Heavy metal concentrations in roadside soil and street dust from Petra region,Jordan

Concentrations of Cd, Cu, Fe, Pb, and Zn were measured in the samples of street dust and surface roadside soil before Jordan switched to unleaded fuel usage. The samples were collected from Petra, the most tourist-attractive site in Jordan. The samples were analyzed for heavy metals by atomic absorption spectrophotometry. Our results show that the distribution of metals in the soil samples is affected by wind direction in the investigated area. The highest level of metals was found in the eastern parts of the roads due to the westerly-dominant wind in the studied area. The contamination levels of metals decrease as the distance from the edge of the road increases. In the roadside soil samples, the means for the concentrations of the metals at 1 m from the east side of the main road are 1.0, 19.1, 3791.4, 177.0, and 129.0 mg kg^?1 for Cd, Cu, Fe, Pb, and Zn, respectively. In the samples of street dust, the means of the concentrations of the metals in the investigated area are 9.7, 11.8, 4694.4, 31.6, and 24.8 mg kg^?1 for Cd, Cu, Fe, Pb, and Zn, respectively. In conclusion, the lithogenic origins (traffic emissions) are responsible for the diffusion of these metals in the studied region.     

Saharan dust particles in snow samples of Alps and Apennines during an exceptional event of transboundary air pollution

Southern European countries are often affected in summer by transboundary air pollution from Saharan dust. However, very few studies deal with Saharan dust pollution at high altitudes in winter. In Italy, the exceptional event occurred on February 19, 2014, colored in red the entire mountain range (Alps and Apennines) and allowed to characterize the particulate matter deposited on snow from a morphological and chemical point of view. Snow samples were collected after this event in four areas in the Alps and one in the Apennines. The particulate matter of the melted snow samples was analyzed by scanning electron microscopy with energy dispersive X-ray spectrometry (SEM-EDS) and by inductively coupled plasma mass spectrometry (ICP-MS). These analyses confirmed the presence of Saharan dust particle components in all areas with similar percentages, supported also by the positive correlations between Mg-Ca, Al-Ca, Al-Mg, and Al-K in all samples.     

Particulate matter concentration levels during intense haze event in an urban environment

This study assessed concentration levels of particulate matter (PM) in the ambient environment of Ilorin metropolis, Nigeria, during haze episodes. Meteorological data (wind speed and direction, rainfall data, sunshine data, relative humidity and temperature) were obtained. Aerocet 531S particle counter (MetOne Instruments, USA) was used to measure four mass concentration ranges of PM (PM_1.0, PM_2.5, PM₁₀ and the total suspended particles (TSP)) in 10 locations taking into consideration land use patterns. Surfer® version 8 (Golden Software LLC, USA) was used to model the spatial variation of particulate matter concentration levels using kriging interpolation griding method. Human exposure assessment was done using the total respiratory deposition dose (TRDD) estimates and statutory limit breach (SLB) approaches. The appearance of dominating weak southern atmospheric wind flow was observed as wind speed ranged from 0 to 6.811 m/s while solar radiation periods ranged from 0.3 to 3.5 h/day. The relative humidity of the metropolis ranged between 28 and 57%, while daily temperature was 15 to 36 °C. Highest concentration levels of PM measured were 73.4, 562.7, 7066.3 and 9907.8 μg/m³ for PM_1.0, PM_2.5, PM₁₀ and TSP, respectively. Very strong negative correlations existed between the PM concentration levels and microclimatic parameters. Spatial variation of the concentration level as modelled using Surfer® version 8 indicated that particulate concentration level increases from south to north. Concentration levels of PM for the 24-h averaging period were generally above the 24-h threshold limit value set by the regulatory agencies for all the locations.     

Assessment of noise level and noise propagation generated by light-lift helicopters in mountain natural environments

The use of helicopter rises discussion about environmental noise propagation especially when it operates in proximity of environmentally sensitive areas (ESAs) for an extended period because of its potential implications in wildlife behaviours. In order to support decisions on helicopter logging operation management in proximity of ESAs, this study focused on (i) analysing the noise spectrum of a light-lift helicopter during logging operations and on (ii) assessing the noise propagation in the surrounding environments. This study investigated a helicopter logging operation for wood fuel extraction in the eastern part of the Italian Alps. The potential disturbance area covered for the entire helicopter logging operation was evaluated by a specific GIS application according to hearing sensitivity of the most sensitive wildlife species in the study area (different strigiform species). The noise level at the ground appeared to be affected by the location regardless both the use of equivalent continuous sound pressures level dB(A) (LAeq) and the single-event level (SEL) noise metrics. The lowest values were recorded when the helicopter was flown over the sound meter level located under the forest canopy, while the highest was recorded when the helicopter was unhooking the loads at the landing. The GIS application highlighted the consistent of the exceeded noise area (weighted to strigiform hearing range and sensitivity) for the lower frequency bands (0.016–0.250 kHz). A more restricted exceeded noise area concerned instead the most sensitive frequency bands" for the strigiform (1–2 kHz).

Open image in new window

Graphical abstract ?

     

Groundwater quality assessment in semi-arid regions using integrated approaches: the case of Grombalia aquifer (NE Tunisia)

As many arid and semi-arid regions in the Mediterranean Basin, the Grombalia coastal aquifer (NE Tunisia) is affected by severe groundwater exploitation and contamination. Therefore, quality assessments are becoming increasingly important as the long-term protection of water resources is at stake. Multidisciplinary investigations, like the one presented in this paper, are particularly effective in identifying the different origins of mineralization within an aquifer and investigating the impact of anthropogenic activities on groundwater quality. An integrated assessment, focused on the combined use of geostatistical, geochemical and isotopic (δ¹⁸O, δ²H and ³H) tools, was performed in the Grombalia aquifer between February and March 2014. The overall goal was to study the main processes controlling aquifer salinization, with special focus to nitrate contamination. Results indicate a persisting deterioration of water quality over the whole basin except the south-eastern zone juxtaposing the recharge area of the aquifer. Nitrate contents exceed the drinking water standard (50 mg/l) in 70% of groundwater samples, mainly due to the excessive use of fertilizers and urban activities. Stable isotope measurements showed the contribution of modern rainwater to aquifer recharge and proved the presence of evaporation contributing to the salinity increase. Tritium values of groundwater samples suggested two hypotheses: the existence of mixture between old and recent water or/and the existence of two recharge periods of the aquifer, pre- and post-nuclear weapons test. Principal component analysis confirmed the geochemical interpretation, highlighting that water-rock interaction evaporation effect and intensive anthropogenic activities constitute the main processes controlling the regional groundwater mineralization.     

Honeybees (<Emphasis Type="Italic">Apis mellifera</Emphasis>) as a biological barrier for contamination of honey by environmental toxic metals

The aim of the study was to investigate the transfer of toxic metals from honeybee workers (Apis mellifera L.) to bee honey in relation to the ecological state of the environment. The materials of the study consisted of samples of honeybee bodies and varietal honeys taken from the same apiary located in three areas: R1—urbanized (16), R2—ecologically clean (16) and R3—industrialized (15) of south-eastern Poland. The contents of 14 elements in all tested samples, including toxic metals (Cd, Pb, Hg, Al, Ni, Tl) as well as bioelements (K, Mg, Ca, Mn, Fe, Zn, Cu, Se), were analysed by the ICP-OES method with prior microwave mineralization. The concentrations of the majority of the studied elements, excluding aluminum and lead, were significantly higher in bee bodies than in honey samples (P?<?0.05). The pollution of bee bodies by toxic metals was dependent on the environmental cleanliness, and the most pollution was observed in the industrialized area. The bee body was the most effective barrier for Cd and Tl transfer to the honey, while the level of Ni was similar in both tested materials. The Al concentration was significantly higher in honey than bee bodies (14.81?±?24.69 and 6.51?±?5.83 mg kg^?1, respectively), which suggests the possibility of secondary contamination of honey. The greatest sensitivity to heavy metal pollution was observed in honeydew honey compared to nectar honeys (P?<?0.05). It was proved for the first time that bees work as biofilters for toxic metals and prevent honey contamination.     

Landscape-based upstream-downstream prevalence of land-use/cover change drivers in southeastern rift escarpment of Ethiopia

Characterized by high population density on a rugged topography, the Gedeo-Abaya landscape dominantly contains a multi-strata traditional agroforests showing the insight of Gedeo farmers on natural resource management practices. Currently, this area has been losing its resilience and is becoming unable to sustain its inhabitants. Based on both RS-derived and GIS-computed land-use/cover changes (LUCC) as well as socioeconomic validations, this article explored the LUCC and agroecological-based driver patterns in Gedeo-Abaya landscape from 1986 to 2015. A combination of geo-spatial technology and cross-sectional survey design were employed to detect the drivers behind these changes. The article discussed that LUCC and the prevalence of drivers are highly diverse and vary throughout agroecological zones. Except for the population, most downstream top drivers are perceived as insignificant in the upstream region and vice versa. In the downstream, land-use/cover (LUC) classes are more dynamic, diverse, and challenged by nearly all anticipated drivers than are upstream ones. Agroforestry LUC has been increasing (by 25% of its initial cover) and is becoming the predominant cover type, although socioeconomic analysis and related findings show its rapid LUC modification. A rapid reduction of woodland/shrubland (63%) occurred in the downstream, while wetland/marshy land increased threefold (158%), from 1986 to 2015 with annual change rates of -?3.7 and +?6%, respectively. Land degradation induced by changes in land use is a serious problem in Africa, especially in the densely populated sub-Saharan regions such as Ethiopia (FAO 2015). Throughout the landscape, LUCC is prominently affecting land-use system of the study landscape due to population pressure in the upstream region and drought/rainfall variability, agribusiness investment, and charcoaling in the downstream that necessitate urgent action.     

A study on the determination of the natural park’s sustainable tourism potential

The surface site of Yesilyuva Nature Park encompasses natural, social, economic, and cultural characteristics and has become a marker of the region’s natural and cultural heritage. To support the preservation of this site, promotional activities should be planned. In this study, because of tourism and related opinions of residents and visitors alike in terms of their natural determination, an important cultural and historical feature is aimed at evaluating the tourism potential of Yesilyuva Nature Park. This framework is designed to establish prospective tourism sustainability. As a result, Yesilyuva Nature Park’s natural and cultural properties have been determined to be suitable for sustainable tourism activities using geographic information systems (GIS). This protection in the field, which balances sustainability and landscape design, will provide for the development of tourism activities. In the Strengths, Weaknesses, Opportunities and Threats (SWOT) analysis and survey, residents and visitors reported that the most important feature of the Yesilyuva Nature Park was its natural beauty. Visitors often come to observe traditional and natural life and to engage in tourism activities. All the data, which includes maps derived from GIS, represents landscape planning for sustainable tourism areas in Yesilyuva Nature Park.     

Relative proportions of <Emphasis Type="Italic">E. coli</Emphasis> and <Emphasis Type="Italic">Enterococcus spp.</Emphasis> may be a good indicator of potential health risks associated with the use of roof harvested rainwater stored in tanks

A total of 285 water samples were collected from 71 roof harvested rainwater tanks from four villages in different provinces over a two-year (2013–2014) period during the early (October to December) and late (January to March) rainy season. Water quality was evaluated based on Escherichia coli, faecal coliforms and Enterococcus spp. prevalence using the IDEXX Quanti-Tray quantification system. Real-Time PCR was used to analyse a subset of 168 samples for the presence of Shigella spp., Salmonella spp. and E. coli virulence genes (stx1, stx2 and eaeA). Escherichia coli were detected in 44.1% of the samples, Enterococcus spp. in 57.9% and faecal coliforms in 95.7%. The most prevalent E. coli concentrations in harvested rainwater were observed in 29.1% of samples and 22.5% for Enterococcus spp. and, were within 1–10 cfu/100 ml and 10–100 cfu/100 ml, respectively, whereas those for faecal coliforms (36.6%) were within 100–1000 cfu/100 ml. On average 16.8% of the samples had neither E. coli nor Enterococcus spp. detected, while 33.9% had only Enterococcus spp. and 23.7% had only E. coli. E. coli and Enterococcus spp. were detected together in 25.5% of the samples. Evaluation of samples for potential pathogenic bacteria showed all tested samples to be negative for the Shigella spp. ipaH gene, while five tested positive for Salmonella ipaB gene. None of the samples tested positive for the stx1 and stx2 genes, and only two tested positive for the eaeA gene. These findings are potentially useful in the development of a simplified risk assessment strategy based on the concentrations of indicator bacteria.     

Effect of ventilation rate on air cleanliness and energy consumption in operation rooms at rest

The interrelationships between ventilation rate, indoor air quality, and energy consumption in operation rooms at rest are yet to be understood. We investigate the effect of ventilation rate on indoor air quality indices and energy consumption in ORs at rest. The study investigates the air temperature, relative humidity, concentrations of carbon dioxide, particulate matter (PM), and airborne bacteria at different ventilation rates in operation rooms at rest of a medical center. The energy consumption and cost analysis of the heating, ventilating, and air conditioning (HVAC) system in the operation rooms at rest were also evaluated for all ventilation rates. No air-conditioned operation rooms had very highest PM and airborne bacterial concentrations in the operation areas. The bacterial concentration in the operation areas with 6–30 air changes per hour (ACH) was below the suggested level set by the United Kingdom (UK) for an empty operation room. A 70% of reduction in annual energy cost by reducing the ventilation rate from 30 to 6 ACH was found in the operation rooms at rest. Maintenance of operation rooms at ventilation rate of 6 ACH could save considerable amounts of energy and achieve the goal of air cleanliness.