Diversity of Soil Nematodes in Areas Polluted with Heavy Metals and Polycyclic Aromatic Hydrocarbons (PAHs) in Lanzhou,China

This study investigated the soil nematode community structure along the Yellow River in the Lanzhou area of China, and analyzed the impact of heavy metals (Cd, Pb, Cr, Cu, and Zn) and polycyclic aromatic hydrocarbons (PAHs) on the nematode community. Soil samples from five locations (named A–E), which were chosen for soil analysis, showed significant differences in their heavy metal content (p < 0.01), as well as in the variety of nematodes (up to 41 genera) and families (up to 20) that were present. The different samples also differed significantly in the total PAH content (p < 0.05), as well as the six types of PAH present. Sites A–C showed the most severe contamination with heavy metals and PAHs; these sites had the lowest abundance of fungivores and omnivore/predators, but the proportion of bacteriovores was the highest (p < 0.05). Site E, in contrast, showed only minor pollution with heavy metals and PAHs, and it contained the highest abundance of plant parasites (p < 0.05). Several nematode ecological indicators were found to correlate with concentration of soil pollutants at all the sites tested: the maturity index (MI, in addition to plant parasites), plant parasite index (PPI), ΣMI (including all the soil nematodes), Shannon-Wiener diversity index (H′′), and Wasilewska index (WI). Disturbance to the soil environment was more severe when MI, ΣMI, and H′ values were lower. The results of the study show that the abundance and structure of the soil nematode communities in the sampling locations were strongly influenced by levels of heavy metals and PAHs in the soil. They also show that the diversity index H′ and the maturity index can be valuable tools for assessing the impact of pollutants on nematodes.     

An Interval-Parameter Waste-Load-Allocation Model for River Water Quality Management Under Uncertainty

A simulation-based interval quadratic waste load allocation (IQWLA) model was developed for supporting river water quality management. A multi-segment simulation model was developed to generate water-quality transformation matrices and vectors under steady-state river flow conditions. The established matrices and vectors were then used to establish the water-quality constraints that were included in a water quality management model. Uncertainties associated with water quality parameters, cost functions, and environmental guidelines were described as intervals. The cost functions of wastewater treatment units were expressed in quadratic forms. A water-quality planning problem in the Changsha section of Xiangjiang River in China was used as a study case to demonstrate applicability of the proposed method. The study results demonstrated that IQWLA model could effectively communicate the interval-format uncertainties into optimization process, and generate inexact solutions that contain a spectrum of potential wastewater treatment options. Decision alternatives can be generated by adjusting different combinations of the decision variables within their solution intervals. The results are valuable for supporting local decision makers in generating cost-effective water quality management strategies.     

A Review of Environmental Sociology and the Sociology of Natural Resources： Insights for the Development of Environmental Sociology in China

Environmental sociology and the sociology of natural resources are two key subdisciplines of the sociological study on the interactions between nature and human society. Previous discussion on the relationships of these two fields has largely focused on their distinctions and synthesis in western （particularly American） academia. Environmental sociology emerged as an important sociological subdiscipline in China in the early 1990s and is under vigorous disciplinary construction at present. By contrast, the sociology of natural resources is still a novel term for most Chinese researchers. This article provides a systematic review of recent literature on the relationships between environmental and natural resource sociologies, which should provide important implications for the further development of environmental sociology in China.     

微生物絮凝剂改善城市污水厂浓缩污泥脱水性能的研究

采用酱油曲霉(Aspergillus sojae)产生的微生物絮凝剂(MBF)作为污泥絮凝脱水剂,对城市污水处理厂浓缩污泥进行调理,确定该絮凝剂对浓缩污泥脱水的处理工艺参数为：微生物絮凝液最佳投加体积为6%～8%（体积比）,发挥絮凝作用的最适污泥温度为28～32℃,最适pH为6～7。经微生物絮凝剂调理的污泥在3 000 r/min离心9 min,污泥脱水率高达82.7%,滤饼含水率降低至77.3%,污泥脱水后体积减至原来的1/5左右。     

Cu~(2+)、Zn~(2+)对生物脱氮系统的影响

Cu2+和Zn2+是污水处理工艺中经常遇到的金属离子.在驯化好的活性污泥系统中,研究了金属离子Cu2+和Zn2+在0～100 mg/L浓度下对活性污泥牛物脱氮系统的影响.试验发现Cu2+＞5 mg/L、Zn2+＞30 ms/L时,对硝化过程具有明显的抑制作用,在同样浓度的试验条件下Cu2+对硝化过程的抑制作用比Zn2+大.Cu2+≤0.5 mg/L时对反硝化过程具有一定的促进作用,有助于提高TN的去除效果;Cu2+＞0.5 mg/L时,对反硝化产牛抑制作用,随着浓度的增加,TN去除率逐渐下降.Zn2+不影响反硝化过程,仅在大于30 mg/L时,对硝化过程产生抑制作用.重金属Cu2+对生物脱氮系统的影响明显强于Zn2+.     

含中间层的DSA电极电催化氧化硝基苯废水的研究

为了提高难降解有机废水的可生化性,以及更高效地去除废水中的特征污染物,同时避免二次污染,利用自制的含锡锑中间层的钌钯氧化物涂层电极对有机废水中的硝基苯进行处理,并利用SEM、XRD等方法对电极中间层、表层进行微观表征。微观测试表明,基体、中间层、表层之间结合力较强,有利于增强电极寿命;水处理实验表明,电催化氧化反应体系适合高浓度有机废水的处理,由于该反应体系需要外加电解质加强传质,这在实际运用中为废水中盐度的处理提供了一种新的途径,当电流密度为20 mA/cm²、电解质浓度为10 g/L、pH=5、极板间距=2 cm时,电催化氧化体系对硝基苯具有较高的去除效率。     

TiO2催化高压脉冲放电等离子体降解2，4-二硝基苯酚

采用TiO2催化高压脉冲放电等离子体降解废水中的2,4-二硝基苯酚,对反应进行了动力学研究.研究结果表明,在高压脉冲放电等离子体及TiO2催化高压脉冲放电等离子体反应中,2,4-二硝基苯酚的降解过程均符合表观一级反应动力学方程.加入TiO2催化剂、提高放电电压均可提高2,4-二硝基苯酚的降解反应速率常数.在TiO2加入量为0.15%、放电电压为16 kV时,2,4-二硝基苯酚的降解率为87.4%,TiO2的催化效应增强因子为1.55.     

微电解-催化氧化法处理高浓度甲醇废水

采用微电解一催化氧化法处理某化工厂的高浓度甲醇生产废水。实验结果表明：在进水pH为2．0、铁炭质量比为2、微电解时间为14h、空气流量为500mL／min的条件下,废水经微电解处理后,出水COD由原来的约7000mg/L降至约1000mg／L,COD去除率达85％以上;在过滤后微电解出水COD约为950mg／L、微电解出水pH为6．5、空气流量为300mL／min、催化氧化时间为3h时的条件下,经催化氧化处理后,出水COD降至100mg/L以下,出水水质达到GB8978--1996《污水综合排放标准》的二级标准。     

Distribution, sources, and potential risk of polycyclic aromatic hydrocarbons (PAHs) in drinking water resources from Henan Province in middle of China

Distribution and risk assessment of polycyclic aromatic hydrocarbons (PAHs) in drinking water resources have been carried out for the first time in Henan Province, China. Water samples collected from four river systems and their tributaries, as well as groundwater resources, were analyzed according to EPA method 525.2. Total of 68 water samples were collected in 18 cities in Henan province in May, August and November, 2001. Concentrations of sum of 16 priority PAHs in water samples ranged from 15 to 844 ng/L with a mean value of 178 +/- 210 ng/L (n = 68). The spatial and temporal distribution of PAHs showed that the Huanghe and the Huaihe river systems had relatively higher concentrations of total PAHs. Higher concentrations of total PAHs were observed in August and November than in May, with respective mean values of 262, 232 and 33.6 ng/L. Ratios of Ant/(Ant + Phe) and Flur/(Flur + Pyr) were calculated to evaluate the possible sources of PAH contamination, which indicated that the coal combustion sources were the main contributors to PAHs in most drinking water resources. Some petrogenic (or pyrolytic) sources of PAHs were also found. The toxic equivalency factors (TEFs) were used to calculate benzo[a]pyrene equivalents (BaPE) for water samples. The average value of BaPE was 0.6 ng/L. The values in most stations were much lower than the guideline values in drinking water of Chinese Environmental Protection Agency (CEPA, 2.8 ng/L) and the US Environmental Protection Agency (US EPA, 200 ng/L). Overall, the drinking water resources in Henan province showed some carcinogenic potential.     

Identification of sources of elevated concentrations of polycyclic aromatic hydrocarbons in an industrial area in Tianjin, China

The concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) were determined by gas chromatography equipped with a mass spectrometry detector in 105 topsoil samples from an industrial area around Bohai Bay, Tianjin in the North of China. Results demonstrated that concentrations of PAHs in 104 soil samples from this area ranged from 68.7 to 5,590 ng g^???1 dry weight with a mean of ∑16PAHs 814 ± 813 ng g^???1, which suggests that there exists mid to high levels of PAH contamination. The concentration of ∑16PAHs in one soil sample from Tianjin Port was exceptionally high (48,700 ng g^???1). Ninety-three of the 105 soil samples were considered to be contaminated with PAHs (>200 ng g^???1), and 25 were heavily polluted (>1,000 ng g^???1). The sites with high PAHs concentration are mainly distributed around chemical industry parks and near highways. Two low molecular weight PAHs, naphthalene and phenanthrene, were the dominant components in the soil samples, which accounted for 22.1% and 10.7% of the ∑16PAHs concentration, respectively. According to the observed molecular indices, house heating in winter, straw stalk combustion in open areas after harvest, and petroleum input were common sources of PAHs in this area, while factory discharge and vehicle exhaust were the major sources around chemical industrial parks and near highways. Biological processes were probably another main source of low molecular weight PAHs.