Longitudinal examination of underage drinking and subsequent drinking and risky driving

INTRODUCTION: Alcohol use, alcohol misuse, and risky driving from adolescence into young adulthood were compared by drinking onset age. METHODS: Surveys were administered in Grades 5/6, 6/7, 7/8, 10, 12, and at approximately age 23. Participants were placed into Drinking Onset groups based on self-reported alcohol use frequency on the adolescent surveys. Driving records were examined in three age periods: under 21, 21-25, and 26+. RESULTS: The earliest drinking initiators reported higher alcohol use and misuse on each survey, and were more likely to have risky driving offenses before age 21 and to have alcohol driving offenses in all three age periods. DISCUSSION: The earliest drinking initiators engaged in risky drinking behavior and risky driving behavior that was consistently higher than those with later drinking initiation, beginning in adolescence and persisting well into young adulthood.     

SAFEST TO TRAVEL BY BICYCLE,CAR, OR BIG TRUCK?

This study compares highway crash incidence, injuries, and costs by vehicle type. Annual crash and injury incidence were estimated using Crashworthiness Data System (1988-1991), National Automotive Sampling System (1982-1986), General Estimates System (1992-1993), and Fatal Analysis Reporting System (1993) data. Costs were computed based on restraint use, body region, and threat-to-life severity of the injury. Costs were then allocated between vehicle types using three different methods in order to answer comparative safety questions. Motor vehicle and bicycle crash costs total $389 billion annually; 75% resulting from passenger vehicles. Motorcycles and bicycles have the highest costs per 1000 vehicle and passenger miles; costs per victim are highest for pedestrians, bicyclists, and motorcyclists. Costs per vehicle mile for heavy trucks and passenger cars are comparable but exceed costs for light trucks. Passenger vehicle occupants are safest if a crash occurs. Light truck, other single truck, and bus occupants have the lowest cost per passenger mile, but higher costs than air and rail travelers. Motorcyclists face the greatest risks. Combination trucks may not impose an excess risk to other drivers, but their drivers face large risks.     

Experimental investigation of hydrogen–air deflagrations and detonations in semi-confined flat layers

This paper presents results of an experimental investigation on the deflagration and deflagration-to-detonation transition (DDT) in an obstructed (blockage ratio BR = 50%), semi-confined flat layer filled with uniform hydrogen–air mixtures. The effect of mixture reactivity depending on flat layer thickness and its width is studied to evaluate the critical conditions for sonic flame propagation and the possibility for detonation onset. The experiments were performed in a transparent, rectangular channel with a length of 2.5 m. The flat layer thickness was varied from 0.06 to 0.24 m and the experiments were performed for different channel widths of 0.3, 0.6 and 0.9 m. The experimental results show flame velocity vs. hydrogen concentration for different thicknesses and widths of the semi-confined flat layer. Three different flame propagation regimes were observed: slow subsonic flame (M << 1), sonic deflagration (M ～ 1) and detonation (M >> 1). It is shown that flame acceleration (FA) to sonic speed is independent of the width of the flat layer. The critical expansion ratio for effective flame acceleration to sonic speed was found to be linearly dependent on the reciprocal layer thickness.     

Worst-case identification of gas dispersion for gas detector mapping using dispersion modeling

To quickly and accurately quantify the material release in process units, gas detectors may be placed according to the results of gas dispersion modeling. DNV's PHAST software is one of the most useful and reliable tools for material dispersion modeling. In this software, fluid dispersion is modeled based on the process conditions, the weather conditions and the specifications of the material release point. However, varying weather conditions throughout the year and the exact determination of the release point on the plot plan and the release elevation are problematic; these issues cause the results to be non-exact and non-integrated. Choosing the most appropriate conditions is challenging. In this paper, a scheme was provided to select the most appropriate conditions for gas dispersion modeling. This scheme approaches modeling based on the worst-case scenario (the situation in which the dispersed gas reaches the detector later in comparison to the other cases). Therefore, different weather conditions, release elevations and release points on the plot plan were modeled for an absorber tower of the Gonbadli Dehydration Unit of the Khangiran Refinery. The worst case of each release condition was then chosen. Finally, gas detectors were placed using the gas dispersion modeling results based on the worst-case scenario.     

Media surface properties and the development of nitrifying biofilms in mixed cultures for wastewater treatment

Plastic was tested to select biofilm support media that would enhance nitrification in the presence of heterotrophs. Eight different types (acrylonitrile butadiene styrene, nylon, polycarbonate, polyethylene, polypropylene, polytetrafluoroethylene (PTFE), polyvinyl chloride and tufnol) were immersed in an aerobic fed-batch reactor receiving domestic settled wastewater. Nitrification rates did not correlate with biomass concentrations, nor surface roughness of the plastics as measured by atomic force microscopy (AFM). The maximum nitrification rate of 1.5 g/m² d^?1 was obtained from biofilms growing on PTFE which had the lowest surface adhesion force (8 nN). Nitrification rates for the biofilms were inversely correlated with the attraction forces as measured by AFM.     

Biological methane production coupled with sulfur oxidation in a microbial electrosynthesis system without organic substrates

Methane is produced in a microbial electrosynthesis system (MES) without organic substrates. However, a relatively high applied voltage is required for the bioelectrical reactions. In this study, we demonstrated that electrotrophic methane production at the biocathode was achieved even at a very low voltage of 0.1 V in an MES, in which abiotic HS⁻ oxidized to SO₄²⁻ at the anodic carbon-cloth surface coated with platinum powder. In addition, microbial community analysis revealed the most probable pathway for methane production from electrons. First, electrotrophic H₂ was produced by syntrophic bacteria, such as Syntrophorhabdus, Syntrophobacter, Syntrophus, Leptolinea, and Aminicenantales, with the direct acceptance of electrons at the biocathode. Subsequently, most of the produced H₂ was converted to acetate by homoacetogens, such as Clostridium and Spirochaeta 2. In conclusion, the majority of the methane was indirectly produced by a large population of acetoclastic methanogens, namely Methanosaeta, via acetate. Further, hydrogenotrophic methanogens, including Methanobacterium and Methanolinea, produced methane via H₂.     

Status of air pollution in Beijing

A study has been made on elements organic constituents, TSP, SO2,NO2 of atmospheric pollutants in Beijing. 17 elements, and some PAHs, e. g. B(a)P, B(b, j, k)P, and B(g, h, i)P, in airborne particles by X-ray fluorescence spectroscopy and HPLC, GC/MS, have been determined respectively. It has been shown that the elements Pb, Zn, S and Cu were more enriched in fine particles and different valence states of sulfur at various sites. It was found that the concentrations of S6+ and S2-were more than 85% and less than 15% of the total sulfur respectively. Concentrations of major PAHs and sulfur-containing compounds increased in winter and in urban area. High values for Pb and Zn in city, Fe and Mn at industrial area and Cu, Al rural sites were obtained respectively. This implies the functions of different elemental sources of various sites. Thus, elements can be from distingushed anthropogenic and natural sources.The main contribution of SO2 was found of to have same seasonal variation as the anthropogenic el     

Development of vermicast from sludge and powdered oyster shell

Soil acidification is one of the rising land degradation issues facing world agriculture. The risk of acidification is currently being assessed as part of agriculture productivity and sustainable theme. This study was conducted to produce a new vermicomposting cast as a recycling resource derived from municipal sewage sludge and waste oyster shell. The earthworm, Eisenia Andrei, was fed under different conditions. The most suitable mixture was 77:23 w/w% of sewage sludge and waste oyster shell. Powdered oyster shell (POS) sludge blend provided a stable pH, due to its buffering capacity during vermiculture because of the Ca²⁺ and OH^? release effect. The vermicast products fulfilled the cast standards of Korea Ministry of Environment for all the parameters such as moisture content, pH, salinity, organic carbon, TKN, Phosphate, and heavy metals. Slowly released organic matter when added to soil improves the capacity of the soil to hold nutrients for plants, improve soil aeration for roots, and improves soil drainage. This product will be an addition to already-commercialized sludge vermicast as a higher value product.     

Female seed beetles, <Emphasis Type="Italic">Callosobruchus maculatus,</Emphasis> remate for male-supplied water rather than ejaculate nutrition

Female seed beetles, Callosobruchus maculatus, mate multiply even though association with males and copulations carry costs, such as injury to the genital tract. Multiple mating (polyandry) may, however, offset these costs through the acquisition of food and water, two material benefits hypothesized to be obtained from the large ejaculates produced by males. The material benefits hypothesis can be tested by increasing female access to nutrients and water, with the prediction that female mating frequency will decrease as copulation is no longer required to derive these materials. Females were given water, 5% sugar–water or baker’s yeast, and were compared with females deprived of these. We presented females with virgin males daily for 8 days and recorded female mating frequency, survivorship, and fecundity. Females provided with water and sugar–water decreased mating frequency. Thus, water, rather than nutrients in the ejaculate, appears to be important to females of this species. In addition, both life span and fecundity were extended for females in the sugar–water and water treatments. Since water is scarce in the arid environment in which this species is found, we conclude that polyandry provides material benefits to females that may offset some of the costs of associating with males.