VOC Emission Controls for Can End Sealing Compounds

Regulations require that emissions of VOC from the application of can end sealing compounds be limited to 440 grams per liter. One can manufacturer has investigated the cost and feasibility of a VOC capture/control system and the availability and efficacy of water-based and high solids end sealing compounds. After characterizing and optimizing VOC evaporation rates, a prototype VOC containment system was tested on one can end sealing compound line. An 83 percent VOC capture efficiency was obtained at approximately 950 acfm. A cost analysis for a full facility capture and control system gave cost-effectiveness values of $1.21 to $2.36 per pound of VOC controlled. An evaluation oflow-VOC end sealing compounds, including long term pack tests, produced a water-based compound that could be implemented on pet food can ends by early 1986. Continuation of pack tests could allow full facility conversion to zero VOC water-based compounds by mid- to late-1987. Using an innovative averaging technique, the can manufacturer has achieved equivalent compliance with the 440 grams per liter standard.     

Long-term survey of heavy-metal pollution, biofilm contamination and diatom community structure in the Riou Mort watershed, South-West France

In a metal-polluted stream in the Riou Mort watershed in SW France, periphytic biofilm was analyzed for diatom cell densities and taxonomic composition, dry weight and metal bio-accumulation (cadmium and zinc). Periphytic diatom communities were affected by the metal but displayed induced tolerance, seen through structural impact (dominance of small, adnate species) as well as morphological abnormalities particularly in the genera Ulnaria and Fragilaria. Species assemblages were characterized by taxa known to occur in metal-polluted environments, and shifts in the community structure expressed seasonal patterns: high numbers of Eolimna minima, Nitzschia palea and Pinnularia parvulissima were recorded in Summer and Autumn, whereas the species Surirella brebissonii, Achnanthidium minutissimum, Navicula lanceolata and Surirella angusta were dominant in Winter and Spring. Commonly used indices such as the Shannon diversity index and Specific Pollution Sensitivity Index reflected the level of pollution and suggest seasonal periodicity, the lowest diversities being observed in Summer.     

Physiological recovery from episodic acid stress does not mean population recovery of Gammarus fossarum

The physiological responses of the acid-sensitive amphipod Gammarus fossarum exposed in situ to acid stress (pH4.5 and 5.5) and then transferred back to neutral water were investigated. Survival rate and haemolymph [Cl(-)] and [Na(+)] were assessed after 24, 48 and 72h of exposure in acidic streams and after a recovery period of 12, 24, 36, 48 and 60h. After 24h, exposure to slightly acidic (pH5.5) and strongly acidic water (pH4.5) led to a severe and significant depletion in haemolymph [Na(+)] and [Cl(-)] compared to organisms exposed in circumneutral water (pH7.3). However, after only a 12h-period of transfer back in neutral water and whatever the previous exposure time (24, 48 and 72h) in both slightly and strongly acidic water, haemolymph [Na(+)] and [Cl(-)] were equal or superior to the control level without associated mortality. In spite of this fast physiological recovery capacity, populations of G. fossarum living in streams undergoing episodic acid stresses were drastically affected thus, demonstrating the high acid-sensitivity of this species. We discuss the possible reasons of population regression and the absence of population recovery.     

The sensitivity of surface waters of Great Britain to acidification predicted from catchment characteristics

Using a combination of soil, land use and geological information, a map of Great Britain has been derived which indicates the sensitivity of surface waters to acidification. For the geological information, a slightly modified version of an available map was used which indicated the sensitivity of groundwaters to acidification. For soils, 1-km databases of soil information for England and Wales and for Scotland were employed to map the soil sensitivity as determined by buffering capacity. The derived soils map was modified to take account of agricultural liming in arable and managed grassland areas using the ITE Land Classification. The final map of surface water sensitivity was obtained by using a geographic information system overlay procedure which enabled each combination of soil and geology sensitivity to be uniquely defined. The final sensitivity classification was based upon expert knowledge and the experience of a similar sensitivity mapping exercise for Wales.     

Variation in CO2 assimilation rate induced by simulated dew waters with different sources of hydroxyl radical (*OH) on the needle surfaces of Japanese red pine (Pinus densifora Sieb. et Zucc.)

The hydroxyl radical (*OH) is generated in polluted dew on the needle surfaces of Japanese red pine (Pinus densiflora Sieb. et Zucc.). This free radical, which is a potent oxidant, is assumed to be a cause of ecophysiological disorders of declining trees on the urban-facing side of Mt. Gokurakuji, western Japan. Mists of *OH-generating N(III) (HNO2 and NO2-) and HOOH + Fe + oxalate solutions (50 and 100 microM, pH 5.1-5.4) simulating the dew water were applied to the foliage of pine seedlings grown in open-top chambers in the early morning. Needles treated with 100 microM N(III) tended to have a greater maximum CO2 assimilation rate (Amax), a greater stomatal conductance (g(s)) and a greater needle nitrogen content (Nneedle), suggesting that N(III) mist acts as a fertilizer rather than as a phytotoxin. On the other hand, needles treated with 100 microM HOOH + Fe + oxalate solution showed the smallest Amax, g(s), and Nneedle, suggesting that the combination of HOOH + Fe + oxalate caused a decrease in needle productivity. The effects of HOOH + Fe + oxalate mist on pine needles were very similar to the symptoms of declining trees at Mt. Gokurakuji.     

Characterization of silver release from commercially available functional (nano)textiles

Silver, both in the nano as well as in other forms, is used in many applications including antimicrobial textiles. Washing of such textiles has already been identified as an important process that results in the release of silver into wastewater. This study thus investigated the release of silver from eight different commercially available silver-textiles during a washing and rinsing cycle. The silver released was size-fractionated and characterized using electron microscopy. In addition, the antimicrobial functionality of the textiles was tested before and after washing. Three of the textiles contained nanosized silver (labeled or confirmed by manufacturers’ information), another used a metallic silver wire and four contained silver in undeclared form. The initial silver content of the textiles was between 1.5 and 2925 mg Ag/kg. Only four of the investigated textiles leached detectable amounts of silver, of which 34-80% was in the form of particles larger than 450 nm. Microscopic analysis of the particles released in the washing solutions identified Ti/Si-AgCl nanocomposites, AgCl nanoparticles, large AgCl particles, nanosilver sulfide and metallic nano-Ag, respectively. The nanoparticles were mainly found in highly agglomerated form. The identified nanotextiles showed the highest antimicrobial activity, whereas some of the other textiles, e.g. the one with a silver wire and the one with the lowest silver content, did not reduce the growth of bacteria at all. The results show that different silver textiles release different forms of silver during washing and that among the textiles investigated AgCl was the most frequently observed chemical form in the washwater.