An application of circular-linear correlation analysis to the relationship between Freon concentration and wind direction in Woods Hole,Massachusetts

Two statistical tests for correlation between a circular variate and a linear variate are presented. The tests are applied to a small data set concerning Freon-12 concentration and wind direction in Woods Hole, Massachusetts during the summer of 1987. A significant correlation is found. Further analysis suggests that this directional effect is related to onshore Freon-12 release.Woods Hole Oceanographic Institution Contribution Number 6750     

Excrement from Heron colonies for environmental assessment of toxic elements

Excrement cast from Great Blue Heron nests was collected during the nesting period of 1978 from four colonies in Washington and Idaho. Cheesecloth strips placed on the ground beneath the nests served as excrement collecting devices. Chemical analysis for lead, mercury and cadmium were performed on dried samples. Lead was the most abundant trace metal found in heron debris. The Idaho colony at Lake Chatcolet had an average concentration of 46 ppm in the beneath-nest samples and 6 ppm in control samples. A heron colony near Tacoma, Washington had beneath-nest samples averaging 28 ppm and control samples averaging 20 ppm. Two colonies located in the interior region of Washington had substantially lower concentrations of lead. The difference observed between colonies was attributed to their associations with a polluted watershed (Chatcolet colony) an interstate highway (Tacoma colony) and an unpopulated largely agricultural area (inland Washington).     

Strontium-90 in Canada goose eggshells and reed canary grass from the Columbia River,Washington

Strontium-90 (⁹⁰SR) released to the ground near the N Reactor at the U.S. Department of Energy's Hanford Site enters the Columbia River through shoreline seeps. The ⁹⁰Sr is then potentially available for uptake by plants and animals. The life history and foraging behavior of nesting Canada geese is such that female geese could ingest ⁹⁰Sr while foraging on shoreline plants. Radichemical analyses showed that goose eggshells taken from an island, downstream from the N Reactor, contained more ⁹⁰Sr than did eggshells collected from other downstream islands. Reed canary grass samples taken from shoreline areas immediately downstream from the N Reactor contained higher concentrations of ⁹⁰Sr than samples from other downstream areas. All goose eggshells did not contain enhanced levels of ⁹⁰Sr, and all reed canary grass samples did not contain enhanced levels of ⁹⁰Sr, but a relationship exists between the releases of ⁹⁰Sr to the Columbia River and the enhanced levels of ⁹⁰Sr in some of the environmental samples analyzed.Pacific Northwest Laboratory is operated by Battelle Memorial Institute for the U.S. Department of Energy under contract DE-ACO6-76RLO 1830.     

Estimation of the Thermal Sensitivity of a Dwelling to Variations in Architectural and Behavioural Parameters

The provision of energy for households is a major contributor to greenhouse gas emissions in the domestic sector. There is significant scope for energy savings and thus emission reduction in this sector. This paper constructs a bridge between thermal analysis and environmental assessment in the occupancy stage of the dwelling life cycle, approaching both methods as being on a common system Environment–Dwelling–Inhabitant. The importance of the local level in the thermal analysis and assessment of either a dwelling or an inhabitant's behaviour is demonstrated. It is shown that the researcher can choose between natural experiment, computer experiment and mathematical modelling to analyze the system. Such a choice is discussed for two particular methods of thermal analysis. Thermal Nomograms are the result of mathematical modelling, and the Energy Score Sheet is the result of a computer experiment in energy rating. Despite being developed for the purpose of thermal analysis, these methods can also be utilized for environmental assessment at the local level. The discussion centres on Australian conditions where the majority of the population resides in a relatively benign climate wherein behavioural alterations have significant potential for energy savings and environmental impact. The purpose of the paper is to emphasise benefits apart from energy minimisation to promote the use of energy efficient housing strategies.     

Environmental monitoring of historical change in arsenic deposition with tree bark pockets

ICP-MS analysis recorded historical change (c. 1846 to 2002) in the arsenic concentration of bark included within the trunks (tree bark pockets) of two Japanese oak trees (Quercus crispula), collected at an elevated location approximately 10 km from the Ashio copper mine and smelter, Japan. The arsenic concentration of the bark pockets was 0.016 +/- 0.003 microg cm(-2) c. 1846 (n = 5) and rose 50-fold from c. 1875 to c. 1925, from approximately 0.01 to 0.5 microg cm(-2). The rise coincided with increased copper production in Ashio from local sulfide ores, from 46 tons per year in 1877 to 16,500 tons per year in 1929. Following a decline in arsenic concentration and copper production, in particular during the Second World War, a second peak was observed c. 1970, corresponding to high levels of production from both local (6,000 tons per year) and imported (30,000 tons per year) ores, smelted from 1954. Compared to the local ores, the contribution of arsenic from imported ores appeared relatively low. Arsenic concentrations declined from c. 1970 to the present following the closure of the mine in 1974 and smelter in 1989, recording 0.058 +/- 0.040 microg cm(-2) arsenic (n = 5) in surface bark collected in 2002. The coincident trends in arsenic concentration and copper production indicated that the bark pockets provided an effective record of historical change in atmospheric arsenic deposition.     

Integration of modeling,monitoring and laboratory observation to determine reasons for air quality violations

An attempt was made to explain ambient air quality violations in the vicinity of industrial plants. Micrometeorology, diffusion calculaations, ambient readings, and plant engineering data are all taken into consideration to ascertain whether the plant is or is not the principal offender.Scrutiny of hi-vol filters using scanning electron microscopy for particle size analysis and particle chemical make-up as an assessment technique is also described.Case histories using the above analytical techniques are discussed.Presented at the 16th National Conference on Energy and the Environment, May 23, 1979     

Further studies using X-ray fluorescence to sample lead contaminated carpeted surfaces

The sampling of carpeted surfaces to test for lead contamination primarily focuses upon vacuum techniques. Vacuum sampling techniques, however, require time-consuming, expensive laboratory analysis of the dusts obtained and are unable to determine total lead load on the carpet. X-ray fluorescence (XRF) analysis is an on-site, inexpensive, non-destructive, quick technique for predicting metals levels in a variety of media, such as water, soil, filter paper and painted surfaces. A 1992 study of the feasibility of XRF to analyze for lead and soil loadings on carpeted surfaces indicated that XRF can detect lead at a low enough level to warrant further study. This paper expands this earlier study and developes lead and soil loading calibration curves for three different carpet types based upon XRF lead L-beta peak areas and XRF iron and barium K-alpha peak and background areas. Results indicate that variation in the data can be reduced through modifications of the XRF analysis technique, thus reducing the statistically determined detection level, and that carpet type does affect the calibration. Detection levels of approximately 70 mg/m² for lead and 5 g/m² for soil were obtained. Overall, good agreement was found between results of this study and the earlier one. XRF shows excellent potential for quantitative analysis of lead on carpeted surfaces.     

Use of cluster and principal component analyses to profile areas in California where ground water has been contaminated by pesticides

An empirical approach to profiling areas of ground water contamination by pesticides was devised that did not rely upon determining the level of vulnerability between land areas and that did not assume any particular pathway for ground water contamination. Climatic and soil data were obtained for 1-square mile sections of land in California where pesticide residues had been found in well water samples and the detection was attributed to legal agricultural applications. These sections were designated as known contaminated (KC) sections. Climate and soil data were also obtained for sections which lacked either well sampling data or a positive pesticide detection. These sections were designated as candidate sections. Statistical procedures were used to cluster groups of KC sections first with respect to climate characteristics and then with respect to soil characteristics. Principal components analysis (PCA) was used to construct a statistical profile of soil variables for each cluster of KC sections. A method based on the PCA was developed to compare the similarity of soil profiles derived for each KC section cluster to individual candidate sections. Since the profiling scheme was based only on data from KC sections, candidate sections that did not match any KC cluster profile could only be considered dissimilar to contaminated sections, receiving a status of not-classified. This profiling method is flexible and it can be revised to incorporate updated well sampling information.     

Ambient air concentrations of PCDDs,PCDFs, coplanar PCBs,and PAHs at the Mississippi Sandhill Crane National Wildlife Refuge,Jackson County,Mississippi

Our objective was to determine the levels of selected airborne contaminants in ambient air at the Mississippi Sandhill Crane National Wildlife Refuge, Mississippi, that might be affecting the health of endangered cranes living there. Two high-volume air samplers were operated at separate locations on the Refuge during May–September 1991. The sampling media were micro-quartz filters in combination with polyurethane foam plugs. Composite bimonthly samples from each station were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs), dibenzofurans (PCDFs), coplanar polychlorinated biphenyls (PCBs), and polycyclic aromatic hydrocarbons (PAHs). Overall, residue concentrations were low. The toxic PCDD isomer 2,3,7,8-tetra-CDD was not detected, nor was penta-CDD. There was no difference (P>0.05) in residue concentrations between stations or over time and meteorological parameters were not correlated with residue concentrations. Because contaminant levels and patterns may differ seasonally, we recommend that air samples collected during winter months also be analyzed for these same chemical groups.     

Criteria for the evaluation of alternative environmental monitoring variables: Theory and an application using winter flounder (Pleuronectes americanus) and Dover sole (Microstomus pacificus)

The design of environmental monitoring programs is frequently hampered by a lack of objective, quantitative criteria for evaluating alternative monitoring variables. In this paper we describe two such criteria, which we call samples required — the number of samples required to detect a given change in value — and information imparted — the amount of environmental information revealed by the monitoring variable. We then use these criteria to evaluate fin erosion in winter flounder (Pleuronectes americanus) and Dover sole (Microstomus pacificus) as marine environmental monitoring variables. Two methods for determining the samples required use contaminated and reference areas to estimate the sample statistics of a hypothetical impacted population. The first method is based on the overall difference in the proportions of diseased fish in the reference and hypothetical populations. The second treats the proportion of diseased fish in individual trawls as the variate and determines the samples required based on the mean and variance of the reference and contaminated populations. We use both methods to predict the number of trawls needed to detect an increase of 200% in fin erosion in the reference population. The first method had greater statistical power but assumes spatially homogeneous populations. The second method accounts for environmental patchiness. For Dover sole it predicted 1661 trawls would be needed to detect the 200% increase. An estuarine winter flounder population would require 74 trawls, and an oceanic winter flounder population would require 142.5 trawls. It appears that fin erosion in winter flounder may be a useful indicator of environmental contamination, but several stipulations apply. Migration may inflate the number of diseased fish observed in the reference population, and a more detailed etiology of the disease is required, including an understanding of what contaminants are responsible for manifestation of the disease.