慢生型花生根瘤菌16S rRNA分析

以２１株分离自四川,云南不同花生产区的慢性型花生根瘤菌和６株参比菌株为材料,进行了１６ＳｒＤＮＡＰＣＲ－ＲＦＬＰ,结果除证实了慢性型花生根瘤菌同慢生型大豆根瘤菌（Ｂｒａｄｙｒｈｉｚｏｂｉｕｍｊａｐｏｎｉｃｕｍ）高度的遗传相似性外,还发现了一些菌株同Ｂｒａｄｙｒｈｉｚｏｉｂｉｕｍｌｉａｏｎｉｎｇｅｎｓｉｓ和Ｂｒａｄｙｒｈｉｚｏｂｉｕｍｅｌｋａｎｉｉ有较高的遗传相似性,菌株Ｓｐｒ１－２的１６ＳｒＲＮＡ     

四川省部分豆科植物根瘤菌的遗传多样性

从四川省豆科植物鸡眼草属、合欢属、豇豆属、葛属、金合欢、杭子梢分离获得了103株根瘤菌,采用AFLP、BOXAIR-PCR研究了这些菌株的遗传多样性.结果表明,分离自四川省豆科植物6个属的根瘤菌存在明显的遗传多样性,AFLP分析中,全部供试菌株的相似性为21%,全部供试菌株可分为26个AFLP遗传群;BOXAIR-PCR聚类分析结果表明,103个菌株分在70%相似性水平处,供试菌株被分为18个BOX遗传群.除部分菌株外,多数根瘤菌按宿主类型聚群,同一宿主而地理来源不同的根瘤菌分布于不同的遗传群,表明宿主和地理环境对根瘤菌具有深刻影响.图3表1参9     

An assessment of the chronic toxicity of the synthetic pyrethroid, fenvalerate, to Daphnia galeata mendotae, using life tables

The effects of chronic exposure to fenvalerate, a synthetic pyrethroid insecticide, on the cladoceran Daphnia galeata mendotae were evaluated under laboratory conditions. The daphnids were exposed for their entire life cycle to concentrations ranging from 0.005 to 0.1 microg fenvalerate litre(-1). The parameters used to determined toxicity were survival, time to first reproduction, reproductive frequency, number of young per brood, cumulative brood size, intrinsic rate of natural increase (r(m)), generation time (T) and net reproductive rate (R(0)). A concentration of 0.005 microg fenvalerate litre(-1) resulted in an increase in longevity but a decrease in production of young. Higher concentrations caused a decrease in survival. Studies of shorter duration than the complete life cycle of the organisms would not have detected toxicity at such low levels. The intrinsic rate of natural increase, r(m), was not affected by fenvalerate until concentration reached 0.05 microg litre(-1) and r(m) decreased to 0.113 from 0.238. A concentration of 0.01 microg litre(-1) caused the net reproductive rate, R(0), and the generation time, T, to decrease to 73.2 offspring per female and 17.3 days from 125.9 offspring per female and 20.3 days, respectively.     

Trees as bioindicator of heavy metal pollution in three European cities

Concentrations of four heavy metals were determined in tree leaves and bark collected from polluted and non-polluted areas of three European cities (Salzburg, Belgrade and Thessaloniki) for a comparative study. Platanus orientalis L. and Pinus nigra Arn., widespread in urban northern and southern Europe, were tested for their suitability for air quality biomonitoring. Leaves and barks were collected uniformly of an initial quantity of about 30 g of each sample. Analysis was accomplished by electrothermal atomic absorption spectrometry after total digestion. Site-dependent variations were found with the highest concentration level measured in Belgrade, followed by Thessaloniki and Salzburg. A higher accumulation of heavy metals was found in bark compared to leaves. Pine tree bark, accumulating higher concentrations of trace metals compared to plane tree bark, shows a higher efficiency as bioindicator for urban pollution. Both indicator species are suitable for comparative studies on bioindication of urban air pollution.     

Passive air sampling theory for semivolatile organic compounds

The mathematical modelling underlying passive air sampling theory can be based on mass transfer coefficients or rate constants. Generally, these models have not been inter-related. Starting with basic models, the exchange of chemicals between the gaseous phase and the sampler is developed using mass transfer coefficients and rate constants. Importantly, the inter-relationships between the approaches are demonstrated by relating uptake rate constants and loss rate constants to mass transfer coefficients when either sampler-side or air-side resistance is dominating chemical exchange. The influence of sampler area and sampler volume on chemical exchange is discussed in general terms and as they relate to frequently used parameters such as sampling rates and time to equilibrium. Where air-side or sampler-side resistance dominates, an increase in the surface area of the sampler will increase sampling rates. Sampling rates are not related to the sampler/air partition coefficient (K(SV)) when air-side resistance dominates and increase with K(SV) when sampler-side resistance dominates.     

Benzyl-penicillin (Penicillin G) transformation in aqueous solution at low temperature under controlled laboratory conditions

Antibiotics are released into the environment in a variety of ways: via wastewater effluent as a result of incomplete metabolism in the body after use in human therapy, as runoff after use in agriculture, through improper disposal by private households or hospitals or through insufficient removal by water treatment plants. Unlike in most European countries, in Arctic regions effluents are not suitably treated prior to their release into the aquatic environment. Also, many of the scattered human settlements in remote regions of the Arctic do not possess sewage treatment facilities and pharmaceutical residues therefore enter the aqueous environment untreated. Only limited data are available on the biodegradation of antibiotics under Arctic conditions. However, such information is needed to estimate the potential harm of antibiotics for the environment. Pen-G is used in this study since it is a widely prescribed antibiotic compound whose environmental properties have not yet been investigated in detail. Thus, for a very first assessment, the OECD approved biodegradation Zahn-Wellens test (ZWT, OECD 302 B) was used to study biodegradation and non-biotic elimination of the antibiotic Benzyl-penicillin (Pen-G) at different temperatures (5°C, 12.5°C and 20°C). The testing period was extended from the OECD standard of 28-42d. In addition to dissolved organic carbon (DOC), Pen-G levels and major transformation products were recorded continuously by LC-ion-trap-MS/MS. DOC monitoring revealed considerable temperature dependence for the degradation process of Pen-G. DOC loss was slowest at 5°C and considerably faster at 12.5°C and 20°C. In the initial step of degradation it was found that Pen-G was hydrolyzed. This hydrolyzed Pen-G was subsequently further degraded by decarboxylation, the result of which was 2-(5,5-dimethyl-1,3-thiazolidin-2-yl)-2-(2-phenylacetamido)acetic acid. Furthermore, direct elimination of 2-phenyl-acetaldehyde from the hydrolyzed and decarboxylated Pen-G also led to the formation of 2-[amino(carboxy)methyl]-5,5-dimethyl-1,3-thiazolidone-4-carboxylic acid. Since biodegradation slows down considerably at a low temperature, the resulting transformation products had considerably longer residence times at 5°C compared to higher temperature conditions within the 42-d experiment. The results presented here clearly demonstrate that a risk assessment for pharmaceuticals present in low ambient temperature environments (i.e. the Arctic) cannot be based on test results obtained under standard laboratory conditions (i.e. 20°C ambient temperatures).     

Estimation and characterization of PCDD/Fs and dioxin-like PCBs from Chinese iron foundries

The iron foundry industry is considered to be a potential source of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). This study investigated the emission factors and total emission amounts of PCDD/Fs and dioxin-like polychlorinated biphenyls (DL-PCBs) from iron foundries in China. The concentrations and the World Health Organization toxicity equivalents (WHO-TEQs) are presented and the congener profiles are discussed in this paper.In the present work, 26 fly ash samples were collected and tested to quantify the PCDD/Fs and DL-PCBs generated by 14 plants of different scales, and five stack gas samples were collected from two (named as EFG and LFG) of those plants. The emission levels of PCDD/Fs and DL-PCBs indicated that hot-air cupolas had lower emissions than cold-air cupolas. When iron ore lump and sinter were used as raw material, the emission factors were about 250 ng TEQ t⁻¹ of product. However, if the raw material was scrap, the emission factors varied owing to the different contents of organic materials in the raw materials. It was found that the mean WHO-TEQ values of PCDD/Fs and DL-PCBs were 144 and 34.2 pg Nm⁻³ in stack gas and 20.0 and 1.58 pg g⁻¹ in fly ash. In multiple tests, it was estimated that the mean emission factors of PCDD/Fs and DL-PCBs were 365 and 10.9 ng WHO-TEQ t⁻¹ released to residue and 2719 and 555 ng TEQ t⁻¹ released to air. The total emission amounts of PCDD/Fs and DL-PCBs from Chinese iron foundries with cupola furnaces released to residue and air were 16.8 and 146 g WHO-TEQ in 2008, respectively.     

Retention characteristics and balance assessment for two polycyclic musk fragrances (HHCB and AHTN) in a typical German sewage treatment plant

Measurements of two polycyclic musk fragrances HHCB (galaxolide) and AHTN (tonalide) were measured in wastewater and sludge of a German sewage treatment plant. The metabolite HHCB-lactone was identified and quantified in the same plant. The influent concentrations were about 1900 ng/l HHCB and 580 ng/l AHTN, while in the sludge about 3000 ng/g HHCB and 1500 ng/g AHTN were analysed. About 35% of both compounds passed through the plant unaltered and were discharged to the river. Slightly more HHCB was sorbed to the sludge than was discharged; while for AHTN about twice as much was sorbed to the sludge than was discharged. About 5-10% of the HHCB was oxidised in the plant to HHCB-lactone. The dominant processes in the STP were sorption processes, though.     

Characterization of atmospheric particulates, particle-bound transition metals and polycyclic aromatic hydrocarbons of urban air in the centre of Athens (Greece)

The concentrations of trace metals and polycyclic aromatic hydrocarbons (PAHs) adsorbed to total suspended particulate (TSP) and finer fractions of airborne particulate matter (PM) were determined from a site in the centre of Athens (Greece), which is characterized by heavy local traffic and is densely populated, during the winter and summer periods in 2003-2004. Also, we collected and analyzed samples of diesel and gasoline exhaust particles from local vehicles (buses, taxis and private cars) and from chimney exhaust of residential central heating appliances. A seasonal effect was observed for the size distribution of aerosol mass, with a shift to larger fine fractions in winter. The most commonly detected trace metals in the TSP and PM fractions were Fe, Pb, Zn, Cu, Cr, V, Ni and Cd and their concentrations were similar to levels observed in heavily polluted urban areas from local traffic and other anthropogenic emissions. Analysis of 16 PAHs bound to PM showed that they are mostly traffic related. In general, the fine particulate PAHs concentrations were higher than coarse particles. The most common PAHs in PM(10.2) and PM(2.1) were pyrene, phenanthrene, acenapthylene and fluoranthene, which are associated with diesel and gasoline exhaust particles. The results of this study underlined the importance of local emission sources, especially vehicular traffic, central heating and other local anthropogenic emissions. Compared with other big cities, Athens has much higher levels of airborne particles, especially of the finer fractions PM(10) and PM(2.5), correlated with traffic-related air pollution.     

Heterogeneous water phase catalysis as an environmental application: a review

Catalytic water phase processes as an environmental application is a relatively novel subject with tremendous potential in the near future. This review of 120 references presents the wide scale of heterogeneous water phase applications studied mainly within past five years. Both oxidation and hydrogenation processes are included as well as TiO₂ assisted photocatalysis. According to the references, heterogeneous catalysis is developing rapidly. New bimetallic catalysts and supports with higher surface area have improved catalytic efficiency in both oxidation and hydrogenation processes. It also seems that study on use of some waste materials such as red mud as catalyst is a very progressive field. On the whole, the chemical aspects are pretty well known, but the catalyst durability, and in many cases activity as well, has to be improved.