Pilot-scale aerated submerged biofilm reactor for organics removal and nitrification at cold temperatures.

This research describes pilot-scale experiments for efficient removal of dissolved organic and nitrogen compounds in domestic wastewater using aerated submerged biofilm (ASBF) reactors. These reactors could enhance the performance of shallow wastewater treatment lagoons through the addition of specially designed structures. The structures are designed to encourage the growth of a nitrifying bacterial biofilm on a submerged surface. They also force the direct contact of rising air bubbles against the submerged biofilm. This direct gas-phase contact is postulated to increase the oxygen transfer rate into the biofilm and increase the microclimate mixing of water, nutrients, and waste products into and out of the biofilm. This research investigated the efficiency of dissolved organic matter and ammonia-nitrogen removals. Specifically, the effects of cold temperatures on the dissolved organic matter and ammonia-nitrogen performance of the ASBF pilot plant (see Figure 1) was investigated for the batch system. Over a period of 3.5 months, a total of 11 batch runs were performed. By the fourth run, the biofilm had matured to the point that it consumed all the ammonia in 40 hours. On the ninth run, the air supply was left off as a control run. This time, the ammonia was barely consumed, with the level dropping from 24 to 18 mg/L in 40 hours. By the middle of December, the average water temperature during the runs had dropped to approximately 6 degrees C and, at one point, was as low as 3.3 degrees C. The biofilm continued to perform even at these low temperatures, reducing ammonia levels from approximately 25 mg/L to basically zero within 40 to 48 hours.     

Antimony speciation and contamination of waters in the Xikuangshan antimony mining and smelting area,China

Water samples from Xikuangshan (China), the world largest antimony (Sb) mine with a Sb mining and smelting history of more than 200 years, were analyzed. These water samples ranged from stream water in the vicinity of the mining and smelting area that received seepage from ore residues to the underground mine-pit drainage. The concentrations of total Sb, Sb (III) and Sb (V) of the samples were determined by HPLC-ICP-MS. In addition, water pH and concentrations of major cations and anions were analyzed. All 18 samples demonstrated total Sb concentrations with ppm levels from 0.33 ppm to 11.4 ppm, which is two to three orders of magnitude higher compared to the typical concentration of dissolved Sb in unpolluted rivers (less than 1 ppb). This is probably the first time that such high Sb contents have been documented with complete environmental information. Distribution of total Sb and Sb species was investigated, taking into account the respective local environment (in the mining area or close to the smelter, etc.). Sb (V) was the predominant valence in all 18 samples. Only trace levels of Sb (III) were detected in 4 of the 18 samples. Geochemical speciation modeling showed the dominant species was Sb(OH)₆⁻. It is also probably the first time that such high Sb contents have been documented in the natural environment with Sb speciation distribution information. Several potential oxidation pathways are also discussed that might have facilitated the oxidation of Sb (III) in the natural environment. Signs of intoxication were observed among local mine workers with extensive exposure to different forms of Sb for a long period of time.     

Development and application of biotechnologies in the metal mining industry

Metal mining faces a number of significant economic and environmental challenges in the twenty-first century for which established and emerging biotechnologies may, at least in part, provide the answers. Bioprocessing of mineral ores and concentrates is already used in variously engineered formats to extract base (e.g., copper, cobalt, and nickel) and precious (gold and silver) metals in mines throughout the world, though it remains a niche technology. However, current projections of an increasing future need to use low-grade primary metal ores, to reprocess mine wastes, and to develop in situ leaching technologies to extract metals from deep-buried ore bodies, all of which are economically more amenable to bioprocessing than conventional approaches (e.g., pyrometallurgy), would suggest that biomining will become more extensively utilized in the future. Recent research has also shown that bioleaching could be used to process a far wider range of metal ores (e.g., oxidized ores) than has previously been the case. Biotechnologies are also being developed to control mine-related pollution, including securing mine wastes (rocks and tailings) by using “ecological engineering” approaches, and also to remediate and recover metals from waste waters, such as acid mine drainage. This article reviews the current status of biotechnologies within the mining sector and considers how these may be developed and applied in future years.     

Self-assembled BiVO4 mesocrystals for efficient photocatalytic decontamination of microcystin-LR

Environmental Chemistry Letters - There is a lack of efficient methods for removing microcystins produced by cyanobacterial blooms. Here, microsphere-like bismuth vanadate (BiVO4-60) mesocrystals...     

The importance of fires and floods on tree ages along mountainous gravel-bed streams.

This paper examines the commonly accepted assumption in the riparian literature that areas adjacent to streams do not burn. Using time-since-fire distributions, derived from stand-origin maps for a watershed in the front ranges of the Canadian Rocky Mountains, we found that the areas adjacent to streams and the whole study watershed have similar fire frequencies. In addition, the relative importance of fires and floods is regulated by a change in channel morphology associated with the creation of bars. The results demonstrate that fires solely control tree establishment along straight streams without bars, while the influence of floods is observed at the onset of lateral- and point-bar formation. This occurs because bars are formed in-channel and require smaller discharges in order to be flooded, compared to higher terraces. Consequently, bars are the only surfaces being flooded more frequently than they are being burned. Thus, overall the results indicate that, on this watershed, areas adjacent to streams are not less likely to burn than the uplands, except for lateral and point bars. The generality of these results to other systems should be tested as they have important implications for current forest ecological definition of "riparian zones," which typically include all fluvially derived landforms, from the channel banks to the terraces. Indeed, this study suggests that along smaller, headwater, gravel-bed mountain watersheds, the forests found on terraces are only influenced by fire and not fluvial processes and should therefore not be included in the riparian zone, while the forests on bars are the only surfaces currently being influenced by fluvial processes. Such a change in definition has implications for both ecologists and forest managers aiming to protect areas along streams as they now must take into account the effects of two disturbances on these small gravel-bed streams.     

Spectral characterization of two bioaccumulated methoxylated polybrominated diphenyl ethers

Two methoxylated polybrominated diphenyl ethers (MeO-PBDEs) were isolated from a True's beaked whale (Mesoplodon mirus) and identified by NMR (1H, 1H-1H and 1H-13C) and high resolution mass spectrometry as 2-(2',4'-dibromophenoxy)-3,5-dibromoanisole (6-MeO-BDE47) and 2-(2',4'-dibromophenoxy)-4,6-dibromoanisole (2'-MeO-BDE68). Previously the structures of these bioaccumulated compounds have been determined by comparison of their mass spectra and gas chromatographic (GC) retention times with those of authentic standards. While this method is accepted and generally successful, NMR of the isolated compounds allows us to definitively identify the congeners. Our characterizations are consistent with those made for MeO-PBDEs in other organisms, identified by chromatographic methods.     

Evaluation of weather conditions for methyl bromide ambient air monitoring in Monterey, Santa Cruz, and Kern Counties in the year 2000

Weather condition is one of the most important factors affecting spatial and temporal distributions of air pollutants, especially for short-term air dispersion. Abnormal weather conditions might lead to higher or lower ambient air concentrations than they would be under normal weather conditions. Therefore, testing for normality of weather conditions during the air monitoring period is an essential step for evaluating ambient air monitoring results. In this paper, a distance method was used to select a most representative weather station from the available candidates. An array of meteorological elements were identified that affect air dispersion and transportation. A statistical method was used to determine whether the weather conditions during the air monitoring period were significantly different from that of previous years. Using methyl bromide ambient air monitoring as a case study, this paper documents the methods, procedures, and results of weather analysis for Monterey, Santa Cruz, and Kern Counties during ambient air monitoring periods for methyl bromide in the year 2000. With a few exceptions, the meteorological elements and atmospheric stability factors, such as wind speeds, wind directions, and stability classes, during the monitoring period were in the normal range. Although there were higher frequencies of stable atmospheric conditions in Monterey/Santa Cruz Counties than in Kern County, weather conditions during the monitoring period were not significantly different from normal local weather conditions of previous years. Consequently, the subchronic air concentrations observed during the ambient air monitoring periods for methyl bromide in the year 2000 was taken under typical weather conditions of those areas at that time of the year.     

Analysis of primary fine particle national ambient air quality standard metrics

In accordance with the Clean Air Act, the U.S. Environmental Protection Agency (EPA) is currently reviewing its National Ambient Air Quality Standards for particulate matter, which are required to provide an adequate margin of safety to populations, including susceptible subgroups. Based on the latest scientific, health, and technical information about particle pollution, EPA staff recommends establishing more protective health-based fine particle standards. Since the last standards review, epidemiologic studies have continued to find associations between short-term and long-term exposure to particulate matter and cardiopulmonary morbidity and mortality at current pollution levels. This study analyzed the spatial and temporal variability of fine particulate (PM2.5) monitoring data for the Northeast and the continental United States to assess the protectiveness of various levels, forms, and combinations of 24-hr and annual health-based standards currently recommended by EPA staff and the Clean Air Scientific Advisory Committee. Recommended standards have the potential for modest or substantial increases in protection in the Northeast, ranging from an additional 13-83% of the population of the region who are living in areas not likely to meet new standards and thereby benefiting from compliance with more protective air pollution controls. Within recommended standard ranges, an optimal 24-hr (98th percentile)/annual standard suite occurs at 30/12 microg/m3, providing short- and long-term health protection for a substantial percentage of both Northeast (84%) and U.S. (78%) populations. In addition, the Northeast region will not benefit as widely as the nation as a whole if less stringent standards are selected. Should the 24-hr (98th percentile) standard be set at 35 microg/m3, Northeast and U.S. populations will receive 16-48% and 7-17% less protection than a 30 microg/m3 standard, respectively, depending on the level of the annual standard. A 30/12 microg/m3 standard suite also provides nearly equivalent 24-hr and annual control of PM2.5 distributions across the United States, thereby ensuring a more uniform and consistent level of protection than unmatched or "controlling" and "backstop" standards. This could occur even within EPA staff's recommended range of standard suites, where 22-43% of the monitors in the country could meet a controlling standard but fail to meet the combined backstop standard, resulting in inconsistent short- and long-term protection across the country. An equivalent standards combination of 30/12 microg/m3 would minimize the wide variation of protectiveness of 24-hr and annual PM2.5 concentrations. Furthermore, given recent associations of subdaily exposures and acute adverse health effects, in the absence of a subdaily averaging metric, a stringent 24-hr standard will more effectively control maximum hourly and multihourly peak concentrations than a weaker standard.     

Downstream and Coastal Impacts of Damming and Water Abstraction in Africa

Anthropogenic factors associated with damming and water abstraction, and the resultant environmental pressures, are reviewed in six African river catchments using records and forecasts of climatic, demographic, and land-use change. Changes in the states of the flow regime through catchment drainage systems to the coastal sea are considered in conjunction with climate change and other human-induced pressures. The impacts of these changes on downstream and coastal environments and their communities are described in past, present, and future perspectives. Linkages between the issues and the pressures of damming and water abstraction are appraised and scientific, policy, and management responses proposed aimed at remedying existing and perceived future negative impacts. The study proposes that there is a need to integrate catchment and coastal management to account for the whole water flow regime together with its human dimensions. Management priorities relating to the operation of existing damming and abstraction schemes and planning of future schemes include the following: consideration of ways in which water discharges could be adjusted to provide improvements in downstream and coastal environmental and socioeconomic conditions; addressing the problem of sediment trapping impacting on the sustainability of dam reservoirs; and assessment of downstream and coastal impacts of future schemes in the light of climate change forecasts.