The wide use of polyacrylamide (PAM) in enhanced oil recovery generates a large amount of polymer-bearing wastewater featuring high viscosity and difficult viscosity reduction, making the treatment of wastewater increasingly difficult. In this paper, the experimental study on reducing the viscosity of wastewater containing polyacrylamide by using the plasma generated by dielectric barrier discharge (DBD) and the synergistic effect of catalyst γ-Al2O3 is carried out. The law of plasma reducing the viscosity of wastewater containing polyacrylamide is studied under the different conditions of amounts of γ-Al2O3 catalyst, discharge voltages, and initial concentrations of polyacrylamide-containing wastewater. The mechanism of viscosity reduction of polyacrylamide is studied through environmental scanning electron microscope (ESEM), Fourier transform infrared (FTIR) spectrometer, and X-ray photoelectron spectroscopy (XPS). The results show that the catalytic viscosity reduction is the best when the discharge voltage is 18 kV and the discharge time is 15 min. With the increase in the input of the γ-Al2O3 catalyst, the viscosity of the PAM solution decreases gradually. When the amount of γ-Al2O3 is 375 mg, the shear rate changes from 0.5 1/sec to 28 1/sec, and the viscosity of the solution containing polyacrylamide changes from 434.5 mPa·s to 40.2 mPa·s. The viscosity reduction rate of the PAM solution is 90.7%. After the catalytic viscosity reduction, the functional groups of polyacrylamide do not change much. The elemental composition of the catalyst has not changed, which is still Al, C, and O.
The evaluation of a novel prototype instrument designed for on-site determinations of VOC mixtures found in indoor working environments is described. The instrument contains a miniature multi-stage preconcentrator, a dual-column separation module with pressure-tunable retention capabilities, and an integrated array of three polymer-coated surface acoustic wave sensors. It was challenged with dynamic test-atmospheres of a set of 15 common indoor air contaminants at parts-per-billion concentrations within a stainless-steel chamber under a range of conditions. Vapours were reliably identified at a known level of confidence by combining column retention times with sensor-array response patterns and applying a multivariate statistical test of pattern fidelity for the chromatographically resolved vapours. Estimates of vapour concentrations fell within 7% on average of those determined by EPA Method TO-17, and limits of detection ranged from 0.2 to 28 ppb at 25 degrees C for 1 L samples collected and analyzed in <12 min. No significant humidity effects were observed (0-90% RH). Increasing the chamber temperature from 25 to 30 degrees C reduced the retention times of the more volatile analytes which, in turn, demanded alterations in the scheduling of column-junction-point pressure (flow) modulations performed during the analysis. Reductions in sensor sensitivities with increasing temperature were predictable and similar among the sensors in the array such that most response patterns were not altered significantly. Short-term fluctuations in concentration were accurately tracked by the instrument. Results indicate that this type of instrument could provide routine, semi-autonomous, near-real-time, multi-vapour monitoring in support of efforts to assess air quality in office environments. 相似文献