Media surface properties and the development of nitrifying biofilms in mixed cultures for wastewater treatment

Plastic was tested to select biofilm support media that would enhance nitrification in the presence of heterotrophs. Eight different types (acrylonitrile butadiene styrene, nylon, polycarbonate, polyethylene, polypropylene, polytetrafluoroethylene (PTFE), polyvinyl chloride and tufnol) were immersed in an aerobic fed-batch reactor receiving domestic settled wastewater. Nitrification rates did not correlate with biomass concentrations, nor surface roughness of the plastics as measured by atomic force microscopy (AFM). The maximum nitrification rate of 1.5 g/m² d^?1 was obtained from biofilms growing on PTFE which had the lowest surface adhesion force (8 nN). Nitrification rates for the biofilms were inversely correlated with the attraction forces as measured by AFM.     

Environmental risk mapping of accidental pollution and its zonal prevention in a city

Accidental releases of pollution can have severe environmental, societal, economic, and institutional consequences. This paper considers the use of risk mapping of accidental pollution events, and zonal prevention measures for alleviating the impact on large urban areas. An Environmental Pollution Accident Risk Mapping (EPARM) model is constructed according to a mapping index system supported by quantitative sub-models dedicated to evaluating the risk arising from different sources of potential accidental pollution. The EPARM approach consists of identifying suitable indexes, assessment of environmental risk at regional and national scales based on information on previous pollution accidents and the prevailing environmental and social conditions, and use of GIS to map the overall risk. A case study of pollution accidents in Minghang District, Shanghai, China is used to demonstrate the effectiveness of the model. The paper also proposes a systemic framework for accidental environmental pollution risk prevention, and detailed countermeasures for specific risk zones.     

Experimental and theoretical investigations for mitigating NaAlH4 reactivity risks during postulated accident scenarios involving exposure to air or water

Experimental and theoretical studies were conducted to investigate the pyrophoricity and water-reactivity risks associated with employing sodium alanate (NaAlH₄) complex metal hydride in on-board vehicular hydrogen (H₂) storage systems. The ignition and explosivity of NaAlH₄ upon exposure to oxidizers in air or water were attributed to the spontaneous formation of stable hydroperoxyl intermediates on the NaAlH₄ surface and/or H₂ production, as well as the large driving force for NaAlH₄ conversion to favorable hydroxide products predicted by atomic and thermodynamic modeling. The major products from NaAlH₄ exposure to air: NaAl(OH)₄, gibbsite and bayerite Al(OH)₃, and Na₂CO₃ observed by XRD, were identified to be formed by surface-controlled reactions. The reactivity risks were significantly minimized, without compromising de-/re-hydrogenation cyclability, by compacting NaAlH₄ powder into wafers to reduce the available surface area. These core findings are of significance to risk mitigation and H₂ safety code and standard development for the safe use of NaAlH₄ for on-board H₂ storage in light-duty vehicles.     

Survey of polycyclic aromatic hydrocarbons (PAHs) in arterial street air of Hangzhou

ＩｎｔｒｏｄｕｃｔｉｏｎＰｏｌｙｃｙｃｌｉｃａｒｏｍａｔｉｃｈｙｄｒｏｃａｒｂｏｎｓ (ＰＡＨｓ)ａｒｅｗｉｄｅｓｐｒｅａｄｅｎｖｉｒｏｎｍｅｎｔａｌｐｏｌｌｕｔａｎｔｓｉｎｔｈｅａｔｍｏｓｐｈｅｒｅ.Ｔｈｅｙａｒｅｇｅｎｅｒａｔｅｄｉｎｔｈｅｃｏｍｂｕｓｔｉｏｎ .Ｔｈｅｍａｊｏｒｓｏｕｒｃｅｓｉｄｅｎｔｉｆｉｅｄｉｎｃｌｕｄｅｆｏｓｓｉｌｆｕｅｌｓ,ｖｅｈｉｃｕｌａｒｔｒａｆｆｉｃ,ｉｎｄｕｓｔｒｉａｌｐｒｏｃｅｓｓｅｓ,ｓｍｏｋｉｎｇａｎｄｄｏｍｅｓｔｉｃｈｅａｔｉｎｇ (Ｐｅｌｔｏｎｅｎ ,1995) .Ｔ…     

Status of air pollution in Beijing

A study has been made on elements organic constituents, TSP, SO2,NO2 of atmospheric pollutants in Beijing. 17 elements, and some PAHs, e. g. B(a)P, B(b, j, k)P, and B(g, h, i)P, in airborne particles by X-ray fluorescence spectroscopy and HPLC, GC/MS, have been determined respectively. It has been shown that the elements Pb, Zn, S and Cu were more enriched in fine particles and different valence states of sulfur at various sites. It was found that the concentrations of S6+ and S2-were more than 85% and less than 15% of the total sulfur respectively. Concentrations of major PAHs and sulfur-containing compounds increased in winter and in urban area. High values for Pb and Zn in city, Fe and Mn at industrial area and Cu, Al rural sites were obtained respectively. This implies the functions of different elemental sources of various sites. Thus, elements can be from distingushed anthropogenic and natural sources.The main contribution of SO2 was found of to have same seasonal variation as the anthropogenic el     

磷石膏水热法合成硫酸钙晶须

以磷石膏为原料,二水合硫酸钙、硫酸镁、甘油为添加剂,采用水热法合成硫酸钙晶须,考察了料浆含量、反应温度、反应时间、体系pH等因素对晶须的直径和长径比的影响;并采用SEM技术观察硫酸钙晶须的形貌。实验结果表明,当磷石膏含量2.5%（w）、反应温度130 ℃、反应时间4 h、体系pH 4时,制备得到的硫酸钙晶须长径比为56.24,平均直径为0.17 μm。SEM表征结果显示,硫酸钙晶须形貌规整、分散均匀、直径较小,达百纳米级。     

纳滤膜深度处理棉针织品印染废水

采用芳香聚酰胺膜(NF-1#)、复合膜(NF-2#)和聚酰胺复合膜(NF-3#)深度处理棉针织品印染废水,考察了膜分离性能及膜污染情况的影响因素。实验结果表明,在操作压力为0.5MPa、废水温度为25~35℃、废水pH为7的条件下,NF-1#膜处理效果最佳,COD去除率最高,为76.0%~85.0%;脱盐率也最高,达90.0%。膜过滤后浓水送污水厂处理,产水回用于车间生产。操作压力增高、废水温度升高和废水pH增大均导致滤饼层阻力(Rc)和膜过滤过程中的总阻力(Rt)增加,Rc是Rt的主要组成部分,同时也是导致膜透过通量下降的主要因素。     

含固率和接种比对林可霉素菌渣厌氧消化的影响

通过林可霉素菌渣的中温厌氧消化摇瓶实验,比较不同的含固率(3%、5%、8%、10%)和接种比(0.5、1、2、3)对菌渣产甲烷能力的影响,以确定菌渣厌氧消化的最优工艺条件.结果表明,在研究参数范围内,含固率越低,接种比越高,越有利于甲烷的产生;经过10d的培养,在含固率为3%、接种比为3时的工况中,菌渣的挥发性固体(VS)累计净产甲烷量最高,为106 mL/g;而含固率>5%、接种比2的液态发酵工艺,此条件既能保证厌氧消化不受消化产物(胺和挥发性有机酸)积累的抑制,也可以缓冲菌渣中残留林可霉素对消化微生物可能产生的抑制效应.     

Enhancement of anaerobic biodegradability of flower stem wastes with vegetable wastes by co-hydrolysis

The vegetable wastes and flower stems were co-digested to evaluate the anaerobic hydrolysis performance of difficultly biodegradable organic wastes by introducing readily biodegradable organic wastes. The experiments were carried out in batches. When the vegetable wastes were mixed with the flower stems at the dry weight ratio of 1 to 13, the overall hydrolysis rate increased by 8%, 12%, and 2% according to the carbon, nitrogen, and total solid （TS） conversion rate, respectively. While the dry weight ratio was designed as 1 to 3, there was a respective rise of 5%, 15%, and 4% in the conversion rate of carbon, nitrogen, and TS. The enhancement of anaerobic hydrolysis from the mixed vegetable wastes and flower stems can be attributed to the formation of volatile fatty acids （VFA） and nutrient supplement like nitrogen content. The maximum VFA concentration can achieve 1.7 g/L owing to the rapid acidification of vegetable wastes, loosing the structure of lignocellulose materials. The statistic bivariate analysis revealed that the hydrolysis performance was significantly related to the physical and biochemical compositions of the feeding substrate. Especially, the soluble carbon concentration in the liquid was significantly positively correlated to the concentration of nitrogen and hemicellulose, and negatively correlated to the concentration of carbon and lignocellulose in the feeding substrate, suggesting that the regulation and control of feedstock can have an important influence on the anaerobic hydrolysis of organic wastes.     

垃圾填埋场覆土层Ⅱ型甲烷氧化菌的群落结构

采用基于16S rDNA 的变性凝胶梯度电泳(DGGE)技术研究了生活垃圾卫生填埋场和生物反应器填埋场覆土中Ⅱ型甲烷氧化菌群落结构,比较了不同填埋操作方式对Ⅱ型甲烷氧化菌的影响.结果表明,覆土铺有HDPE 膜、无填埋气体渗入的填埋覆土中未发现Ⅱ型甲烷氧化菌;而有填埋气体渗入时,进行渗滤液亚表面灌溉的生物反应器填埋场,无论是否同时进行层内回灌,其覆土中均检测到甲烷孢囊菌(Methylocystis).卫生填埋场填埋龄长达5a 的填埋覆土中发现了甲基弯菌(Methylosinus),填埋龄较低的填埋场覆土中未发现II 型甲烷氧化菌.渗滤液亚表面灌溉及长时间填埋气体驯化能促进Ⅱ型甲烷氧化菌的生长.有机质等营养物质丰富而NH4+-N浓度较低的填埋覆土有利于Ⅱ型甲烷氧化菌的生长.