A novel low-cost detection method for screening of arsenic in groundwater

In the present work, a novel and simple detection system for As inorganic species contained in groundwater is presented. To reach the required detection limit, the proposed methodology is based on two steps: first is the transport and preconcentration of the inorganic arsenic species using a polymer inclusion membrane (PIM) system and second is the formation of a coloured complex, the  absorbance of which is measured. Different parameters related to the membrane composition and the transport kinetics have been studied, and it was found that membranes made of polyvinyl chloride (PVC) as a polymer, and Aliquat 336 as a carrier, ensured efficient arsenic transport when the carrier content was at least 31 % (w/w). The implementation of the designed PIM in a special device that contained only 5 mL of the stripping solution (0.1 M NaCl) allowed As preconcentration from a 100-mL water sample, thus facilitating its detection with the colorimetric method. The new method developed here was validated, and its analytical figures of merit were determined, i.e. limit of detection of 4.5 μg L^?1 at 820 nm and a relative standard deviation within the range 8–10 %. Finally, the method was successfully applied to the analysis of different water samples from Catalonia region with naturally occurring As.     

The influence of a voluntary fee in the consumption of plastic bags on supermarkets from Madeira Island (Portugal)

Since 2007, some supermarkets in Portugal have voluntarily abolished the free distribution of plastic bags, implementing a symbolic charge of €0.02 each at the same time that others still offer free plastic bags. This study assesses the influence of this voluntary measure on the reduction of plastic bags consumption, comparing clients from supermarkets that have adopted it with others who have free distribution. The reutilisation of bags reached 37% in supermarkets where customers pay a fee and was absent in supermarkets where plastic bags are free. Even the abstention of using bags, when clients buy only few products, is significantly higher in supermarkets where there are charges for plastic bags. The 2 cents charged has also induced a significant increase in optimal use of plastic bags since 52% of clients that pay for plastic bags use them so they are almost full, but only 17% do the same when they are free. Taken together, the different effects of charging for plastic bags represents a potential reduction of 64%. A mandatory tax on plastic bags is an important measure to reduce substantially the number of plastic bags consumed and to improve sustainability through the reduction of environmental, economic and social costs of pollution and waste management.     

Passive treatment of acid mine drainage with high metal concentrations using dispersed alkaline substrate

Passive treatment systems based on the dissolution of coarse calcite grains are widely used to remediate acid mine drainage (AMD). Unfortunately, they tolerate only low metal concentrations or acidity loads, because they are prone to passivation (loss of reactivity due to coating) and/or clogging (loss of permeability) by precipitates. To overcome these problems, a dispersed alkaline substrate (DAS) composed of a fine-grained alkaline reagent (calcite sand) mixed with a coarse inert matrix (wood chips) was developed. The small grains provide a large reactive surface and dissolve almost completely before the growing layer of precipitates passivates the substrate, whereas the dispersion of nuclei for precipitation on the inert surfaces retards clogging. Chemical and hydraulic performance of DAS was investigated in two laboratory columns fed at different flow rates with natural AMD of pH 2.3 to 3.5 and inflow net acidity 1350 to 2300 mg/L as CaCO(3). The DAS columns removed 900 to 1600 mg/L net acidity, 3 to 4.5 times more than conventional passive treatment systems. Regardless of the flow rate employed, Al, Fe(III), Cu, and Pb were virtually eliminated. Minor Zn, Ni, and Cd were removed at low flow rates. High acidity removal is possible because these metals accumulate intentionally in DAS, and their precipitation promotes further calcite dissolution. During 15 mo, DAS operated without clogging at 120 g acidity/m(2).d, four times the loading rate recommended for conventional passive systems; DAS may therefore be capable of treating AMD at sites where influent chemistry precludes the use of other passive systems.     

Are motorway wildlife passages worth building? Vertebrate use of road-crossing structures on a Spanish motorway

Numerous road and railway construction projects include costly mitigation measures to offset the barrier effect produced on local fauna, despite the scarcity of data on the effectiveness of such mitigation measures. In this study, we evaluate the utility of different types of crossing structures. Vertebrate use of 43 transverse crossing structures along the A-52 motorway (north-western Spain) was studied during spring 2001. Research centered on wildlife passages (9), wildlife-adapted box culverts (7), functional passages (6 overpasses, 7 underpasses) and culverts (14), with marble dust being used to record animal tracks. A total of 424 track-days were recorded, with most of the larger vertebrate groups present in the area being detected. All crossing structure types were used by animals, although the intensity of use varied significantly among them (Kruskal-Wallis test, p<0.05); culverts were used less frequently than other structures. Crossing structure type and width were identified as the most important factors in their selection for use. Wildlife passages and adapted culverts allowed crossing by certain species (wild boar, roe deer, Eurasian badger), which do not tend to cross elsewhere. These results highlight the importance of using both mixed-type structures and wildlife passages in reducing the barrier effect of roads.     

Dibenzothiophene desulfurization by Gordonia alkanivorans strain 1B using recycled paper sludge hydrolyzate

Enzymatic hydrolyzates of recycled paper sludge were tested as suitable feedstock for biological desulfurization by Gordonia alkanivorans strain 1B. Only the hydrolyzate obtained after enzymatic mixture dialysis (dialyzed hydrolyzate) allowed dibenzothiophene (DBT) desulfurization, in spite of faster bacterial growth did occur on non-dialyzed hydrolyzate. For dialyzed hydrolyzate, 250microM DBT was consumed after 96h displaying a maximum specific productivity of 2-hydroxybiphenyl of 1.1micromol g(-1)(dry cell weight) h(-1). A comparison of the kinetics of biodesulfurization was assessed according to the type of hydrolyzate supplementation. Complete consumption of DBT was observed upon the addition of only phosphates and ammonia although further addition of zinc did increase the 2-hydroxybiphenyl production by 14%. Strain 1B was able to desulfurize a model oil containing DBT, 4-methylDBT and 4,6-dimethylDBT, reducing by 63% the total sulfur content in 168h.     

Comparison of the removal efficiency of endocrine disrupting compounds in pilot scale sewage treatment processes

The removal efficiency of endocrine disrupting compounds from effluents using pilot scale sewage treatment processes, including various treatment technologies, such as membrane bioreactors (MBR), nanofiltration (NF) and reverse osmosis (RO) for the purpose of water reuse, were estimated and compared. The calculated estrogenic activity, expressed in ng-EEQ/l, based on the concentration detected by GC/MS, and relative potencies for each target compound were compared to those measured using the E-screen assay. The removal efficiencies for nonylphenol, was within the range of 55-83% in effluents. High removal efficiencies of approximately >70% based on the detection limits were obtained for bisphenol A, E1, EE2 and genistein with each treatment processes, with the exception of E1 ( approximately 64%) using the MBR process. The measured EEQ values for the effluents from the MBR, NF and RO processes also indicated low estrogenic activities of 0.65, 0.23 and 0.05 ng-EEQ/l, respectively. These were markedly reduced values compared with the value of 1.2 ng-EEQ/l in influent. Consequently, the removals of EDCs in terms of the EEQ value from the biological and chemical determinations were sufficiently achieved by the treatment process applied in this study, especially in the cases of the NF and RO treatments.     

Development of pseudo-amphoteric sponge media using polyalkylene oxide-modified polydimethylsiloxane (PDMS) for rapid start-up of wastewater treatment plant

Hydrophobic sponge media require a relatively long start-up period, as they just float on the surface of aeration tanks due to their little tendency to adsorb water, which causes a delay in the initiation of bacterial attachment. In order to overcome this difficulty, a new pseudo-amphoteric BioCube media (a standard BioCube is hydrophobic) using polyalkylene oxide-modified polydimethylsiloxane (PDMS) as a surfactant was developed. Of the many evaluated hydrophilizing agents, polyalkylene oxide-modified PDMS was found suitable. Among the diverse types of modified PDMS, the non-reactive polyethylene oxide-modified PDMS was found to be optimum agent. Pseudo-amphoteric BioCube media are readily immersible, but after complete immersion, they gradually become hydrophobic, as the polyethylene oxide-modified PDMS is designed to alienate from polyurethane backbone of BioCube to provide hydrophobic surfaces exhibiting more affinity for bacterial attachment. Clearly, the pseudo-amphoteric BioCube showed faster bacterial attachment during the early stage due to chances of enhanced contact between the bacteria and media surfaces, but the extent of attachment between the hydrophobic and pseudo-amphoteric BioCube was similar at the steady state because the former (pseudo-amphoteric BioCube) had already changed to hydrophobic. Fluorescent in situ hybridization result showed 14% occupation by ammonia oxidizing bacteria, 13% by nitrite oxidizing bacteria and 73% by others in pseudo-amphoteric BioCube, respectively.     

Distribution and biological impact of dioxin-like compounds in risk zones along the Ebro River basin (Spain)

The aim of this investigation was to evaluate the environmental impact associated to PCDDs/Fs and dioxin-like PCBs in the Ebro River basin. Sediments and fish from several species were sampled at three sites with different historical pollution records, including the Barbastro area with different industrial activities, and the Flix and Monzón sites, associated to heavy organochlorine compound pollution. Seventeen toxic PCDDs/Fs and 12 dioxin-like PCBs were analyzed by GC-MS. The results obtained indicated significant accumulation of dioxin-like PCBs, but not PCDDs/Fs, in sediments and fish at the Flix site compared to the other sites. Concomitantly, cytochrome p450 1A (CYP1A) expression, a known indicator for pollution by dioxins and dioxin-like PCBs, was significantly elevated in barbel (Barbus graellsii) from the Flix site, compared to the population from the Barbastro site. CYP1A expression correlated with the concentration of dioxin-like PCBs in the fish fat, whereas no significant correlation was found with PCDDs/Fs concentrations. Our data suggest a significant biological impact at the Flix site, closely related to the presence of dioxin-like PCBs, whereas the PCDDs/Fs contribution to this impact appears to be non-significant, at least in the studied sites.     

Can Offshore Wind Energy Be a Lever for Job Creation in France? Some Insights from a Local Case Study

The French government has launched three separate calls for tender in July 2011, March 2013, and December 2016 to install 3.5 GW of offshore wind. In addition to contributing to the fulfillment of environmental commitments, the deployment of offshore wind energy is expected to be a lever for economic development. To assess gross economic impacts, mainly in terms of job creation, we built a regional input-output model of the wind farm off Saint-Brieuc located in the region of Brittany, north-western France. Our model indicates that the project will have positive effects on Brittany’s economy. In particular, during the investment phase, the wind farm is expected to lead to €0.38 M/year/MW of added value and 6.03 full-time equivalent (FTE) jobs/year/MW. During the operation and maintenance (O&M) phase, the model predicts the generation of €0.15 M/year/MW of added value and 1.02 FTE jobs/year/MW. These results imply that the project will increase Brittany’s GDP slightly by 0.22 and 0.09% during the investment and O&M phases, respectively. Results also show that out of total wealth created in France, 38 and 66% will be created in Brittany as well as 32 and 51% of employment during respectively investment and O&M phases. A comparative analysis highlights in particular that economic impacts are generally stronger during the investment phase. It also demonstrates that the magnitude of economic impacts depends on the proportion of local industries in the supply chain. Policy implications of our model stress the need to revise the economic, technological, regulatory, and social frameworks within which the offshore wind industry currently operates in France to establish the conditions necessary for its development.     

Modeling and model performance evaluation of sewage sludge gasification in fluidized-bed gasifiers using Aspen Plus

A model was developed to simulate the sewage sludge gasification in an atmospheric fluidised bed gasifier using Aspen Plus. The model here presented was based on the Gibbs free energy minimisation and the restricted equilibrium method was used to calibrate it against previously published experimental data obtained in a lab-scale gasification plant. A sensitivity analysis of the model was carried out by modifying parameters such as the temperature, equivalence ratio (ER) and the steam-to-biomass ratio. The modeled results were in good agreement with the experimental data (especially when air was used as gasifying agent) and reproduced satisfactorily the experimental trends found for the gas composition, the carbon conversion (Xc) and the cold gas efficiency (CGE) under different gasification conditions. Operating at higher temperatures increased the production of H₂ and CO, as well as the Xc and the CGE. The increase in ER produced higher Xc, yet the CGE experienced slight changes due to a decrease in the lower heating value of the resulting syngas, as well as the oxidation of combustible gases. The use of air+steam as gasifying agent increased the H₂ content of the produced gases but decreased the accuracy of the model.

Implications: Gasification is an available alternative to produce energy as well as several raw materials from sewage sludge. The syngas obtained from this technology totally depends on the type of gasifier and the operation conditions, which can be optimized with the help of models. In this work, a relatively simple model was built using ASPEN PLUS. Despite its simplicity, the outputs of the model are in good agreement with experimental results what makes its use interesting for assessing scaling-up possibilities from lab-scale to pilot-scale gasification processes.