An electrochemical-activated denitrifying biofilm system consisting of activated carbon fiber electrodes immobilized with denitrifying bacteria film as cathode was studied. A revised model for an electrochemical-activated denitrifying biofilm was developed and validated by electrochemical analysis of cathodal polarization curves and nitrate consumption rate. The cathodal polarization curve and nitrate consumption rate were introduced to verify the rate of electrochemical reaction and the activity of denitrifying bacteria, respectively. It was shown that the denitrification process effectively strengthened the electrochemical reaction while the electron also intensified denitrification activity. Electron was transferred between electrochemical process and biological process not only by hydrogen molecule but also by new produced active hydrogen atom. Additionally, a parameter of apparent exchange current density was deprived from the cathodal polarization curve with high overpotential, and a new bio-effect current density was defined through statistical analysis, which was linearly dependent to the activity of denitrification bacteria. Activated carbon fiber (ACF) electrode was also found to be more suitable to the electrochemical denitrifying system compared with graphite and platinum. 相似文献
采用15种不同的微生物菌剂,以葡萄糖配水、中药提取废水、啤酒废水、氨氮配水等为基质,分别测定了微生物菌剂的耗氧速率和厌氧比产甲烷速率,以单位菌剂对不同基质的耗氧速率和厌氧比产甲烷活性为指标,比较了各菌剂对废水的适配性.根据测定结果选择活性高的菌剂,在试验室进行了菌剂对废水的连续处理试验.结果表明,不同菌剂对同一种废水的好氧或厌氧活性不同,同种菌剂对不同废水的好氧和厌氧活性不同.废水的连续处理试验取得良好的处理效果.No.8菌剂处理葡萄糖配水,系统有机负荷最高可达(COD)10.8 g L-1d-1,COD去除率可达90%以上;采用No.10菌剂处理氨氮配水,好氧氨氮负荷可达(NH4-N )1.42 g L-1d-1,厌氧氨氮负荷可达(NH4-N )0.3 gL-1d-1,系统NH4-N 去除率可达90%以上.图2表3参8 相似文献
This study describes a fast activated carbon fiber-solid phase microextraction (ACF-SPME) method for determining organochlorine pesticides (OCPs) in water. The pesticides in this study consist of Hexachlorobenzene (HCB) and alpha-, beta-, gamma-hexachlorocyclohexanes (HCHs). The optimal experimental procedures for the adsorption and desorption of four OCPs were evaluated. The linearity was obtained with a RSD of 20% for the OCPs studied over a range from 1.0 to 100 microg/L. The limits of detection at ng/L level were achieved with GC-MS under selected ion monitoring (SIM) acquisition mode. The proposed method was applied to the determination of OCPs concentration in tap water. The results have demonstrated the suitability of the ACF-SPME-GC-MS approach for the analysis of multi-residue OCPs in water. Compared to the commercial fiber, ACF has shown its advantages in solvent-resistance, thermal stability, and the cost. The results obtained in this study suggest that ACF is a promising choice in solid phase microextraction. 相似文献
Method 30B and the Ontario Hydro Method (OHM) were used to sample the mercury in the flue gas discharged from the seven power plants in Guizhou Province, southwest China. In order to investigate the mercury migration and transformation during coal combustion and pollution control process, the contents of mercury in coal samples, bottom ash, fly ash, and gypsum were measured. The mercury in the flue gas released into the atmosphere mainly existed in the form of Hg°. The precipitator shows a superior ability to remove Hgp (particulate mercury) from flue gas. The removal efficiency of Hg2+ by wet flue gas desulfurization (WFGD) was significantly higher than that for the other two forms of mercury. The synergistic removal efficiency of mercury by the air pollution control devices (APCDs) installed in the studied power plants is 66.69–97.56%. The Hg mass balance for the tested seven coal-fired power plants varied from 72.87% to 109.67% during the sampling time. After flue gas flowing through APCDs, most of the mercury in coal was enriched in fly ash and gypsum, with only a small portion released into the atmosphere with the flue gas. The maximum discharge source of Hg for power plants was fly ash and gypsum instead of Hg emitted with flue gas through the chimney into the atmosphere. With the continuous upgrading of APCDs, more and more mercury will be enriched in fly ash and gypsum. Extra attention should be paid to the re-release of mercury from the reutilization of by-products from APCDs.
Implications: Method 30B and the Ontario Hydro Method (OHM) were used to test the mercury concentration in the flue gas discharged from seven power plants in Guizhou Province, China. The concentrations of mercury in coal samples, bottom ash, fly ash, and gypsum were also measured. By comparison of the mercury content of different products, we found that the maximum discharge source of Hg for power plants was fly ash and gypsum, instead of Hg emitted with flue gas through the chimney into the atmosphere. With the continuous upgrading of APCDs, more and more mercury will be enriched in fly ash and gypsum. Extra attention should be paid to the re-release of mercury from the reutilization of by-products from APCDs. 相似文献