我国安全生产行政执法统计指标体系研究与应用

我国安全生产行政执法统计指标体系自施行以来,一直存在统计指标体系过于繁杂、部分统计指标较笼统,未充分体现安全生产重点工作及其成效等问题,创新改革安全生产行政执法统计制度具有重要的理论意义和实用价值。通过梳理安全生产行政执法统计指标体系演变脉络,在实地调研和现场访谈的基础上,基于PDCA理论提出以执法人员-执法对象-执法行为“三位一体”的安全生产行政执法统计指标体系,明确包含执法力量、执法对象、执法检查和事故查处等方面的综合评价指标,并在实践中得以应用和检验,为全面分析安全生产执法效能拓展空间,统计制度的后续修订和安全生产综合分析工作奠定基础。     

基于非线性技术锅炉故障分析*

为预测和判断锅炉故障的发生,完善锅炉故障检测技术,基于锅炉运转具有非线性特点,提出将非线性评价指标应用于锅炉故障诊断。研究特征信号的非线性特性,通过确定延迟时间和嵌入维数来重构相空间;采用混沌分形理论研究非线性评价指标;提取最大Lyapunov指数和关联维数,并为收集的每种特征信号选择最合适的非线性指标。结果表明:蒸汽压力的非线性特征指标应选择关联维数,烟气温度1、烟气温度2、水管温度1和水管温度2的非线性特征指标应当选择最大Lyapunov指数。     

考虑儿童运动特性的小学教学楼楼梯间人员疏散研究

为研究小学教学楼楼梯间人员运动行为以及影响人员疏散的因素,开展人员疏散实验并构建疏散模拟场景。基于疏散实验研究不同实验场景的出口流量和人员运动速度,通过疏散仿真模拟,分析不同人员运动速度、人员数量及疏散策略对疏散的影响。结果表明:排队下楼的人员运动速度比紧急疏散人员低22.7%,自由上楼人员运动速度比排队上楼人员高8%;人员总疏散时间随人员运动速度的增加而降低,但总疏散时间随速度增加而降低的幅度变小;加入分层疏散策略会增加人群疏散总时间,但整个疏散过程人员分布均匀,在建筑瓶颈不易产生人员过度拥挤现象,因而在疏散过程中应适当采用分层疏散策略。     

Effect of pipes in heat pump system on electric vehicle energy saving

ABSTRACT

Refrigerant pressure drop and temperature change in pipes are normally ignored in the thermodynamic analysis of traditional vehicle air conditioning system, this will result in serious errors. In this Paper, pressure drop and temperature difference are simulated in different pipes of electric vehicle (EV) heat pump system to analysis the effects of pipes in the actual EV heat pump system. The results indicate that the greater the mass flow, the faster pressure drop increases, the temperature difference decreases. Pressure drop of saturated liquid refrigerant is smaller than that of saturated gas refrigerant at the same saturation pressure and mass flow rate. The higher the refrigerant pressure (no phase change), the slower pressure drop decreases, the faster the temperature difference decreases. Pressure drop decreases with the increment of bending angle of the pipe. For EV heat pump system, suitable valves and less branches are helpful for energy saving of the system. Shortening the pipe between compressor and condenser can reduce temperature change obviously. Pressure drop per unit length in the pipe between evaporator and compressor is large especially in heating mode because of lower refrigerant density. It even reaches to over 100 times of that in the pipe between condenser and throttle valve in heating mode and has negative effects on the performance of the system. If the evaporator is closer to the compressor and the number of branches is less, then pressure drop will decrease a lot, which will be advantageous for energy saving of the heat pump system.     

生态文明治理体系和治理能力现代化的几个核心问题研究

生态文明治理现代化是国家治理现代化的重要组成部分,本文从国家治理现代化出发,分析了我国生态文明治理体系和治理能力现代化的概念与内涵,针对当前生态文明治理体系和治理能力存在的五个方面问题,提出了生态文明治理体系现代化需要坚持完善的生态环境保护、资源高效利用、生态保护修复、生态环保责任等四个重点方向,提出了生态文明治理能力现代化需要改革创新的领导能力、决策能力、法治能力、科学精准治理能力、基础保障能力、市场化治理能力、公众参与能力等七大关键领域,这是加快推进生态文明治理体系和治理能力现代化的迫切需求。     

典型有机磷酸酯阻燃剂分析方法研究进展

有机磷酸酯(OPEs)是一类重要的有机磷阻燃剂,近些年逐渐取代了溴代阻燃剂,广泛应用于各行各业,也因此导致在多种环境介质中有较高的暴露量和潜在风险。已有研究表明,OPEs具有一定的毒理效应,对人体及其他生物均有潜在危害。本文综述了近年来国内外OPEs的检测技术,详述了不同环境介质OPEs的前处理方法。结果表明,目前固相萃取(SPE)和固相微萃取(SPME)仍是水样前处理的主要方法;对于固体样品,加速溶剂萃取/加压液相萃取(ASE/PLE)和微波辅助萃取(MAE)应用较多;虽然大气样品仍以固体吸附剂方式为主,但已向在线一体化方向发展;而生物样品的前处理方法多与水样和固体样品方法相似;但是对于复杂环境介质中OPEs样品的前处理较为困难,方法有待改善;气相色谱-质谱联用(GC-MS)和气相色谱-氮磷检测器(GC-NPD)对弱极性和易挥发的OPEs分析效果好,而强极性和难挥发的OPEs多用液相色谱-质谱联用(LCMS);气相色谱-质谱串联(GC-MS/MS)、液相色谱-质谱串联(LC-MS/MS)和高效液相色谱-质谱串联(UPLC-MS/MS)等对多种复杂的环境介质中的OPEs均有较好的检测分析效果,但并未普及。最后,对OPEs分析测试方法的发展趋势提出了展望。     

天津市地表水体与沉积物中7种高关注酚类化合物的污染特征与生态风险分析

为探究地表水体与沉积物中酚类化合物的污染分布特征和生态风险,选择天津市3个水源地与6条主要河流,采集了26个地表水样与6个沉积物样品,利用固相萃取与超声萃取、高效液相色谱-串联质谱法(HPLC-MS/MS)测定了水样及沉积物中1-萘酚(1-naphthol)、壬基酚(nonylphenol, NP)、双酚A(bisphenol A, BPA)、2-苯基苯酚(biphenyl-2-ol)、3,4-二氯酚(3,4-dichlorophenol)、四溴双酚A(tetrabromobisphenol A, TBBPA)和对叔丁基苯酚(p-tert-butylphenol, PTBP)等7种高关注酚类化合物的浓度水平,并应用物种敏感性分布(species sensitivity distribution, SSD)法和熵值法(ecological risk quotient, RQ)评估7种酚类化合物水环境和沉积物的生态风险。结果表明,地表水样中7种酚类化合物均全部检出;其中壬基酚的检出浓度最高,其次为四溴双酚A、对叔丁基苯酚、1-萘酚、2-苯基苯酚、3,4-二氯酚和双酚A。沉积物中酚类化合物的污染分布规律与水样相似,除双酚A外的目标物全部检出。其中,壬基酚浓度比其他物质浓度高2个数量级。风险评估结果显示,壬基酚对水环境与沉积物存在不可接受的风险;而四溴双酚A、对叔丁基苯酚、1-萘酚、2-苯基苯酚、3,4-二氯酚和双酚A则对环境具有较低风险或者存在一定的风险。     

Utilization of MSWI fly ash as partial cement or sand substitute with focus on cementing efficiency and health risk assessment

• Washed MSWI fly ash was used as partial cement or sand substitute. • Sand replacing is beneficial for strength, while cement replacement reduces strength. • Cementing efficiency factor and mortar pore structure explain the strength results. • Health risk assessment was conducted for MSWI fly ash blended cement mortar. • CR and HI contributed by different exposures and heavy metals were analyzed. The strength of cement substituted mortar decreases with the increase in fly ash amount, whereas the strength increases when the fly ash is blended as sand substitute. A mortar with highest strength (compressive strength= 30.2 Mpa; flexural strength= 7.0 Mpa) was obtained when the sand replacement ratio was 0.75%. The k value (cementing efficiency) of fly ash varied between 0.36 and 0.15 for the fly ash fraction in binder between 5% and 25%. The k values of fly ash used for sand replacement were all significantly above that used for cement substitution. The macropores assigned to the gaps between particles decreased when the fly ash was used as sand replacement, providing an explanation for the strength enhancement. The waste-extraction procedure (toxicity-sulphuric acid and nitric acid method (HJ/T 299-2007)) was used to evaluate metal leaching, indicating the reuse possibility of fly ash blended mortar. For the mortar with the mass ratio of fly ash to binder of 0.5%, the carcinogenic risks (CR) and non-carcinogenic hazard quotient (HQ) in sensitive scenario for blended mortar utilization were 9.66 × 10^-7 and 0.06, respectively; these results were both lower than the threshold values, showing an acceptable health risk. The CR (9.89 × 10^-5) and HQ (3.89) of the non-sensitive scenario for fly ash treatment exceeded the acceptable threshold values, indicating health risks to onsite workers. The main contributor to the carcinogenic and non-carcinogenic risk is Cr and Cd, respectively. The CR and HQ from inhalation was the main route of heavy metal exposure.