Determination of polycyclic aromatic hydrocarbons in urban street dust: implications for human health

The determination of sixteen polycyclic aromatic hydrocarbons in urban street dust has been done. Samples were collected from 12 sampling locations in a city centre location (Newcastle upon Tyne, north east England) and extracted using in situ pressurised fluid extraction followed by gas chromatography mass spectrometry. From the results it was possible to identify three groups, with respect to PAH concentration, with PAH contents ranging between 0.6-2.3 mg kg⁻¹, 15.6-22.5 mg kg⁻¹ and 36.1-46.0 mg kg⁻¹. The total PAH content of samples from these sampling sites has been compared to 22 urban locations around the world; comparable levels were found in these samples compared to the other cities around the world.The potential source of PAHs has been investigated by investigating the proportion of pyrogenic and petrogenic material in urban street dust using specific individual PAH ratios. The results indicate that the PAH content of urban street dust from the chosen sites are more likely to be due to pyrogenic sources i.e. vehicle exhaust emissions. The particle size fractions (<63 μm; 63-125 μm; 125-250 μm; 250-500 μm; 500-1000 μm; and 1000-2000 μm) of individual PAHs in three selected sampling sites was investigated. In two of the selected sites the PAH content was independent of particle size whereas in sampling site 10 elevated PAH levels are noted in the <63 μm size fraction. Sampling site 10 is located at the junction of three road tributaries which are used as major access points to the east of the city centre. Finally, the potential health risk for unintentional consumption of PAHs was assessed in terms of a mean daily intake (based on an ingestion rate of 100 mg d⁻¹). It was found that all 4-6 membered ring PAHs had concentrations in excess of the mean daily intake thereby reflecting a potential health risk, particularly in the smallest size particle fractions.     

How decisions about fitting species distribution models affect conservation outcomes

Species distribution models (SDMs) are increasingly used in conservation and land-use planning as inputs to describe biodiversity patterns. These models can be built in different ways, and decisions about data preparation, selection of predictor variables, model fitting, and evaluation all alter the resulting predictions. Commonly, the true distribution of species is unknown and independent data to verify which SDM variant to choose are lacking. Such model uncertainty is of concern to planners. We analyzed how 11 routine decisions about model complexity, predictors, bias treatment, and setting thresholds for predicted values altered conservation priority patterns across 25 species. Models were created with MaxEnt and run through Zonation to determine the priority rank of sites. Although all SDM variants performed well (area under the curve >0.7), they produced spatially different predictions for species and different conservation priority solutions. Priorities were most strongly altered by decisions to not address bias or to apply binary thresholds to predicted values; on average 40% and 35%, respectively, of all grid cells received an opposite priority ranking. Forcing high model complexity altered conservation solutions less than forcing simplicity (14% and 24% of cells with opposite rank values, respectively). Use of fewer species records to build models or choosing alternative bias treatments had intermediate effects (25% and 23%, respectively). Depending on modeling choices, priority areas overlapped as little as 10–20% with the baseline solution, affecting top and bottom priorities differently. Our results demonstrate the extent of model-based uncertainty and quantify the relative impacts of SDM building decisions. When it is uncertain what the best SDM approach and conservation plan is, solving uncertainty or considering alterative options is most important for those decisions that change plans the most.     

Occupational exposure of farm workers to pesticides: biochemical parameters and evaluation of genotoxicity

To assess the effects of exposure to complex mixtures of pesticides in farm workers from two communities from Rio Grande do Sul, Brazil, we evaluated the activities of butyrylcholinesterase (BChE) and delta-aminolevulinic acid dehydratase (ALA-D) enzymes, hematological, lipid parameters, and genotoxicity using two tests to detect DNA damage, the Comet assay in peripheral blood leukocytes and the micronucleus (MN) test in oral mucosa cells. The use of personal protective equipment (PPE), age and smoke habits were considered in the analysis. There was a significant decrease in the BChE and ALA-D activities in farm workers (n=37) relative to the control group (n=20) (P< or =0.05 and P< or =0.001, respectively). The Comet assay in peripheral blood leukocytes showed that the Damage index and Damage frequency observed in the exposed group were significantly higher in relation to the controls (P< or =0.001, and P< or =0.05, respectively). No differences were detected regarding the hematological parameters, lipids profile, and MN frequencies. In addition, no significant differences were observed between younger (< or =38 years) and older subjects (>38 years), or between smokers and non-smokers within the groups, either by Comet assay or MN test. However, the use of PPE seems to be important in the prevention of contamination, as suggested by BChE levels and Comet assay results.     

Source apportionment of settleable particles in an impacted urban and industrialized region in Brazil

Environmental Science and Pollution Research - Settleable particulate matter (SPM), especially coarser particles with diameters greater than 10&nbsp;μm, has been found culprit of high...     

Leaching of three imidazolinone herbicides during sprinkler irrigation

Some imidazolinone herbicides have been shown to be mobile in soil, raising concern about their possible movement to ground water. Three imidazolinone herbicides (imazamethabenz-methyl, 497 g ha(-1); imazethapyr, 14.7 g ha(-1); and imazamox, 14.7 g ha(-1)) commonly used in crop production on the Canadian prairies were applied to a tile-drained field to assess their susceptibility to leach when subjected to sprinkler irrigation using a center pivot. Tile-drain flow began when the water table rose above tile-drain depth, and peak flow rates corresponded to the greatest depths of ground water above the tile drains. Interception of irrigation water by the tile drains in each quadrant of the field varied from ～11 to 20% of the water applied. Under a worst-case scenario in which irrigation began the day after herbicide application and irrigation water was applied at 25 mm d(-1) for 12 d, there was evidence of preferential flow of all three herbicides and hydrolysis of imazamethabenz-methyl to imazamethabenz in the initial samples of tile-drain effluent. In subsequent samples, concentrations (analysis by LC-MS-MS) of the summation of imazamethabenz-methyl (25-24,000 ng L(-1)) plus its hydrolysis product imazamethabenz (63-26,500 ng L(-1)) greatly exceeded those of imazethapyr (<13-1260 ng L) and imazamox (19-599 ng L(-1)), thus reflecting relative application rates. In contrast, estimates of total transport of each herbicide from the root zone, which varied in each quadrant and ranged from 0.06 to 2.3% for imazamethabenz-methyl plus imazamethabenz, 0.71 to 3.1% for imazethapyr, and 0.61 to 2.8% for imazamox, did not reflect application rates. In shallow ground water (piezometer samples), there was inconsistent and infrequent detection all four compounds. With the frequency and amount of rainfall typically encountered in the prairie region of Canada, contamination of shallow ground water with detectable concentrations of the three imidazolinone herbicides would be unlikely.     

Methodology for the Study of Public Attitudes Concerning Air Pollution

A significant element of a community's total air pollution picture is the “state of mind” of the people living in the area with respect to air pollution. The reasons why a study of public attitudes can be an important factor in planning an air pollution control program are briefly summarized. The methodology applied in one such study in the St. Louis Metropolitan area is described, and possible variations related to different scope, objectives and survey area characteristics are suggested.     

Windblown Dust Contributes to High PM25 Concentrations

ABSTRACT

The revised National Ambient Air Quality Standards for PM include fine particulate standards based upon mass measurements of PM₂₅. It is possible in arid and semi-arid regions to observe significant coarse mode intrusion in the PM_2.5 measurement. In this work, continuous PM₁₀, PM_2.5, and PM_1.0 were measured during several windblown dust events in Spokane, WA. PM_{2 5} constituted ~30% of the PM₁₀ during the dust event days, compared with ~48% on the non-dusty days preceding the dust events. Both PM₁₀ and PM_2.5 were enhanced during the dust events. However, PM_1.0 was not enhanced during dust storms that originated within the state of Washington. During a dust storm that originated in Asia and impacted Spokane, PM_1.0 was also enhanced, although the Asian dust reached Washington during a period of stagnation and poor dispersion, so that local sources were also contributing to high particulate levels. The “intermodal” region of PM, defined as particles ranging in aerodynamic size from 1.0 to 2.5 um, was found to represent a significant fraction of PM₂₅ (~51%) during windblown dust events, compared with 28% during the non-dusty days before the dust events.     

Effects of doping amounts of potassium ferricyanide with titanium dioxide and calcination durations on visible-light degradation of pharmaceuticals

Acetaminophen (ACT) is one of the most frequently detected pharmaceuticals in aqueous environments, and treatment of ACT were generally carried out by photocatalytic degradations under high energy UV irradiation. In this study, potassium ferricyanide was utilized as a quadruple-elemental dopant in a TiO₂ photocatalyst in order to enhance its visible-light activity. Two critical parameters (amounts of dopants and durations of calcination) of the synthesis of the photocatalyst by a sol–gel method were systematically evaluated. Crystal structure of the doping TiO₂ was examined by X-ray diffraction while the effects of the two parameters on the photocatalytic activity were elucidated by various characterizations. Increasing the amount of dopant or the duration of calcination red-shifted the UV–vis DRS of the doped TiO₂. The estimated band gap energy of the doped TiO₂ decreased slightly as the amount of dopant increased, but it increased as the duration of calcination increased. The FT-IR yielded characteristic peaks that revealed the effects of the two parameters, whereas the SEM images revealed the morphological evolutions of each effect. The photocatalyst, synthesized at optimum conditions was able to remove 99.1 % acetaminophen with rate constant of 7.9 × 10⁻³ min⁻¹, which was 4.88 times greater than virgin TiO₂. In general, this study not only optimized synthetic conditions of the new visible-light active photocatalyst for ACT degradation but also presented characterizations conducted by SEM, XRD, UV–vis DRS, and FTIR to elucidate the relationship between modified structure and the photocatalytic activity.

Effects of doping amounts of K₃[Fe(CN)₆] and calcunation duration on visible light absorbance of TiO₂ photocatalysts

     

Multiresidue analysis of organophosphate and pyrethroid pesticides in duplicate-diet solid food by pressurized liquid extraction

An analytical method was developed for determining organophosphate pesticides (OPP) and pyrethroid pesticides (PYR) in duplicate-diet solid food. The method consisted of pressurized liquid extraction (PLE) with dichloromethane followed by cleanup with gel permeation and solid phase extraction columns and gas chromatography/mass spectrometry (GC/MS) analysis. Quantitative recoveries (73–117 %) of the target pesticides were obtained for spiked duplicate-diet food samples. The percent standard deviation (% RSD) of replicate food samples was within ± 20 %. Another method was developed for determining a common OPP metabolite, 3, 5, 6-trichloro-2-pyridinol (TCP) in duplicate-diet food. The method consisted of a PLE with methanol followed by liquid-liquid partitioning, derivatization, and GC/MS analysis. Recoveries of TCP ranged from 83 to 101 % for spiked duplicate-diet food samples. The % RSD of replicate food samples was within ± 15 %. The results confirmed that these methods are reliable and robust, and that they can be used in routine analysis. In addition, a storage stability study for a common OPP, chlorpyrifos (CPF), in solid food samples was performed. The fortified ¹⁵N-¹³C-labeled CPF was stable over 16 mo storage at ?20° C in the dark. The developed analytical methods were successfully applied to 278 duplicate-diet food samples from preschool children, demonstrating that these methods are robust and suitable for routine analysis in future exposure monitoring studies.