过氯乙烯滤膜采样-酸消解-钼蓝光度法测定磷酸雾

建立了过氯乙烯滤膜采样 -酸消解 -钼蓝分光光度法测定磷化车间磷酸雾的监测方法。实验室模拟采样的捕集效率为 95 7%～ 99 1 %。单个实验室对含 5μg和 1 5μg样品进行多次测定 ,其相对标准差小于 5% ,样品加标回收率为 98 2 %～ 1 0 0 5% ,方法检测限为 0 0 0 7mg/m3。对标样测定 ,结果均在给定值范围内。用该法与等离子发射光谱法(ICP)对 5个样品进行比对测定 ,结果均令人满意。     

5—(4—磺酸基苯偶氮)8—(2,4—二硝基苯氨基)喹啉测定食品中铜的研究应用

在弱碱性介质中 ,5— (4—磺酸基苯偶氮 ) 8— (2 ,4—二硝基苯氨基 )喹啉 (SPDNPAQ)与铜反应生成 2∶ 1紫红色络合物 ,体系 λmax=56 0 nm,ε=1.2 3× 10 5L· mol-1· cm-1。铜含量在 0～ 0 .4 mg/ L内符合比耳定律 ,方法用于一些生物样品和水样中铜的测定。     

Performance evaluation of a full-scale natural treatment system for nonpoint source and point source pollution removal

This study presents a full-scale performance of a natural treatment system (NTS) facility in Taiwan with nearly 2 years of observations. The study site, composed of several treatment ponds in series, was designed primarily to reduce polluted stormwater runoff from tea gardens and partially to untreated domestic wastewater from nearby villages. Thus, both nonpoint source and point source pollution are treated in this system. From 28 field samplings in 2006-2007, the NTS site shows satisfactory treatment performance and the effluent water quality is significantly improved. Seven of the 28 sampling events are storm events (nonpoint source pollution) and the remainder are from regular monitoring (point source pollution). The average volume of influent and effluent is 533 CMD and 196 CMD, respectively. In order to determine the removal efficiency, several assessment measures are employed in an attempt to obtain unbiased conclusions. They are removal rate (RR), efficiency rate (ER), summation of loads (SOL), flux rate (FR), and effluent probability method (EPM). The average percent removal efficiency of NH(3)-N is 53.5-75.2% and of TP is 59.0-84.7%, in which the highest result is calculated by SOL method and the lowest rate is obtained from RR. In FR evaluation, larger treatment capacity for NH(3)-N than for TP is provided in the site and the average FR is respectively 0.230 g/m(2) day and 0.017 g/m(2) day. Of the methods examined, EPM is the only method capable of illustrating data distribution. Finally, recommendations on the usefulness of these measures are summarized to facilitate the understandings of NTS performance evaluations.     

Disinfection by-product formation and mutagenic assay caused by preozonation of groundwater containing bromide

Brominated organic and inorganic by-products are generated during ozonation of groundwater containing high bromide concentrations. This study measured concentrations of bromate, bromoform, bromoacetic acids, bromoacetonitriles, bromoacetone, 2,4-dibromophenol and aldehyde generated by ozonation. The potential mutagenicity of ozonated waters was assessed using the Ames and Microtox tests. Test results for the 18 ozonated groundwater samples demonstrate that bromate formation is associated with high pH, bromide and alkalinity content, low levels of dissolved organic carbon (DOC) and ammonia, and low alkalinity. Brominated organic by-products were correlated with high bromide ion and natural organic matter content, and low ammonia concentrations. The Ames test results demonstrate that all extracts from ozonated water have mutagenic activity; however, the 18 raw groundwater samples had no mutagenicity. The Microtox test results also show that the ozonated water samples were highly toxic. Generally, both bromide and DOC content promoted the formation of ozonation by-products and mutagenicity. Controlling of bromide and DOC concentrations is an effective method of reducing potential by-product formation and eliminating mutagenicity problems associated with groundwater ozonation.     

Identification of sources of elevated concentrations of polycyclic aromatic hydrocarbons in an industrial area in Tianjin, China

The concentrations of 16 polycyclic aromatic hydrocarbons (PAHs) were determined by gas chromatography equipped with a mass spectrometry detector in 105 topsoil samples from an industrial area around Bohai Bay, Tianjin in the North of China. Results demonstrated that concentrations of PAHs in 104 soil samples from this area ranged from 68.7 to 5,590 ng g^???1 dry weight with a mean of ∑16PAHs 814 ± 813 ng g^???1, which suggests that there exists mid to high levels of PAH contamination. The concentration of ∑16PAHs in one soil sample from Tianjin Port was exceptionally high (48,700 ng g^???1). Ninety-three of the 105 soil samples were considered to be contaminated with PAHs (>200 ng g^???1), and 25 were heavily polluted (>1,000 ng g^???1). The sites with high PAHs concentration are mainly distributed around chemical industry parks and near highways. Two low molecular weight PAHs, naphthalene and phenanthrene, were the dominant components in the soil samples, which accounted for 22.1% and 10.7% of the ∑16PAHs concentration, respectively. According to the observed molecular indices, house heating in winter, straw stalk combustion in open areas after harvest, and petroleum input were common sources of PAHs in this area, while factory discharge and vehicle exhaust were the major sources around chemical industrial parks and near highways. Biological processes were probably another main source of low molecular weight PAHs.     

青岛市区春夏季大气能见度与颗粒物的关系

利用青岛市灰霾综合观测站2012年3月2日-2012年6月7日期间的监测数据,分析了青岛市区大气能见度与不同粒径颗粒物质量浓度的日变化特征,比较了各级别大气能见度下不同粒径颗粒物质量浓度及所占比例的相关性,研究了相对湿度对大气能见度和颗粒物质量浓度相关性的影响.结果表明,监测时段大气能见度与颗粒物质量浓度呈现较好的负相关,每天大气能见度最低值出现在早晨07:00--09:00;剔除相对湿度高于90％的前提下,PM2.5是影响大气能见度的主要因子,随着其在PM1o中所占比例上升,大气能见度级别不断下降,相关系数为-0.84;不同相对湿度区间下,PM2.5对大气能见度的影响最明显,其中,相对湿度为60％ ～ 70％,大气能见度与颗粒物质量浓度之间的相关性最好.     

工业类建设项目验收技术规范编制内容探讨

简述了我国建设项目环保验收技术规范颁布实施,以及国外对建设项目实行全过程监管方式现状,指出现行环保验收技术规范在行业性内容、验收监测频次、质量控制措施、总量核算方面存在的问题,提出,应出台总工业类环保验收技术规范,对出台行业类验收技术规范严格把关,并加大验收技术科研力度的建议.     

克拉玛依市核技术应用单位安全监管中应注意的几个问题

克拉玛依市的核技术应用逐渐增多,带给人们在工作、生活等方面快捷和高效的同时,随之也带来了潜在的辐射安全隐患,辐射风险由此增加。本文探讨了在辐射环境管理中监管执法面临的实际问题和解决问题的思路。强调了监管的重要性。     

Effect of air-drying and oven-drying treatment on Cr(VI) content and Cr bond forms in soil

Air-drying and oven-drying are pretreatment processes often used before testing and analyzing various soil characteristics in the laboratory. This study selected three kinds of soil, including red soil, entisol, and alluvial soil, and examined the variation of the Cr(VI) content and Cr bond forms in these soils during air-drying and oven-drying. The results show that when the soil is air-dried in natural environment, the Cr(VI) content decreases with air-drying time. On day 10 of air-drying, the Cr(VI) content in these soils is 22.8～47.9 % of the initial value. When the soil is oven-dried, the Cr(VI) concentration decays faster; on day 8, the Cr(VI) is no longer detected in these soil samples. When the Cr(VI)-contaminated soil is treated by air-drying and oven-drying, the Cr bond form converts into a more stable form. After oven-drying, the Cr mainly exists in Fe–Mn oxide form, organic bond form, and residual form. The air-drying and oven-drying pretreatment processes of soil reduce the Cr(VI) content and stabilize the Cr bond form. If the laboratory analytic results are applied to risk analysis or remediation strategy planning for chromium-contaminated soil, the toxicity, bioavailability, and mobility of Cr in soil may be underrated.     

Atmospheric depositional fluxes and sources apportionment of organochlorine pesticides in the Pearl River Delta region, South China

Organochlorine pesticides (OCPs) have variously been phased out in agricultural activities, but they are still widely detected in air, water, and soil systems due to their recalcitrant nature in the environment. The purposes of this study were to assess potential OCP pollution via dry and wet deposition over the fast developing Pearl River Delta area with 41,700 km², where the main effort has been focused on emerging pollutants such as petroleum hydrocarbons and PM2.5. We quantified both the dry and wet deposition fluxes of 19 OCPs including dichlorodiphenyltrichloroethanes (DDTs), endosulfans (Endos), and hexachlorocyclohexanes (HCHs). The results showed that each year about 67.4, 42.0, 15.0, and 8.07 kg of total OCPs, DDTs, Endos, and HCHs were returned to the ground, among which 11.7, 10.4, 0.84, and 0.16 kg were in the dry deposition forms. The large spatial variations in OCP deposition fluxes indicated that OCP pollution in the air is mainly influenced on local scales because evaporation from local soil is likely the major source of the phased out OCPs. Source analysis indicated that DDTs may be still in use as antifouling agent and/or dicofol, but Endos and HCHs were mainly derived from the residual of historical usage. The study suggests that the historical OCP pollutants are persistent at high levels in this area and should not be overlooked, while we tackle emerging pollutants.