燃烧油品的沸溢特性分析研究

分析了油罐火灾中燃烧油品的沸溢现象,阐述了沸溢发生的条件,研究了沸溢时火焰的热辐射强度,研究表明沸溢时火焰温度平均升高300℃左右,火焰平均热辐射强度是沸溢发生前的2.5～3倍.     

Enhanced heterogeneous Fenton-like activity by Cu-doped BiFeO<Subscript>3</Subscript> perovskite for degradation of organic pollutants

Heterogeneous Fenton-like reaction has been extensively investigated to eliminate refractory organic contaminants in wastewater, but it usually shows low catalytic performance due to difficulty in reduction from Fe(III) to Fe(II). In this study, enhanced catalytic efficiency was obtained by employing Cu-doped BiFeO₃ as heterogeneous Fenton-like catalysts, which exhibited higher catalytic performance toward the activation of H₂O₂ for phenol degradation than un-doped BiFeO₃. BiFe_0.8Cu_0.2O₃ displayed the best performance, which yielded 91% removal of phenol (10 mg L^–1) in 120 min. The pseudo first-order kinetic rate constant of phenol degradation in BiFe_0.8Cu_0.2O₃ catalyzed heterogeneous Fenton-like reaction was 5 times higher than those of traditional heterogeneous Fenton-like catalysts, such as Fe₃O₄ and goethite. The phenol degradation efficiency could still reach 83% after 4 cycles, which implied the good stability of BiFe_0.8Cu_0.2O₃. The high catalytic activity of BiFe_0.8Cu_0.2O₃ was attributed to the fact that the doping Cu into BiFeO₃ could promote the generation of Fe(II) in the catalyst and then facilitate the activation of H₂O₂ to degrade the organic pollutants.

Open image in new window

     

Study on HCl removal for medical waste pyrolysis and combustion using a TG-FTIR analyzer

Under both pyrolysis and combustion condition, HCl removal efficiency for medical waste with Ca-based additives was semi-quantitatively studied by means of TG-FTIR. Additionally, the difference of HCl removal efficiency for PVC and medical waste was compared. Experimental results showed that: 1) Thermal degradation of medical waste mainly took place in two steps under both pyrolysis and combustion condition; 2) HCl emitted at both two steps and HCl concentration increased with the increased of Cl ratio in the medical waste; 3) for the same additive, HCl concentration decreased with the increased of additives amount, that is to say, HCl removal efficiency of medical waste increased as the increased of Ca/Cl molar ratio. Fourth, when Ca(OH)₂ was used as additive, HCl removal efficiency for medical waste combustion was a little higher than that for medical waste pyrolysis, but either CaCO₃ or CaO was used as additive, it was just opposite, more specifically, when CaCO₃ was used as additive with Ca/Cl=1.3, HCl removal efficiency was 5.49% under pyrolysis condition, but that was only 4.24% under combustion condition. Fifth, under the same Ca/Cl molar ratio, HCl removal efficiency for PVC was higher than that for medical waste under both pyrolysis and combustion condition, more specifically, when Ca(OH)₂ was used as additive with Ca/Cl=1, HCl removal efficiency was 64.51% for PVC, but that was only 27.66% for medical waste pyrolysis with 4% Cl under pyrolysis condition.     

硫铝酸盐水泥处理冶金固体废弃物的研究

利用硫铝酸盐水泥作为粘结剂,采用水硬化球团加工工艺,对冶金过程的二次资源进行了成球性能研究。研究结果表明:在70%硫酸渣、20%除尘灰和10%精矿粉原料条件下,添加6.5%的硫铝酸盐水泥和1.2%的复合粘结剂,能够获得粒度组成和强度均较理想的小球作为烧结料。该项成果的特点是带入原料的S iO2大量减少,水硬化球团养护期大幅度缩短,在重钢集团铁业公司取得了良好的生产效果。     

利用CALPUFF对安徽和河南秸秆焚烧的模拟与研究

秸秆焚烧会产生大量的颗粒物(PM)、氮氧化物、有机碳、苯以及多环芳烃等污染物,不仅影响空气质量,危害人体健康,而且大大降低能见度,对交通运输构成威胁. 针对安徽和河南2009年6月严重的秸秆焚烧现象,对CALPUFF模拟系统和FEPS模型进行重新编译与整合,对空气动力学直径小于10 μm的颗粒物(PM₁₀)进行扩散模拟,得到逐时ρ(PM₁₀₎的烟羽扩散,并对模拟结果进行分析. 结果表明,秸秆焚烧过程中焚烧点附近的ρ(PM₁₀₎较大,研究区域内部分区域的日均ρ(PM₁₀₎大于我国二级标准(150 μg/m3)甚至三级标准(350 μg/m3). 如果考虑二次粒子,其影响程度会更加严重.      

大气14CO2的加速器质谱分析技术研究进展

利用加速器质谱技术测定大气¹⁴CO₂以示踪大气化石源CO₂成为当前减污降碳工作的热点。该文从加速器质谱¹⁴C分析基础出发,系统介绍了加速器质谱的工作原理、大气样品的采集及纯化、石墨化样品的制备和测定,阐述了大气碳监测领域14 CO₂测试的研究进展。随着加速器质谱技术的不断发展,大气¹⁴CO₂的研究将会更加广泛和深入,有助于进一步认识大气化石源CO₂的来源,更有针对性地开展减污降碳工作。未来应统一制定¹⁴CO₂监测方法标准,规范操作流程和质控手段,完善实验仪器配套设施,加快提升监测能力和水平。     

环保台帐──中小企业废水治理监督的有效手段

中小企业废水达标治理是目前环保监督管理的难点。对企业废水治理工程物料、能源消耗建立台帐管理是弥补现有管理方式不足,强化企业有效处理废水制约机制的有效手段。     

阿特拉津在土壤中的环境行为研究进展

概述了阿特拉津在土壤中的迁移、降解及其对植物的影响等环境行为,阐述了土壤组成、土壤pH值以及温度、湿度等因素对各种环境行为过程的影响,并结合目前国内外的研究现状,提出了阿特拉津环境行为新的研究方向。     

生活垃圾仓式静态好氧发酵供风系统工艺设计

生活垃圾堆肥厂的核心——发酵系统对堆肥产品的质量和成本起着决定性的作用,所以其设计显得至关重要。结合多年的科研及工程实践经验,就垃圾仓式静态好氧发酵供风系统工艺设计中供风形式、方式选择,风量、风压计算以及供风控制形式选择等几个关键部分做了详细介绍。     

地震引发城市燃气管线事故的定量风险评价

为了对地震作为诱发事件导致燃气管线的风险进行量化,提出了地震引发城市燃气管线事故的定量风险评价程序,基于离散化的地震PGA值和地震预期重现时间给出可能的损坏概率和参考事故场景,并进行事故场景的后果评价,最终实现燃气管线个人风险和社会风险的表征.此外,基于Matlab编写了适用于该风险评价程序的GUI程序,结合淮南市城市次高压燃气管线的具体实例,实现了风险表征并研究了地震参数变化对风险变化的影响.