Arsenic-speciation in arsenate-resistant and non-resistant populations of the earthworm,Lumbricus rubellus

Arsenic speciation was determined in Lumbricus rubellus Hoffmeister from arsenic-contaminated mine spoil sites and an uncontaminated site using HPLC-MS, HPLC-ICP-MS and XAS. It was previously demonstrated that L. rubellus from mine soils were more arsenate resistant than from the uncontaminated site and we wished to investigate if arsenic speciation had a role in this resistance. Earthworms from contaminated sites had considerably higher arsenic body burdens (maximum 1,358 mg As kg-1) compared to the uncontaminated site (maximum 13 mg As kg-1). The only organo-arsenic species found in methanol/water extracts for all earthworm populations was arsenobetaine, quantified using both HPLC-MS and HPLC-ICP-MS. Arsenobetaine concentrations were high in L. rubellus from the uncontaminated site when concentrations were expressed as a percentage of the total arsenic burden (23% mean), but earthworms from the contaminated sites with relatively low arsenic burdens also had these high levels of arsenobetaine (17% mean). As arsenic body burden increased, the percentage of arsenobetaine present decreased in a dose dependent manner, although its absolute concentration rose with increasing arsenic burden. The origin of this arsenobetaine is discussed. XAS analysis of arsenic mine L. rubellus showed that arsenic was primarily present as As(III) co-ordinated with sulfur (30% approx.), with some As(v) with oxygen (5%). Spectra for As(III) complexed with glutathione gave a very good fit to the spectra obtained for the earthworms, suggesting a role for sulfur co-ordination in arsenic metabolism at higher earthworm arsenic burdens. It is also possible that the disintegration of As(III)-S complexes may have taken place due to (a) processing of the sample, (b) storage of the extract or (c) HPLC anion exchange. HPLC-ICP-MS analysis of methanol extracts showed the presence of arsenite and arsenate, suggesting that these sulfur complexes disintegrate on extraction. The role of arsenic speciation in the resistance of L. rubellus to arsenate is considered.     

Linking National Sustainable Development Strategy and Local Implementation: a case study in Sweden

Sweden has led the way in Europe in environmental protection, ecologically based technological innovation and social democracy. As new economic and ethnographic realities impact upon it, it faces challenges to its policies and practices long familiar elsewhere in Europe. We report on a study for the Swedish Research Councils in which we examined the national framework and political strategy for sustainable development, and how the strategy is being implemented in Sweden's three major cities and two case-study municipalities. History and tradition, cultural homogeneity and a strong and shared sense between sectors of 'the public good', emerged as very important. Until recently, these have obviated the need for formal links between the environmental, social and economic agendas. They now appear inadequately developed at all levels of governance. Tensions in policy are being played out at the level of the municipality, to which power is highly devolved, and Local Agenda 21, interpreted as project rather than process, seems unequal to the task of integration. We suggest what lessons may be drawn from the Swedish experience if issues of power and trust, leadership and participatory vs representative democracy are to be resolved.     

The use of indicators in environmental policy appraisal: lessons from the design and evolution of water security policy measures

Drawing up environmental policy options is a complex activity which involves defining and weighing the merits and risks of various alternative courses of action governments could pursue. In its modern version, this task typically involves formal policy analysis or ‘policy appraisal’, that is, policy work specifically undertaken to generate and evaluate policy options in order to address problems or issues on a policy agenda. Indicators play a powerful but under-investigated role in this process. To shed light on this issue, the paper conducts a case study of the design and evolution of policy indicators in water security policy formulation, examining both their utilization and impact. The paper documents the origins of water security policy indicators; assesses their relevance and influence in policy formulation and identifies the reasons for the emergence of certain preferred indices, despite their having several well-known limitations. In particular, the discussion flags the significance of the political advantages surrounding their ease of use and interpretation, rather than their technical merits, as a key factor affecting the continued utilization and influence of specific indicators in environmental policy and planning.     

Spatial gradients and source apportionment of volatile organic compounds near roadways

Concentrations of 55 volatile organic compounds (VOCs) (C₂–C₁₂) are reported near a highway in Raleigh, NC. Thirty-minute samples were collected at eight locations, ranging from approximately 10–100 m perpendicular from the roadway. The highest concentrations of VOCs were generally measured closest to the roadway, and concentrations decreased exponentially with increasing distance from the roadway. The highest mean concentration for individual VOCs were for ethylene (3.10 ppbv) (mean concentration at x = 13 m), propane (2.27 ppbv), ethane (1.91 ppbv), isopentane (1.54 ppbv), toluene (0.95 ppbv), and n-butane (0.89 ppbv). Concentrations at the nearest roadway location (x = 13 m) were generally between 2.0 and 1.5 times those from the farthest roadway location (x = 92 m). The data were apportioned into four source categories using the EPA Chemical Mass Balance Model (CMB8.2): motor vehicle exhaust, compressed natural gas, propane gas, and evaporative gasoline. The majority of the VOCs resulted from motor vehicle exhaust (67 ± 12%) (% of total VOC at x = 13 m ± S.D.). Compressed natural gas, propane gas, and evaporative gasoline accounted for approximately 15%, 7% and 1% of the total VOC emissions, respectively, at x = 13 m.     

Analysis of coupled model uncertainties in source-to-dose modeling of human exposures to ambient air pollution: A PM2.5 case study

Quantitative assessment of human exposures and health effects due to air pollution involve detailed characterization of impacts of air quality on exposure and dose. A key challenge is to integrate these three components on a consistent spatial and temporal basis taking into account linkages and feedbacks. The current state-of-practice for such assessments is to exercise emission, meteorology, air quality, exposure, and dose models separately, and to link them together by using the output of one model as input to the subsequent downstream model. Quantification of variability and uncertainty has been an important topic in the exposure assessment community for a number of years. Variability refers to differences in the value of a quantity (e.g., exposure) over time, space, or among individuals. Uncertainty refers to lack of knowledge regarding the true value of a quantity. An emerging challenge is how to quantify variability and uncertainty in integrated assessments over the source-to-dose continuum by considering contributions from individual as well as linked components. For a case study of fine particulate matter (PM_2.5) in North Carolina during July 2002, we characterize variability and uncertainty associated with each of the individual concentration, exposure and dose models that are linked, and use a conceptual framework to quantify and evaluate the implications of coupled model uncertainties. We find that the resulting overall uncertainties due to combined effects of both variability and uncertainty are smaller (usually by a factor of 3–4) than the crudely multiplied model-specific overall uncertainty ratios. Future research will need to examine the impact of potential dependencies among the model components by conducting a truly coupled modeling analysis.     

An integrated approach to assess broad-scale condition of coastal wetlands—the Gulf of Mexico Coastal Wetlands pilot survey

The Environmental Protection Agency (EPA) and U.S. Geological Survey (USGS) initiated a two-year regional pilot survey in 2007 to develop, test, and validate tools and approaches to assess the condition of northern Gulf of Mexico (GOM) coastal wetlands. Sampling sites were selected from estuarine and palustrine wetland areas with herbaceous, forested, and shrub/scrub habitats delineated by the US Fish and Wildlife Service National Wetlands Inventory Status and Trends (NWI S&T) program and contained within northern GOM coastal watersheds. A multi-level, stepwise, iterative survey approach is being applied to multiple wetland classes at 100 probabilistically-selected coastal wetlands sites. Tier 1 provides information at the landscape scale about habitat inventory, land use, and environmental stressors associated with the watershed in which each wetland site is located. Tier 2, a rapid assessment conducted through a combination of office and field work, is based on best professional judgment and on-site evidence. Tier 3, an intensive site assessment, involves on-site collection of vegetation, water, and sediment samples to establish an integrated understanding of current wetland condition and validate methods and findings from Tiers 1 and 2. The results from this survey, along with other similar regional pilots from the Mid-Atlantic, West Coast, and Great Lakes Regions will contribute to a design and implementation approach for the National Wetlands Condition Assessment to be conducted by EPA’s Office of Water in 2011.     

First flush in a combined sewer system

Pollutant first flush was examined in an urban catchment with area of 12.7 ha and drained by a combined sewer system located in northern Italy. A total of 23 rainfall-runoff events were monitored and 281 samples were analyzed. The selected quality parameters were biochemical oxygen demand, chemical oxygen demand, suspended solids, settleable solids, total phosphorus, total nitrogen, ammonium nitrogen, lead, and zinc, specific conductivity and hydrocarbons. A subset of representative storms was selected for first flush analysis. The catchment presented a strong first flush for almost all storms and most constituents. The analysis shows that treating the maximum amount of the early part of the runoff is a better strategy than treating a constant flow rate. Best management practices that can treat or store the first runoff are favored in this kind of system for these water quality parameters.