Treatment of wastewater from red and tropical fruit wine production by zeolite anaerobic fluidized bed reactor

A study of the anaerobic treatment of wastewaters derived from red (RWWW) and tropical fruit wine (TFWWW) production was carried out in four laboratory-scale fluidized bed reactors with natural zeolite as bacterial support. These reactors operated at mesophilic temperature (35°C). Reactors R1 and R2 contained Chilean natural zeolite, while reactors R3 and R4 used Cuban natural zeolite as microorganism support. In addition, reactors R1 and R3 processed RWWW, while reactors R2 and R4 used TFWWW as substrate. The biomass concentration attached to zeolites in the four reactors studied was found to be in the range of 44–46 g volatile solids (VS)/L after 90 days of operation time. Both types of zeolites can be used indistinctly in the fluidized bed reactors achieving more than 80%–86% chemical oxygen demand (COD) removals for organic loading rates (OLR) of up to at least 20 g COD/L d. pH values remained within the optimal range for anaerobic microorganisms for OLR values of up to 20 and 22 g COD/L d for RWWW and TFWWW, respectively. Toxicity and inhibition levels were observed at an OLR of 20 g COD/L d in reactors R1 and R3 while processing RWWW, whereas the aforementioned inhibitory phenomena were not observed at an OLR of 24 g COD/L d in R2 and R4, treating TFWWW as a consequence of the lower phenolic compound content present in this substrate. The volatile fatty acid (VFA) levels were always lower in reactors processing TFWWW (R2 and R4) and these values (< 400 mg/L, as acetic acid) were lower than the suggested limits for digester failure. The specific methanogenic activity (SMA) was twice as high in reactors R2 and R4 than in R1 and R3 after 120 days of operation when all reactors operated at an OLR of 20 g COD/L d.     

Antioxidants in Capsicum chinense: Variation among countries of origin

The main objective of this investigation was to evaluate fruits of C. chinense accessions for their concentration of β -carotene, ascorbic acid, and phenols for use as parents in breeding for these phytochemicals. Mature fruits of 63 accessions of C. chinense originally acquired from Belize, Brazil, Colombia, Ecuador, Mexico, Peru, Puerto Rico, and the United States were analyzed for their chemical composition. Fruits of C. chinense accessions PI-152452 (Brazil) and PI-360726 (Ecuador) contained the greatest concentrations of ascorbic acid (1.2 and 1.1 mg g^?1 fresh fruit, respectively), while PI-438648 (Mexico) contained the greatest concentration of total phenols content (349 μ g g^?1 fresh fruit) among the other 63 accessions tested. Accession PI-355817 from Ecuador contained the greatest concentrations of β -carotene (8 mg g^?1fresh fruit). These accessions were identified as potential candidates for mass production of antioxidants with health-promoting properties.     

Evaluation of protective effects of sulforaphane on DNA damage caused by exposure to low levels of pesticide mixture using comet assay

The objective of the study was to evaluate the potential risk of DNA damage due to exposure to a mixture of the most widely used pesticides, namely endosulfan, chlorpyriphos and thiram at an environmentally relevant concentration (5 μM each) and the DNA protective capacity of sulforaphane (SFN) (10–30 μg/mL). DNA damage in human lymphocytes was ascertained with Single Cell Gel Electrophoresis (SCGE), also called Comet Assay. For positive control, H₂O₂ at 100 mM was used. The pesticide mixture produced DNA damage at the concentration used in the lymphocytes. SFN was able to offer a statistically significant (P < 0.01), concentration-dependant protection to DNA damage between 10–20 μg/mL in both the pre-incubation and co-incubation strategies. The results indicate that exposure to low levels of these pesticide mixtures can induce DNA damage, and the presence of SFN in diet may reduce the incidence of genetic damage, especially in farm workers. However, it is not clear whether SFN is involved in quenching of the free radicals generated by the pesticide mixture or it is involved in DNA repair mechanism.     

Screening Capsicum chinense fruits for heavy metals bioaccumulation

Elevated concentrations of heavy metals in edible plants could expose consumers to excessive levels of potentially hazardous chemicals. Sixty-three accessions (genotypes) of Capsicum chinense Jacq, collected from 8 countries of origin were grown in a silty-loam soil under field conditions. At maturity, fruits were collected and analyzed for seven heavy metals (Cd, Cr, Ni, Pb, Zn, Cu, and Mo) concentrations. The main objectives of this investigation were: 1) to determine the concentrations of seven heavy metals in the soil and monitor their accumulation in mature fruits, 2) to categorize the pepper accessions as low or high heavy metal accumulators, and 3) to determine if heavy metal content of the pepper fruit was lower than the permitted limits. Concentrations and relative proportions of heavy metals in pepper fruits of C. chinense varied among accessions. Fruits of Plant Introduction (PI) 355820 accumulated significant concentrations of Cd (0.47 μ g g^?1dry fruit). PI-260522 accumulated the highest concentration of Pb (2.12 μ g g^?1 dry fruit) among the 63 accessions tested. This accession (PI-260522) contained about twice the Pb limit on a fresh weight basis. Among the 63 accessions analyzed, PI-238051 contained the highest levels of Ni (17.2 μ g g^?1). We concluded that high accumulator genotypes may be useful for phytoremediation, while, low accumulator accessions might be appropriate selections for growing on Cd-, Pb-, or Ni-contaminated soils to prevent potential human exposure to heavy metals and health hazards through the food chain.     

Comparison of gamma-ray dosimeters in a field study in the Chernobyl exclusion zone

ABSTRACT

Five different models of dosimeters were compared in the Chernobyl Inner Exclusion Zone by measuring gamma radiation in 12 locations. We used an instrument made by Mirion Technologies, Inc., as the reference, since that instrument had an NIST-traceable calibration. Two models of dosimeters gave radiation values similar to the Mirion at all levels of radiation encountered. Two other models gave similar values to the Mirion instrument at low radiation levels but not at higher radiation levels encountered. These results offer a caution regarding the accuracy of inexpensive commercially available radiation instruments.

Implications: Comparison of gamma ray dosimeters in the Chernobyl Exclusion Zone showed varying agreement with an NIST-calibrated instrument, as well as varying linearity of response to ambient radiation. These results suggest caution regarding accuracy of inexpensive dosimeters. However, dosimeters used that were manufactured in Ukraine exhibited good agreement with the reference instrument.     

SITE Demonstration of Slurry-Phase Biodegradation of PAH Contaminated Soil

This paper summarizes a joint Superfund Innovative Technology Evaluation (SITE) project on slurry-phase biodegradation and a project to collect information for the data base on Best Demonstrated Available Technologies (BOAT). In this 12-week study, a creosote contaminated soil from the Burlington Northern Superfund site in Brainerd, Minnesota was used to evaluate the effectiveness of the bioslurry reactors. During the demonstration, five 64-liter stainless steel bioreactors, equipped with agitation, aeration and temperature controls were used. The pilot scale study employed a 30 percent slurry, an inoculum of indigenous polynuclear aromatic hydrocarbon (PAH) degraders, and inorganic nutrients.

Total PAH degradation averaged 93.4 ± 3.2 percent over all five operating reactors in the 12 weeks with 97.4 percent degradation of the 2- and 3-ring PAHs and 90 percent degradation of the 4- to 6-ring PAHs. A study of the air emissions, both semivolatile compounds such as naphthalene, anthracene, and phenanthrene and volatile compounds such as toluene, xylene, and benzene, from the units showed that the greatest amount of emissions occurred during the loading of the reactors and during the first few days of operation. Therefore, it may not be cost-effective to require elaborate emissions controls unless there are significant quantities of volatile compounds present in the soil or water to be treated in a bioslurry reactor system.     

Evaluation of Vegetation Near Coal-burning Power Plants in Southwestern Pennsylvania. II. Ozone Injury on Foliage of Hybrid Poplar

The objective of this study was to determine if the incidence or severity of foliar injury induced by regional, ambient ozone was influenced by local emissions from a complex of coal-burning power plants in southwestern Pennsylvania. Plantings of an ozonesensitive hybrid poplar clone {Populus maximowizii x trichocarpa, clone NE 388) were established in 1972 at various distances and directions from the power plants. Foliar injury caused by ambient ozone was evaluated annually from 1973 to 1990 in early to mid- August. Data are presented for the 12-year period, 1979 to 1990 inclusive, for which the most complete data sets were available. Injury from ambient ozone varied spatially and temporally, but with little relationship to power plant location. There was an apparent negative relationship between emission trends and ozone-induced symptoms, but only for one power plant. The correlation between annual mean levels of ozone-induced stipple and frequency of days (per year) with a 1-hr ozone maximum exceeding 0.04 ppm was weak, but significant. Ozone-induced bifacial necrosis was not observed on the foliage of the hybrid poplar during the drought year of 1988 in spite of record high levels of ozone; however, ozoneinduced stipple was observed.     

IAPCS: A Computer Model that Evaluates Pollution Control Systems for Utility Boilers

The IAPCS model, developed by U.S. EPA’s Air and Energy Engineering Research Laboratory and made available to the public through the National Technical Information Service, can be used by utility companies, architectural and engineering companies, and regulatory agencies at all levels of government to evaluate commercially available technologies for control of SO₂, NO_x, and particulate matter emissions from coal-fired utility boilers with respect to performance and cost. The model is considered to be a useful tool to compare alternative control strategies to be used by utilities to comply with the requirements of the CAA, and to evaluate the sensitivity of control costs with respect to many of the significant variables affecting costs.

To illustrate the use of the model for site-specific studies, the authors used the model to estimate control costs for SO₂ and NO_x control at Detroit Edison’s Monroe plant and two hypothetical plants under consideration and at three plants operated by New York State Electric and Gas Corporation. The economic and technical assumptions used to drive the model were those proposed by the utilities if cited, and if not cited, the model default values were used. The economic format and methodologies for costs cited in the Electric Power Research Institute’s Technical Assessment Guide are used in the IAPCS model. Depending on the specific conditions and assumptions for the cases evaluated, SO₂ control costs ranged from $417 to $3,159 per ton of SO₂ removed, and NO_x control costs ranged from $461 to $3,537 per ton of NO_x removed or reduced.     

Quality Time: Temporal and Other Aspects of Ethical Principles Based on a “Life Worth Living”

The evaluation of whether an animal has a life worth living (LWL) has been suggested as a useful concept for farm animal policymaking. But there are a number of different ways in which the concept could be applied. This paper attempts to identify and evaluate candidate ethical principles based on the concept. It suggests that an appropriate principle by which to apply the concept is one that (1) is framed in terms of preventing an animal having a life worth avoiding (LWA), rather than ensuring they have LWL, (2) is based on a prospective, rather than retrospective, concept of a life’s worth, and (3) relates to both the perpetuation and creation of an animal at all times during its life. The paper concludes by endorsing an overarching principle that no animal should be unreasonably caused to be, or allowed to remain, in a position of having a prospective LWA.     

Comparison of Stream Invertebrate Response Models for Bioassessment Metrics1

Waite, Ian R., Jonathan G. Kennen, Jason T. May, Larry R. Brown, Thomas F. Cuffney, Kimberly A. Jones, and James L. Orlando, 2012. Comparison of Stream Invertebrate Response Models for Bioassessment Metrics. Journal of the American Water Resources Association (JAWRA) 48(3): 570-583. DOI: 10.1111/j.1752-1688.2011.00632.x Abstract: We aggregated invertebrate data from various sources to assemble data for modeling in two ecoregions in Oregon and one in California. Our goal was to compare the performance of models developed using multiple linear regression (MLR) techniques with models developed using three relatively new techniques: classification and regression trees (CART), random forest (RF), and boosted regression trees (BRT). We used tolerance of taxa based on richness (RICHTOL) and ratio of observed to expected taxa (O/E) as response variables and land use/land cover as explanatory variables. Responses were generally linear; therefore, there was little improvement to the MLR models when compared to models using CART and RF. In general, the four modeling techniques (MLR, CART, RF, and BRT) consistently selected the same primary explanatory variables for each region. However, results from the BRT models showed significant improvement over the MLR models for each region; increases in R² from 0.09 to 0.20. The O/E metric that was derived from models specifically calibrated for Oregon consistently had lower R² values than RICHTOL for the two regions tested. Modeled O/E R² values were between 0.06 and 0.10 lower for each of the four modeling methods applied in the Willamette Valley and were between 0.19 and 0.36 points lower for the Blue Mountains. As a result, BRT models may indeed represent a good alternative to MLR for modeling species distribution relative to environmental variables.