Visible light responsive N-F-codoped TiO2 photocatalysts for the degradation of 4-chlorophenol

Visible light responsive N-F-codoped TiO₂ photocatalysts exhibit a higher catalytic activity than N-doped TiO₂ for the degradation of 4-chlorophenol due to the synergistic effect of nonmetal elements.     

Structural and electrochemical properties of annealed La1-xYxNi3.55Mno.4Alo.3Coo.75 hydrogen storage alloys

The effects of the annealing and partial substitution of Y for La on the structural and electrochemical properties of La_1-xY_xNi_3.55Mn_o.4Al_o.3Cr_o.75 (x = 0, 0.1 and 0.2) alloys were reported in the present work. The single-phased CaCu₅-type structure was retained after La was partially substituted by Y. However, the increase of Y content leads to decrease of the lattice parameters and the unit-cell volume. The annealed La_o.9Y_o.1Ni_3.55Mn_o.4Al_o.3Co_o.75 alloys shows typical isometric microstructure, indicating that the composition segregation is improved by annealing. Y substitution for La in the alloys is effective to improve the electrochemical properties at both room temperature and high temperature. A critical substitution content of Y is found at x = 0.1.     

Decolorization of dye solutions with Ruditapes philippinarum conglutination mud and the isolated bacteria

Application of Ruditapes Philippinarum conglutination mud (RPM) for decolorizing synthetic dye solutions was studied. RPM showed good activity for decolorization of Methylene Blue, Crystal Violet, Malachite Green, and Ink Blue. The amount of the RPM had great effect on the decoloration rate of the dye solutions. However, the decoloration rate did not continue to increase when the amount of mud exceeded the optimum dose. The temperature of the dye solution had a remarkable effect on the decolorization rate of Ink Blue solution, but had little effect on the other three dye solutions. The initial pH of the dye solutions evidently affected the decolorization rate of Malachite Green solution, but had less effect on the other three. The decolorization rate of the dye solutions increased significantly with treatment time within 8 hr, but tended to be steady after 8 hr for Methylene Blue, Crystal Violet and Malachite Green solutions, and after 12 hr for Ink Blue solution. The decolorization efficiencies for the four dye solutions under the optimum conditions were all above 90%. Seventeen strains screened from RPM showed flocculation ability for kaolin clay suspension. Out of them, the flocculation rate of strain ZHT3-9 and strain ZHT4-13 were up to 88.14% and 86.01%, respectively. ZHT3-9 was studied, and its decolorization rate for Methylene Blue, Crystal Violet, and Malachite Green reached 90.02%, 89.21%, and 80.29%, respectively. By morphological, physiological and biochemical characteristics analysis and 16S rRNA sequencing, the strain ZHT3-9 was identified as Arthrobacter sp.     

Cadmium removal from wastewater by sponge iron sphere prepared by hydrogen reduction

A new type of sponge iron sphere (NSIS) with 1-5 mm diameter, made of concentrated iron powder and possessed high activity and intension, was prepared by mini-pellet sintering integrated with H₂ direct reduction. Static state experiment has been carried on to investigate the Cd²⁺ removal efficiency from wastewater by the NSIS and to explore the Cd²⁺ removal reaction kinetics. It was suggested that initial pH value and Cd²⁺ original concentration had significant influence on Cd²⁺ removal percentage. Cd²⁺ removal percentage decreased significantly with the increasing of Cd²⁺original concentration whether the original pH value be adjusted to 3.0 or without adjustment. The results showed that the Cd²⁺ removal process followed the first order reaction because the reaction order was from 0.803 to 0.996. The apparent reaction rate constant between Cd²⁺ and NSIS was from 0.0025 to 0.1000 (mg·L^?1)^1-n·min^?1. Compared with SIS reduced by charcoal reduction, NSIS deoxided by hydrogen possessed higher activity, and could remove the same quantity of Cd²⁺ within a shorter period of time.     

化学品测试合格实验室体系建设与发展

根据《新化学物质环境管理办法》要求,为新化学物质申报目的提供测试数据的境内测试机构,应当为环境保护部公告的化学物质测试机构,并接受环境保护部的监督和检查。拟通过借鉴国际合格实验室规范(GLP)基本原则和国内其他GLP认证工作经验做法,结合环境保护部已开展的检查考核工作和化学品测试实验室实际情况,探讨化学品测试合格实验室的管理现状和存在的问题,旨在为推动我国化学品测试合格实验室体系建设提供新的管理思路。     

COD/SO42-对硫酸盐有机废水处理效率的影响

以人工配制的含硫酸盐有机废水作为原水,研究不同COD/SO42-值下厌氧折流板反应器(ABR)处理含硫酸盐有机废水去除率.试验结果表明:当COD/SO42-＜14.8时COD的去除率可达95%,SO42-的去除率在86%～96%之间;当COD/SO42-在14.8～4.0之间时,COD的去除率有所下降但仍能保持在94%...     

交通拥堵对TSP排放的影响分析

在上海市杨浦区军工路部分路段采集TSP浓度、气压、温度、分车型车流量、区段车速、信号配时等数据,通过多元回归方法分析小型车交通量,大型车交通量,拖挂车交通量及区段车速对TSP浓度的影响,建立起TSP浓度与上述交通变量的函数关系,并通过AIMSUN交通仿真软件以及基础采集数据,建立军工路路网,模拟四种交通拥堵状况(重度拥堵,中度拥堵,轻度拥堵,基本畅通)的产生和消散过程。综合分析路段交通拥堵对道路TSP排放和分布的影响。分析整理得出道路TSP小时排放总量和拥堵程度成正比关系,且TSP污染主要集中在车辆拥挤怠速的部分,车辆拥挤排队的队尾部分是TSP排放源强最高、源强增长最快的区域,增长率达到240%～290%。     

污染底泥的原位钝化技术研究进展

底泥是湖泊重要的内源污染来源,关于底泥污染控制的研究近年来受到广泛重视。目前对底泥污染的控制技术主要包括原位处理技术和异位处理技术。原位处理技术主要包括钝化、覆盖、生物修复等。钝化技术是一种高效的湖泊内源污染控制技术,它通过抑制内源营养盐的释放来控制水体营养盐含量。文章综述了底泥原位钝化技术的研究及其应用情况;分析了原位钝化技术的特点及主要功能;介绍了常用底泥钝化剂的应用情况以及新型钝化剂的研究进展;并对原位钝化技术的未来发展进行了展望。     

兰州银滩湿地5种植物对重金属吸附能力的分析

利用原子吸收分光光度法测定兰州银滩湿地5种植物及其生长土壤(表层)中Cu、Pb、Zn的含量,结果表明,采样区域表层土壤存在轻度Cu、Zn、Pb污染,其中Cu、Pb的来源或污染途径可能相同,且Cu、Zn、Pb的生物可利用性较低,TCLP生态风险评价显示均小于国际标准值;采样区域表层土壤Cu、Zn、Pb总量与TCLP提取量...