Circulation and Stream Plume Modeling in Conesus Lake

A three-dimensional hydrodynamic model that includes the effect of drag from macrophytes was applied to Conesus Lake to study the seasonal circulation and thermal structure during spring and early summer. Local weather conditions and stream flow data were used to drive the model. The drag coefficient for macrophytes was calculated as a function of leaf density. In general, the model results show good agreements with the observations, including vertical temperature profiles measured at two locations and average surface temperature derived from calibrated thermal imagery for large-scale simulations of the entire lake. Additional high-resolution simulations were carried out to understand water circulation and transport of sediment and model-generated tracer during hydrometeorological events at stream mouths for two experimental sites. The model results show that the plume development at stream mouths during storm events in Conesus Lake are site-dependent and may either be current- or wind-driven. The results also show a significant effect from the presence of macrophytes on sediment deposition near stream mouths.     

Heavy metals in the liver and muscle of <Emphasis Type="Italic">Micropogonias manni</Emphasis> fish from Budi Lake,Araucania Region,Chile: potential risk for humans

The concentrations of cadmium, lead, manganese and zinc were determined in the fish species Micropogonias manni captured in Budi Lake, Araucanía Region (Chile). The measurements were made by atomic absorption spectroscopy, and the analysis considered the sex, weight and size of the species; the representative samples were taken from the liver and muscle tissue. The method was validated using certified reference material (DOLT-1). The ranges of concentrations found in the muscle tissue were: Cd, not determinate (n.d.)–0.26; Pb, n.d.–1.88; Mn, 0.02–12.17 and Zn, 0.48–39.04 mg kg⁻¹ (dry weight). The concentrations in muscle tissue were generally lower than those found in the liver. With respect to the average concentrations recorded for each metal in the edible part of the fish (muscle tissue), it was found that the levels of Cd, Pb, Mn and Zn are within the ranges published by other authors in similar works and below the maximum concentration limits permitted by current legislation (FAO/WHO 2004; EU 2001) and do not constitute a health hazard for consumers of this species. The results were subjected to statistical analysis to evaluate the correlations between the content of the various metals and the sex, weight and size of each sample.     

Biological activities of the essential oil from the leaves of Lantana montevidensis (Spreng) Briq. in mice

Environment, Development and Sustainability - This work aimed to analyze the chemical composition and evaluate the anti-inflammatory and antinociceptive properties of the essential oil obtained...     

Introduction to SWAT+, A Completely Restructured Version of the Soil and Water Assessment Tool

SWAT+ is a completely restructured version of the Soil and Water Assessment Tool (SWAT) that was developed to face present and future challenges in water resources modeling and management and to meet the needs of the worldwide user community. It is expected to improve code development and maintenance; support data availability, analysis, and visualization; and enhance the model's capabilities in terms of the spatial representation of elements and processes within watersheds. The most important change is the implementation of landscape units and flow and pollutant routing across the landscape. Also, SWAT+ offers more flexibility than SWAT in defining management schedules, routing constituents, and connecting managed flow systems to the natural stream network. To test the basic hydrologic function of SWAT+, it was applied to the Little River Experimental Watershed (Georgia) without enhanced overland routing and compared with previous models. SWAT+ gave similar results and inaccuracies as these models did for streamflow and water balance. Taking full advantage of the new capabilities of SWAT+ regarding watershed discretization and landscape and river interactions is expected to improve simulations in future studies. While many capabilities of SWAT have already been enhanced in SWAT+ and new capabilities have been added, the model will continue to evolve in response to advancements in scientific knowledge and the demands of the growing worldwide user community. Editor's note: This paper is part of the featured series on SWAT Applications for Emerging Hydrologic and Water Quality Challenges. See the February 2017 issue for the introduction and background to the series.     

The Effect of Extraction Conditions on the Chemical Characteristics of Pectin from Opuntia ficus indica Cladode Flour

Pectin from the cladode flour of Opuntia ficus indica was extracted at different ethylenediaminetetraacetate concentrations (10 or 20 %), temperatures (40 or 80 °C), pH values (2 or 11), and times (10, 20, 30 40, 50 or 60 min). The effects of the extraction conditions on the yield, purity, and chemical composition of pectin were assessed. The highest pectin yield was observed for pectin obtained under alkaline conditions and 20 % of EDTA. However, pectin produced from alkaline extractions had a lower content of GalA than pectin produced from acid extractions. Higher temperatures favored the extraction of pectin under acid conditions, but these conditions diminished the arabinose content of pectins in a time-dependent manner. The tested extraction conditions caused only slight changes in the molecular weight of the extracted pectin as a function of time.     

Effect of water composition on the photocatalytic removal of pesticides with different TiO2 catalysts

The objective of this work is double—firstly to explore the photocatalytic efficiency of five different commercial TiO₂ catalysts in the photodegradation of a mixture of pesticides classified by the EU as priority pollutants and secondly to analyze the correlation between their physicochemical properties and the inhibition of the studied photocatalytic process when natural water was employed. Photocatalytic efficiencies when ultrapure water was used seem to point out that surface area was not a prerequisite for the photodegradation of the selected mixture of pesticides. On the other hand, significant differences in total organic carbon (TOC) conversions were obtained with the two studied water compositions. On one side, Evonik materials appear to be mostly inhibited when natural water was employed, whereas on the other, it should be remarked that anatase Sigma-Aldrich (SA) and, particularly, Hombikat UV100 (HBK) materials presented a very limited photo-efficiency inhibition or even a higher initial rate of TOC removal when a natural water matrix was used, probably due to their specific surface properties (PZC, S _BET). Therefore, heterogeneous photocatalysis has proved to be a promising technology for the degradation of the selected mixture of pesticides where the final photo-efficiency of the five commercial titania catalysts studied here responds to a complex balance between its surface and structural properties.     

Preparation and Properties of Chitosan–PVA Fibers Produced by Wet Spinning

Chitosan fibers were prepared by wet spinning in three stages. Initially, a polymer solution of chitosan and polyvinyl alcohol (PVA) was solidified in a mixture of potassium hydroxide and ethanol. The polymers were then crosslinked with sodium tripolyphosphate (TPP) or glutaraldehyde, and finally dried in methanol or acetone. The effect of these conditions was evaluated based on scanning electron microscopy images, water-holding capacity, and swelling and mechanical properties. The miscibility of the mixture was evaluated using Fourier Transform Infrared spectroscopy and differential scanning calorimetry. The results obtained showed that chitosan fibers containing 45% (v/v) PVA and crosslinked using TPP have properties similar to those of commercial sutures prepared using other biomaterials.     

Herbicide incorporation by irrigation and tillage impact on runoff loss

Runoff from farm fields is a common source of herbicide residues in surface waters. Incorporation by irrigation has the potential to reduce herbicide runoff risks. To assess impacts, rainfall was simulated on plots located in a peanut (Arachis hypogaea L.) field in Georgia's Atlantic Coastal Plain region after pre-emergence application of metolachlor (2-chloro-N-(2-ethyl-6-methylphenyl)-N-[(1S)-2-methoxy-1-methylethyl]-acetamide) and pendimethalin (N-(1-ethylpropyl)-3,4-dimethyl-2,6-dinitro-benzenamine). Runoff, sediment, and herbicide loss as function of strip tillage (ST) versus conventional tillage (CT) were compared with and without irrigation (12.5 mm) after application of an herbicide tank mixture. For the CT system, metolachlor runoff was reduced 2x and pendimethalin 1.2x when compared with the non-irrigated treatment. The difference in irrigated and non-irrigated metolachlor means was significant (P = 0.05). Irrigation reduced metolachlor runoff by 1.3x in the ST system, but there was a 1.4x increase for pendimethalin. Overall results indicated that irrigation incorporation reduces herbicide runoff with the greatest impact when CT is practiced and products like metolachlor, which have relatively low K(oc) and high water solubility, are used. The lower ST system response was likely due to a combination of spray interception and retention by the ST system cover crop mulch and higher ST soil organic carbon content and less total runoff. During the study, the measured K(oc) of both herbicides on runoff sediment was found to vary with tillage and irrigation after herbicide application. Generally, K(oc) was higher for ST sediment and when irrigation incorporation was used with the CT system. These results have significant implications for simulation model parametization.     

Forest health conditions in North America

Some of the greatest forest health impacts in North America are caused by invasive forest insects and pathogens (e.g., emerald ash borer and sudden oak death in the US), by severe outbreaks of native pests (e.g., mountain pine beetle in Canada), and fires exacerbated by changing climate. Ozone and N and S pollutants continue to impact the health of forests in several regions of North America. Long-term monitoring of forest health indicators has facilitated the assessment of forest health and sustainability in North America. By linking a nationwide network of forest health plots with the more extensive forest inventory, forest health experts in the US have evaluated current trends for major forest health indicators and developed assessments of future risks. Canada and Mexico currently lack nationwide networks of forest health plots. Development and expansion of these networks is critical to effective assessment of future forest health impacts.     

Overview of particulate exposures in the US trucking industry

As part of a large epidemiologic study of lung cancer, 55,000 subjects, we have conducted a nation-wide survey of particulate exposures in the US trucking industry. The goal is to differentiate the risks from various types of particulate exposures, such as traffic emissions and general air pollution. We hypothesize that exposures defined by job and work site characteristics can be linked with subjects using their personal job histories. This report covers exposures at 36 randomly chosen large truck freight terminals in the US. Measurements were made of PM2.5, elemental carbon (EC), and organic carbon (OC) upwind of the terminal (background) and in work areas, and by personal samples. Significant differences in exposure intensity, microg m(-3), were found for work locations and jobs relative to background levels (GM[GSD]) at terminal sites: PM2.5 9.8[2.34], EC 0.5[3.24], and OC 5.0[1.76]. Using EC as a marker for diesel particles, work locations varied significantly: office 0.3[3.7], dock area 0.7[2.89] and shop area 1.5[3.52]), as did job titles (non-smokers): clerk 0.1[9.98], dock worker 0.8[2.13], and mechanic 2.0[3.82]. Cigarette smoking contributed substantially to personal exposures, approximately doubling PM2.5 and OC, but having less of an effect on EC. Large differences were seen across the terminal sites due to differences in local regional air pollution levels from traffic and other sources. We conclude that it will be possible to estimate current exposures of the cohort using an exposure assignment matrix based on job title, work location, and terminal site. This distribution overlaps substantially with the general public's exposure to these sources.