As(V)在金红石TiO_2颗粒表面吸附特性及机理

通过静态动力学和热力学吸附实验,研究了温度、共存离子以及溶质的初始浓度对As(V)在金红石TiO2颗粒表面吸附的影响,探讨了As(V)在金红石TiO2颗粒表面吸附特性及机理。结果表明,在As(V)初始浓度为10 mg/L,pH为7的条件下,25℃时的吸附量0.41 mg/g高于30℃时的吸附量0.31 mg/g,As(V)在金红石TiO2上的吸附为放热过程。CaCl2和MgCl2的添加对As(V)在金红石TiO2表面吸附起到明显的促进作用。T=25℃,Ca2+或Mg2+浓度为10 mmol/L时,As(V)吸附量分别为0.64和0.56 mg/g,Ca2+比Mg2+对As(V)吸附促进作用强。As(V)在金红石TiO2的吸附等温线符合Frendlich方程,Lagergren二级动力学方程能较好地描述As(V)在金红石TiO2颗粒表面吸附的动力学过程。     

5种植物材料的水解释碳性能及反硝化效率

碳源在硝酸盐去除过程中起电子供体的作用,是生物反硝化反应的关键物质之一。为解决污水处理脱氮时碳源不足抑制反硝化反应造成脱氮效率低的问题,本研究选取风车草、甘蔗渣、芦竹、美人蕉和稻草秆5种植物材料作为反硝化碳源,探讨不同植物材料的水解释碳能力和释放规律;并进一步以其水解液作为外加碳源,探讨其对反硝化脱氮效率的影响。研究结果表明,植物材料水解释碳过程符合二级动力学反应规律,不同植物材料的释碳能力具有显著性差异,以甘蔗渣在固液比1∶80时COD释放当量最大,为45.45 mg/L;添加植物水解液可显著提高反硝化脱氮效率,以芦竹水解液脱氮效果最好,达到71.9%。此外,碳氮比是影响脱氮效率的重要因素之一,以碳氮比为9时反硝化脱氮效果最佳。     

废旧冰箱拆解聚氨酯泡沫塑料制备PU/PP复合材料

利用废旧冰箱拆解的聚氨酯泡沫塑料(PU)和聚丙烯(PP)、聚丙烯接枝马来酸酐(PP-g-MAH)为原料,采用物理化学回收技术制备PU/PP复合材料。用正交实验法分析PU填充量、PU粒径和PP-g-MAH 3个因素对PU/PP复合材料力学性能影响的显著性。结果表明,PU填充量对PU/PP复合材料拉伸性能有显著影响,对冲击性能和弯曲性能没有显著影响;在本文的实验范围内,PU粒径对PU/PP复合材料的力学性能影响不大;而PP-g-MAH投加量对PU/PP复合材料具有一定的影响。确定的优化工艺配方为:PU 40%;PU粒径选择2.00 mm;PP-g-MAH投加量10%。采用优化工艺制备的PU/PP复合材料的密度为1 042.88 kg/m3;冲击强度为2.9 kJ/m2;拉伸强度为10.30 MPa;拉伸模量为1 100 MPa;弯曲强度为18.5 MPa;弯曲模量为733 MPa。     

生物阴极式碳纸隔膜微生物燃料电池的反硝化和产电性能

为了探讨生物阴极式廉价隔膜微生物燃料电池(microbial fuel cell,MFC)的基本性能,首先以生物反硝化作用为基础构建了生物阴极MFC,并进一步以涂布聚四氟乙烯(PTFE)的廉价碳纸代替昂贵的质子交换膜(PEM)构建碳纸隔膜生物阴极式MFC。研究结果显示,对于生物阴极式MFC,阴极室中最适宜反硝化细菌生长的NO-3-N浓度为99.2 mg/L,此时输出电压最高可达0.11 V,1 h内NO-3-N的去除率达到80.0%,COD去除率为62.8%;以涂PTFE的碳纸代替PEM的生物阴极式MFC与有PEM的MFC最高输出电压基本一致(均达到0.22 V,外阻500Ω),但碳纸隔膜MFC的产电更稳定。结果验证了廉价隔膜生物阴极式MFC的可行性,并为其应用于污水脱氮奠定基础。     

假单胞菌好氧降解四溴双酚A的特性

为了解四溴双酚A(TBBPA)的好氧降解特性,采用选择富集法从活性污泥中分离出一株能够高效降解四溴双酚A的菌株。根据其形态、生理生化特性及16S rDNA核苷酸序列分析,该菌株被鉴定为假单胞菌属(Pseudomonas sp.)。研究结果表明,该菌株可通过好氧共代谢方式实现四溴双酚A的降解,葡萄糖是四溴双酚A降解的最佳碳源,其最优降解条件为葡萄糖8 g/L,牛肉膏0.5 g/L,pH值为7.0,培养温度为35℃,摇床转速为150 r/min。在该条件下其生物降解过程符合一级动力学模型,6 d后的降解率高达95.6%。LC-MS结果表明,四溴双酚A在好氧降解过程中会生成异丙苯酚类物质。     

镍渣的重金属浸出特性

在分析镍渣的矿物相组成和重金属元素含量的基础上,鉴定了镍渣样品的浸出毒性,并考察了pH、液固比和浸出时间等条件对镍渣样中铬、铅、铜和锌等重金属浸出特性的影响。结果表明,镍渣中的重金属总量约为渣样的0.9%,且铬、铜和锌的含量较高,需进行安全管理。实验所用镍渣样品为第Ⅰ类一般工业固体废物。在强酸条件下镍渣中重金属浸出浓度较大,pH3后浸出浓度显著降低;液固比40 L/kg时,镍渣中重金属不断溶出,液固比40 L/kg后,浸出达到饱和,浸出浓度趋于平衡;随着浸出时间的增加,重金属离子的浸出浓度先增加后减少,但由于各重金属性质不同,各重金属达到最大浸出浓度的时间不同。     

高铝粉煤灰提取氧化铝后硅钙渣用作水泥混合材

为了使高铝粉煤灰提取氧化铝后所产生的硅钙渣被大量的用作水泥混合材,通过水泥强度、水化放热和干缩性实验研究了原状硅钙渣和脱碱硅钙渣对水泥强度和稳定性的影响。结果表明,当硅钙渣掺量达30%时,硅钙渣水泥强度仍可满足P·C 32.5水泥要求。且随硅钙渣掺入量的增加,水泥早期水化放热速率增加的同时水泥累计水化放热量和干缩率还会显著降低。与原状硅钙渣相比,在同等掺量的情况下,脱碱硅钙渣更有利于保持水泥强度,降低其水化热和改善干缩性。     

Chemical oxidation of sulfadiazine by the Fenton process: Kinetics,pathways, toxicity evaluation

This paper investigated sulfadiazine oxidation by the Fenton process under various reaction conditions. The reaction conditions tested in the experiments included the initial pH value of reaction solutions, and the dosages of ferrous ions and hydrogen peroxide. Under the reaction conditions with pH 3, 0.25 mM of ferrous ion and 2 mM of hydrogen peroxide, a removal efficiency of nearly 100% was achieved for sulfadiazine. A series of intermediate products including 4-OH-sulfadiazine/or 5-OH-sulfadiazine, 2-aminopyrimidine, sulfanilamide, formic acid, and oxalic acid were identified. Based on these products, the possible oxidation pathway of sulfadiazine by Fenton's reagent was proposed. The toxicity evaluation of reaction solutions showed increased antimicrobial effects following the Fenton oxidation process. The results from this study suggest that the Fenton oxidation process could remove sulfadiazine, but also increase solution toxicity due to the presence of more toxic products.     

Modeling of Solid Particle Flow and Heat Transfer in Rotary Kiln Calciners

Abstract

Contaminated solid wastes exist in many industrial sites, gas plants, and oil refineries. One method of decontaminating the soil is to subject it to high temperatures in a rotary calciner in an anaerobic environment. Preliminary results from a computational model are presented in this paper for the flow and heat transfer from granular solid particles under treatment in a rotary kiln calciner. A fluidization model using kinetic theory of granular flow has been employed to solve the particle flow and heat transfer problem. While a two-dimensional model is used to predict the rotation induced flow of the solid particles, a pseudo three-dimensional model for heat transfer is developed where the axial bulk temperature gradient is obtained from a one-dimensional energy balance model. The model predictions indicate interesting features of the flow and temperature fields in the bed material. Future tasks include the development of a devolatilization model to study the decontamination of waste soil in the rotary calciner.     

Preliminary Strategic Environmental Assessment of the Great Western Development Strategy: Safeguarding Ecological Security for a New Western China

The Great Western Development Strategy (GWDS) is a long term national campaign aimed at boosting development of the western area of China and narrowing the economic gap between the western and the eastern parts of China. The Strategic Environmental Assessment (SEA) procedure was employed to assess the environmental challenges brought about by the western development plans. These plans include five key developmental domains (KDDs): water resource exploitation and use, land utilization, energy generation, tourism development, and ecological restoration and conservation. A combination of methods involving matrix assessment, incorporation of expert judgment and trend analysis was employed to analyze and predict the environmental impacts upon eight selected environmental indicators: water resource availability, soil erosion, soil salinization, forest destruction, land desertification, biological diversity, water quality and air quality. Based on the overall results of the assessment, countermeasures for environmental challenges that emerged were raised as key recommendations to ensure ecological security during the implementation of the GWDS. This paper is intended to introduce a consensus-based process for evaluating the complex, long term pressures on the ecological security of large areas, such as western China, that focuses on the use of combined methods applied at the strategic level.