Surfactant enhanced recovery of tetrachloroethylene from a porous medium containing low permeability lenses. 1. Experimental studies

A matrix of batch, column and two-dimensional (2-D) box experiments was conducted to investigate the coupled effects of rate-limited solubilization and layering on the entrapment and subsequent recovery of a representative dense NAPL, tetrachloroethylene (PCE), during surfactant flushing. Batch experiments were performed to determine the equilibrium solubilization capacity of the surfactant, polyoxyethylene (20) sorbitan monooleate (Tween 80), and to measure fluid viscosity, density and interfacial tension. Results of one-dimensional column studies indicated that micellar solubilization of residual PCE was rate-limited at Darcy velocities ranging from 0.8 to 8.2 cm/h and during periods of flow interruption. Effluent concentration data were used to develop effective mass transfer coefficient (Ke) expressions that were dependent upon the Darcy velocity and duration of flow interruption. To simulate subsurface heterogeneity, 2-D boxes were packed with layers of F-70 Ottawa sand and Wurtsmith aquifer material within 20-30 mesh Ottawa sand. A 4% Tween 80 solution was then flushed through PCE-contaminated boxes at several flow velocities, with periods of flow interruption. Effluent concentration data and visual observations indicated that both rate-limited solubilization and pooling of PCE above the fine layers reduced PCE recovery to levels below those anticipated from batch and column measurements. These experimental results demonstrate the potential impact of both mass transfer limitations and subsurface layering on the recovery of PCE during surfactant enhanced aquifer remediation.     

Biosurfactant-enhanced solubilization of NAPL mixtures

Remediation of nonaqueous phase liquids (NAPLs) by conventional pump-and-treat methods (i.e., water flushing) is generally considered to be ineffective due to low water solubilities of NAPLs and to mass-transfer constraints. Chemical flushing techniques, such as surfactant flushing, can greatly improve NAPL remediation primarily by increasing the apparent solubility of NAPL contaminants. NAPLs at hazardous waste sites are often complex mixtures. However, the equilibrium and nonequilibrium mass-transfer characteristics between NAPL mixtures and aqueous surfactant solutions are not well understood. This research investigates the equilibrium solubilization behavior of two- and three-component NAPL mixtures (containing akylbenzenes) in biosurfactant solutions. NAPL solubilization is found to be ideal in water (i.e., obeys Raoult's Law), while solubilization in biosurfactant solutions was observed to be nonideal. Specifically, the relatively hydrophobic compounds in the mixture experienced solubility enhancements that were greater than those predicted by ideal enhanced solubilization theory, while the solubility enhancements for the relatively hydrophilic compounds were less than predicted. The degree of nonideality is shown to be a nonlinear function of the NAPL-phase mole fraction. Empirical relationships based on the NAPL-phase mole fraction and/or micelle-aqueous partition coefficients measured in single-component NAPL systems are developed to estimate values for the multicomponent partition coefficients. Empirical relationships that incorporate both the NAPL-phase mole fraction and single-component partition coefficients yield much improved estimates for the multicomponent partition coefficient.     

Determination of source contributions to ambient PM2.5 in Kaohsiung, Taiwan, using a receptor model

Ambient particulates of PM2.5 were sampled at three sites in Kaohsiung, Taiwan, during February and March 1999. In addition, resuspended PM2.5 collected from traffic tunnels, paved roads, fly ash of a municipal solid waste (MSW) incinerator, and seawater was obtained. All the samples were analyzed for twenty constituents, including water-soluble ions, organic carbon (OC), elemental carbon (EC), and metallic elements. In conjunction with local source profiles and the source profiles in the model library SPECIATE EPA, the receptor model based on chemical mass balance (CMB) was then applied to determine the source contributions to ambient PM2.5. The mean concentration of ambient PM2.5 was 42.69-53.68 micrograms/m3 for the sampling period. The abundant species in ambient PM2.5 in the mass fraction for three sites were OC (12.7-14.2%), SO4(2-) (12.8-15.1%), NO3- (8.1-10.3%), NH4+ (6.7-7.5%), and EC (5.3-8.5%). Results of CMB modeling show that major pollution sources for ambient PM2.5 are traffic exhaust (18-54%), secondary aerosols (30-41% from SO4(2-) and NO3-), and outdoor burning of agriculture wastes (13-17%).     

A tracer study of headspace ventilation in a collector sewer

A field-scale tracer test was conducted to evaluate in-situ ventilation rates in a major collector sewer. The sewer under study was approximately 11 km long and ranged from 0.61 to 2.1 m in diameter. For the purposes of the tracer testing, the collector was divided into four reaches, each of which was tested individually. The tracer test involved injecting a measured volume of CO gas into a manhole over a short time period. CO concentrations were then measured in the collector headspace at selected manholes along the length of the reach. The technique employed successfully measured average headspace velocities over extended lengths of the collector. In a section that had a relatively stagnant headspace, approximately 1.1 km of sewer could be evaluated, with substantial tracer loss attributed to losses to manholes. In a section of the sewer with elevated headspace velocities, a section approximately 7.0 km long was successfully tested with one injection of tracer gas. The velocities observed in the collector varied substantially with time and location in the collector. The lowest velocities measured were in the upstream sections, with a minimum observed value of 3.8 m/min. The highest velocities were observed in the downstream sections, with a maximum value of 31.5 m/min. The presence of a substantial drop structure appeared to reduce the headspace velocity in the upstream reach. In general, there was an increasing trend in gas-phase flows with distance along the length of the collector. Flows at the discharge end of the collector were almost 2 orders of magnitude greater than those at the beginning.     

Performance evaluation of laser-induced breakdown spectrometry as a multimetal continuous emission monitor

Laser-induced breakdown spectroscopy (LIBS) has been evaluated as a multimetal continuous emissions monitor (CEM) at the U.S. Environmental Protection Agency (EPA) rotary kiln incinerator simulator (RKIS) facility in Raleigh, NC. Two detection systems with a bifurcated optical fiber bundle were used for simultaneously monitoring the concentrations of Be, Cd, Cr, and Hg in the test. Two calibration techniques were evaluated in the laboratory for the field measurements. On-line calibration of relative metal concentration was also performed in the simulated incinerator gas stream. Toxic metal concentrations measured with LIBS have been compared with the EPA reference method (RM) results.     

Changes in concentration of five PCDD/F congeners after cooking beef from treated cattle

A large piece of meat taken from a single animal, which had been dosed with five selected PCDD/Fs, was prepared and cooked by a selection of different methods; burgers (fried, grilled, barbecued), roasts (cooked using conventional and microwave ovens) and stews (open pan and pressure cooked). For some of the cooking methods, concentration changes, on a whole product basis, were observed between raw and cooked product. However, in all cases these could be explained simply through changes arising from loss of water and elimination of PCDD/Fs with released fat. The total amounts of PCDD/Fs present in the system (including in released fat) remained unchanged. Dietary intake of PCDD/Fs could therefore be reduced by the removal of visible fat from meat before cooking and by discarding any fat released from foods during the cooking process.     

Seveso Women's Health Study: does zone of residence predict individual TCDD exposure?

The compound, 2,3,7,8-tetrachlorodibenzo-p-dioxin (TCDD), is produced as an unwanted by-product of various chemical reactions and combustion processes, including the manufacture of chlorinated phenols and derivatives. In animals, TCDD exposure is associated with toxic, carcinogenic, developmental, and reproductive effects. In 1976, a chemical plant explosion in Seveso, Italy, exposed the residents in the surrounding community to the highest exposure to TCDD known in humans. Materials from an aerosol cloud of sodium hydroxide, sodium trichlorophenate and TCDD were deposited over an 18.1 km2 area. As evidence of the significant level of TCDD exposure, numerous animals died and 193 cases of chloracne were reported among residents of the area. Initially, the contaminated area was divided into three major exposure Zones (A, B, R) based on the concentration of TCDD in surface soils. To date, the majority of epidemiologic studies conducted in Seveso have used Zone of residence as a proxy measure of exposure. The purpose of the present study is to validate the use of Zone of residence in Seveso as a proxy measure of exposure against individual serum TCDD measurement, and to determine whether questionnaire information can improve the accuracy of the exposure classification. Using data collected from the Seveso Women's Health Study (SWHS), the first comprehensive epidemiologic study of the reproductive health of women in Seveso, we determined that Zone of residence is a good predictor of individual serum TCDD level, explaining 24% of the variance. Using questionnaire information could have improved prediction of individual exposure levels in Seveso, increasing the percent of the variation in serum TCDD levels explained to 42%.     

PCDD and PCDF exposures in workers and controls living near an industrial waste incinerator

This study measured the levels of 17 congeners of PCDDs/PCDFs in serum to compare the levels between potentially exposed workers at an industrial waste incinerator and any residents with no known exposures. The 1,2,3,6,7,8- and 1,2,3,7,8,9-HxCDD were detected in serum of workers but in controls. Likewise, 1,2,3,7,8-PeCDF, 1,2,3,6,7,8- and 1,2,3,7,8,9-HxCDF were detected only in serum of workers. The international toxic equivalent (TEQ) levels of PCDDs/PCDFs in sera of workers are much higher than in controls. Among PCDDs, the proportion of total concentration and TEQ level is dominated predominantly by 1,2,3,6,7,8- and 1,2,3,7,8,9-HxCDD. We need extensive studies to estimate human exposure and are continuing this investigation.     

ESF Workshop

Dioxin and PCB monitoring programs for food and feeding stuff in most countries of the world, including many European Countries are currently inadequate. Better control of food production lines and food processing procedures is needed to minimize entry of dioxin to the food chain and will help to avoid dioxin contamination accidents. This would also improve the ability to trace back a possible contamination to its source. European guidelines for monitoring programs should be established to ensure comparable and meaningful results. These guidelines should define the minimum requirements for the design of monitoring programs, analytical methods, and quality assurance. Though data from Northern Europe shows that the general population exposure to dioxin and PCB has decreased during the last ten years these compounds continue to be a risk of accidental contamination of the food chain. The most prominent recent example is the Belgian dioxin contamination of feeding stuff in 1999. The Belgian dioxin contamination was not detected due to dioxin monitoring programs but by their direct biological effects seen in animals. Four other cases of dioxin contamination have been detected in Europe since 1997 due to local monitoring programs. One of them (citrus pulp pellets 1998) was in a much larger scale than the Belgian dioxin contamination. The general population's exposure to dioxins and PCBs is still in the same range (1-4 pg WHO-TEQ/kg body weight and day) as the recently revised WHO tolerable daily intake (TDI). There is concern that short-term high level exposure to dioxins, furans, and PCB may cause biological effects on the human fetal development and further research is required. Further actions to control sources building on considerable advances already made in many countries may need to be supplemented by measures to prevent direct contamination of feeding stuff or food to reduce general population exposure further.