Nutrient leaching in a Colombian savanna Oxisol amended with biochar

Nutrient leaching in highly weathered tropical soils often poses a challenge for crop production. We investigated the effects of applying 20 t ha biochar (BC) to a Colombian savanna Oxisol on soil hydrology and nutrient leaching in field experiments. Measurements were made over the third and fourth years after a single BC application. Nutrient contents in the soil solution were measured under one maize and one soybean crop each year that were routinely fertilized with mineral fertilizers. Leaching by unsaturated water flux was calculated using soil solution sampled with suction cup lysimeters and water flux estimates generated by the model HYDRUS 1-D. No significant difference ( > 0.05) was observed in surface-saturated hydraulic conductivity or soil water retention curves, resulting in no relevant changes in water percolation after BC additions in the studied soils. However, due to differences in soil solution concentrations, leaching of inorganic N, Ca, Mg, and K measured up to a depth of 0.6 m increased ( < 0.05), whereas P leaching decreased, and leaching of all nutrients (except P) at a depth of 1.2 m was significantly reduced with BC application. Changes in leaching at 2.0 m depth with BC additions were about one order of magnitude lower than at other depths, except for P. Biochar applications increased soil solution concentrations and downward movement of nutrients in the root zone and decreased leaching of Ca, Mg, and Sr at 1.2 m, possibly by a combination of retention and crop nutrient uptake.     

Usability of non-standard lower anchor configurations for child restraint system (CRS) installation

Abstract

Objectives: The objective of this study was to determine whether the amount of tension required for proper child restraint system (CRS) installation varies with lower anchor spacing and to determine whether nonexperts can produce adequate tension on wider-than-standard lower anchor configurations.

Methods: CRSs were installed by certified child passenger safety technicians (CPSTs; n?=?6 subjects, n?=?72 installations) and nonexperts (n?=?30 subjects, n?=?120 installations) on a mock-up vehicle seat fixture with lower anchors set at 11 (standard), 15, 19, and 23 in. apart from one another. Each CPST installed a rear-facing (RF) infant base, RF convertible, and forward-facing (FF) convertible into each of the 4 spacing configurations in random order. The CPSTs were instructed to tighten the lower connector strap until the tension was exactly at the threshold between passing and failing the 1-in. test. Each nonexpert installed one CRS model into all 4 spacing conditions in random order. Nonexperts were instructed to install the CRS to the best of their ability. The tension produced on the lower connector strap was recorded via load cell in the lower anchor assembly of the vehicle seat. Resultant tension magnitudes were compared across spacing conditions using matched pair t-tests. The CPSTs’ mean 1-in. test threshold values were compared to tensions produced by nonexperts. Installations were visually evaluated for errors and qualitative usability feedback was collected via survey.

Results: CPSTs installed the infant base with higher tensions in the 15-, 19-, and 23-in. configurations compared to the standard 11-in. configuration (P = .034, .032, and .003, respectively). The nonexperts installed the infant base with higher tension in the 15- and 23-in. configurations compared to the 11-in. configuration (P = .004 and .026, respectively). The RF convertible and FF convertible installations showed no significant differences in tension among any of the spacing configurations for either group. Only 19% of the nonexperts’ installations were tight enough to pass CPST thresholds, and the pass rate did not vary with respect to lower anchor spacing. In feedback surveys, the nonexpert group did not show a consistent preference for either standard or wider-than-standard lower anchor configurations.

Conclusions: The amount of tension required to pass the 1-in. rule did not vary with lower anchor spacing configurations for the RF and FF convertible CRS, but the infant base required more tension in wider anchor configurations. Nonexperts tended to produce less than ideal tension in all configurations, although their tension magnitudes increased for the infant base in wider configurations.     

Elevated carbon dioxide does not offset loss of soil carbon from a corn-soybean agroecosystem

The potential for storing additional C in U.S. Corn Belt soils - to offset rising atmospheric [CO₂] - is large. Long-term cultivation has depleted substantial soil organic matter (SOM) stocks that once existed in the region's native ecosystems. In central Illinois, free-air CO₂ enrichment technology was used to investigate the effects of elevated [CO₂] on SOM pools in a conservation tilled corn-soybean rotation. After 5 and 6 y of CO₂ enrichment, we investigated the distribution of C and N among soil fractions with varying ability to protect SOM from rapid decomposition. None of the isolated C or N pools, or bulk-soil C or N, was affected by CO₂ treatment. However, the site has lost soil C and N, largely from unprotected pools, regardless of CO₂ treatment since the experiment began. These findings suggest management practices have affected soil C and N stocks and dynamics more than the increased inputs from CO₂-stimulated photosynthesis.     

Survey of polyfluorinated chemicals (PFCs) in the atmosphere over the northeast Atlantic Ocean

High volume air sampling in Bermuda, Sable Island (Nova Scotia) and along a cruise track from the Gulf of Mexico to northeast coast of the USA, was carried out to assess air concentrations, particle-gas partitioning and transport of polyfluorinated chemicals (PFCs) in this region. Samples were collected in the summer of 2007. Targeted compounds included the neutral PFCs: fluorotelomer alcohols (FTOHs), perfluoroalkyl sulfonamides (FOSAs) and perfluoroalkyl sulfonamido ethanols (FOSEs).Among the FTOHs, 8:2 FTOH was dominant in all samples. Sum of the concentration of FTOHs (gas+particle phase) were higher in Bermuda (mean, 34 pg m^?3) compared to Sable Island (mean, 16 pg m^?3). In cruise samples, sum of FTOHs were highly variable (mean, 81 pg m^?3) reflecting contributions from land-based sources in the northeast USA with concentrations reaching as high as 156 pg m^?3.Among the FOSAs and FOSEs, MeFOSE was dominant in all samples. In Bermuda, levels of MeFOSE were exceptionally high (mean, 62 pg m^?3), exceeding the FTOHs. Sable Island samples also exhibited the dominance of MeFOSE but at a lower concentration (mean, 15 pg m^?3). MeFOSE air concentrations (pg m^?3) in cruise samples ranged from 1.6 to 73 and were not linked to land-based sources. In fact high concentrations of MeFOSE observed in Bermuda were associated with air masses that originated over the Atlantic Ocean.The partitioning to particles for 8:2 FTOH, 10:2 FTOH, MeFOSE and EtFOSE ranged from as high as 15 to 42% for cruise samples to 0.9 to 14% in Bermuda. This study provides key information for validating and developing partitioning and transport models for the PFCs.     

Effect of dibenzopyrene measurement on assessing air quality in Beijing air and possible implications for human health

Size fractionated particulate matter (PM) was collected in summer and winter from Beijing, China for the characterization of an expanded list of PAHs and evaluation of air pollution metrics. Summertime ΣPAHs on PM was 14.6 ± 29(PM 1.5), 0.88 ± 0.49(PM 1.5-7.2) and 0.29 ± 0.076(PM 7.2) ng m(-3) air while wintertime concentrations were 493 ± 206(PM 1.5), 26.7 ± 14(PM 1.5-7.2) and 5.3 ± 2.5(PM 7.2) ng m(-3) air. Greater than 90% of the carcinogenic PAHs were concentrated on PM(1.5). Dibenzopyrene isomers made up a significant portion (～30%) of the total carcinogenic PAH load during the winter. To our knowledge, this is the first report of dibenzopyrenes in the Beijing atmosphere and among the few studies that report these highly potent PAHs in ambient particulate matter. Lifetime risk calculations indicated that 1 out of 10,000 to over 6 out of 100 Beijing residents may have an increased risk of lung cancer due to PAH concentration. Over half of the lifetime risk was attributed to Σdibenzopyrenes. The World Health Organization and Chinese daily PM(10) standard was exceeded on each day of the study, however, PAH limits were only exceeded during the winter. The outcomes of the air pollution metrics were highly dependent on the individual PAHs measured and seasonal variation.     

Adverse birth outcomes in the vicinity of industrial installations in Spain 2004–2008

Industrial activity is one of the main sources of ambient pollution in developed countries. However, research analyzing its effect on birth outcomes is inconclusive. We analyzed the association between proximity of mother’s municipality of residence to industries from 24 different activity groups and risk of very (VPTB) and moderate (MPTB) preterm birth, very (VLBW) and moderate (MLBW) low birth weight, and small for gestational age (SGA) in Spain, 2004–2008. An ecological study was defined, and a “near vs. far” analysis (3.5 km threshold) was carried out using Hierarchical Bayesian models implemented via Integrated Nested Laplace Approximation. VPTB risk was higher for mothers living near pharmaceutical companies. Proximity to galvanization and hazardous waste management industries increased the risk of MPTB. Risk of VLBW was higher for mothers residing near pharmaceutical and non-hazardous or animal waste management industries. For MLBW many associations were found, being notable the proximity to mining, biocides and animal waste management plants. The strongest association for SGA was found with proximity to management animal waste plants. These results highlight the importance of further research on the relationship between proximity to industrial sites and the occurrence of adverse birth outcomes especially for the case of pharmaceutical and animal waste management activities.     

Review of LCA studies of solid waste management systems – Part I: Lessons learned and perspectives

The continuously increasing solid waste generation worldwide calls for management strategies that integrate concerns for environmental sustainability. By quantifying environmental impacts of systems, life cycle assessment (LCA) is a tool, which can contribute to answer that call. But how, where and to which extent has it been applied to solid waste management systems (SWMSs) until now, and which lessons can be learnt from the findings of these LCA applications? To address these questions, we performed a critical review of 222 published LCA studies of SWMS. We first analysed the geographic distribution and found that the published studies have primarily been concentrated in Europe with little application in developing countries. In terms of technological coverage, they have largely overlooked application of LCA to waste prevention activities and to relevant waste types apart from household waste, e.g. construction and demolition waste. Waste management practitioners are thus encouraged to abridge these gaps in future applications of LCA. In addition to this contextual analysis, we also evaluated the findings of selected studies of good quality and found that there is little agreement in the conclusions among them. The strong dependence of each SWMS on local conditions, such as waste composition or energy system, prevents a meaningful generalisation of the LCA results as we find it in the waste hierarchy. We therefore recommend stakeholders in solid waste management to regard LCA as a tool, which, by its ability of capturing the local specific conditions in the modelling of environmental impacts and benefits of a SWMS, allows identifying critical problems and proposing improvement options adapted to the local specificities.     

Review of LCA studies of solid waste management systems – Part II: Methodological guidance for a better practice

Life cycle assessment (LCA) is increasingly used in waste management to identify strategies that prevent or minimise negative impacts on ecosystems, human health or natural resources. However, the quality of the provided support to decision- and policy-makers is strongly dependent on a proper conduct of the LCA. How has LCA been applied until now? Are there any inconsistencies in the past practice? To answer these questions, we draw on a critical review of 222 published LCA studies of solid waste management systems. We analyse the past practice against the ISO standard requirements and the ILCD Handbook guidelines for each major step within the goal definition, scope definition, inventory analysis, impact assessment, and interpretation phases of the methodology. Results show that malpractices exist in several aspects of the LCA with large differences across studies. Examples are a frequent neglect of the goal definition, a frequent lack of transparency and precision in the definition of the scope of the study, e.g. an unclear delimitation of the system boundaries, a truncated impact coverage, difficulties in capturing influential local specificities such as representative waste compositions into the inventory, and a frequent lack of essential sensitivity and uncertainty analyses. Many of these aspects are important for the reliability of the results. For each of them, we therefore provide detailed recommendations to practitioners of waste management LCAs.