Spatial distribution and vertical profile of polybrominated diphenyl ethers and hexabromocyclododecanes in sediment core from Tokyo Bay, Japan

Brominated flame retardants (BFRs), hexabromocyclododecanes (HBCDs) and polybrominated diethyl ethers (PBDEs) were detected in three sediment cores and six surface sediments of Tokyo Bay, Japan. HBCDs were detected for the first time in this region with concentrations ranging from 0.056 to 2.3 ng/g dry wt, implying their widespread contamination, even though their concentrations were lower than summation operatorPBDEs (di- to nona-BDEs) and BDE-209. Levels of these compounds were higher near to the highly populated industrial area of the bay implicating industrial and human activities as sources of these compounds. Summation operatorPBDEs increased in the sediment layer up to the mid-1990s and decreased afterwards, whereas BDE-209 showed an increasing trend until now, following the usage of different commercial BDE mixtures. HBCDs first appeared in the mid-1970s and increased until today. The annual surficial flux of HBCDs (0.62-2.4 ng/cm2/yr) is equal to summation operatorPBDEs (0.95-2.6 ng/cm2/yr) but lower than that of BDE-209 (17-58 ng/cm2/yr).     

Ambient Aerosol and its Carbon Content in Gainesville, a Mid-Scale City in Florida

Ambient aerosols were collected during 2000–2001 in Gainesville, Florida, using a micro-orifice uniform deposit impactor (MOUDI) to study mass size distribution and carbon composition. A bimodal mass distribution was found in every sample with major peaks for aerosols ranging from 0.32 to 0.56 μm, and 3.2 to 5.6 μm in diameter. The two distributions represent the fine mode (<2.5 μm) and the coarse mode (>2.5 μm) of particle size. Averaged over all sites and seasons, coarse particles consisted of 15% carbon while fine particles consisted of 22% carbon. Considerable variation was noted between winter and summer seasons. Smoke from fireplaces in winter appeared to be an important factor for the carbon, especially the elemental carbon contribution. In summer, organic carbon was more abundant. The maximum secondary organic carbon was also found in this season (7.0 μg m⁻³), and the concentration is between those observed in urban areas (15–20 μg m⁻³) and in rural areas (4–5 μg m⁻³). However, unlike in large cities where photochemical activity of anthropogenic emissions are determinants of carbon composition, biogenic sources were likely the key factor in Gainesville. Other critical factors that affect the distribution, shape and concentration were precipitation, brushfire and wind.     

Results of An Indoor Size Fractionated PM School Sampling Program in Libby, Montana

Libby, Montana is the only PM_2.5 nonattainment area in the western United States with the exceptions of parts of southern California. During January through March 2005, a particulate matter (PM) sampling program was conducted within Libby’s elementary and middle schools to establish baseline indoor PM concentrations before a wood stove change-out program is implemented over the next several years. As part of this program, indoor concentrations of PM mass, organic carbon (OC), and elemental carbon (EC) in five different size fractions (>2.5, 1.0–2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) were measured. Total measured PM mass concentrations were much higher inside the elementary school, with particle size fraction (>2.5, 0.5–1.0, 0.25–0.5, and <0.25 μm) concentrations between 2 and 5 times higher when compared to the middle school. The 1.0–2.5 μm fraction had the largest difference between the two sites, with elementary school concentrations nearly 10 times higher than the middle school values. The carbon component for the schools’ indoor PM was found to be predominantly composed of OC. Measured total OC and EC concentrations, as well as concentrations within individual size fractions, were an average of two to five times higher at the elementary school when compared to the middle school. For the ultrafine fraction (<0.25), EC concentrations were similar between each of the schools. Despite the differences in concentrations between the schools at the various fraction levels, the OC/EC ratio was determined to be similar.     

Performance of an electrochemical COD (chemical oxygen demand) sensor with an electrode-surface grinding unit

An electrochemical COD (chemical oxygen demand) sensor using an electrode-surface grinding unit was investigated. The electrolyzing (oxidizing) action of copper on an organic species was used as the basis of the COD measuring sensor. Using a simple three-electrode cell and a surface grinding unit, the organic species is activated by the catalytic action of copper and oxidized at a working electrode, poised at a positive potential. When synthetic wastewater was fed into the system, the measured Coulombic yields were found to be dependent on the COD of the synthetic wastewater. A linear correlation between the Coulombic yields and the COD of the synthetic wastewater was established (10-1000 mg L(-1)) when the electrode-surface grinding procedure was activated briefly at 8 h intervals. When various kinds of wastewater samples obtained from various sewage treatment plants were measured, linear correlations (r(2)> or = 0.92) between the measured EOD (electrochemical oxygen demand) value and COD of the samples were observed. At a practical wastewater treatment plant, the measurement system was successfully operated with high accuracy and good stability over 3 months. These experimental results show that the application of the measurement system would be a rapid and practical method for the determination of COD in water industries.     

Organochlorines and polybrominated diphenyl ethers in four geographically separated populations of Atlantic salmon (Salmo salar)

Atlantic salmon (Salmon salar) populations from four locations, two from isolated Swedish lake systems, one of the Baltic Sea and one of the North Atlantic, were analyzed to determine the concentrations and spatial variations of polybrominated diphenyl ethers (PBDEs) and organochlorines (DDT, PCB and HCH). Levels in both liver and muscle were in the same range as previously reported in Atlantic salmon, except for elevated concentrations found per lipid weight (lw) in the muscle samples of salmon from the North Atlantic ( summation PBDE 263 ng g(-1) lw, summation PCB 3262 ng g(-1) lw, summation DDT 4063 ng g(-1) lw summation HCH 131 ng g(-1)). In general, elevated concentrations in the muscles compared to the liver were observed, especially in lipid depleted migrating salmon, possibly caused by a faster lipid depletion compared with the redistribution of PBDEs, PCBs and DDTs. These findings indicated that the life stage and thereby the lipid dynamics of the fish must be considered prior to comparison based on lipid weight, especially as Atlantic salmon experience large variations in lipid content during periods of migration. The dominating PBDE congener was BDE-47, representing more than 25% in all fish. The PBDE pattern changed between locations, with a significant separation of the fish from the freshwater and marine environment when analyzed using principal component analysis.     

Validation of a European standard for the determination of hexavalent chromium in solid material

A European standard for the determination of Cr(vi) in solid material has been elaborated in the framework of an international co-operation and finally validated in the course of an interlaboratory comparison. The procedure is based on the alkaline digestion prescribed by EPA method 3060A followed by ion chromatography and determines an operationally defined content of Cr(vi), including water-soluble and insoluble chromates. A preliminary robustness study was carried out in order to compare different extraction methodologies and to study the equivalency of different analytical methods for the determination of Cr(vi) in alkaline extracts of soil and waste materials. During an interlaboratory validation trial with 19 European laboratories a set of 4 samples (2 soil and 2 waste samples) was analysed to determine performance characteristics for different combinations of digestion and detection methods. With the procedures prescribed by the new European standard (EN 15192) acceptable results were obtained for both soil samples and one of the waste samples (sludge). However, for the second waste sample (fly ash) a large deviation in analytical results was observed. This indicates that particularly for waste materials a possible occurrence of strong matrix effects has to be considered and supplementary quality control data are needed in order to assess the validity of analytical results. The accuracy of the determination of Cr(vi) in solid matrices remains a challenging field in terms of maximum extraction efficiency and minimum species interconversion.     

Passive sampling: partition coefficients for a silicone rubber reference phase

Silicone rubber sheeting can be used as a passive sampling device for hydrophobic organic contaminants in the environment to determine the available concentrations in water and sediments. Reliable sampler-water partition coefficients are required to determine the sampling rates and the dissolved contaminant concentrations in water and in sediment pore water. Log partition coefficients (logK(sr,w)) for silicone rubber-water have been estimated for 32 polycyclic aromatic hydrocarbons (PAHs), 2 deuterated PAH analogues and 32 chlorobiphenyls (CBs) using the cosolvent method, with methanol as cosolvent. Strong linear relationships were found with literature values for the corresponding log octanol-water partition coefficients (logK(ow)) for both CBs and PAHs, confirming that partitioning into the silicone rubber is strongly determined by the hydrophobicity of the compounds, which suggests logK(ow) is a good predictor of logK(sr,w) and that absorption is the main mechanism for accumulation of analytes into the silicone rubber polymer.     

Polychlorinated dibenzo-p-dioxins and dibenzofurans in paddy soils and river sediments in Akita, Japan

Paddy soils and sediments from the Yoneshirogawa, Omonogawa, and Koyoshigawa River Basins in Akita were analyzed for polychlorinated dibenzo-p-dioxins (PCDDs) and dibenzofurans (PCDFs). The levels and compositions in those samples including soils from non-agricultural areas (non-agricultural soils) were investigated using isomer-specific analysis to determine characteristic sources. The PCDD/PCDF compositions in the samples were compared with respect to possible sources. The PCDD/PCDF concentrations in paddy soils were much higher than those in the non-agricultural soils and much higher than those found in other parts of Japan. Although PCDD/PCDFs were ubiquitous in sediments from river sources to mouths of the respective river basins, those concentrations were much lower than those from paddy soils and non-agricultural soils, and from other parts of Japan. Comparison of PCDD/PCDF homologues and isomer compositions for samples indicated that compositions of paddy soils and sediments, except for those from river sources, had similar characteristics to PCDD/PCDFs originating from impurities in herbicides, 2,4,6-trichlorophenyl 4-nitrophenyl ether (CNP) and pentachlorophenol (PCP), and that compositions of river-source sediments and non-agricultural soils resembled those of atmospheric depositions. Results of statistical analyses suggest that PCDD/PCDF contamination of paddy soils and sediments is attributable mainly to three sources: CNP, PCP, and atmospheric deposition. Results of this study also demonstrate that CNP and PCP are not only important contaminants of local areas of Japan, but that they exist throughout Akita, in northern Japan. We therefore conclude that PCDD/PCDF pollution caused by those compounds has a widespread influence on paddy soils and river sediments in Japan.     

Essential and non-essential element concentrations in two sleeper shark species collected in arctic waters

A number of elements/metals have increased in arctic biota and are of concern due to their potential toxicity. Most studies on elements in the Arctic have focused on marine mammals and seabirds, but concentrations in the Greenland shark (Somniosus microcephalus) and Pacific sleeper shark (Somniosus pacificus), the only two shark species known to regularly inhabit arctic waters, have never been reported. To address this data gap, concentrations and patterns of 25 elements were analyzed in liver of Greenland sharks collected about Cumberland Sound (n=24) and Pacific sleeper sharks collected about Prince William Sound (n=14). Several non-essential elements differed between species/locations, which could suggest geographical exposure differences or ecological (e.g., diet) differences between the species. Certain essential elements also differed between the two sleeper sharks, which may indicate different physiological requirements between these closely related shark species, although information on such relationships are lacking for sharks and fish.     

Differential responses of the freshwater wetland species Juncus effusus L. and Caltha palustris L. to iron supply in sulfidic environments

Sulfur pollution can lead to serious problems in freshwater wetlands, including phosphorus eutrophication and sulfide toxicity. We tested the effects of anaerobic iron-rich groundwater discharge in fens, simulated by iron injection, on two characteristic species (Juncus effusus and Caltha palustris) in a sulfidic environment. Biomass production of C. palustris roots showed an optimum response to the combined addition of iron and sulfide, with highest values at intermediate concentrations of both substances. Iron deficiency apparently occurred at low iron concentrations, while at high iron concentrations, growth was decreased. For J. effusus, in contrast, no toxic effects were found of both iron and sulfide. This could be explained by larger radial oxygen loss (ROL) of J. effusus and could not be explained by differences in phosphorous concentrations. The results of our experiments confirm that iron-rich groundwater discharge has the potential to affect vegetation composition through toxicity modification in sulfidic environments.