Pilot project of mechanical-biological treatment of waste in Brazil

By mechanical-biological treatment (MBT) of residual municipal solid waste the behaviour of landfills can be significantly improved. After MBT the organic content (COD and BOD5), total organic carbon, and total nitrogen in the leachate, as well as the gas production rate, are reduced to values lower than 90% of the fresh untreated waste. The volume of the stabilized material to be disposed on landfills decreases enormously, by up to 70%. The monitoring effort for a landfill constructed under these conditions is reduced to a minimum and the stabilized material can be used in other ways, as material for reforestation, for cover material or for thermal utilization to produce energy. Environmental conditions are important in MBT, as well as waste characteristics. This paper describes the results of a pilot project of MBT performed in Rio de Janeiro, Brazil. The results have shown that this technology can be used successfully in developing countries, with economy for the society and important results for the environment.     

Chemical and mineralogical evaluation of slag products derived from the pyrolysis/melting treatment of MSW

This paper provides the results of studies on the characteristics of novel material derived from pyrolysis/melting treatment of municipal solid waste in Japan. Slag products from pyrolysis/melting plants were sampled for the purpose of detailed phase analysis and characterization of heavy metal-containing phases using optical microscopy, electron probe microanalysis (EPMA), XRF and XRD. The study revealed that the slag material contains glass (over 95%), oxide and silicate minerals (spinel, melilite, pseudowollastonite), as well as individual metallic inclusions as the major constituents. A distinct chemical diversity was discovered in the interstitial glass in terms of silica content defined as low and high silica glass end members. Elevated concentrations of Zn, Cr, Cu, Pb and Ba were recorded in the bulk composition. Cu, Pb and Ba behave as incompatible elements since they have been markedly characterized as part of polymetallic alloys and insignificantly sulfides in the form of spherical metallic inclusions associated with tracer amounts of other elements such as Sb, Sn, Ni, Zn, Al, P and Si. In contrast, an appreciable amount of Zn is retained by zinc-rich end members of spinel and partially by melilite and silica glass. Chromium exhibits similar behavior, and is considerably held by Cr-rich spinel. The intense incorporation of Zn and Cr into spinel indicates the very effective enrichment of these two elements into phases more environmentally resistant than glass. There was no evidence, however, that Cu and Pb enter into the structure of the crystalline silicates or oxides that may lead to their easier leachability upon exposure to the environment.     

Emergence of Indigenous Vegetation Classifications Through Integration of Traditional Ecological Knowledge and Remote Sensing Analyses

Traditional ecological knowledge (TEK) can play an important role in the understanding of ecological systems. Although TEK has complemented scientific and managerial programs in a variety of contexts, its formal incorporation into remote sensing exercises has to date been limited. Here, we show that the vegetation classifications of the Ache, an indigenous hunter-gatherer tribe of the Mbaracayu Forest Reserve in Paraguay, are reflected in a supervised classification of satellite imagery of the reserve. Accuracy of classification was toward the low end of the range of published values, but was reasonable given the difficult nature of separating forest classes from satellite images. Comparison of the resultant map with a more traditionally elaborated vegetation map highlights differences between the two approaches and the gain in information obtained by considering TEK classifications. We suggest that integration of TEK and remote sensing may provide alternative insights into the ecology of vegetation communities and land cover, particularly in remote and densely forested areas where ecological field research is often limited by roads and/or trail systems.     

Fall fertilization timing effects on nitrate leaching and turfgrass color and growth

Fall season fertilization is a widely recommended practice for turfgrass. Fertilizer applied in the fall, however, may be subject to substantial leaching losses. A field study was conducted in Connecticut to determine the timing effects of fall fertilization on nitrate N (NO3-N) leaching, turf color, shoot density, and root mass of a 90% Kentucky bluegrass (Poa pratensis L.), 10% creeping red fescue (Festuca rubra L.) lawn. Treatments consisted of the date of fall fertilization: 15 September, 15 October, 15 November, 15 December, or control which received no fall fertilizer. Percolate water was collected weekly with soil monolith lysimeters. Mean log(10) NO3-N concentrations in percolate were higher for fall fertilized treatments than for the control. Mean NO3-N mass collected in percolate water was linearly related to the date of fertilizer application, with higher NO3-N loss for later application dates. Applying fall fertilizer improved turf color and density but there were no differences in color or density among applications made between 15 October and 15 December. These findings suggest that the current recommendation of applying N in mid- to late November in southern New England may not be compatible with water quality goals.     

Forest carbon management in the United States: 1600-2100

This paper reviews the effects of past forest management on carbon stocks in the United States, and the challenges for managing forest carbon resources in the 21st century. Forests in the United States were in approximate carbon balance with the atmosphere from 1600-1800. Utilization and land clearing caused a large pulse of forest carbon emissions during the 19th century, followed by regrowth and net forest carbon sequestration in the 20th century. Recent data and knowledge of the general behavior of forests after disturbance suggest that the rate of forest carbon sequestration is declining. A goal of an additional 100 to 200 Tg C/yr of forest carbon sequestration is achievable, but would require investment in inventory and monitoring, development of technology and practices, and assistance for land managers.     

Modeling methyl isothiocyanate soil flux and emission ratio from a field following a chemigation of metam-sodium

Metam-sodium had become the most heavily used soil fumigant in recent years as the deadline approached for methyl bromide to phase out in January 2005. After application, metam-sodium decomposes rapidly to methyl isothiocyanate (MITC), a highly toxic compound capable of killing a wide spectrum of soil-borne pests. Inhalation risk of MITC ranked high among airborne agricultural pesticides in California. Information about off-gassing intensity and percentage of emission is essential for exposure risk assessment and mitigation measures, but is limited, especially for new application methods such as drip chemigation. Air concentrations of MITC were monitored around a field treated with metam-sodium through surface drip irrigation system. The field was tarped with plastic films before the chemigation. The air concentrations at receptor locations were simulated for the period of air monitoring with the Industrial Source Complex (ISC3) Dispersion Model, and soil flux density of MITC at various periods after chemigation was estimated through a back-calculation procedure. The estimated soil flux density of MITC showed a diurnal pattern, with the daytime flux stronger than nighttime. However, the average air concentration at nighttime was higher than that at daytime. Soil flux density peaked at 4.30 microg m-2 s-1 in the first 12-h period after chemigation, then declined with time. The MITC emission percentage in the first 60-h was 2.65% of applied mass, of which 57% occurred in the first 24-h after chemigation. The study indicated that the tarped bed drip application method of metam-sodium had a relatively good control of MITC emission from soil.     

Spatiotemporal evolution of soil pH and zinc after the Aznalcollar mine spill

The residual pollution after the Aznalcóllar (southwestern Spain) pyrite mine spill is still a threat due to the continuing oxidation of sulfuric minerals. The objective of this paper was to analyze the combined effect of pyrite oxidation, sugar beet foam applications, and meteorological conditions on the spatiotemporal evolution of the pH and EDTA-extractable Zn concentration, using non co-located data from 11 sampling dates between June 1999 and March 2002. Median pH values ranged from 4.4 at the beginning of the monitoring period to 7.6 at the end, although values near 2.5 were observed throughout the entire period, despite of two sugar beet foam (SBF) applications. Zinc distributions were positively skewed and median concentrations ranged from 17 to 94 mg kg(-1). The inverse relationship between pH and Zn became weaker toward the end of the monitoring period as a consequence of the precipitation and posterior dissolution of newly formed minerals from the reaction products of the pyrite oxidation. Normal score maps showed that after the SBF applications only 0.5% of the monitored area was below the pH = 4 threshold, while on other dates up to one-third of the area remained below this value. The better performance of the second SBF application could be explained in terms of pyrite oxidation pathways and environmental conditions. From this analysis, with data obtained under uncontrolled field conditions, it is concluded that SBF should be applied before or during the wet and cold season to alleviate acidification, caused by the oxidation of pyrite or other sulfuric minerals.     

Managing disposal of water produced with petroleum in Kuwait

Disposal of water produced with petroleum has been of great interest in Kuwait for the last 20 years. The current problem arose when the Burgan oil field, which is the second largest field in the world, experienced successive increases in the water content of the produced oil. This study introduces a decision-making analysis of the considered alternatives for the disposal of the produced water. Four alternative solutions exist for the industry as practical solutions for the disposal of water produced in Kuwait. The first method utilizes a large number of pits to discharge water. The second alternative depends on discharging water into sealed pits. The third approach to dispose water is by injecting the water underground. The last method is similar to the previous one, but takes into consideration the recovery of reservoir pressure to maintain the rate of oil production. A questionnaire was distributed to 48 experts at the top management level of the petroleum companies and the governmental authority. The data collected considered cost, efficiency, and environmental parameters. Based on the data, a statistical analysis was conducted using the factor analysis method to reduce the number of investigated variables. The analysis concluded that the optimal solution is to use the effluent injection method to discharge water produced with oil in Burgan and similar fields in Kuwait.     

Effects of calibration on L-THIA GIS runoff and pollutant estimation

Urbanization can result in alteration of a watershed's hydrologic response and water quality. To simulate hydrologic and water quality impacts of land use changes, the Long-Term Hydrologic Impact Assessment (L-THIA) system has been used. The L-THIA system estimates pollutant loading based on direct runoff quantity and land use based pollutant coefficients. The accurate estimation of direct runoff is important in assessing water quality impacts of land use changes. An automated program was developed to calibrate the L-THIA model using the millions of curve number (CN) combinations associated with land uses and hydrologic soil groups. L-THIA calibration for the Little Eagle Creek (LEC) watershed near Indianapolis, Indiana was performed using land use data for 1991 and daily rainfall data for six months of 1991 (January 1-June 30) to minimize errors associated with use of different temporal land use data and rainfall data. For the calibration period, the Nash-Sutcliffe coefficient was 0.60 for estimated and observed direct runoff. The calibrated CN values were used for validation of the model for the same year (July 1-December 31), and the Nash-Sutcliffe coefficient was 0.60 for estimated and observed direct runoff. The Nash-Sutcliffe coefficient was 0.52 for January 1, 1991 to December 31, 1991 using uncalibrated CN values. As shown in this study, the use of better input parameters for the L-THIA model can improve accuracy. The effects on direct runoff and pollutant estimation of the calibrated CN values in the L-THIA model were investigated for the LEC. Following calibration, the estimated average annual direct runoff for the LEC watershed increased by 34%, total nitrogen by 24%, total phosphorus by 22%, and total lead by 43%. This study demonstrates that the L-THIA model should be calibrated and validated prior to application in a particular watershed to more accurately assess the effects of land use changes on hydrology and water quality.     

Recycling of an industrial sludge and marine clay as light-weight aggregates

The geographical limitations of Singapore, its restricted natural resources and voluminous municipal and industrial waste streams, make environmental management a major challenge for the island state. In an attempt to find ways to reduce importation of raw materials and the waste sent to landfill, light weight aggregates were produced from marine clay and a CaF(2)-rich semiconductor industry sludge. Aggregates were produced in a bench-scale rotary kiln with three clay/sludge loadings (90/10, 70/30 and 50/50%). All three mixtures showed good bloating behavior during firing and the ceramic pellets (1-1.5cm diameter) had densities well below that required for light-weight aggregates. In the initial tests, the pore sizes of the aggregates were in general too large resulting in high water absorption. Comparisons between the composition of the two waste products and the aggregates showed a significant loss of fluorine (40-60%) during processing; a problem which may require flue gas treatment. Leach testing showed that the formed aggregates would not pose a human or environmental hazard in terms of fluorine mobilization.