Risks of sea level rise to disadvantaged communities in the United States

Climate change and sea level rise (SLR) pose risks to coastal communities around the world, but societal understanding of the distributional and equity implications of SLR impacts and adaptation actions remains limited. Here, we apply a new analytic tool to identify geographic areas in the contiguous United States that may be more likely to experience disproportionate impacts of SLR, and to determine if and where socially vulnerable populations would bear disproportionate costs of adaptation. We use the Social Vulnerability Index (SoVI) to identify socially vulnerable coastal communities, and combine this with output from a SLR coastal property model that evaluates threats of inundation and the economic efficiency of adaptation approaches to respond to those threats. Results show that under the mid-SLR scenario (66.9 cm by 2100), approximately 1,630,000 people are potentially affected by SLR. Of these, 332,000 (～20%) are among the most socially vulnerable. The analysis also finds that areas of higher social vulnerability are much more likely to be abandoned than protected in response to SLR. This finding is particularly true in the Gulf region of the United States, where over 99% of the most socially vulnerable people live in areas unlikely to be protected from inundation, in stark contrast to the least socially vulnerable group, where only 8% live in areas unlikely to be protected. Our results demonstrate the importance of considering the equity and environmental justice implications of SLR in climate change policy analysis and coastal adaptation planning.     

Modulation-assisted high speed machining of compacted graphite iron (CGI)

The application of controlled, low-frequency modulation (～100 Hz) superimposed onto the cutting process in the feed-direction – modulation-assisted machining (MAM) – is shown to be quite effective in reducing the wear of cubic boron nitride (CBN) tools when machining compacted graphite iron (CGI) at high machining speeds (>500 m/min). The tool life is at least 20 times greater than in conventional machining. This significant reduction in wear is a consequence of the multiple effects realized by MAM, including periodic disruption of the tool–workpiece contact, formation of discrete chips, enhanced fluid action and lower cutting temperatures. The propensity for thermochemical wear of CBN, the principal wear mode at high speeds in CGI machining, is thus reduced. The tool wear in MAM is also found to be smaller at the higher cutting speeds (730 m/min) tested. The feed-direction MAM appears feasible for implementation in industrial machining applications involving high speeds.     

Coastal flooding,climate change and environmental justice: identifying obstacles and incentives for adaptation in two metropolitan Boston Massachusetts communities

We explored the possible future impacts of increased coastal flooding due to sea level rise and the potential adaptation responses of two urban, environmental justice communities in the metropolitan Boston area of Massachusetts. East Boston is predominantly a residential area with some industrial and commercial activities, particularly along the coastal fringe. Everett, a city to the north of Boston, has a diversified industrial and commercial base. While these two communities have similar socioeconomic characteristics, they differ substantially in the extent to which residents would be impacted by increased coastal flooding. In East Boston, a large portion of residents would be flooded, while in Everett, it is the commercial/industrial districts that are primarily vulnerable. Through a series of workshops with residents in each community, we found that the target populations do not have an adaptation perspective or knowledge of any resources that could assist them in this challenge. Furthermore, they do not feel included in the planning processes within their communities. However, a common incentive for both communities was an intense commitment to their communities and an eagerness to learn more and become actively engaged in decisions regarding climate change adaptation. The lessons that can be applied to other studies include 1) images are powerful tools in communicating concepts, 2) understanding existing cultural knowledge and values in adaptation planning is essential to the planning process and 3) engaging local residents at the beginning of the process can create important educational opportunities and develop trust and consensus that is necessary for moving from concept to implementation.     

Study of vehicle speeds on a major highway in Ghana: implication for monitoring and control

OBJECTIVE: Vehicular speeds have been identified to be at the core of road accident severity and frequency globally. Whereas speed control is a fundamental priority and the cornerstone of road safety in the developed world, the subject is at rudimentary stages in most developing countries thus making research into vehicle speeds in developing nations imperative. The main aim of the study was to establish two major speed parameters, namely the mean speed and dispersion, and their implications for more extensive and long-term speed monitoring in Ghana. METHODS: Research workers stationed themselves in a parked car and used a radar gun to unobtrusively measure the travelling speeds of 4,163 vehicles over two 24-hour periods at two separate sites on one of the main inter-urban roads (Accra-Kumasi). Both sites were settled areas with posted speed limits of 50 km/hr. RESULTS: Over 95% of vehicles travelled above the posted speed limit of 50 km/hr. Vehicles on an average travelled at 87 km/hr, (95% CI=87, 88). Variation in speeds was wide, with a standard deviation of 18 km/hr for all classes of vehicles, and with a range of 40 to 187 km/hr. The highest vehicular speed was associated with the private car (97.6+/-18.3 km/hr) followed by large buses (93.6+/-13.3 km/hr) and the least was with heavy trucks (73.8+/-12.9 km/hr). CONCLUSION: The excessive vehicular speeds coupled with the wide speed variations explain in part the high incidence of traffic crashes and fatalities on the Accra-Kumasi highway. An integrated speed monitoring and control program, and realigning the highway to by-pass small and medium settlements would be required as a long-term measure for the reduction of speed-related road traffic crashes, fatalities, and injuries in Ghana.     

Anatomical localization and stereoisomeric composition of <Emphasis Type="Italic">Tribolium castaneum</Emphasis> aggregation pheromones

We report that the abdominal epidermis and associated tissues are the predominant sources of male-produced pheromones in the red flour beetle, Tribolium castaneum and, for the first time, describe the stereoisomeric composition of the natural blend of isomers of the aggregation pheromone 4,8-dimethyldecanal (DMD) in this important pest species. Quantitative analyses via gas chromatography–mass spectrometry showed that the average amount of DMD released daily by single feeding males of T. castaneum was 878 ± 72 ng (SE). Analysis of different body parts identified the abdominal epidermis as the major source of aggregation pheromone; the thorax was a minor source, while no DMD was detectable in the head. No internal organs or obvious male-specific glands were associated with pheromone deposition. Complete separation of all four stereoisomers of DMD was achieved following oxidation to the corresponding acid, derivatization with (1R, 2R)- and (1S, 2S)-2-(anthracene-2,3-dicarboximido)cyclohexanol to diastereomeric esters, and their separation on reversed-phase high-performance liquid chromatography at −54°C. Analysis of the hexane eluate from Porapak-Q-collected volatiles from feeding males revealed the presence of all four isomers (4R,8R)/(4R,8S)/(4S,8R)/(4S,8S) at a ratio of approximately 4:4:1:1. A walking orientation bioassay in a wind tunnel with various blends of the four synthetic isomers further indicated that the attractive potency of the reconstituted natural blend of 4:4:1:1 was equivalent to that of the natural pheromone and greater than that of the 1:1 blend of (4R,8R)/(4R,8S) used in commercial lures.     

Spatial and temporal variations in groundwater nitrate at an intensive dairy farm in south-east Ireland: Insights from stable isotope data

Achievement of at least “good ecological status” in all waterbodies under the EU Water Framework Directive by 2015 will in some cases be a challenge. The twin challenge is to manage expectations of policy makers for such waterbodies as to a realistic length of time required for improvement in water quality. Hence, understanding the source, transformation processes and residence time of nitrate in a hydrological system is an essential part of meeting such challenges. On a dairy farm with 24 shallow groundwater wells, the dual isotopic composition of nitrate (δ¹⁵N and δ¹⁸O) was used to clarify nitrate sources, to assess spatial and temporal variability in nitrate concentrations and to determine if and where denitrification was occurring. Vertical travel time was estimated to correlate nitrate concentrations with management practices. Organically derived nitrogen was the predominant source contributing to groundwater nitrate concentrations. Denitrification was identified as prevalent within specific regions of the study site. The distinct low temporal variability in the isotopic data suggests constancy among nitrate sources and processes over time across the study site. Vertical travel times of up to 3 years were estimated on site indicating the influence of recent management practices on nitrate concentrations. Very slow horizontal migration of groundwater (decades) indicates a legacy of older management practices. Stable isotope techniques, together with an understanding of time lag, provide an extra mechanism to test the efficacy of monitoring and mitigation programmes.     

dry coke quenching,air pollution and energy: a status report

Dry quenching of incandescent coke after it has been pushed from the coking ovens is a proved, reliable process that is presently being used in several industrialized countries. Foremost among dry quenching’s advantages are: (1) virtual elimination of air pollutants emitted during quenching; (2) elimination of potential water pollution associated with wet quenching; (3) improvements in the working environment; (4) saving substantial amounts of energy in usable forms; (5) producing more usable coke that is superior to wet-quenched coke. By continuously circulating inert gases through a cooling chamber that contains hot coke, dry quenching recovers waste-heat energy that can be used to produce steam, to produce electricity, to preheat combustion air, to preheat coal, to dry coal, and to preheat feed water supplied to fuel-fired boilers. The pay-out period on the capital investment (approximately $7,100,000) for an installation capable of processing 5500 tons of coke/day is less than four years.     

Modeling the dynamic habitat and breeding population of Southwestern Willow Flycatcher

To aid in the management and conservation of Southwestern Willow Flycatcher (Empidonax traillii extimus, hereafter “Flycatcher”), we developed numerous models of flycatcher breeding habitat at Roosevelt Lake, AZ. For model development and testing, we compiled 10 years of flycatcher territory data that were obtained from intensive fieldwork between 1996 and 2005. We identified riparian vegetation annually in the project area from Landsat Thematic Mapper images, and extracted floodplain features from a digital elevation model. We created a novel class of temporal (i.e., multiyear) variables by characterizing the stability and variability in breeding habitat over a 6-year time interval. We used logistic regression to determine associations between environmental variables and flycatcher territory occurrence, and to test specific hypotheses. We mapped the probability of territory occurrence with a GIS and determined model accuracies with a classification table and a 10-year population database. Environmental features that were associated with breeding flycatchers included floodplain size, proximity to water, and the density, heterogeneity, age and stability of riparian vegetation. Our best model explained 79% of the variability in the flycatcher breeding population at Roosevelt Lake. The majority of predicted flycatcher habitat formed between 1996 and 2004 on an exposed lakebed ～3 years after water levels receded during a prolonged drought. A high correlation between annual reservoir levels and predicted breeding habitat (r = ?0.82) indicates that we can create and manage habitat for conservation purposes. Our predictive models quantify and assess the relative quality of flycatcher breeding habitat remotely, and can be used to evaluate the effectiveness of habitat restoration activities. Numerous techniques we developed can be used to characterize riparian vegetation and patch dynamics directly off of satellite imagery, thereby increasing its utility for conservation purposes.     

Sampling animal association networks with the gambit of the group

Ecologists increasingly use network theory to examine animal association patterns. The gambit of the group (GoG) is a simple and useful assumption for accumulating the data necessary for a network analysis. The gambit of the group implies that each animal in a group is associating with every other individual in that group. Sampling is an important issue for networks in wild populations collected assuming GoG. Due to time, effort, and resource constraints and the difficulty of tracking animals, sampled data are usually a subset of the actual network. Ecologists often use association indexes to calculate the frequency of associations between individuals. These indexes are often transformed by applying a filter to produce a binary network. We explore GoG sampling using model networks. We examine assortment at the level of the group by a single dichotomous trait, along with many other network measures, to examine the effect of different sampling regimes, and choice of filter on the accuracy and precision with which measures are estimated. We find strong support for the use of weighted, rather than filtered, network measures and show that different filters have different effects depending on the nature of the sampling. We make several practical recommendations for ecologists planning GoG sampling.