Evaluation of Caging Designs and a Fingernail Clam for Use in an In Situ Bioassay

Two cage designs and fingernail clams(Sphaerium fabale) were evaluated for theirsuitability for use in in situ bioassays toassess the ecological condition of a stream andpredict ecological recovery potential. One design(referred to as tray design) was a modified plastictray about one-fourth full of small gravels andcovered with 1 mm fiberglass mesh. The second design(referred to as tube-plates) consisted of shortplexiglass tubes about one-third full of small gravelsand attached horizontally to a plexiglass plate. Oneend of each tube faced into the current; both endswere covered with mesh. Cages containing clams weredeployed at reference and impacted (test) sites forperiods of 70 to 135 d. Growth and survival were theprimary endpoints evaluated, but the tube-platesallowed isolation of individual clams so that natalityalso could be evaluated as an endpoint. Results ofbenthic macroinvertebrate surveys, performed foranother study, were included to help validate bioassayresults. Both cage designs yielded good quantitative,site-specific results for clam survival and growth;results for natality, though, were less conclusive. Clam survival and growth results were in good generalagreement with the results for the benthicmacroinvertebrate community surveys. At a site wherethe macroinvertebrate community was the mostdepauperate, clam mortality was always rapid. At asite where the condition of the macroinvertebratecommunity was only slightly less impacted than themost impacted site, clam growth was almost alwayssignificantly lower than at reference sites. Survivalof clams was significantly reduced in <25 d at thissite in some trials, but in other trials there waslittle mortality. At a minimally impacted site, clamsurvival was similar to that found at reference sites,and differences in clam growth were not detectableuntil after 40 to 50 d of exposure. The tube-platedesign was easier to use, allowed more flexibility inselection of response parameters, and required lesshandling time of test animals, thus, this was thepreferred design. Our results demonstrated thateither in situ bioassay design can be used toaugment monitoring and assessment programs. Their useas a predictor of ecological recovery, however,requires further evaluation.     

Monitoring Australian Rangeland Sites Using Landscape Function Indicators and Ground- and Remote-Based Techniques

If the goal for managing rangelands is to achieve a balance between production and conservation, then monitoring is essential to detect change and apply corrective action. In some range-land areas of northern Australia, monitoring has detected a tilt in the production-conservation balance towards excessive production. How big is this imbalance? Can it shift back? Robust monitoring is needed to answer these questions. The aim is to know what to monitor, and where. For example, to detect changes caused by livestock on rangeland forage production and soil erosion, indicators linking grazing disturbances to landscape function are needed, that is, indicators that signal how well landscapes are capturing, concentrating, and utilizing scarce water, nutrient, and organic resources. Studies in Australia and the USA document that simple vegetation and soil patch attributes can be measured as indicators of the 'state of health' of landscape function. For example, field and remote sensing-based grazing studies in Australia document that landscapes with a high cover of perennial plant patches function effectively to capture runoff water and nutrients in sediments, whereas landscapes with a low cover of these patches do not — they are dysfunctional — as indicated by large patches of bare soil. Aerial videography is proving to be a robust technique for measuring indicators of landscape function such as small patches of vegetation and the extent of bare soil. These indicators typically have a sigmoidal response to grazing impacts. We illustrate that if these indicators are measured on monitoring sites established near the sigmoidal 'point of inflection’ then small changes in these indicators can be detected.     

Environmetrics to evaluate marine environment quality

The environmetric data analysis of analytical datasets from sediment and benthic organisms samples collected from different sampling sites along the coast of Black Sea near to City of Varna, Bulgaria has given some important indications about the bioindication properties of both type of samples. Various multivariate statistical methods like cluster analysis, principal components analysis, source apportioning modeling and partial least square (PLS) modeling were used in order to classify and interpret the parameters describing the chemical content of the coastal sediments (major components, heavy metals and total organic carbon) and benthic organisms (heavy metals). It has been shown that seriously polluted coastal zones are indicated in the same way by all benthic species, although some specificity could be detected for moderate polluted regions' e.g. polychaeta accumulated preferably Co, Cr, Cu, and Pb; crustacea - As, Cd, and Ni; mollusca - Zn. The identified latent factors responsible for the dataset structure are clearly indicated and apportioned with respect to their contribution to the total mass or total concentration of the species in the samples. The linear regression and PLS models indicated that a reliable forecast about the relation between naturally occurring chemical components and polluting species accumulated in the benthic organisms is possible.     

Development of an integrated sensor to measure odors

Odorous air samples collected from several sources were presented to an olfactometer, an electronic nose, a hydrogen sulfide (H(2)S) detector and an ammonia (NH(3)) detector. The olfactometry measurements were used as the expected values while measurements from the other instrumentation values became input variables. Five hypotheses were established to relate the input variables and the expected values. Both linear regression and artificial neural network analyses were used to test the hypotheses. Principal component analysis was utilized to reduce the dimensionality of the electronic nose measurements from 33 to 3 without significant loss of information. The electronic nose or the H(2)S detector can individually predict odor concentration measurements with similar accuracy (R (2) = 0.46 and 0.50, respectively). Although the NH(3) detector alone has a very poor relationship with odor concentration measurements, combining the H(2)S and NH(3) detectors can predict odor concentrations more accurately (R (2) = 0.58) than either individual instrument. Data from the integration of the electronic nose, H(2)S, and NH(3) detectors produce the best prediction of odor concentrations (R (2) = 0.75). With this accuracy, odor concentration measurements can be confidently represented by integrating an electronic nose, and H(2)S and NH(3) detectors.     

Polycyclic aromatic hydrocarbon contamination in stormwater detention pond sediments in coastal South Carolina

The purpose of this study was to characterize the polycyclic aromatic hydrocarbon (PAH) contamination in the sediments of stormwater detention ponds in coastal South Carolina. Levels of the sum of PAH analytes were significantly higher in the sediments of commercial ponds compared to that of reference, golf course, low-density residential, and high-density residential ponds. Isomer ratio analysis suggested that the predominant source of PAHs were pyrogenic; however, many ponds had a PAH signature consistent with mixed uncombusted and combusted PAH sources. PAH levels in these sediments could be modeled using both pond drainage area and pond surface area. These results demonstrate that the sediment from most commercial ponds, and a few residential and golf course ponds, were moderately contaminated with PAHs. PAH levels in these contaminated ponds exceeded between 42% and 75% of the ecological screening values for individual PAH analytes established by US EPA Region IV, suggesting that they may pose a toxicological risk to wildlife.     

Use of preserved museum fish to evaluate historical and current mercury contamination in fish from two rivers in Oklahoma, USA

We examined the effects of a commonly used preservation technique on mercury concentration in fish tissue. After fixing fish muscle tissue in formalin followed by preservation in isopropanol, we found that mercury concentration in fish muscle tissue increased by 18%, reaching an asymptote after 40 days. We used formalin–isopropanol-preserved longear sunfish (Lepomis megalotis) from the Sam Noble Oklahoma Museum of Natural History to examine historical changes and predict current mercury concentrations in fish from two rivers in southeastern Oklahoma. Glover River was free-flowing, while Mountain Fork River was impounded in 1970 and a coldwater trout fishery was established upstream from the collection site in 1989. Mercury concentrations in longear sunfish from Glover River showed no historical changes from 1963 to 2001. Mercury concentrations in longear sunfish from Mountain Fork River showed no change from 1925 to 1993 but declined significantly from 1993 to 2003. We also compared mercury concentrations of the most recently collected longear sunfish in the museum to mercury concentrations of unpreserved fish collected from the rivers in 2006. Concentrations of mercury in museum fish were not significantly different from mercury concentrations in unpreserved fish we collected from the rivers. Our study indicates that preserved museum fish specimens can be used to evaluate historical changes and predict current levels of mercury contamination in fish.     

Serial batch leaching procedure for characterization of coal fly ash

Although many leaching methods have been used for various purposes by research groups, industries, and regulators, there is still a need for a simple but comprehensive approach to leaching coal utilization by-products and other granular materials in order to estimate potential release of heavy metals when these materials are exposed to natural fluids. A serial batch characterization method has been developed at the National Energy Technology Laboratory that can be completed in 2–3 days to serve as a screening tool. The procedure provides an estimate of cumulative metals release under varying pH conditions, and leaching the sample at increasing liquid/solid ratios can indicate the rate at which this process will occur. This method was applied to eight fly ashes, adapted to the acidic or alkaline nature of the ash. The leachates were analyzed for 30 elements. The test was run in quadruplicate, and the relative standard deviation (RSD) was used as a measure of method reproducibility. RSD values are between 0.02 and 0.70, with the majority of the RSD values less than 0.3. The serial batch leaching procedure was developed as a simple, relatively quick, yet comprehensive method of estimating the risk of heavy metal release from fly ash when it is exposed to natural fluids, such as acid rain or groundwater. Tests on a random selection of coal fly ashes have shown it to be a reasonably precise method for estimating the availability and long-term release of cations from fly ash.     

Management options and effects on a marine ecosystem: assessing the future of the Baltic

We are using the coupled models in a decision support system, Nest, to evaluate the response of the marine ecosystem to changes in external loads through various management options. The models address all the seven major marine basins and the entire drainage basin of the Baltic Sea. A series of future scenarios have been developed, in close collaboration with the Helsinki Commission, to see the possible effects of improved wastewater treatment and manure handling, phosphorus-free detergents, and less intensive land use and live stocks. Improved wastewater treatment and the use of phosphorus-free detergents in the entire region would drastically decrease phosphorus loads and improve the marine environment, particularly the occurrence of cyanobacterial blooms. However, the Baltic Sea will remain eutrophic, and to reduce other effects, a substantial reduction of nitrogen emissions must be implemented. This can only be obtained in these scenarios by drastically changing land use. In a final scenario, we have turned 50% of all agricultural lands into grasslands, together with efficient wastewater treatments and a ban of phosphorus in detergents. This scenario will substantially reduce primary production and the extension of hypoxic bottoms, increase water transparency in the most eutrophied basins, and virtually eliminate extensive cyanobacterial blooms.