Produce: A Risk Assessment for Hepatitis A and <Emphasis Type="Italic">Salmonella</Emphasis>

The purpose of this study was to quantify the transfer of viral and bacterial pathogens in water used to dilute pesticides sprayed onto the surfaces of cantaloupe, iceberg lettuce, and bell peppers. The average percent transfer of bacteria was estimated to range from 0.00021 to 9.4%, while average viral transfer ranged from 0.055 to 4.2%, depending on the type of produce. Based on these values the concentrations of hepatitis A virus (HAV) and Salmonella in water necessary to achieve a 1:10,000 annual risk of infection were calculated. Under worst case scenario assumptions, in which a pesticide is applied on the same day that the produce is harvested and when maximum transfer values are used, concentrations of 1.5 × 10⁻³ CFU Salmonella or 2.7 × 10⁻⁷ MPN HAV per 100 ml of the water used for application would result in 1:10,000 annual infection risk to anyone who consumes the fresh produce. If harvesting does not occur until at least 14 days after the application, to produce the same risk of infection, the numbers of Salmonella in 100 ml of water used to dilute the pesticides will be greater by up to five orders of magnitude, while the HAV numbers will have increased by up to two orders of magnitude. Based on the reported concentrations of enteric viruses in surface and ground waters in the United States, a 1:10,000 annual risk of infection could easily be exceeded with some groundwater sources used in the United States. To reduce the risks associated with the consumption of fresh produce, water used to prepare pesticides in spray applications should be evaluated for its microbiological quality.     

Investigation of the accumulation of ash,heavy metals,and polycyclic aromatic hydrocarbons to assess the stability of lysis–cryptic growth sludge reduction in sequencing batch reactor

The accumulation of ash, heavy metals, and polycyclic aromatic hydrocarbons (collectively called potential accumulating substances, PAS) was evaluated to ascertain the stability of lysis–cryptic growth sludge reduction process (LSRP) for municipal sludge treatment. One sequencing batch reactor (SBR) incorporated with homogenization was run to test the LSRP and another SBR as a control. The continuous monitoring results for 2 months showed that the ash and heavy metals slightly increased, and the polycyclic aromatic hydrocarbons decreased by 18.0%, indicating that there may be negligible accumulations during the LSRP. Their accumulations met pattern I, as demonstrated by statistical analysis, proving no PAS accumulation for LSRP. This was further confirmed by sludge activity and system performance. Moreover, the mechanism for no PAS accumulation was discussed. It was concluded that the LSRP was stable with no worries about PAS accumulation under the operational conditions.     

Patagonian Fjord Ecosystems in Southern Chile as a Highly Vulnerable Region: Problems and Needs

Southern Chile encompasses one of the most extensive fjord regions of the world, the Patagonia, currently exposed to natural and anthropogenic perturbations. These fjord ecosystems provide important services to humans, which have not been adequately measured and valued. As a consequence, ecosystem services are commonly ignored in public policy design and in the evaluation of development projects. Here we tackle questions that are highly relevant for the nation’s development, namely (1) understanding fjord functioning, and (2) developing management strategies based on ecosystem services, in order to secure simultaneous and adequate use of these ecosystems which area influenced by ecological (e.g., biogeochemical) and productive (e.g., aquaculture, fisheries) processes. We also seek to strengthen the analysis of fjord ecosystem value from the economical (including coastal zoning), socio-cultural, institutional, and governmental points of view. In addition, the investigation of current and future effects of climate change on this large region offers a unique opportunity to understand the social and economic consequences of a global phenomenon at local to regional scales. Biogeochemical and socio-economic models will be used to simulate future scenarios under a gamut of management options.     

Adsorption of Ammonium by Graphene Oxide-Based Composites Prepared by UV Irradiation and Using as Slow-Release Fertilizer

A novel sodium alginate-grafted poly(acrylic acid)/graphene oxide (NaAlg-g-PAA/GO) composite hydrogel was prepared via ultraviolet irradiation, and characterized by infrared spectroscopy spectrometer. X-ray diffraction, X-ray photoelectron spectroscopy and scanning electron microscopy. It was employed to adsorb NH₄⁺ from aqueous solution and used as slow-release nitrogen fertilizers (SNFs). Result indicated that the adsorption process for NH₄⁺ reached equilibrium within 50 min, with the adsorption capacity of 6.6 mmol g^?1 even if 30 wt% GO was incorporated. The results of adsorption kinetic and isotherm were well described by the pseudo-second-order and Freundlich model. The thermodynamics analysis showed the adsorption process was spontaneous. The study indicated excellent water-holding ratio of soil with 2 wt% SNFs was 81.2%, and nitrogen release was up to 55.1% within 40 days in soil. Overall, NaAlg-g-PAA/GO could be considered as an efficient adsorbent for the recovery of nitrogen with the agronomic reuse as a fertilizer.     

Discrimination of predatory versus nonpredatory mammals by box turtles, <Emphasis Type="Italic">Terrapene carolina</Emphasis>

Summary. Although terrestrial turtles have served as a model for studies of olfactory neurophysiology, little is known about how they use chemical information in an ecological sense. We tested whether box turtles (Terrapene carolina) use chemical information to distinguish between predatory and nonpredatory mammals. Box turtles in our study exhibited more escape behavior when exposed to urine from a predator (coyote, Canis latrans) than when exposed to urine from a nonpredator (white-tailed deer, Odocoileus virginianus) or a blank control. Escape behavior is consistent with an antipredator response. In addition, the turtles decreased their handling time for food when in the presence of urine from either species of mammal in comparison to the blank, indicating that chemical cues from mammals in general may result in increased vigilance by terrestrial turtles. Examination of a variety of response variables may be important for adequate assessment of the ecological role of chemosensory behavior.     

PCDD/PCDF formation in the chlor-alkali process—laboratory study and comparison with patterns from contaminated sites

Studies on the formation of polychlorinated dibenzo-p-dioxins (PCDDs) and polychlorinated dibenzofurans (PCDFs) during the electrolysis of sodium chloride solution (brine) using graphite or titanium electrodes were carried out at a laboratory scale. High concentrations of PCDFs but no PCDDs were formed in tests using graphite electrodes. With titanium electrodes, PCDFs were only formed when tar pitch was added and mainly originated from the dibenzofuran present in the tar. For the first time, a detailed assessment of the formation of mono- to octachlorinated PCDD/PCDF from tar pitch was investigated. The assessment included of the chlorination steps proved that PCDFs were formed by successive lateral chlorinated from dibenzofuran to MonoCDFs, DiCDFs, and TriCDFs to form the typical known “chlorine pattern” of TetraCDF to OctaCDF with a dominance of 1,2,7,8- and 2,3,7,8-TetraCDFs, 1,2,3,7,8-PentaCDF, and 1,2,3,4,7,8-HexaCDF as marker congeners. The final homologue distributions depended on reaction time and reaction temperature. In addition, electrolysis with non-chlorinated dibenzo-p-dioxins, dibenzofuran, and biphenyl was carried out. As a result, PCDDs, PCDFs, and PCB were formed at comparable yields. Congener patterns in soil samples from a PCDD/F-contaminated site where chlor-alkali electrolysis had been operated for decades in Japan had identical isomer distribution demonstrating the source and contamination potential and risk of these processes. Therefore, sites where in the past 120 years chlor-alkali electrolysis has been operated or where residues from chlor-alkali production or other chlorine using industries have been disposed should be assessed for their pollution level and exposure relevance. The assessment of total organohalogen content revealed that PCDF is only a small fraction of organohalogens in the contaminated soils. For an appropriate risk assessment, also other chlorinated aromatic compounds such as PCBs or PCNs need to be considered.     

Influence of different textile fibers on characterization of dyeing wastewater and final effluent

Textile industry needs to recover and reuse its wastewater as to fulfil the demand of increasingly strict regulations. The characterization of dyeing wastewater samples according to textile fiber and final textile effluent enables the application of different treatment methods. This study aims to characterize dyeing wastewater in black color of polyamide, polyester, and viscose fibers and final textile effluent. Samples were collected and characterized completely for major pollution indicator parameters. Dyeing wastewater of polyester showed higher values for some parameters, e.g., 4994.44% (49,944,400 mg L^?1 and 917 NTU) of turbidity and 4100.00% of phenol when compared to dyeing wastewater of other fibers. Other parameters such as pH, alkalinity, color, phosphorus, nitrogen, sulfides, chlorides, oil and grease, dissolved solids, and chemical and biochemical oxygen demand were also assessed. In addition to individual characterization, this study also presents a correlation of the contribution of each parameter to the final textile effluent. Although dyeing wastewater of polyamide contributes the most in terms of quantity for the final effluent, this study revealed that dyeing wastewater of polyester influenced the most on the final composition of the textile wastewater when evaluating color, turbidity, total iron, biochemical oxygen demand, chemical oxygen demand, phenol, mercury, oil and grease, and total phosphorus. The present study is focused on bringing new insights to provide future research with other strategies to improve the treatment of dyeing wastewater. In addition, some suggestions are also given for wastewater treatments according to type of textile fiber.     

Evaluation of a fast response pressure solver for flow around an isolated cube

This work describes and evaluates a pressure solver that has been incorporated into a fast response three-dimensional building-resolving diagnostic wind modeling system. The solver computes the three-dimensional pressure field around buildings and on exterior walls in terms of a coefficient of pressure by solving a simplified pressure Poisson equation (that neglects turbulence stresses in the Navier-Stokes) for incompressible flow. The input to the solver is the three-dimensional mean wind field obtained from a fast response empirical-diagnostic urban wind model. The present study is an evaluation of the pressure solver using wind-tunnel data for flow normal to and at a 45° angle to an isolated cubical building. Results for the normal incident wind angle case indicate that the model satisfactorily reproduces the general spatial patterns and the magnitude of the pressure difference around much of the cube. Details of the flow field that are not satisfactorily predicted include the spatial distribution of pressure on the roof and the lower half of the front side of the building and the magnitude along the sidewalls where pressures are over predicted. The results for the 45° case show reasonable agreement between the model and experiments on the front and the back walls, but over predict pressures on the leading edge of the rooftop. Regions with poor pressure predictions appear to be a result of unsatisfactory mean wind modeling.