Influence of organic waste type and soil structure on the bacterial filtration rates in unsaturated intact soil columns

Organic wastes are considered to be a source for the potentially pathogenic microorganisms found in surface and sub-surface water resources. Following their release from the organic waste matrix, bacteria often infiltrate into soil and may be transported to significant depths contaminating aquifers. We investigated the influence of soil texture and structure and most importantly the organic waste properties on the transport and filtration coefficients of Escherichia coli and total bacteria in undisturbed soil columns. Intact soil columns (diameter 16 cm and height 25 cm) were collected from two soils: sandy clay loam (SCL) and loamy sand (LS) in Hamadan, western Iran. The cores were amended with cow manure, poultry manure and sewage sludge at a rate of 10 Mg ha(-1) (dry basis). The amended soil cores were leached at a steady-state flux of 4.8 cm h(-1) (i.e. 0.12 of saturated hydraulic conductivity of the SCL) to a total volume of up to 4 times the pore volume of the columns. The influent (C(0)) and effluent (C) were sampled at similar time intervals during the experiments and bacterial concentrations were measured by the plate count method. Cumulative numbers of the leached bacteria, filtration coefficient (lambda(f)), and relative adsorption index (S(R)) were calculated. The preferential pathways and stable structure of the SCL facilitated the rapid transport and early appearance of the bacteria in the effluent. The LS filtered more bacteria when compared with the SCL. The effluent contamination of poultry manure-treated columns was greater than the cow manure- and sewage sludge-treated ones. The difference between cow manure and sewage sludge was negligible. The lambda(f) and S(R) values for E. coli and total bacteria were greater in the LS than in the SCL. This indicates a predominant role for the physical pore-obstruction filtration mechanisms as present in the poorly structured LS vs. the retention at adsorptive sites (chemical filtration) more likely in the better structured SCL. While the results confirmed the significant role of soil structure and preferential (macroporous) pathways, manure type was proven to have a major role in determining the maximum penetration risk of bacteria by governing filtration of bacteria. Thus while the numbers of bacteria in waste may be of significance for shallow aquifers, the type of waste may determine the risk for microbial contamination of deep aquifers.     

Evaluation of the aggressive potential of marine chloride and sulfate salts on mortars applied as renders in the Metropolitan Region of Salvador--Bahia, Brazil

In recent years, growing interest has focused on determining the performance of materials and evaluating the service life of structures exposed to various environmental forces. In this context, the determination of the aggressive potential of marine salts on mortars used as external renders is critical. The present study aimed to evaluate the spatial distribution of marine salts relative to distance from the sea. This was done by monitoring the deposition rate of chlorides and sulfates in wet candle sensors, located at nine stations scattered around the Metropolitan Region of Salvador, state of Bahia, Brazil. The study also determined the effectiveness of water-soluble salts at penetrating three different types of mortars of varying cement content via deposition and diffusion. The methodology employed enabled an evaluation of the efficiency of the monitoring sensors' measurement of the aggressiveness potential of local marine aerosol, and determination of the comparative performance of the three mortars tested, from the standpoint of resistance to salt penetration. The type and amount of salts captured both in solution and in powder samples extracted from the mortars were determined by ion chromatography. The analysis of the various types of mortars tested indicated which types are more resistant to the aggressive potential of the region's marine aerosol and the distance from the shore where local buildings are liable to be most strongly affected.     

Conceptual issues in designing a policy to phase out metal-based antifouling paints on recreational boats in San Diego Bay

In marine areas throughout the world where recreational boats are densely located, concentrations of copper in the water are being found to be in excess of government standards, due to the hull coatings used on these boats. Copper-based hull coatings are intended to be antifouling in that they retard the growth of algae, barnacles and tubeworms; but alternatives exist that can eliminate the harm that copper contamination does to marine organisms. A variety of policy options are available to mandate or provide economic incentives to switch to these less harmful alternatives. This paper puts forth a conceptual framework for thinking about how to design and evaluate alternative policies to transition to nontoxic boat hulls, drawing from the authors' experience designing a policy for use in San Diego Bay. Many of the issues raised are broadly applicable to environmental problems where the solution involves a large-scale replacement of durable consumer goods.     

Prediction of the Fate and Transport Processes of Atrazine in a Reservoir

The fate and transport processes of a toxic chemical such as atrazine, an herbicide, in a reservoir are significantly influenced by hydrodynamic regimes of the reservoir. The two-dimensional (2D) laterally-integrated hydrodynamics and mass transport model, CE-QUAL-W2, was enhanced by incorporating a submodel for toxic contaminants and applied to Saylorville Reservoir, Iowa. The submodel describes the physical, chemical, and biological processes and predicts unsteady vertical and longitudinal distributions of a toxic chemical. The simulation results from the enhanced 2D reservoir model were validated by measured temperatures and atrazine concentrations in the reservoir. Although a strong thermal stratification was not identified from both observed and predicted water temperatures, the spatial variation of atrazine concentrations was largely affected by seasonal flow circulation patterns in the reservoir. In particular, the results showed the effect of flow circulation on spatial distribution of atrazine during summer months as the river flow formed an underflow within the reservoir and resulted in greater concentrations near the surface of the reservoir. Atrazine concentrations in the reservoir peaked around the end of May and early June. A good agreement between predicted and observed times and magnitudes of peak concentrations was obtained. The use of time-variable decay rates of atrazine led to more accurate prediction of atrazine concentrations, while the use of a constant half-life (60 days) over the entire period resulted in a 40% overestimation of peak concentrations. The results provide a better understanding of the fate and transport of atrazine in the reservoir and information useful in the development of reservoir operation strategies with respect to timing, amount, and depth of withdrawal.     

The Effect of Water Harvesting Techniques on Runoff,Sedimentation, and Soil Properties

This study addressed the hydrological processes of runoff and sedimentation, soil moisture content, and properties under the effect of different water harvesting techniques (treatments). The study was conducted at three sites, representing environmental condition gradients, located in the southern part of the West Bank. For each treatment, the study evaluated soil chemical and physical properties, soil moisture at 30 cm depth, surface runoff and sedimentation at each site. Results showed that runoff is reduced by 65–85% and sedimentation by 58–69% in stone terraces and semi-circle bunds compared to the control at the semi-humid site. In addition, stone terraces and contour ridges significantly reduced the amount of total runoff by 80% and 73%, respectively, at the arid site. Soil moisture content was significantly increased by water harvesting techniques compared to the control in all treatments at the three study sites. In addition, the difference between the control and the water harvesting structures were higher in the arid and semi-arid areas than in the semi-humid area. Soil and water conservation, via utilization of water harvesting structures, is an effective principle for reducing the negative impact of high runoff intensity and subsequently increasing soil moisture storage from rainfall. Jessour systems in the valley and stone terraces were effective in increasing soil moisture storage, prolonging the growing season for natural vegetation, and decreasing the amount of supplemental irrigation required for growing fruit trees.     

Diversity of Soil Nematodes in Areas Polluted with Heavy Metals and Polycyclic Aromatic Hydrocarbons (PAHs) in Lanzhou,China

This study investigated the soil nematode community structure along the Yellow River in the Lanzhou area of China, and analyzed the impact of heavy metals (Cd, Pb, Cr, Cu, and Zn) and polycyclic aromatic hydrocarbons (PAHs) on the nematode community. Soil samples from five locations (named A–E), which were chosen for soil analysis, showed significant differences in their heavy metal content (p < 0.01), as well as in the variety of nematodes (up to 41 genera) and families (up to 20) that were present. The different samples also differed significantly in the total PAH content (p < 0.05), as well as the six types of PAH present. Sites A–C showed the most severe contamination with heavy metals and PAHs; these sites had the lowest abundance of fungivores and omnivore/predators, but the proportion of bacteriovores was the highest (p < 0.05). Site E, in contrast, showed only minor pollution with heavy metals and PAHs, and it contained the highest abundance of plant parasites (p < 0.05). Several nematode ecological indicators were found to correlate with concentration of soil pollutants at all the sites tested: the maturity index (MI, in addition to plant parasites), plant parasite index (PPI), ΣMI (including all the soil nematodes), Shannon-Wiener diversity index (H′′), and Wasilewska index (WI). Disturbance to the soil environment was more severe when MI, ΣMI, and H′ values were lower. The results of the study show that the abundance and structure of the soil nematode communities in the sampling locations were strongly influenced by levels of heavy metals and PAHs in the soil. They also show that the diversity index H′ and the maturity index can be valuable tools for assessing the impact of pollutants on nematodes.     

Increasing exfiltration from pervious concrete and temperature monitoring

Pervious concrete typically has an infiltration rate far exceeding any expectation of precipitation rate. The limiting factor of a retention based pervious concrete system is often defined by how quickly the underlying soil subgrade will infiltrate the water temporarily stored within the concrete and/or aggregate base. This issue is of particular importance when placing a pervious concrete system on compacted fine textured soils. This research describes the exfiltration from twelve pervious concrete plots constructed on a compacted clay soil in eastern Tennessee, USA. Several types of treatments were applied to the clay soil prior to placement of the stone aggregate base and pervious concrete in an attempt to increase the exfiltration rate, including: 1) control – no treatment; 2) trenched – soil trenched and backfilled with stone aggregate; 3) ripped – soil ripped with a subsoiler; and 4) boreholes – placement of shallow boreholes backfilled with sand. The average exfiltration rates were 0.8 cm d⁻¹ (control), 4.6 cm d⁻¹ (borehole), 10.0 cm d⁻¹ (ripped), and 25.8 cm d⁻¹ (trenched). The trenched treatment exfiltrated fastest, followed by the ripped and then the borehole treatments, although the ripped and borehole treatments were not different from one another at the 5% level of significance. The internal temperature of the pervious concrete and aggregate base was monitored throughout the winter of 2006–2007. Although the temperature of the pervious concrete dropped below freezing 24 times, freezing concrete temperatures never coincided with free water being present in the large pervious concrete pores. The coldest recorded air temperature was −9.9 °C, and the corresponding coldest recorded pervious concrete temperature was −7.1 °C. The temperature of the pervious concrete lagged diurnal air temperature changes and was generally buffered in amplitude, particularly when free water was present since the addition of water increases the thermal capacity of the pervious concrete greatly. The temperature of the aggregate base was further buffered to diurnal changes, and no freezing temperatures were recorded.     

Balancing Conservation and Economic Sustainability: The Future of the Amazon Timber Industry

Logging has been a much maligned feature of frontier development in the Amazon. Most discussions ignore the fact that logging can be part of a renewable, environmentally benign, and broadly equitable economic activity in these remote places. We estimate there to be some 4.5 ± 1.35 billion m³ of commercial timber volume in the Brazilian Amazon today, of which 1.2 billion m³ is currently profitable to harvest, with a total potential stumpage value of $15.4 billion. A successful forest sector in the Brazilian Amazon will integrate timber harvesting on private lands and on unprotected and unsettled government lands with timber concessions on public lands. If a legal, productive, timber industry can be established outside of protected areas, it will deliver environmental benefits in synergy with those provided by the region’s network of protected areas, the latter of which we estimate to have an opportunity cost from lost timber revenues of $2.3 billion over 30 years. Indeed, on all land accessible to harvesting, the timber industry could produce an average of more than 16 million m³ per year over a 30-year harvest cycle—entirely outside of current protected areas—providing $4.8 billion in returns to landowners and generating $1.8 billion in sawnwood sales tax revenue. This level of harvest could be profitably complemented with an additional 10% from logging concessions on National Forests. This advance, however, should be realized only through widespread adoption of reduced impact logging techniques.     

Sustainability Assessment for Agriculture Scenarios in Europe’s Mountain Areas: Lessons from Six Study Areas

Sustainability assessment (SA) is a holistic and long-range strategic instrument capable of assisting policy-making in electing, and deciding upon, future development priorities. The outcomes of an SA process become more relevant and strengthened when conducted with multi-stakeholder engagement, which provides for multiple dialogues and perspectives. This was the object of research of the SA team in the context of BioScene (Scenarios for Reconciling Biodiversity Conservation with Declining Agriculture Use in Mountain Areas in Europe), a three-year project (2002–2005) funded by the European Union 5th Framework Program, which aimed to investigate the implications of agricultural restructuring and decline for biodiversity conservation in the mountain areas of Europe, using three distinct methodological streams: the ecological, the socio-economic, and the SA approaches. The SA approach drew on the previous two to assess the importance for biodiversity management of different scenarios of agri-environmental change and rural policy in six countries (France, Greece, Norway, Slovakia, Switzerland, and the United Kingdom), develop causal chains, include stakeholder views, and identify potential contributions for, or conflicts with, sustainability. This article tells how SA was used, what sustainability meant in each study area through different objectives of sustainability considered, discusses the methods used in SA, and the benefits arising. The SA was conducted by a team independent of any study area, who developed and oversaw the application of the SA methodology, assisting national teams, and developing a cross-country understanding of the sustainability of proposed scenarios in the different geographical and social contexts, and their implications for policy-making. Finally, it reflects on the persistent challenges of interdisciplinary research, compounded by multi-cultural teams, and concludes on the BioScene’s lessons for the further development and application of SA.

Vulnerability of Rehabilitated Agricultural Production Systems to Invasion by Nontarget Plant Species

Vast areas of arable land have been retired from crop production and “rehabilitated” to improved system states through landowner incentive programs in the United States (e.g., Conservation and Wetland Reserve Programs), as well as Europe (i.e., Agri-Environment Schemes). Our review of studies conducted on invasion of rehabilitated agricultural production systems by nontarget species elucidates several factors that may increase the vulnerability of these systems to invasion. These systems often exist in highly fragmented and agriculturally dominated landscapes, where propagule sources of target species for colonization may be limited, and are established under conditions where legacies of past disturbance persist and prevent target species from persisting. Furthermore, rehabilitation approaches often do not include or successfully attain all target species or historical ecological processes (e.g., hydrology, grazing, and/or fire cycles) key to resisting invasion. Uncertainty surrounds ways in which nontarget species may compromise long term goals of improving biodiversity and ecosystem services through rehabilitation efforts on former agricultural production lands. This review demonstrates that more studies are needed on the extent and ecological impacts of nontarget species as related to the goals of rehabilitation efforts to secure current and future environmental benefits arising from this widespread conservation practice.