Factors Influencing the Emissions of Nitrated-Polynuclear Aromatic Hydrocarbons(Nitro-PAH) from Diesel Engines

The potential problem of 1-nitropyrene (1-NP) formation during filter sampling of diesel emissions from dilution tubes is assessed. Rates of formation are calculated using data generated from several independent filter exposure studies. A portion of the 1-NP (12% average) found in participates collected from light-duty (LDD) and heavy-duty diesels (HOD) was found to be due to formation on the filter under average sampling conditions of 10-15/1 dilution at 44°C with 3 ppm NO₂ for 23 min. On the average, the concentration of 1-NP in participates emitted from HDD is 16 times less than that found in LDD run under similiar transient conditions. The average emission rate of 1-NP generated from the LDD and HDD was 4.7 μg/km and 1.5 μg/km, respectively for the vehicles operating under Federal Test Procedure (FTP)-transient conditions. Under operating conditions which increase exhaust temperature (increased speed and load), the concentration of nitro-PAH is significantly reduced with a concurrent increase in the concentration of partially oxidized nitro-PAH and dinitro-PAH. The concentration of 1-NP in the particulates measured from HDD in these dilution tube studies (0.33-0.95 ppm, depending upon engine load) is comparable to that measured in highway tunnel experiments (0.54 ppm average).     

An Assessment of the Economic Effects of Ozone on U.S. Agriculture

Past attempts to measure the economic consequences of ozone on agriculture have been based on limited plant science information. This paper reports on an economic assessment of ozone on U.S. agriculture using recent crop response data from the National Crop Loss Assessment Network (NCLAN). The results are derived from a U.S. agricultural sector model that includes major crop and livestock production as well as domestic consumption, livestock feeding and export uses. The economic effects of four hypothetical ambient ozone levels are investigated. The analysis Indicates that the benefits to society of moderate (25%) ozone reductions are approximately $1.7 billion. A 25% Increase in ozone pollution results in costs (negative benefits) of $2.1 billion. These estimates do not reflect compliance costs of achieving the ozone changes and hence are not net benefits.     

Evaluation of Selected Gaseous Halocarbons for Use in source Test Performance Audits

A repository of 38 gaseous organic compounds in compressed gas cylinders has been established by EPA. This repository was established to provide standards for source test performance audits, that is, quantitative quality assurance tests. Among these compounds are ten halogenated organic species, which are the focus of this paper.

Stability studies of all ten compounds have been performed to determine the feasibility of using them as performance audit standards. Results indicate that all of the halocarbons tested are adequately stable to be used as reliable audit standards.

Subsequent to completion of stability studies, four of the ten halocarbons were used in source test performance audits. Results are available at this time for two of the four compounds; the results show agreement within 10% of the concentrations previously established by Research Triangle Institute.     

Environmental Auditing—A Timely and Effective Tool

The requirements of environmental regulations imposed on industry are complex and expensive. As these regulations have developed, corporate compliance programs have had to become more sophisticated. For many, this means that an environmental auditing program is now timely (or overdue) for organizing their approach to meeting the constraints of these regulations. Contributing to this timeliness is a renewed emphasis by regulators on enforcement activities. This paper discusses what environmental auditing is and what it consists of, gives examples from a few approaches which are currently being used, and reviews some of its benefits and liabilities.     

Relationship of Destruction Parameters to the Destruction/Removal Efficiency of PCBs

The destruction/removal efficiency (DRE), and the ability to accurately measure it, is a function of the concentration of the chemical compound in the input waste, the incinerator design and operation, sampling methods, and the analytical procedures. All of these are interrelated. This paper discusses the basic DRE equation [DRE = W_In W_out)/W_in × 100] and how it relates to some of the other destruction parameters. Some example data from the literature are presented. While PCBs have been used as the example, the equations and graphs are equally valid for some other hazardous compounds (POHCs), with the substitution of the 99.99% DRE requirement in lieu of the 99.9999% DRE for PCBs. The use of the relationships discussed in this paper should allow incinerator operators to more efficiently plan demonstration test burns which will adequately demonstrate the DRE.     

A Survey of Nitrogen Dioxide Levels Measured Inside Mobile Homes

As part of the California Mobile Home Study, over 250 mobile homes from throughout the state were monitored for nitrogen dioxide (NO₂) concentrations. Week-long average measurements were taken with Palmes tubes in the kitchen and bedroom of each mobile home during the summer of 1984 and the winter of 1985. The study was conducted entirely by mail with the participants providing all the necessary information. Mobile homes using gas for cooking had significantly higher indoor NO₂ levels than those using electricity. Mobile homes located in the Los Angeles basin had significantly higher indoor NO₂ concentrations than did mobile homes in the rest of the state. Gas cooking, the inverse of the house volume and geographic location (as a surrogate of outdoor NO₂) were the most important variables identified by multiple linear regression.     

An Evaluation of the Semi-VOST Method for Determining Emissions from Hazardous Waste Incinerators

The Semi-Volatile Organic Sampling Train method was investigated to determine its reliability and to determine the bias and precision of the method when used to determine emissions from hazardous waste incinerators. Experiments showed that the matrix and sampling variables usually involved in sampling emissions from a hazardous waste incinerator had no significant effect on the recovery of 11 different organic compounds. Significant losses of the sampled compounds can occur during sample preparation. The degree of loss appears to be directly related to the compounds, vapor pressure. These losses can be corrected for by adding deuterated surrogates to the sample and analyzing the surrogates along with the native compounds.

The bias determination was based on dynamic spiking of the sampling train with five deuterated organic compounds selected from Appendix VIII of the Resource Conservation and Recovery Act regulations. The results show biases of from -1 ± 8 percent to -18 ± 27 percent for chlorinated and nonchlorinated compounds. Pyridine, a water-soluble compound, showed a larger bias of-29 ± 13 percent. Particular attention to the recovery of water soluble compounds is necessary to minimize bias in their determinations. Further work is needed to determine the reliability of laboratory-determined retention volumes that are used to determine sampling conditions.     

Predicting and Managing the Health Risks of Sour-Gas Wells

The development of sour-gas resources in Canada and the United States has prompted concerns about the public health risks of accidental releases of gas contaminated with hydrogen sulfide (H₂S) from wells. This paper focuses on methods for improving the prediction and management of those risks. Data associated with the health effects of hydrogen sulfide are examined, and it is suggested that sublethal effects should be addressed in risk assessments of sour-gas wells along with the life-threatening effects normally considered. The demarcation of hazard zones around wells can be improved by using a statistical approach for estimating an upper-bound H₂S release rate; this rate can then be used in an atmospheric dispersion model to estimate maximum distances to downwind concentrations for lethal (300 ppmv) and sublethal (50 ppmv) effects resulting from an accidental release. A vertical release is found to have little impact, especially under stable atmospheric conditions; horizontal releases, on the other hand, result in the greatest downwind distances for health impacts. Management of health risks depends on a mix of safety technologies and contingency actions, such as well-ignition options and provision for post-release monitoring and assessment of ambient H₂S concentrations.     

Use of Energy Scenarios in Addressing the CO2 Question

A reference scenario for CO₂ emissions was developed using a model of world energy supply and demand. In the reference scenario, world GNP and world energy demand increase at average rates of 2.1 percent per year and 1.5 percent per year, respectively during the period 1975-2100. The corresponding annual CO₂ emissions rise to a maximum of 16 gigatons of carbon around 2050 and then decline as a result of a transition to nonfossil fuel energy systems. A modified scenario for high CO₂ emissions was obtained by assuming an abundant supply of low cost coal, thus eliminating the transition. A low case was developed in which the low cost of alternative energy (i.e., solar, nuclear) induces an earlier shift away from fossil fuels.

Annual emissions of the three scenarios were used as input to a global carbon cycle model and the CO₂ buildup in the atmosphere during the period 1980-2100 was determined by the model. All three scenarios showed continuous rises in atmospheric CO₂ concentration. The reference scenario reached 775 ppm by 2100. The high CO₂ case resulted in concentrations of over 1040 ppm, and for the low case the 2100 concentration was just under 700 ppm. If the climate theory is correct, even 700 ppm is sufficient to give significant climate warming, but by experiencing the change gradually over a century, adaptation may not be painful. An early transition to nonfossil fuel supplies makes the problem less severe but does not eliminate it.