Emission Impacts of Electric Vehicles

Alternative vehicular fuels are proposed as a strategy to reduce urban air pollution. In this paper, we analyze the emission Impacts of electric vehicles In California for two target years, 1995 and 2010. We consider a range of assumptions regarding electricity consumption of electric vehicles, emission control technologies for power plants, and the mix of primary energy sources for electricity generation. We find that, relative to continued use of gasoline-powered vehicles, the use of electric vehicles would dramatically and unequivocally reduce carbon monoxide and hydrocarbons. Under most conditions, nitrogen oxide emissions would decrease moderately. Sulfur oxide and particulate emissions would Increase or slightly decrease. Because other areas of the United States tend to use more coal in electricity generation and have less stringent emission controls on power plants, electric vehicles may have less emission reduction benefits outside California.     

The Cost Estimation of Thermal and Catalytic Incinerators for the Control of VOCs

In an earlier paper, major commercially available incinerator technologies designed to treat dilute waste gas streams containing volatile organic compounds (VOCs) were described in a qualitative comparison. In addition, a simplified procedure was outlined through which important sizing parameters could be calculated given certain information about the waste gas. This paper describes the use of these parameters in developing a study (±30percent) cost estimate for the total capital investment and the total annual costs incurred in treating a waste stream of volatile organic compounds (VOCs). An illustrative problem used in the former paper is completed here in order to contrast some of the economic differences between thermal and catalytic incinerator systems.     

The relationship between flow and bacteria in streams

A method is proposed to relate the statistics of in-stream bacteria concentrations to the surface-runoff fraction of stream flow. The parameters of this relationship include the characteristic concentration of bacteria in surface runoff and the characteristic concentration of bacteria in the base flow, and these parameters can be derived from synoptic bacteria and flow measurements. The effectiveness of the proposed method is demonstrated at several U.S. locations for both Escherichia coli and fecal coliform bacteria. Application of the proposed method at a particular location showed that the method can be used to identify the most effective bacteria source controls and that conventional application of the load-duration curve might lead to erroneous identification of target sources.     

Development of Thixotropic Coatings Using Dimerized Soybean Oil Fatty Acids: The Case of Polyamide of 1,2-Phenylene Diamine

Soybean oil (SBO) was dimerized and the crude dimer acid product reacted with 1,2-phenylene diamine at 210 ± 5 °C under inert atmosphere to obtain fatty polyamide (FPA). The FPA was used to modify a commercial alkyd resin by reacting a mixture of the alkyd resin with 5 wt% of FPA at 120 °C for 80 min under inert atmosphere. The FTIR spectrum of the FPA modified resin showed evidence of higher degree of H-bonding than was found for the unmodified alkyd. White gloss coatings of 15, 20, 25, and 30% solids were formulated from the modified and unmodified resins and examined for performance with respect to: leveling, sag resistance, drying time, pigment settling, skinning tendency and film hardness. Results showed that the unmodified alkyd coatings exhibited good leveling but poor sag resistance at all solid contents. In contrast, FPA modified alkyd coatings combined good leveling with high sag resistance indicating their thixotropic nature. A strong tendency to pigment settling was observed for unmodified alkyd coatings but was not observed in the FPA modified alkyd coatings. The modified alkyd coatings showed skinning while the unmodified alkyd coatings did not skin. A 30% solids coating formulation of the FPA modified resin showed shorter surface dry time but longer hard dry time than the unmodified alkyd resin coating.     

Preparation and Characterization of Hydrogel Based on Poly(vinyl alcohol) Cross-Linked by Different Cross-Linkers Used to Dry Organic Solvents

Poly(vinyl alcohol) (PVA) hydrogels were chemically cross-linked with/without different cross-linkers such as glutaraldehyde and epichlorohydrin, in the presence of a catalyst, or activator (potassium hydroxide) to produce three types of hydrogels. The structures of PVA and the prepared gel types were determined by FTIR spectroscopy, the mechanical and thermal properties, of these hydrogels were examined. The effects of different pH values and temperatures on the swelling properties of the prepared gels were examined. From the obtained results, it was found that, the low concentration of the cross-linker produced hydrogel with moderate properties, but in absence of the cross-linker, the obtained hydrogel exhibited good properties and can be used as friendly environmentally moisture absorbents from the organic solvents. The insolubility and swelling properties of gels were tested in these solvents. The results indicated that these hydrogels can be used as moisture absorbents and solvent dryers.     

Remediation,land use,and risk at Hanford

U.S. Department of Energy (US DOE) remediation responsibilities include the Hanford site in Washington State. Cleanup is governed by the Tri‐Party Agreement (TPA) between the US DOE as the responsible party and the U.S. Environmental Protection Agency and Washington State Department of Ecology as joint regulators. In 2003, the US DOE desired to implement a “Risk‐Based End State” (RBES) policy at Hanford, with remediation measures driven by acceptable risk standards using exposure scenarios based on the 1999 Hanford Comprehensive Land‐Use Plan. Facing resistance from regulators and stakeholders, the US DOE solicited public input on its policy. This led to a Hanford Site End State Vision in 2005 and a commitment that the TPA would continue to control remediation. This article describes how regulator and public participation modified RBES to an end‐state vision. © 2010 Wiley Periodicals, Inc.     

Universal criteria for assessing the ecological state of soil algocenoses

A set of criteria allowing demarcation between algocenoses is proposed. These criteria characterize the species composition, group of dominants, and taxonomic and ecological structure of algocenoses.