A tracer study of headspace ventilation in a collector sewer

A field-scale tracer test was conducted to evaluate in-situ ventilation rates in a major collector sewer. The sewer under study was approximately 11 km long and ranged from 0.61 to 2.1 m in diameter. For the purposes of the tracer testing, the collector was divided into four reaches, each of which was tested individually. The tracer test involved injecting a measured volume of CO gas into a manhole over a short time period. CO concentrations were then measured in the collector headspace at selected manholes along the length of the reach. The technique employed successfully measured average headspace velocities over extended lengths of the collector. In a section that had a relatively stagnant headspace, approximately 1.1 km of sewer could be evaluated, with substantial tracer loss attributed to losses to manholes. In a section of the sewer with elevated headspace velocities, a section approximately 7.0 km long was successfully tested with one injection of tracer gas. The velocities observed in the collector varied substantially with time and location in the collector. The lowest velocities measured were in the upstream sections, with a minimum observed value of 3.8 m/min. The highest velocities were observed in the downstream sections, with a maximum value of 31.5 m/min. The presence of a substantial drop structure appeared to reduce the headspace velocity in the upstream reach. In general, there was an increasing trend in gas-phase flows with distance along the length of the collector. Flows at the discharge end of the collector were almost 2 orders of magnitude greater than those at the beginning.     

Performance evaluation of laser-induced breakdown spectrometry as a multimetal continuous emission monitor

Laser-induced breakdown spectroscopy (LIBS) has been evaluated as a multimetal continuous emissions monitor (CEM) at the U.S. Environmental Protection Agency (EPA) rotary kiln incinerator simulator (RKIS) facility in Raleigh, NC. Two detection systems with a bifurcated optical fiber bundle were used for simultaneously monitoring the concentrations of Be, Cd, Cr, and Hg in the test. Two calibration techniques were evaluated in the laboratory for the field measurements. On-line calibration of relative metal concentration was also performed in the simulated incinerator gas stream. Toxic metal concentrations measured with LIBS have been compared with the EPA reference method (RM) results.     

Changes in concentration of five PCDD/F congeners after cooking beef from treated cattle

A large piece of meat taken from a single animal, which had been dosed with five selected PCDD/Fs, was prepared and cooked by a selection of different methods; burgers (fried, grilled, barbecued), roasts (cooked using conventional and microwave ovens) and stews (open pan and pressure cooked). For some of the cooking methods, concentration changes, on a whole product basis, were observed between raw and cooked product. However, in all cases these could be explained simply through changes arising from loss of water and elimination of PCDD/Fs with released fat. The total amounts of PCDD/Fs present in the system (including in released fat) remained unchanged. Dietary intake of PCDD/Fs could therefore be reduced by the removal of visible fat from meat before cooking and by discarding any fat released from foods during the cooking process.     

Seveso Women's Health Study: does zone of residence predict individual TCDD exposure?

The compound, 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD), is produced as an unwanted by-product of various chemical reactions and combustion processes, including the manufacture of chlorinated phenols and derivatives. In animals, TCDD exposure is associated with toxic, carcinogenic, developmental, and reproductive effects. In 1976, a chemical plant explosion in Seveso, Italy, exposed the residents in the surrounding community to the highest exposure to TCDD known in humans. Materials from an aerosol cloud of sodium hydroxide, sodium trichlorophenate and TCDD were deposited over an 18.1 km2 area. As evidence of the significant level of TCDD exposure, numerous animals died and 193 cases of chloracne were reported among residents of the area. Initially, the contaminated area was divided into three major exposure Zones (A, B, R) based on the concentration of TCDD in surface soils. To date, the majority of epidemiologic studies conducted in Seveso have used Zone of residence as a proxy measure of exposure. The purpose of the present study is to validate the use of Zone of residence in Seveso as a proxy measure of exposure against individual serum TCDD measurement, and to determine whether questionnaire information can improve the accuracy of the exposure classification. Using data collected from the Seveso Women's Health Study (SWHS), the first comprehensive epidemiologic study of the reproductive health of women in Seveso, we determined that Zone of residence is a good predictor of individual serum TCDD level, explaining 24% of the variance. Using questionnaire information could have improved prediction of individual exposure levels in Seveso, increasing the percent of the variation in serum TCDD levels explained to 42%.     

Time to death response in carabid beetles exposed to multiple stressors along a gradient of heavy metal pollution

We investigated the responses of invertebrates inhabiting polluted environments to multiple stressors. Carabid beetles (Pterostichus oblongopunctatus F.) were subjected to food deprivation and insecticide treatment (dimethoate) to resolve trends associated with a gradient of heavy metal pollution. Metal concentrations along the gradient of five sites ranged from approximately 150 to 10,500 mg/kg Zn, 136 to 2600 mg/kg Pb, and 0.84 to 81.9 mg/kg Cd. There was no difference in body mass along the pollution gradient. However, the beetles originating from the most contaminated sites were significantly less tolerant to food deprivation than beetles from the reference site. Median survival time was 120 h for the two most polluted sites, compared with 168 h at the reference site. Beetles from the two most polluted sites were also significantly more susceptible to dimethoate at 0.1 microgram active ingredient/beetle. Median survival times were 12 and 123 h for beetles from the two most polluted sites and 359 h for the reference site. Carabid beetles exposed to chronic pollution, therefore, exhibit elevated susceptibility to additional stressors.     

ESF Workshop

Dioxin and PCB monitoring programs for food and feeding stuff in most countries of the world, including many European Countries are currently inadequate. Better control of food production lines and food processing procedures is needed to minimize entry of dioxin to the food chain and will help to avoid dioxin contamination accidents. This would also improve the ability to trace back a possible contamination to its source. European guidelines for monitoring programs should be established to ensure comparable and meaningful results. These guidelines should define the minimum requirements for the design of monitoring programs, analytical methods, and quality assurance. Though data from Northern Europe shows that the general population exposure to dioxin and PCB has decreased during the last ten years these compounds continue to be a risk of accidental contamination of the food chain. The most prominent recent example is the Belgian dioxin contamination of feeding stuff in 1999. The Belgian dioxin contamination was not detected due to dioxin monitoring programs but by their direct biological effects seen in animals. Four other cases of dioxin contamination have been detected in Europe since 1997 due to local monitoring programs. One of them (citrus pulp pellets 1998) was in a much larger scale than the Belgian dioxin contamination. The general population's exposure to dioxins and PCBs is still in the same range (1-4 pg WHO-TEQ/kg body weight and day) as the recently revised WHO tolerable daily intake (TDI). There is concern that short-term high level exposure to dioxins, furans, and PCB may cause biological effects on the human fetal development and further research is required. Further actions to control sources building on considerable advances already made in many countries may need to be supplemented by measures to prevent direct contamination of feeding stuff or food to reduce general population exposure further.     

Adsorption of imidazolinone herbicides on ferrihydrite-humic acid associations.

Adsorption of the imidazolinone herbicides imazapyr, imazethapyr and imazaquin was studied on two binary systems (ferrihydrite-humic acid) prepared by treating ferrihydrite (Fh) immediately after its precipitation with a soil humic acid (HA) at different loadings (4% and 8% HA content), and on a blank ferrihydrite sample prepared in the same way, but without HA addition. Imidazolinone adsorption on pure Fh and on the 4% Fh-HA decreased with increasing of the herbicide hydrophobicity (imazaquin相似文献   

The velocity of DNAPL fingering in water-saturated porous media: laboratory experiments and a mobile-immobile-zone model.

Dense nonaqueous phase liquids (DNAPLs) are immiscible with water and can give rise to highly fingered fluid distributions when infiltrating through water-saturated porous media. In this paper, a conceptual mobile-immobile-zone (MIZ) model is presented to describe the structure of a DNAPL finger in water-saturated porous media and the velocity of finger propagation. A finger is composed of a finger body and a tip. The finger body has a mobile core and an immobile sheath. All the DNAPL within the tip of a finger is mobile. Lab experiments utilizing image analyses of a DNAPL (PCE) penetrating into water-saturated homogeneous glass beads were carried out in a two-dimensional transparent chamber. The results show that the fingers elongated almost linearly with time. The fingers did not grow laterally after the tip of the finger had passed. The average finger diameters were between 3.9 and 5.4 mm for PCE propagation in water-saturated glass bead porous media with mean particle diameters from 0.32 to 1.36 mm. The estimated mobile core diameters were 51-60% of the average finger diameters.     

Management, disposal and recycling of waste industrial organic solvents in Hong Kong.

An attempt has been made to establish a mass balance of industrial organic solvents in Hong Kong. It is estimated that only a small portion, less than 4%, of all the organic solvents consumed in Hong Kong are collected as waste solvents and properly treated, while the remainder are used either in the formulation of solvent containing products, or are lost to the environment through vapour emissions, leaks and spills, or dumped illegally. It was found that solvent recycling has been a common practice in some industries but the existing level of solvent recycling in Hong Kong is difficult to estimate. About 87.4% of all the waste organic solvents disposed of at the licensed facilities are potentially recyclable although whether they can be recycled in practice depends on many factors. Examples of existing waste organic solvent management and recycling practices from selected industries in Hong Kong are presented. The economic feasibility of current and future potential recycling systems is evaluated for a few selected cases. An integrated waste organic solvent management strategy is proposed to minimize adverse impacts of organic solvents to the environment and human health.