Heterogeneous Fenton-like reaction has been extensively investigated to eliminate refractory organic contaminants in wastewater, but it usually shows low catalytic performance due to difficulty in reduction from Fe(III) to Fe(II). In this study, enhanced catalytic efficiency was obtained by employing Cu-doped BiFeO3 as heterogeneous Fenton-like catalysts, which exhibited higher catalytic performance toward the activation of H2O2 for phenol degradation than un-doped BiFeO3. BiFe0.8Cu0.2O3 displayed the best performance, which yielded 91% removal of phenol (10 mg L–1) in 120 min. The pseudo first-order kinetic rate constant of phenol degradation in BiFe0.8Cu0.2O3 catalyzed heterogeneous Fenton-like reaction was 5 times higher than those of traditional heterogeneous Fenton-like catalysts, such as Fe3O4 and goethite. The phenol degradation efficiency could still reach 83% after 4 cycles, which implied the good stability of BiFe0.8Cu0.2O3. The high catalytic activity of BiFe0.8Cu0.2O3 was attributed to the fact that the doping Cu into BiFeO3 could promote the generation of Fe(II) in the catalyst and then facilitate the activation of H2O2 to degrade the organic pollutants.
Under both pyrolysis and combustion condition, HCl removal efficiency for medical waste with Ca-based additives was semi-quantitatively studied by means of TG-FTIR. Additionally, the difference of HCl removal efficiency for PVC and medical waste was compared. Experimental results showed that: 1) Thermal degradation of medical waste mainly took place in two steps under both pyrolysis and combustion condition; 2) HCl emitted at both two steps and HCl concentration increased with the increased of Cl ratio in the medical waste; 3) for the same additive, HCl concentration decreased with the increased of additives amount, that is to say, HCl removal efficiency of medical waste increased as the increased of Ca/Cl molar ratio. Fourth, when Ca(OH)2 was used as additive, HCl removal efficiency for medical waste combustion was a little higher than that for medical waste pyrolysis, but either CaCO3 or CaO was used as additive, it was just opposite, more specifically, when CaCO3 was used as additive with Ca/Cl=1.3, HCl removal efficiency was 5.49% under pyrolysis condition, but that was only 4.24% under combustion condition. Fifth, under the same Ca/Cl molar ratio, HCl removal efficiency for PVC was higher than that for medical waste under both pyrolysis and combustion condition, more specifically, when Ca(OH)2 was used as additive with Ca/Cl=1, HCl removal efficiency was 64.51% for PVC, but that was only 27.66% for medical waste pyrolysis with 4% Cl under pyrolysis condition. 相似文献