A case study of an isolated wind powered electricity system meeting 100% of local demand

Using meteorological and electricity demand data for a 4-year period, electricity demand in Shetland was modeled to provide an estimate of the demand over a 30-year period from 1 January 1981. That modeled demand was then compared to estimated wind power output over the same period using the WAsP model. The wind farm output was estimated for a range of sizes of wind farm up to the consented 370 MW Viking Wind Farm in Shetland. Some wind power was available for 94% of the time and the 370 MW wind farm would meet 100% of demand for nearly 80% of the time. The statistics of single and accumulated deficits were calculated for a range of wind farms and estimates of the amount of additional generation capacity and additional power requirements were assessed. The study suggests that with storage, wind power in Shetland could meet all electricity demand in Shetland at around £130 to £150/MWh (excluding subsidy) and with a grid connection allowing the sale of excess power, those costs could be reduced.     

Matrix Diffusion Modeling Applied to Long‐Term Pump‐and‐Treat Data: 2. Results From Three Sites

The data mining/groundwater modeling methodology developed in McDade et al. (2013) was performed to determine if matrix diffusion is a plausible explanation for the lower‐concentration but persistent chlorinated solvent plumes in the groundwater‐bearing units at three different pump‐and‐treat systems. Capture‐zone maps were evaluated, and eight wells were identified that did not draw water from any of the historical source areas but captured water from the sides of the plume. Two groundwater models were applied to study the persistence of the plumes in the absence of contributions from the historical source zones. In the wells modeled, the observed mass discharge generally decreased by about one order of magnitude or less over 4 to 10 years of pumping, and 1.8 to 17 pore volumes were extracted. In five of the eight wells, the matrix diffusion model fit the data much better than the advection dispersion retardation model, indicating that matrix diffusion better explains the persistent plume. In the three other wells, confounding factors, such as a changing capture zone over time (caused by changes in pumping rates in adjacent extraction wells); potential interference from a high‐concentration unremediated source zone; and limited number of pore volumes removed made it difficult to confirm that matrix diffusion processes were active in these areas. Overall, the results from the five wells indicate that mass discharge rates from the pumping wells will continue to show a characteristic “long tail'' of mass removal from zones affected by active matrix diffusion processes. Future site management activities should include matrix diffusion processes in the conceptual site models for these three sites. © 2013 Wiley Periodicals, Inc.     

PM10 concentration levels at an urban and background site in Cyprus: The impact of urban sources and dust storms

Air quality in Cyprus is influenced by both local and transported pollution, including desert dust storms. We examined PM₁₀ concentration data collected in Nicosia (urban representative) from April 1, 1993, through December 11, 2008, and in Ayia Marina (rural background representative) from January 1, 1999, through December 31, 2008. Measurements were conducted using a Tapered Element Oscillating Micro-balance (TEOM). PM₁₀ concentrations, meteorological records, and satellite data were used to identify dust storm days. We investigated long-term trends using a Generalized Additive Model (GAM) after controlling for day of week, month, temperature, wind speed, and relative humidity. In Nicosia, annual PM₁₀ concentrations ranged from 50.4 to 63.8 μg/m³ and exceeded the EU annual standard limit enacted in 2005 of 40 μg/m³ every year. A large, statistically significant impact of urban sources (defined as the difference between urban and background levels) was seen in Nicosia over the period 2000–2008, and was highest during traffic hours, weekdays, cold months, and low wind conditions. Our estimate of the mean (standard error) contribution of urban sources to the daily ambient PM₁₀ was 24.0 (0.4) μg/m³. The study of yearly trends showed that PM₁₀ levels in Nicosia decreased from 59.4 μg/m³ in 1993 to 49.0 μg/m³ in 2008, probably in part as a result of traffic emission control policies in Cyprus. In Ayia Marina, annual concentrations ranged from 27.3 to 35.6 μg/m³, and no obvious time trends were observed. The levels measured at the Cyprus background site are comparable to background concentrations reported in other Eastern Mediterranean countries. Average daily PM₁₀ concentrations during desert dust storms were around 100 μg/m³ since 2000 and much higher in earlier years. Despite the large impact of dust storms and their increasing frequency over time, dust storms were responsible for a small fraction of the exceedances of the daily PM₁₀ limit.

ImplicationsThis paper examines PM₁₀ concentrations in Nicosia, Cyprus, from 1993 to 2008. The decrease in PM₁₀ levels in Nicosia suggests that the implementation of traffic emission control policies in Cyprus has been effective. However, particle levels still exceeded the European Union annual standard, and dust storms were responsible for a small fraction of the daily PM₁₀ limit exceedances. Other natural particles that are not assessed in this study, such as resuspended soil and sea salt, may be responsible in part for the high particle levels.     

Volatile Organic Compounds from Coal Tar and Soil Vapor Samples at MGP Sites

This study characterized organic compounds found in New York State manufactured gas plant (MGP) coal tar vapors using controlled laboratory experiments from four separate MGP sites. In addition, a limited number of deep (0.3–1.2 m above coal tar) and shallow (1.2–2.4 m above coal tar) soil vapor samples were collected above the in situ coal tar source at three of these sites. A total of 29 compounds were consistently detected in the laboratory-generated coal tar vapors at 50°C, whereas 24 compounds were detected at 10°C. The compounds detected in the field sample results were inconsistent with the compounds found in the laboratory-generated samples. Concentrations of compounds in the shallow soil vapor sample were either non-detectable or substantially lower than those found in deeper samples, suggesting attenuation in the vadose zone. Laboratory-generated data at 50°C compared the (% non-aromatic)/(% aromatic) ratio and indicated that this ratio may provide good discrimination between coal tar vapor and common petroleum distillates.     

Dioxin-like activity in sediments from Tai Lake, China determined by use of the H4IIE-luc bioassay and quantification of individual AhR agonists

Deterioration of the general ecosystem and specifically quality of the water in Tai Lake (Ch: Taihu), the third largest freshwater in China, is of great concern. However, knowledge on status and trends of dioxin-like compounds in Tai Lake was limited. This study investigated AhR-mediated potency and quantified potential aryl hydrocarbon receptor (AhR) agonists in sediments from four regions (Meiliang Bay, Zhushan Lake, Lake Center, Corner of Zhushan Lake, and Meiliang Bay) of Tai Lake by use of the in vitro H4IIE-luc, cell-based, transactivation, reporter gene assay, and instrumental analysis. Concentrations of 2,3,7,8-tetrachlorodibenzo-p-dioxin equivalents (Bio-TEQs) in sediments ranged from less than the limit of detection to 114.5 pg/g, dry weight, which indicated that organic extracts of sediments exhibited significant AhR-mediated potencies. Results of the potency balance analysis demonstrated that acid-labile, dioxin-like compounds represented a greater proportion of concentrations of Bio-TEQs in sediments from Tai Lake. Concentrations of 2,3,7,8-tetrachlorodibenzo-p-dioxin equivalents calculated as the sum of the product of concentrations of individual congeners and their respective relative potencies (Chem-TEQs) based on polycyclic aromatic hydrocarbons and/or polychlorinated biphenyls represented no more than 10 % of the total concentrations of Bio-TEQs.     

Development of aquatic life criteria in China: viewpoint on the challenge

While more developed countries have a well-established systems to develop water quality criteria (WQC), little research has been done on the adequacy of the current WQC to protect endemic species of China. In order to maintain the health of aquatic ecosystems in China, a series of projects to establish national WQC based on regional characteristics has recently been initiated. However, the establishment of a completely novel methodology would be costly and time consuming. Also, due to the similarities in physiologies and natural histories of classes of aquatic organisms, there is no reason to believe that WQC would not be sufficient to protect unique species in China. This review was undertaken to identify key outstanding issues regarding establishment of aquatic life criteria (ALC) to be applied in China, including prioritization of chemicals, test species, mode of action, field/semi-field data, and methods of aggregating the information and calculating the ALC. This was used to identify the principle issues that need to be addressed in order to better understand the methods for development of criteria for the protection of aquatic life and provide a reference to China and other developing countries committed to the establishment of their own WQC system.     

A comparison of statistical methods for deriving freshwater quality criteria for the protection of aquatic organisms

Species sensitivity distributions (SSDs) are increasingly used in both ecological risk assessment and derivation of water quality criteria. However, there has been debate about the choice of an appropriate approach for derivation of water quality criteria based on SSDs because the various methods can generate different values. The objective of this study was to compare the differences among various methods. Data sets of acute toxicities of 12 substances to aquatic organisms, representing a range of classes with different modes of action, were studied. Nine typical statistical approaches, including parametric and nonparametric methods, were used to construct SSDs for 12 chemicals. Water quality criteria, expressed as hazardous concentration for 5 % of species (HC₅), were derived by use of several approaches. All approaches produced comparable results, and the data generated by the different approaches were significantly correlated. Variability among estimates of HC₅ of all inclusive species decreased with increasing sample size, and variability was similar among the statistical methods applied. Of the statistical methods selected, the bootstrap method represented the best-fitting model for all chemicals, while log-triangle and Weibull were the best models among the parametric methods evaluated. The bootstrap method was the primary choice to derive water quality criteria when data points are sufficient (more than 20). If the available data are few, all other methods should be constructed, and that which best describes the distribution of the data was selected.     

Screening Capsicum chinense fruits for heavy metals bioaccumulation

Elevated concentrations of heavy metals in edible plants could expose consumers to excessive levels of potentially hazardous chemicals. Sixty-three accessions (genotypes) of Capsicum chinense Jacq, collected from 8 countries of origin were grown in a silty-loam soil under field conditions. At maturity, fruits were collected and analyzed for seven heavy metals (Cd, Cr, Ni, Pb, Zn, Cu, and Mo) concentrations. The main objectives of this investigation were: 1) to determine the concentrations of seven heavy metals in the soil and monitor their accumulation in mature fruits, 2) to categorize the pepper accessions as low or high heavy metal accumulators, and 3) to determine if heavy metal content of the pepper fruit was lower than the permitted limits. Concentrations and relative proportions of heavy metals in pepper fruits of C. chinense varied among accessions. Fruits of Plant Introduction (PI) 355820 accumulated significant concentrations of Cd (0.47 μ g g^?1dry fruit). PI-260522 accumulated the highest concentration of Pb (2.12 μ g g^?1 dry fruit) among the 63 accessions tested. This accession (PI-260522) contained about twice the Pb limit on a fresh weight basis. Among the 63 accessions analyzed, PI-238051 contained the highest levels of Ni (17.2 μ g g^?1). We concluded that high accumulator genotypes may be useful for phytoremediation, while, low accumulator accessions might be appropriate selections for growing on Cd-, Pb-, or Ni-contaminated soils to prevent potential human exposure to heavy metals and health hazards through the food chain.