N-nitrosodimethylamine and trihalomethane formation and minimisation in Southeast Queensland drinking water

This study assesses the prevalence of disinfection by-product (DBP) precursors in some Southeast Queensland drinking water sources by conducting formation potential experiments for the four regulated trihalomethanes (THMs), and the potent carcinogen, N-nitrosodimethylamine (NDMA). NDMA formation potentials were consistently low (<5-21 ng/L), and total THM (tTHM) formation potentials were consistently below the Australian Drinking Water Guideline (250 μg/L). NDMA concentration of finished drinking waters was also monitored and found to be <5 ng/L in all cases. The effect of coagulation and advanced oxidation on the formation of NDMA and THMs is also reported. UV/H(2)O(2) pre-treatment was effective in producing water with very low THMs concentrations, and UV irradiation was an effective method for NDMA degradation. H(2)O(2) was not required for the observed NDMA degradation to occur. Coagulation using alum, ferric chloride or poly(diallyldimethylammonium chloride) (polyDADMAC) was ineffective in removing DBPs precursors from the source water studied, irrespective of the low dissolved organic carbon (DOC) and dissolved organic nitrogen (DON) attained. Rather, coagulation with polyDADMAC caused an increase in NDMA formation potential upon chloramination, and all coagulants led to an increased tTHM formation potential upon chlorination due to the high bromide concentration of the source water studied.     

Attribution of Carbon Dioxide Fluxes to Crop Types in a Heterogeneous Agricultural Landscape of Argentina

The increasing proportion of agricultural lands worldwide makes it necessary to intensify the research concerning the carbon exchange at agricultural sites. In order to determine the Net Ecosystem Exchange (NEE) in an agricultural landscape in the province of Buenos Aires, Argentina, we carried out eddy covariance measurements with a flux tower, which was placed between two agricultural fields. Therefore, the measured CO₂ flux represents the accumulated flux from both areas, i.e., from different crop types. We here present an analysis method which attributes the flux to the two crop types. For this analysis, we applied the Hsieh footprint model to identify the contributing source area to the flux measurement. We then applied a multiple regression analysis to calculate the NEE in the growing season 2011/2012 for each field separately. The pronounced differences in the time courses of the CO₂ fluxes in the two fields can be explained by the different sowing times and different growth stages of both cultivations. The time courses furthermore show that the CO₂ uptake of the plants was strongly affected by the drought which lasted from December 2011 to January 2012. For the growth cycle of maize (216 days), the NEE was ?240 g C m^?2 and for the growth cycle of soybean (154 days) ?231 g C m^?2. In order to obtain the NEE of a complete agricultural cycle (from harvest to harvest), we also considered the NEE of autumn and winter 2011. Uncertainties of the spatially partitioned NEE are quantified and discussed.     

Assessing reliable indicators to sewage pollution in coastal soft-bottom communities

Physicochemical characteristics of sediment and benthic communities were studied in the proximity of seven sewage outfalls with differences in flow and wastewater treatment in the Western Mediterranean Sea. Redox potential was the only abiotic parameter which showed a pattern related with distance to outfalls, whereas granulometry, percentage of organic matter, metal concentrations or pH did not show changes related with outfall presence. Benthic community analysis proved to be the most suitable monitoring tool. The results showed that the highest impacted stations corresponded with those closest to outfall with the highest flow and only pre-treatment, whilst a decrease of this tendency was detected in the locations where secondary treatment takes place. Meta-analysis showed a decrease of amphipods and tanaids abundance as well as redox potential, as the indicators with the clearest response to sewage presence.     

A methodology to identify representative configurations of sensors for monitoring soil moisture

Soil moisture is the key link among hydroecological compartments, responding dynamically to sequences of atmospheric processes and management conditions and modulating physical, chemical, and biological processes in the soil. Currently, there are a variety of monitoring techniques to measure, directly or indirectly, the soil moisture. However, some practical issues remain open like the definition a priori of the number, location and depth of the monitoring points, and the impact of failing or poor performance soil moisture sensors. Here, we present a set of techniques, namely Δθ time series, wavelet filtering, and time stability, to identify representative points and monitoring depths through an analysis of hourly soil moisture time series for different configuration of the monitoring network. We used real data from a monitoring network consisting of seven monitoring points, each one with four EC-5 probes (Decagon Devices Inc., Pullman, WA) at 20, 40, 60, and 100?cm. The use of simple time series of Δθ allowed us to assess the spatiotemporal influence of the monitoring points, while the wavelet periodograms allowed us to get insight about the response of the monitoring points at different time scales. Both methods are easy to implement or adapt to specific conditions, being coherent to the results derived from time stability analysis. For our case study, we concluded that we could reallocate 16 sensors (out of 28) without a significant loss of information. However, the final decision strongly relies on a deep knowledge of the site features and the objectives of the monitoring network.     

The spatial statistics formalism applied to mapping electromagnetic radiation in urban areas

Determining the electromagnetic radiation levels in urban areas is a complicated task. Various approaches have been taken, including numerical simulations using different models of propagation, sampling campaigns to measure field values with which to validate theoretical models, and the formalism of spatial statistics. In the work, we present here that this latter technique was used to construct maps of electric field and its associated uncertainty from experimental data. For this purpose, a field meter and a broadband probe sensitive in the 100-kHz–3-GHz frequency range were used to take 1,020 measurements around buildings and along the perimeter of the area. The distance between sampling points was 5 m. The results were stored in a geographic information system to facilitate data handling and analysis, in particular, the application of the formalism of spatial statistical to the analysis of the distribution of the field levels over the study area. The spatial structure was analyzed using the variographic technique, with the field levels at non-sampled points being interpolated by kriging. The results indicated that, in the urban area analyzed in the present work, the linear density of sampling points could be reduced to a distance which coincides with the length of the blocks of buildings without the statistical parameters varying significantly and with the field level maps being reproduced qualitatively and quantitatively.     

Fast simultaneous determination of traces of Cu(II) and Co(II) in soils and sediments with the luminol/perborate chemiluminescent system

A flow injection analysis method based on ion chromatography and luminol chemiluminescence detection was used for the simultaneous determination of copper (II) and cobalt (II) trace levels in soils and sediments following microwave-assisted acid digestion. Detection was based on chemiluminescence (CL) of the luminol–perborate system in an alkaline medium, which is catalyzed by both transition metals. The concentration and pH of the eluent (oxalic acid) was found to affect CL intensities and retention times, both of which were inversely proportional to the oxalic acid concentration. The calibration curves for both metal ions were linear and allowed a limit of detection of 0.003 μg l^?1 for cobalt (II) and 0.014 μg l^?1 for cooper (II) to be calculated. The proposed method was successfully used to determine both metal ions in certified reference materials of stream and river sediments and soil samples. Based on the results, the determination is free of interferences from the usual concomitant ions.     

Rate of occurrence of failures based on a nonhomogeneous Poisson process: an ozone analyzer case study

Atmospheric pollutant monitoring constitutes a primordial activity in public policies concerning air quality. In São Paulo State, Brazil, the São Paulo State Environment Company (CETESB) maintains an automatic network which continuously monitors CO, SO₂, NO _x , O₃, and particulate matter concentrations in the air. The monitoring process accuracy is a fundamental condition for the actions to be taken by CETESB. As one of the support systems, a preventive maintenance program for the different analyzers used is part of the data quality strategy. Knowledge of the behavior of analyzer failure times could help optimize the program. To achieve this goal, the failure times of an ozone analyzer—considered a repairable system—were modeled by means of the nonhomogeneous Poisson process. The rate of occurrence of failures (ROCOF) was estimated for the intervals 0–70,800 h and 0–88,320 h, in which six and seven failures were observed, respectively. The results showed that the ROCOF estimate is influenced by the choice of the observation period, t ₀?=?70,800 h and t ₇?=?88,320 h in the cases analyzed. Identification of preventive maintenance actions, mainly when parts replacement occurs in the last interval of observation, is highlighted, justifying the alteration in the behavior of the inter-arrival times. The performance of a follow-up on each analyzer is recommended in order to record the impact of the performed preventive maintenance program on the enhancement of its useful life.     

Assessment of potential health risk for inhabitants living near a former lead smelter. Part 1: metal concentrations in soils, agricultural crops, and homegrown vegetables

Soil contamination by metals engenders important environmental and health problems in northern France where a smelter (Metaleurop Nord) was in activity for more than a century. This study aims to look at the long-term effects of the smelter after its closedown by combining data on the degree of soil contamination and the quality of the crops grown (agricultural crops and homegrown vegetables) in these soils for a better assessment of the local population’s exposure to Cd, Pb, and Zn. Seven years after the Metaleurop Nord closedown, (1) the agricultural and urban topsoils were strongly contaminated by Cd, Pb, and Zn; (2) the kitchen garden topsoils were even more polluted than the agricultural soils, with great variability in metal concentrations within the gardens studied; (3) a high proportion of the agricultural crops for foodstuffs did not conform with the European legislation; (4) for feedstuffs, most samples did not exceed the Cd and Pb legislation limits, indicating that feedstuffs may be an opportunity for most agricultural produce; and (5) a high proportion of the vegetables produced in the kitchen gardens did not conform with the European foodstuff legislation. The high contamination level of the soils studied continues to be a risk for the environment and the population’s health. A further investigation (part 2) assesses the associated potential health risk for local inhabitants through consumption of homegrown vegetables and ingestion of soil particles by estimating the site-specific human health assessment criteria for Cd and Pb.     

DDT, DDE, and 1-hydroxypyrene levels in children (in blood and urine samples) from Chiapas and Oaxaca, Mexico

The aim of this study was to evaluate the DDT, DDE, and 1-hydroxypyrene exposure levels of children living in communities located in southeastern Mexico. The study communities were Lacanja and Victoria in Chiapas state and Ventanilla in Oaxaca state. Children living in Lacanja had total blood DDT levels (mean?±?SD, 29,039.6?±?11,261.4 ng/g lipid) that were significantly higher than those of children in Victoria (10,220.5?±?7,893.1 ng/g lipid) and Ventanilla (11,659.7?±?6,683.7 ng/g lipid). With respect to the 1-hydroxypyrene levels in urine samples, the levels in Lacanja (4.8?±?4.1 μg/L or 4.5?±?3.9 μmol/mol creatinine) and Victoria (4.6?±?3.8 μg/L or 3.9?±?3.0 μmol/mol Cr) were significantly higher than levels found in Ventanilla (3.6?±?1.4 μg/L or 2.5?±?0.5 μmol/mol Cr). In conclusion, our data indicate high levels of exposure in children living in the communities studied in this work. The evidence found in this study could be further used as a trigger to revisit local policies on environmental exposures.