health effects associated with increased use of coal

The increased use of coal projected under the National Energy Plan has raised fears of increased morbidity and mortality related to fossil fuel combustion products. The evidence for adverse health effects from the major emissions of coal combustion is considered, as well as the basis for predictions of an increase in morbidity and mortality. It can be concluded that with presently available control technology, no detectable adverse health effects will be observed associated with increased coal combustion. It is further concluded that a reduction in energy supply, or a large increase in energy cost leading to reduced energy supply to lower socio-economic groups will cause far more demonstrable adverse health effects than increased coal utilization.     

Electrostatic Precipitator Performance from the Point of View of Gas Treatment Time

This paper describes a risk assessment methodology for preliminary assessment of municipal sludge incineration. The methodology is a valuable tool in that it can be used for determining the hazard indices of chemical contaminants that might be present in sewage sludge used in incineration. The paper examines source characteristics (i.e., facility design), atmospheric dispersion of emission, and resulting human exposure and risk from sludge incinerators. Seven of the ten organics were screened for furtherinvestigation. An example of the calculations are presented for cadmium.     

Technique for Measuring the Total Concentration of Gaseous Fixed Nitrogen Species

This paper reports the development of a rapid, continuous technique for analyzing fixed nitrogen species (NH₃, HCN, CH₃NH₂, etc.). The technique uses a platinum catalyst at low pressure in combination with a conventional chemiluminescent NO _x analyzer. Previous workers observed that conventional stainless steel catalysts, and platinum catalysts operated at atmospheric pressure, do not reliably convert NH₃ to NO. The most serious problem was the variation in the efficiency of these catalysts with operating conditions. Changes in temperature, gas composition, or X_NH3 could change the conversion efficiency from 99.9% to <30%. The new conversion technique, however, is quantitative up to several thousand ppm NH₃ in either O₂/He or O₂/CO₂/N₂.     

Change in Pulmonary Function in Children Associated with Air Pollution Episodes

Pulmonary function of approximately 200 school children in Steubenville, OH was measured before and immediately following air pollution alerts in the fall of 1978 and 1979. TSP concentrations exceeded the National Primary Ambient Air Quality 24 h standards in 1978. SO₂ exceeded the standard in 1979. The children were then reexamined in three weekly visits following each alert. Estimated mean Forced Vital Capacity (FVC) was approximately 2% lower following each alert, although the lowest means were observed one to two weeks after the episodes. Forced Expired Volume in 0.75 sec (FEV_0.75) did not change during the 1978 study, but was 4% lower immediately following the 1979 alert. The children were measured again in five weekly examinations in the spring and fall of 1980. Air pollution levels did not exceed the standards on either occasion. In the spring of 1980, estimated mean FVC and FEV_0.75 showed a decline similar to that observed following the alerts in 1978 and 1979. In the fall of 1980, there were no significant differences in the estimated mean FVC or FEV_0.75 between the examinations. A total of 335 children were tested in the four studies, including 194 who participated in more than one study. The evidence for each child from all the studies was combined in a regression analysis of pulmonary function on TSP and SO₂ average concentrations in the previous 24 h. The distribution of the individual regression coefficients was centered significantly below zero, implying a decrease in pulmonary function with increasing TSP and SO₂ concentrations. The magnitude of the median change was less than 1% of the mean FVC and FEV_0.75 over the range of TSP and SO₂ concentrations observed.     

An Evaluation of the Semi-VOST Method for Determining Emissions from Hazardous Waste Incinerators

The Semi-Volatile Organic Sampling Train method was investigated to determine its reliability and to determine the bias and precision of the method when used to determine emissions from hazardous waste incinerators. Experiments showed that the matrix and sampling variables usually involved in sampling emissions from a hazardous waste incinerator had no significant effect on the recovery of 11 different organic compounds. Significant losses of the sampled compounds can occur during sample preparation. The degree of loss appears to be directly related to the compounds, vapor pressure. These losses can be corrected for by adding deuterated surrogates to the sample and analyzing the surrogates along with the native compounds.

The bias determination was based on dynamic spiking of the sampling train with five deuterated organic compounds selected from Appendix VIII of the Resource Conservation and Recovery Act regulations. The results show biases of from -1 ± 8 percent to -18 ± 27 percent for chlorinated and nonchlorinated compounds. Pyridine, a water-soluble compound, showed a larger bias of-29 ± 13 percent. Particular attention to the recovery of water soluble compounds is necessary to minimize bias in their determinations. Further work is needed to determine the reliability of laboratory-determined retention volumes that are used to determine sampling conditions.     

Addressing Public Fears Related to the Siting of Hazardous Waste Facilities

Recent catastrophic industrial accidents have left the public wary of most industrial facilities. Fearing illness and death from toxic releases, the public has opposed siting hazardous waste facilities in their locale. Associated with these concerns are fears of declining property values and a perceived reduction in the quality of life for a community. Recent political actions stemming from these fears have made siting these facilities an extremely unpopular and expensive process.

This paper presents a systematic, phased approach for performing a reliability and hazards analysis of a hazardous waste facility design. It also demonstrates how the results of a risk analysis can present an accurate "risk picture" of the facility for use in alleviating public fears. A typical analysis is outlined and methods that can be used to convey to the public the results of this type of risk analysis are explored.     

Particulate,Carbon Monoxide,and Acid Emission Factors for Residential Wood Burning Stoves

Emissions from residential wood burning stoves are of Increasing concern in many areas. This concern is due to the magnitude of the emissions and the toxic and chemical characteristics of the pollutants. Recent testing of standard and new technology woodstoves has provided data for developing a family of particulate and carbon monoxide emission factor curves. This testing has also provided data illustrating the acidity of woodstove emissions. The particulate and carbon monoxide curves relate the actual stove emissions to the stove size and operating parameters of burn rate, fuel loading, and fuel moisture. Curves relating stove types to the acidity of emissions have also been constructed.

Test data show actual emissions vary from 3 to 50 grams per kilogram for particles and from 50 to 300 grams per kilogram for carbon monoxide. Since woodstove emissions are the largest single category of particulate emissions in many areas, it Is essential that these emissions be quantified specifically for geographic regions, allowing meaningful impact analysis modeling to be accomplished. Emission factors for particles and carbon monoxide are presented from several stove sizes and burn rates.

The acidic nature of woodstove emissions has been clearly demonstrated. Tests indicate woodstove flue gas condensate solutions to be predominantly in the 2.8 to 4.2 pH range. Condensate solutions from conventional woodstoves exhibited the characteristic buffering capacity of carboxylic acids when titrations were performed with a strong base. The environmental impact of buffered acidic woodstove emissions is not currently well understood; however, it is possible with the data presented here to make semi-quantitative estimates of acid emissions from particulate and carbon monoxide emission factors and wood use inventories.