A2/O-MBR工艺处理印染废水中试研究

将平板微滤膜与A2/O工艺结合构建了A2/O-MBR中试系统,探讨了中试系统处理印染废水的效果及稳定性.结果表明,水解酸化可提高印染废水的可生化性,对COD平均去除率达到了43%.系统处理效果稳定,在最佳工况下COD、NH3-H和TN的去除率分别为88%、98%和80%.     

氧化石墨烯负载纳米零价铁的制备及其对亚甲基蓝的吸附

采用液相还原法制备氧化石墨烯负载纳米零价铁吸附剂(Fe0/GO),并用于吸附去除溶液中的亚甲基蓝(MB)。考察了溶液p H、吸附温度、吸附时间、初始MB质量浓度对Fe0/GO吸附MB的影响。SEM等表征结果显示:Fe0以球形或短链形负载在GO上,增加了材料的反应活性位点;Fe0/GO的比表面积为158.32 m2/g,等电点为3。实验结果表明:在溶液p H为6、吸附时间5 h、吸附温度25℃的最佳条件下,加入400 mg/L的Fe0/GO,处理初始MB质量浓度为160 mg/L的MB溶液,MB去除率为89.26%,吸附量为125.5 mg/g;Langmuir等温吸附方程和Frenudlich等温吸附方程均能较好地描述Fe0/GO对MB的吸附过程;Fe0/GO对MB的吸附行为遵循准二级动力学方程;计算得出吸附温度为25℃、初始MB质量浓度为160 mg/L时的饱和吸附量为201.2 mg/g,平衡吸附量为124.3 mg/g。     

浸没式膜-生物反应器膜面污染物性质研究

研究了浸没式平板膜-生物反应器冬季运行时的膜污染状况.结果表明,出水COD稳定,但出现了亚硝酸盐积累,总氮的去除不是很理想.凝胶过滤色谱测定结果发现,O段混合液经0.45 靘滤膜过滤的滤液和膜面污染物含有重均分子量千万级以上的大分子物质,而进水中并无此类物质.环境扫描电镜和能谱分析表明,膜面无机污染物的阳离子主要包括Na、Mg、Al、Si、K、Ca和Fe.傅立叶红外光谱分析证明,膜面有机污染物主要是多糖和蛋白质等物质,而且胞外聚合物可能是造成膜面污染的主要物质之一.     

MgO/SiO_2纳米复合材料同步吸附亚甲基蓝和Cu~(2+)

采用化学沉积法合成了MgO/SiO_2纳米复合材料,通过扫描电子显微镜和X射线能谱分析(SEM-EDX)、X射线衍射(XRD)、Zeta电位仪、FTIR等方法对其进行了表征。研究了MgO/SiO_2对亚甲基蓝(MB)和Cu~(2+)的吸附行为及同步吸附效果。表征结果表明:MgO/SiO_2为褶皱、凸起的球形形貌;MgO成功负载在SiO_2表面。实验结果表明:MgO/SiO_2对MB和Cu~(2+)的吸附符合准二级动力学模型和Langmuir等温吸附模型,MB和Cu~(2+)的饱和吸附量分别为83.72 mg/g和208.70 mg/g;MB和Cu~(2+)的同步吸附在MgO/SiO_2表面存在竞争关系;在溶液体积为30m L、MgO/SiO_2加入量为10 mg、MB质量浓度为10 mg/L或Cu~(2+)质量浓度为100 mg/L、吸附温度为25℃、吸附时间为24 h、初始溶液pH为4.00、解吸时间为4 h的条件下,MgO/SiO_2第1次吸附MB和Cu~(2+)的去除率分别为92.8%和90.1%,第5次吸附的去除率分别为59.6%和57.4%。     

金属半导体纳米粒子对水培水稻幼苗的毒性及吸收转运规律

金属半导体纳米粒子由于其独特的理化性质被广泛应用于工业生产和科学研究,而遗留在水环境中的金属半导体纳米粒子对植物的危害程度和累积水平还有待研究和完善.本文以水稻为实验对象,通过水培试验研究了氧化铜纳米粒子(CuONPs)、氧化锌纳米粒子(ZnONPs)和硫化锌纳米粒子(ZnSNPs)在不同浓度(10、50和100 mg·L~(-1))下的植物毒性及其在水稻体内的吸收转运行为.纳米粒子悬浮液的粒径分布和Zeta电位分析结果表明,CuONPs在水中的分散性和稳定性高于ZnONPs和ZnSNPs.ZnONPs悬浮液中溶解的金属离子量高于CuONPs和ZnSNPs悬浮液.毒性实验结果表明,较高浓度(50和100 mg·L~(-1))的ZnONPs和CuONPs不同程度地阻碍了水稻幼苗的生长,增加了根系中丙二醛(MDA)的含量,降低了根系活力和叶片中的叶绿素含量.50和100 mg·L~(-1)的ZnONPs导致根系鲜重分别降低至对照组的47.3%和44.3%,100 mg·L~(-1)ZnONPs和CuONPs使根系活力由对照组的710.4μg·g-1·h~(-1)分别降低至150.0和481.9μg·g-1·h~(-1).ZnSNPs在实验设置浓度下体现了促进水稻生长的作用.10 mg·L~(-1)的ZnSNPs使地上部分鲜重增加到对照组的109.8%,100 mg·L~(-1)时使根系活力提高到了对照组的2倍.Zn的选择性吸收和生物转运系数均高于Cu,本研究结果证明了金属半导体纳米粒子的植物毒性和累积水平与纳米粒子在水中的理化性质及植物对不同毒物的反应程度有关.     

Biopurification of industrial waste gas from rubber regeneration.

By using the biopurifying technology, the organic waste gas in low concentrations emitted from the rubber-regeneration process was purified in this research. The result of the 100-day continuous running test of the industrial test device indicated that the purification efficiency of toluene in the rubber-regeneration waste gas could be maintained at about 90% for a long period of time and the treated waste gas could meet the China National Emission Standard. The cost of waste gas biotreatment was about 0.12-0.14% of rubber-regeneration production value of the factory. The biopurifying technology of waste gas displayed its excellent technical advancement and economic rationale. The following industrialized device was run continuously and passed the examination and acceptance by the local EPA.     

Photolysis kinetics and influencing factors of bisphenol S in aqueous solutions

The photodegradation of bisphenol S (BPS) in aqueous solutions was studied under different conditions. Photolysis and kinetics were investigated, as were the photolysis mechanism and the influences of initial pH value, light source, and environmental substances in water. The results showed that the photolysis of BPS occurred under UV light, and the rate increased with light source intensity. The photolysis of 5.0-50.0 mg/L BPS in water followed first-order kinetics: the rate was γ= 0.0161C_BPS under a 40-W UV-lamp, and the degradation half-life was 43.1 min. Due to its absorption of light, direct photolysis of BPS was a predominant pathway for BPS but was not obviously affected by reactive oxygen species. The results confirmed that the photolysis rates of BPS in alkaline water solution were faster than those in acidic and neutral water solution because of the ionization of BPS. The photodegradation rate of BPS increased in the presence of chloride and ferric ions, while the rate was inhibited by nitrate and phosphate in aqueous solution.     

A~2/O-MBR工艺处理印染废水中试研究

将平板微滤膜与A2/O工艺结合构建了A2/O-MBR中试系统,探讨了中试系统处理印染废水的效果及稳定性。结果表明,水解酸化可提高印染废水的可生化性,对COD平均去除率达到了43%。系统处理效果稳定,在最佳工况下COD、NH3-H和TN的去除率分别为88%、98%和80%。     

The combined toxicity and mechanism of multi-walled carbon nanotubes and nano copper oxide toward freshwater algae: Tetradesmus obliquus

Nanoparticles(NPs) are widely used for their special physical properties and released into the natural environment. When two types of NPs exist in the same environment, the presence of one type of NP may affect the properties of the other type of NP. This study investigated the toxic effects of multi-walled carbon nanotubes(MWCNTs) and copper oxide nanoparticles(Cu O NPs) on Tetradesmus obliquus. Both NPs had toxic effects on algae, and the toxic effects of MWCNTs were significantly stronger tha...     

Eutrophication status and control strategy of Taihu Lake

The water quality and eutrophication status of Taihu Lake in recent years are presented and the pollution trends are analyzed. It is shown that because of unreasonable industrial structures, pollution discharge per GDP is high within the Taihu basin, and the pollution discharge from point and non-point sources exceed the basin’s environmental carrying capacity. Especially, excessive pollutants containing nitrogen and phosphorus are being discharged. Moreover, eutrophication may also result from internal pollution sources such as the release of nutrient elements from sediment. All these factors have resulted in the water quality deterioration of Taihu Lake. To solve this environmental problem, possible control strategies are summarized, including the control of internal pollution sources and inflow-river pollution, ecological restoration and reconstruction of the degraded lakeside zone ecosystem, clean water diversion, dredging, and manual algae removal.