全文获取类型
收费全文 | 8796篇 |
免费 | 711篇 |
国内免费 | 3018篇 |
专业分类
安全科学 | 871篇 |
废物处理 | 434篇 |
环保管理 | 785篇 |
综合类 | 5523篇 |
基础理论 | 1371篇 |
污染及防治 | 2223篇 |
评价与监测 | 467篇 |
社会与环境 | 426篇 |
灾害及防治 | 425篇 |
出版年
2024年 | 31篇 |
2023年 | 139篇 |
2022年 | 457篇 |
2021年 | 375篇 |
2020年 | 392篇 |
2019年 | 327篇 |
2018年 | 337篇 |
2017年 | 445篇 |
2016年 | 445篇 |
2015年 | 503篇 |
2014年 | 624篇 |
2013年 | 862篇 |
2012年 | 764篇 |
2011年 | 890篇 |
2010年 | 669篇 |
2009年 | 665篇 |
2008年 | 683篇 |
2007年 | 635篇 |
2006年 | 584篇 |
2005年 | 391篇 |
2004年 | 293篇 |
2003年 | 303篇 |
2002年 | 254篇 |
2001年 | 211篇 |
2000年 | 226篇 |
1999年 | 163篇 |
1998年 | 140篇 |
1997年 | 145篇 |
1996年 | 112篇 |
1995年 | 107篇 |
1994年 | 81篇 |
1993年 | 76篇 |
1992年 | 73篇 |
1991年 | 47篇 |
1990年 | 29篇 |
1989年 | 9篇 |
1988年 | 9篇 |
1987年 | 8篇 |
1986年 | 5篇 |
1985年 | 2篇 |
1984年 | 6篇 |
1983年 | 4篇 |
1982年 | 3篇 |
1981年 | 1篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
851.
852.
通过选用昆明市第五污水处理厂的一级A标出水和水处理厂外排污泥作为静态实验环境,研究不同混养密度下铜锈环棱螺、椭圆背角无齿蚌对污水处理厂再生水环境的净化性能,筛选出净化效果较好的放养密度。结果表明:放养30 d,铜锈环棱螺、椭圆背角无齿蚌对污水处理厂再生水环境的水质、底质均有一定的净化作用,扣减空白对照影响,水中COD、TP、NH3-N及底泥有机质平均去除率分别为22.26%、26.10%、25.60%和25.69%,底泥厚度平均减少3.8 cm;与对照相比,放养螺蚌45 d内水均能清澈见底,透明度均>70 cm,能明显稳定水体透明度,改善水环境。综合螺蚌生长适应性和净化效果考虑:污水处理厂再生水静态环境中,螺蚌混养密度应≤3 000 g/m3,在2 000~2 500 g/m3为宜,其中铜锈环棱螺的最适放养密度在400 g/m3,椭圆背角无齿蚌为1 600~2 100 g/m3。 相似文献
853.
进水水质成分改变引发的污泥粘性膨胀及控制 总被引:2,自引:0,他引:2
在研究强化SBR工艺除污性能时,由于可溶性淀粉投加导致进水水质成分发生改变,污泥沉降性能在短时间内迅速恶化,污泥出现大量的粘液。镜检发现,大量指状菌胶团异常增殖且丝状菌的数量也逐渐减少。实验结果表明,系统膨胀属于污泥粘性膨胀。停止可溶性淀粉和提高主反应池的DO浓度,污泥粘性膨胀并未得到恢复,但污泥粘液逐渐消失。粘液消失后,通过模拟前期进水水质成分和缩短泥龄,污泥粘性膨胀得以控制,污泥沉降性能在短时间内恢复。实验还研究了污泥粘性膨胀对污染物去除性能的影响。 相似文献
854.
采用NaBH4作为还原剂回收电镀废液中的铜。正交实验结果表明,各因素对剩余铜离子质量浓度的影响的显著性顺序为n(NaBH4)∶n(CuSO4)反应时间反应温度。最佳实验条件为:n(NaBH4)∶n(CuSO4)=1.50,反应温度30℃,反应时间25min。经该工艺可获得平均粒径为33nm的近球形立方晶系纳米铜粉,处理后废液中铜离子质量浓度低至0.2mg/L。在铜粉制备过程中加入非离子型表面活性剂可有效阻止晶粒长大,并提高其分散性能,使产物粒径均匀。采用苯骈三氮唑处理后的铜粉抗氧化能力明显提高。 相似文献
855.
856.
857.
Se Jin Choi Ssang Sun Jun Jae Eun Oh Paulo J. M. Monteiro 《Journal of Material Cycles and Waste Management》2010,12(4):275-282
This article investigates the effects of stone powder sludge on the microstructure and strength development of alkali-activated fly ash and blast furnace slag mixes. Stone powder sludge produced from a crushed aggregate factory was used to replace fly ash and granulated blast furnace slag at replacement ratios of 0%, 10%, 20%, and 30% by mass. The unit weight and compressive strength of the samples were measured, and scanning electron microscopy/energy dispersive spectroscopy and X-ray diffraction (XRD) analyses were performed. The test results indicated that the compressive strength of alkali-activated blast furnace slag mixes using stone powder sludge was higher than that of the alkali-activated blast furnace slag control mix, but the compressive strength of alkali-activated fly ash mixes decreased with increasing replacement ratio of stone powder sludge. Microscopy results indicated that for alkaliactivated blast furnace slag samples, broken surfaces were more evident than for the alkali-activated fly ash samples. For all XRD diagrams, broad and diffuse peaks were observed around 2θ = 35° (d = 2.96–3.03 Å), implying amorphous or short-ordering structure phases. 相似文献
858.
Cost-effectiveness of two operational models at industrial wastewater treatment plants in China: A case study in Shengze town,Suzhou City 总被引:1,自引:0,他引:1
The widespread illegal discharge of industrial wastewater in China has posed significant challenges to the effective management of industrial wastewater treatment plants (IWTPs) and caused or exacerbated critical social issues such as trans-boundary environmental pollution. This study examines two operational strategies, decentralized model and an innovative integrated model, that have been used in the industrial town of Shengze (located in Suzhou City) over the past two decades at IWTPs handling wastewater from the city’s dyeing industry. Our cost-effectiveness analysis shows that, although the operational cost of IWTPs under the integrated model is higher than under the original decentralized model, the integrated model has significantly improved IWTP performance and effectively reduced illegal discharge of industrial wastewater. As a result, the number of reported incidents of unacceptable pollution in local receiving water bodies had declined from 13 in 2000–1 in 2008. Key factors contributing to the success of the innovative integrated model are strong support from municipal and provincial leaders, mandatory ownership transfer of IWTPs to a centralized management body, strong financial incentives for proper plant management, and geographically-clustered IWTPs. 相似文献
859.
860.