Change in Pulmonary Function in Children Associated with Air Pollution Episodes

Pulmonary function of approximately 200 school children in Steubenville, OH was measured before and immediately following air pollution alerts in the fall of 1978 and 1979. TSP concentrations exceeded the National Primary Ambient Air Quality 24 h standards in 1978. SO₂ exceeded the standard in 1979. The children were then reexamined in three weekly visits following each alert. Estimated mean Forced Vital Capacity (FVC) was approximately 2% lower following each alert, although the lowest means were observed one to two weeks after the episodes. Forced Expired Volume in 0.75 sec (FEV_0.75) did not change during the 1978 study, but was 4% lower immediately following the 1979 alert. The children were measured again in five weekly examinations in the spring and fall of 1980. Air pollution levels did not exceed the standards on either occasion. In the spring of 1980, estimated mean FVC and FEV_0.75 showed a decline similar to that observed following the alerts in 1978 and 1979. In the fall of 1980, there were no significant differences in the estimated mean FVC or FEV_0.75 between the examinations. A total of 335 children were tested in the four studies, including 194 who participated in more than one study. The evidence for each child from all the studies was combined in a regression analysis of pulmonary function on TSP and SO₂ average concentrations in the previous 24 h. The distribution of the individual regression coefficients was centered significantly below zero, implying a decrease in pulmonary function with increasing TSP and SO₂ concentrations. The magnitude of the median change was less than 1% of the mean FVC and FEV_0.75 over the range of TSP and SO₂ concentrations observed.     

Resource Recovery from Flue Gas Desulfurization Systems

The cost effective benefits of yielding a flue gas desulfurization (FGD) sludge predominantly composed of CaSO₄·2H₂O, have been previously established. The recovery of this material as FGD by-product gypsum has been demonstrated abroad. Recently U.S. wallboard manufacturers have recognized the viability of this recovery practice. Such techno-economic decision making variables as a) by-product specification, b) transportation costs, and c) location of suitable FGD systems enable the recognition of FGD by-product recovery. Recent investigations of resultant solids content and chloride washing reflect the technical possibility of delivering a suitable product. Commercial and economic factors favor recovery based upon rising disposal and transportation costs. Existing and near term proposed systems surface the technical and commercial problems faced by utilities considering recovery.

Generation of an oxidized FGD sludge consisting of 90⁺% CaSO₄·2H₂O and dewatered to 80⁺% solids is technically achievable by air sparging within the FGD system. Although the product is suitable for land disposal, electric power utilities should consider and evaluate by-product recovery. U.S. wallboard manufacturers have established technical criteria for FGD by-product gypsum. Percent CaSO₄·2H₂O, final solids content, particle size, and chloride content are primarily technical parameters. Technology exists within the FGD industry to satisfy these criteria and results are discussed.

Economic factors comparing mining costs, transportation costs, and disposal costs are developed for specific utility projects. Such comparison established generalized financial criteria for a given utility to develop the economic reasonableness of considering FGD byproduct recovery.

End product user perspectives are presented providing electric utilities with a realistic appreciation for by-product recovery potential. Location of existing wallboard plants highlight potential recovery regions. Quality control problems are discussed in terms of generating a by-product rather than a disposable material.     

R&D Activities,Operating Experience Discussed at Fabric Alternatives Forum

ABSTRACT

Previously reported volatile organic compounds (VOC) radiocarbon (¹⁴C) measurements for 1992 summertime Atlanta, GA, have been compared with chromatographic data and emissions inventory predictions. The chromatographic approach that was used provided a more comprehensive VOC characterization than typically achieved, and the emissions inventory was research-grade level (date-, site-, and time-specific). The comparisons are in general agreement that biogenic emissions contribute only modestly (<10%) to the VOC content of the particular ambient samples that were collected and measured. The choices of sampling site (near city-center) and times (early morning and late evening) are major influences on the results, which consequently should not be regarded as representing the average VOC biogenic impact for the Atlanta area.     

The Relationship between Cross-Sectional and Time Series Studies

Abstract

There is a dearth of information on dust emissions from sources that are unique to the U.S. Department of Defense testing and training activities. However, accurate emissions factors are needed for these sources so that military installations can prepare accurate particulate matter (PM) emission inventories. One such source, coarse and fine PM (PM₁₀ and PM_2.5) emissions from artillery backblast testing on improved gun positions, was characterized at the Yuma Proving Ground near Yuma, AZ, in October 2005. Fugitive emissions are created by the shockwave from artillery pieces, which ejects dust from the surface on which the artillery is resting. Other contributions of PM can be attributed to the combustion of the propellants. For a 155–mm howitzer firing a range of propellant charges or zones, amounts of emitted PM₁₀ ranged from ～19 g of PM₁₀ per firing event for a zone 1 charge to 92 g of PM₁₀ per firing event for a zone 5. The corresponding rates for PM_2.5 were ～9 g of PM_2.5 and 49 g of PM_2.5 per firing. The average measured emission rates for PM₁₀ and PM_2.5 appear to scale with the zone charge value. The measurements show that the estimated annual contributions of PM₁₀ (52.2 t) and PM_2.5 (28.5 t) from artillery backblast are insignificant in the context of the 2002 U.S. Environment Protection Agency (EPA) PM emission inventory. Using national–level activity data for artillery fire, the most conservative estimate is that backblast would contribute the equivalent of 5 x 10^–4% and 1.6 x 10^–3% of the annual total PM₁₀ and PM_2.5 fugitive dust contributions, respectively, based on 2002 EPA inventory data.     

health effects associated with increased use of coal

The increased use of coal projected under the National Energy Plan has raised fears of increased morbidity and mortality related to fossil fuel combustion products. The evidence for adverse health effects from the major emissions of coal combustion is considered, as well as the basis for predictions of an increase in morbidity and mortality. It can be concluded that with presently available control technology, no detectable adverse health effects will be observed associated with increased coal combustion. It is further concluded that a reduction in energy supply, or a large increase in energy cost leading to reduced energy supply to lower socio-economic groups will cause far more demonstrable adverse health effects than increased coal utilization.     

Electrostatic Precipitator Performance from the Point of View of Gas Treatment Time

This paper describes a risk assessment methodology for preliminary assessment of municipal sludge incineration. The methodology is a valuable tool in that it can be used for determining the hazard indices of chemical contaminants that might be present in sewage sludge used in incineration. The paper examines source characteristics (i.e., facility design), atmospheric dispersion of emission, and resulting human exposure and risk from sludge incinerators. Seven of the ten organics were screened for furtherinvestigation. An example of the calculations are presented for cadmium.     

1987 Joint EPRI/EPA Symposium on Stationary Combustion NOX Control

From March 23rd to 26th, 1987, the city of New Orleans hosted 350 attendees, including representatives from 15 foreign countries, at the 1987 Joint Symposium on Stationary Combustion NO_x Control. Cosponsored by the Electric Power Research Institute (EPRI) and the U.S. Environmental Protection Agency (EPA), the symposium provided attendees the opportunity to hear 49 papers in nine sessions covering technological and regulatory developments on NO_x control in the United States and abroad since the May 1985 symposium in Boston. Session topics included general environmental issues, low-NO_x combustion equipment (i.e., low-NO_x burners, reburning, etc.), flue gas treatment, fundamental combustion research, and special issues for cyclone coal-fueled boilers, oil- and gas-fired boilers, and industrial combustion applications.

Advances to the state-of-the-art presented at this symposium include: improved and/or newly applied combustion modifications for pulverized coal-fired boilers; further analyses of reburning, the leading combustion modification option for cyclone-equipped boilers; initial experiences with catalytic flue gas treatment in Europe; studies of NO_x control retrofit options for oil- and gas-fired utility systems; and new technology developments for coal, oil, and gas fueled utility and industrial combustors.

This paper summarizes those presentations that discussed significant changes since May 1985 in areas of potential interest to EPRI and its utility members. Where appropriate, they include our perspectives on the applicability of these newly disclosed findings to utility systems.     

An Evaluation of the Semi-VOST Method for Determining Emissions from Hazardous Waste Incinerators

The Semi-Volatile Organic Sampling Train method was investigated to determine its reliability and to determine the bias and precision of the method when used to determine emissions from hazardous waste incinerators. Experiments showed that the matrix and sampling variables usually involved in sampling emissions from a hazardous waste incinerator had no significant effect on the recovery of 11 different organic compounds. Significant losses of the sampled compounds can occur during sample preparation. The degree of loss appears to be directly related to the compounds, vapor pressure. These losses can be corrected for by adding deuterated surrogates to the sample and analyzing the surrogates along with the native compounds.

The bias determination was based on dynamic spiking of the sampling train with five deuterated organic compounds selected from Appendix VIII of the Resource Conservation and Recovery Act regulations. The results show biases of from -1 ± 8 percent to -18 ± 27 percent for chlorinated and nonchlorinated compounds. Pyridine, a water-soluble compound, showed a larger bias of-29 ± 13 percent. Particular attention to the recovery of water soluble compounds is necessary to minimize bias in their determinations. Further work is needed to determine the reliability of laboratory-determined retention volumes that are used to determine sampling conditions.     

Predicting and Managing the Health Risks of Sour-Gas Wells

The development of sour-gas resources in Canada and the United States has prompted concerns about the public health risks of accidental releases of gas contaminated with hydrogen sulfide (H₂S) from wells. This paper focuses on methods for improving the prediction and management of those risks. Data associated with the health effects of hydrogen sulfide are examined, and it is suggested that sublethal effects should be addressed in risk assessments of sour-gas wells along with the life-threatening effects normally considered. The demarcation of hazard zones around wells can be improved by using a statistical approach for estimating an upper-bound H₂S release rate; this rate can then be used in an atmospheric dispersion model to estimate maximum distances to downwind concentrations for lethal (300 ppmv) and sublethal (50 ppmv) effects resulting from an accidental release. A vertical release is found to have little impact, especially under stable atmospheric conditions; horizontal releases, on the other hand, result in the greatest downwind distances for health impacts. Management of health risks depends on a mix of safety technologies and contingency actions, such as well-ignition options and provision for post-release monitoring and assessment of ambient H₂S concentrations.