Environmental monitoring of historical change in arsenic deposition with tree bark pockets

ICP-MS analysis recorded historical change (c. 1846 to 2002) in the arsenic concentration of bark included within the trunks (tree bark pockets) of two Japanese oak trees (Quercus crispula), collected at an elevated location approximately 10 km from the Ashio copper mine and smelter, Japan. The arsenic concentration of the bark pockets was 0.016 +/- 0.003 microg cm(-2) c. 1846 (n = 5) and rose 50-fold from c. 1875 to c. 1925, from approximately 0.01 to 0.5 microg cm(-2). The rise coincided with increased copper production in Ashio from local sulfide ores, from 46 tons per year in 1877 to 16,500 tons per year in 1929. Following a decline in arsenic concentration and copper production, in particular during the Second World War, a second peak was observed c. 1970, corresponding to high levels of production from both local (6,000 tons per year) and imported (30,000 tons per year) ores, smelted from 1954. Compared to the local ores, the contribution of arsenic from imported ores appeared relatively low. Arsenic concentrations declined from c. 1970 to the present following the closure of the mine in 1974 and smelter in 1989, recording 0.058 +/- 0.040 microg cm(-2) arsenic (n = 5) in surface bark collected in 2002. The coincident trends in arsenic concentration and copper production indicated that the bark pockets provided an effective record of historical change in atmospheric arsenic deposition.     

Integration of modeling,monitoring and laboratory observation to determine reasons for air quality violations

An attempt was made to explain ambient air quality violations in the vicinity of industrial plants. Micrometeorology, diffusion calculaations, ambient readings, and plant engineering data are all taken into consideration to ascertain whether the plant is or is not the principal offender.Scrutiny of hi-vol filters using scanning electron microscopy for particle size analysis and particle chemical make-up as an assessment technique is also described.Case histories using the above analytical techniques are discussed.Presented at the 16th National Conference on Energy and the Environment, May 23, 1979     

Determination of biomass burning emission factors: Methods and results

Biomass burning, in a broad sense, encompasses different burning practices, including open and confined burnings, and different types of vegetation. Emission factors of gaseous or particulate trace compounds are directly dependent both on the fuel type and the combustion process. Emission factors are generally calculated by stoichiometric considerations using the carbon mass balance method, applied either to combustion chamber experiments or to field experiments based on ground-level measurements or aircraft sampling in smoke plumes. There have been a number of experimental studies in the last 10 years to investigate wildfires in tropical, temperate, or boreal regions. This article presents an overview of measurement methods and experimental data on emission factors of reactive or radiatively active trace compounds, including trace gases and particles. It focuses on fires in tropical regions, that is, forest and savanna fires, agricultural burns, charcoal production, use of fuelwood, and charcoal combustion.     

Characterizing soils for hazardous waste site assessments

This paper provides a review and justification of the minimum data needed to characterize soils for hazardous waste site assessments and to comply with the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA). Scientists and managers within the regulatory agency and the liable party need to know what are the important soil characteristics needed to make decisions about risk assessment, what areas need remediation and what remediation options are available. If all parties involved in characterizing a hazardous waste site can agree on the required soils data set prior to starting a site investigation, data can be collected in a more efficient and less costly manner. Having the proper data will aid in reaching decisions on how to address concerns at, and close-out, hazardous waste sites.This paper was prepared to address two specific concerns related to soil characterization for CERCLA remedial response. The first concern is the applicability of traditional soil classification methods to CERCLA soil characterization. The second is the identification of soil characterization data type required for CERCLA risk assessment and analysis of remedial alternatives. These concerns are related, in that the Data Quality Objective (DQO) process addresses both. The DQO process was developed in part to assist CERCLA decision-makers in identifying the data types, data quality, and data quantity required to support decisions that must be made during the remedial investigation/feasibility study (RI/FS) process. Data Quality Objectives for Remedial Response Activities: Development Process (US EPA, 1987a) is a guidebook on developing DQOs. This process as it relates to CERCLA soil characterization is discussed in the Data Quality Objective Section of this paper.     

Effects of exposure of aquatic snails to sublethal concentrations of waste drilling fluid

Static bioassays were carried out using two aquatic snails (Pilia sp. and Lanistes sp.) as test organisms in soft natural dilution water, with waste drilling fluid as the test material, at 28±2°C. Comparison of results for the control and different concentrations of the waste drilling fluid were made by means of the F-statistic method. The waste drilling fluid was practically non-toxic to the two aquatic snails.     

Heavy metals in the SPM of air in the environment surrounding a ferro-alloy industrial plant in India

Prices for ferro-alloys have hardened due to the closure of plants in developed countries on account of increasingly stringent pollution control legislation, resulting in a higher cost of production. A ferro-alloy industry with a capacity of 80000 MT per annum was selected to study the nature of pollution. Because of the objectionable nature of polluting air in and around the plant it was located in a rural area where there was no other industry. The area was agriculturally active and there was no effective control system for this plant.The quality of ambient air around the plant site is discussed in this paper along with the meteorological conditions. The maximum concentration of suspended particulate matter (SPM) was 768 µg/NM³ downwind of the plant, minimum 184 µg/NM³, and the average was more than 446 µg/NM³. The presence of heavy metals, viz. Fe, Mn, Cr and Pb, was also assessed. The concentration of Fe was 50 µg/NM³ downwind and 10 µg/NM³ upwind. The concentration of other metals followed a similar trend.     

Organochlorine contaminant concentrations in caddisfly adults (Trichoptera) collected from great lakes connecting channels

Pennsylvania-style light traps were used to capture adult Trichoptera from the St. Marys, St. Clair, Detroit and Niagara rivers, Canada. Adequate biomass was acquired in single, 2-h collections to permit triplicate gas chromatographic analyses of 1–4 g samples for 36 organochlorine contaminants. Contaminant levels varied unpredictably but relatively little among samples taken at monthly intervals over the summer. Samples collected simultaneously from the two sides of the Detroit R. reflected local sediment contaminant patterns, suggesting limited dispersal by adults. Genus-specific differences in contaminant concentrations within the Hydropsychidae and Leptoceridae probably reflect differences in larval habitats and manner of feeding. Contaminant concentrations and relative composition paralleled published reports of contaminants in sediments from collection locations. St. Marys R. caddisflies contained contaminant levels indistinguishable from samples collected at reference sites. St. Clair R. samples contained high levels of compounds associated with petrochemical industries located in the river's upstream reaches. High levels of polychlorinated biphenyls (PCBs) and most other contaminants in Detroit R. samples reflected industrial loadings near Detroit, Michigan. Niagara R. samples contained elevated concentrations of PCBs and pesticides. Cluster analysis grouped samples into five clusters each with unique contaminant composition. These also corresponded to geographic origin: St. Marys, St. Clair, Detroit and upper and lower Niagara rivers. The relative ease of collection and consistent results obtained render adult Trichoptera potentially valuable candidates for surveys of aquatic contamination over a broad range of geographical and ecological conditions.     

Matrix diffusion effects in the cleanup of heterogeneous aquifers

Simple mathematical models are developed to account for the rather slow mass transport of nonaqueous phase liquid (NAPL) into aqueous solution in groundwater during flushing operations. The models are based on the assumption that this bottleneck in the process is associated with diffusion in the aqueous phase in the porous medium from the location of the NAPL drops/ganglia in a region of relatively low permeability out into a region of substantially higher permeability, somewhat analogous to diffusion from a block of porous rock into a nearby fracture, where the fracture system overwhelmingly dominates the overall permeability. The models include batch flushing, flushing in a laboratory column, and a one-dimensional model for flushing by means of a single recovery well.     

Patchy distributions: Optimising sample size

A method for estimating sample size which does not require an a priori definition of desired precision, or the assumption that the population is normally distributed with constant variance, has recently been proposed. This paper discusses this method and presents five modifications which make the method easier to use and reduce the probability of estimating a larger sample size than is actually required. The method is extended and used to estimate the mean abundance of patchily distributed benthic organisms. The technique can be used to guide the design of any environmental sampling programme, be it physical, chemical or biological, where comparisons between times and/or locations are required. Trade-offs between numbers of replicates and numbers of levels/sites are discussed.     

Distribution of polychlorinated biphenyls (PCBs) and organochlorine pesticides in soils from the East Antarctic coast

Concentrations of hexachlorobenzene (HCB), alpha-, beta- and gamma-hexachlorocyclohexane (HCH) isomers, 6 o,p'-and p,p'-isomers of DDT and 28 PCB congeners have been measured in eleven soil samples and one lichen collected on the Eastern coast of Antarctica from 5 Russian stations. For samples with low concentrations of PCBs (range 0.20-0.41 ng g(-1) dry weight) and pesticides (0.86-4.69 ng g(-1) and 0.11-1.22 ng g(-1) dry weight for HCHs and DDTs, respectively), atmospheric long-range transport from Africa, South America or Australia was suggested as the sole source of contamination. The profile of PCB congeners was dominated by the more volatile tri-, tetra- and penta-PCBs congeners, thus supporting long-range transport hypothesis. Four samples contained moderate levels of PCBs (range 1.98-6.94 ng g(-1) dry weight) and variable concentrations of pesticides (gamma-HCH, p,p'-DDT and o,p'-DDT being the main contaminants). For samples with high concentrations of PCBs (range 90.26-157.45 ng g(-1)) and high concentrations of pesticides, the presence of high molecular weight PCB congeners such as: 153, 180, 187, 170 etc, strongly suggest a local source (biotic) of PCBs rather than atmospheric transport. It is likely that on a local scale, biotic focussing of pollutants, due to bird activities (nesting and excrement) can cause high contamination levels and become more significant than contaminant input via abiotic pathways.