The fate of metal contaminated sediments in Foundry Cove, New York

The distribution of heavy metal contaminated sediments in Foundry Cove, a freshwater embayment of the Hudson River, was examined twelve years after the discharging of wastes from a battery factory had ceased. Concentrations of Cd, Ni and Co were measured in surficial sediments (top 5 cm) and seven detailed depth profiles. Comparison with earlier surveys showed that metal levels of surficial sediments have been considerably reduced throughout the cove. Evidence suggests that this reduction may be largely due to burial rather than transport of metals out of the cove or a redistribution (via sediment resuspension and redeposition) within the cove. This is suggested by the presence of a peak in metal concentrations at a depth of several centimetres in depositional environments, a calculation showing the loss of waterborne cadmium to be much less than the amount of cadmium lost from the surficial sediment, and the absence of increased pollution in the cleaner parts of the cove. Despite improvement, metal levels remain extremely high, including a persistent 'hot-spot' with levels higher than 10 000 ppm Cd.     

Electrochemical oxidation of bisphenol A. Application to the removal of bisphenol A using a carbon fiber electrode

Leachate samples with a high strength of ammonium-nitrogen (NH4+-N) were collected from a local landfill site in Hong Kong. Two experiments were carried out to study (1) the inhibition of microbial activity of activated sludge by NH4+-N and (2) the chemical precipitation of NH4+-N from leachate as a preliminary treatment prior to the activated sludge process. The experimental results demonstrated that the efficiency of COD removal decreased from 97.7% to 78.1%, and the dehydrogenase activity of activated sludge decreased from 9.29 to 4.93 microg TF/mg MLSS, respectively, when the NH4+-N concentration increased from 53 to 800 mg/l. The experiment also demonstrated that the NH4+-N in the leachate can be quickly precipitated as MgNH4PO4 x 6H2O after addition of MgCl2 x 6H2O + Na2HPO4 x 12H2O. The NH4+-N concentration was reduced from 5618 to 112 mg/l within 15 min when a molar ratio of Mg2+:NH+:PO4(3-) = 1:1:1 was used. The optimum pH to reach the minimum solubility of MgNH4PO4 x 6H2O was found to be in the range of 8.5-9.0. Attention should be given to the high salinity formed in the treated leachate by using MgCl2 x 6H2O + Na2HPO4 x 12H2O, which may affect microbial activity in the following biological treatment processes. Using two other combinations of chemicals [MgO + 85%H3PO4 and Ca(H2PO4)2 x H2O + MgSO4 x 7H2O] could minimise salinity generation after precipitation, while they were less efficient for NH4+-N removal.     

Agriculture's share in the emission of trace gases affecting the climate and some cause-oriented proposals for sufficiently reducing this share

This paper discusses agriculture's share in the world-wide emissions of climate-affecting gases and in the global warming potential (GWP). Proposals also are presented to reduce these emissions adequately, using a cause-oriented approach. Largely due to the fertilization and cultivation of agriculture as well as the burning of biomass, agriculture has a very high share in the anthropogenic emissions of NH(3), N(2)O, CH(4) and CO at >95%, 81%, 70% and 52%, respectively, while its share in the NO(x) and CO(2) emissions is relatively small at 35% and 21%. The GWP of agriculture, based on annually 16.1 x 10(9) tons of CO(2), approaches 63% of the GWP of the energy sector or 80% of the GWP of its CO(2) emissions. At 34% and 32%, respectively, the main originators in the GWP of agriculture would seem to be CO(2) (changing land use) and CH(4) (animal husbandry/rice cropping/biomass burning) followed at 15% by NO(2) (technical and biological N fixation/(cultivation and recultivation/biomass burning) and 10% and 9% by CO and NO(x). The GWP of 3 German dairy cows corresponds with 13.2 tonnes CO(2) per year the GWP of two average German automobiles. However, the ozone-destroying effect of N(2)O and the climate-relevant effects of NH(3) are not yet included here. As with the therapy for other 'modern' boundary-crossing environmental damages, such as acidification or eutrophication, global climate change therapy likewise needs a therapy for the respective effects of reactive compounds of carbon, nitrogen, phosphorous, and sulfur also emitted by agriculture. Proposals for reducing these emissions within the agricultural sector include need-oriented plant, animal and human nutrition, more efficient external and internal nutrient recycling, the cessation of further clearing by burning, along with intensified afforestation mainly in the tropics, targeted measures to reduce nutrient losses/emissions, and measures for more efficient use of nutrients in plant, animal and human nutrition. These measures would at best result in reduced pollution of the global environment but not put it to an end. Decisive, therefore, is both the tolerable extent of mankind and its long-term sustainable way of life.     

The sensitivity of surface waters of Great Britain to acidification predicted from catchment characteristics

Using a combination of soil, land use and geological information, a map of Great Britain has been derived which indicates the sensitivity of surface waters to acidification. For the geological information, a slightly modified version of an available map was used which indicated the sensitivity of groundwaters to acidification. For soils, 1-km databases of soil information for England and Wales and for Scotland were employed to map the soil sensitivity as determined by buffering capacity. The derived soils map was modified to take account of agricultural liming in arable and managed grassland areas using the ITE Land Classification. The final map of surface water sensitivity was obtained by using a geographic information system overlay procedure which enabled each combination of soil and geology sensitivity to be uniquely defined. The final sensitivity classification was based upon expert knowledge and the experience of a similar sensitivity mapping exercise for Wales.     

Means to improve the effect of in situ bioremediation of contaminated soil: an overview of novel approaches

Different aspects of bacterial degradation of organic contaminants in soil, and how to improve the efficiency and reproducibility is discussed in this review. Although bioremediation in principle includes the use of any type of organism in improving the condition of a contaminated site, most commonly bacteria are the degraders and other organisms, such as soil animals or plant roots, play a role in dissemination of bacteria and, indirectly, plasmids between bacteria, and in providing nutrients and co-substrates for the bacteria active in the degradation process. There are a number of different procedures that have been tested more-or-less successfully in attempts to improve reliability, cost efficiency and speed of bioremediation. The methods range from minimal intervention, such as mere monitoring of intrinsic bioremediation, through in situ introduction of nutrients and/or bacterial inocula or improvement of physico-chemical conditions, all the way to excavation followed by on site or ex situ composting in its different varieties. In the past the rule has been that more intervention (leading to higher costs) has been more reliable, but novel ideas are continuously tried out, both as a means to come up with new truly functional applications and also as a line of studies in basic soil microbial ecology. Both approaches generate valuable information needed when predicting outcome of remediation activities, evaluating environmental risks, deciding on cleaning-up approaches, etc. The emphasis of this review is to discuss some of the novel methods for which the value has not been clearly shown, but that in our view merit continued studies and efforts to make them work, separately or in combination.     

Influence of ozone stress on growth processes, yields and grain quality characteristics among soybean cultivars

Field studies were conducted at USDA Beltsville Agricultural Research Center, Beltsville, Maryland, in 1984 and 1985 using open-top chambers to acquire information on the responses of 12 soybean (Glycine max L. Merr.) cultivars to O3 stress and to examine the interactions between maturity groups and O3 stress. Cultivars representing Groups III, IV, and V were exposed for approximately 3 months to charcoal-filtered air (CF) and nonfiltered air plus 40 nl litre(-1) O3 (NF + O3). Ozone was added 6 h d(-1), 5 d week(-1) for 13 weeks. The CF effectively reduced the accumulative oxidant exposure (AOX) to less than 1.0 microl litre(-1) h and the NF + O3 treatment approximately doubled the ambient AOX (16.7 microl litre(-1) h) to about 30 microl litre(-1) h. The AOX estimates the total O3 exposure above 30 nl litre(-1) during an entire growing season. Plant growth rates and relative growth rates were reduced by 17.0 and 14.4%, respectively, when averaged over cultivars. Based on growth rates, the Group III cultivars were the most affected by O3 stress. Averaged over cultivars, leaf expansion rates, leaf conductance, and transpiration rates were lower in the NF + O3 treatment compared to the CF control; however, wide variation was found with the stomatal results from field observations. Combined over years and cultivars, grain yield was reduced by an average of 12.5% by O3 stress with 3 of 12 cultivars showing significant reductions. Grain protein content was increased by 0.7% by O3 stress, but cultivar differences were equal to the differences caused by the O3 treatments. Grain oil content was unchanged by the O3 treatments. Group IV cultivars showed the greatest decrease in grain yield due to O3 stress. Multiple regression analyses were calculated using the difference between the CF and NF + O3 treatment as a measure of O3 stress. Significant positive relationships were found among net assimilation rates, plant growth rates, relative growth rates, and leaf expansion rates, which suggest that growth analysis characteristics would be useful in addition to yield in air pollution tolerance improvement studies with soybeans.     

Cadmium contamination in orchard soils and fruit trees and its potential health risk in Guangzhou, China

This study examines cadmium (Cd) contamination in orchard soils and fruit trees in Guangzhou, China, and assesses its potential health risk. Soils and tissues samples of three species of fruit trees were collected from three orchards. The average soil Cd concentration was 1.27, 1.84 and 0.68 mg/kg in orchards I, II, and III, respectively. The carambola (Averrhoa carambola) accumulated exceptionally high concentrations of Cd (7.57, 10.84, 9.01 and 2.15 mg/kg dw in root, twig, leaf and fruit, respectively), being 6.0-24 times and 4.0-10 times the corresponding tissue Cd in the longan (Dimocarpus longan) and wampee (Clausena lansium), respectively. Furthermore, all Cd concentrations (0.04-0.25 mg Cd/kg fw) of the fruits exceeded the tolerance limit of cadmium in foods of PR China (0.03 mg/kg fw). Our results indicate that the carambola tree has high Cd accumulation capacity and might be a Cd accumulator; and its fruit, among the three species of fruits studied, also poses the highest potential health risk to local residents.     

Heavy metal and Pb isotopic compositions of aquatic organisms in the Pearl River Estuary, South China

The accumulation of trace metals in aquatic organisms may lead to serious health problems through the food chain. The present research project aims to study the accumulation and potential sources of trace metals in aquatic organisms of the Pearl River Estuary (PRE). Four groups of aquatic organisms, including fish, crab, shrimp, and shellfish, were collected in the PRE for trace metal and Pb isotopic analyses. The trace metal concentrations in the aquatic organism samples ranged from 0.01 to 2.10 mg/kg Cd, 0.02 to 4.33 mg/kg Co, 0.08 to 4.27 mg/kg Cr, 0.15 to 77.8 mg/kg Cu, 0.17 to 31.0 mg/kg Ni, 0.04 to 30.7 mg/kg Pb, and 8.78 to 86.3 mg/kg Zn (wet weight). High concentrations of Cd were found in crab, shrimp and shellfish samples, while high concentration of Pb was found in fish. In comparison with the baseline reference values in other parts of the world, fish in the PRE had the highest elevated trace metals. The results of Pb isotopic compositions indicated that the bioaccumulation of Pb in fish come from a wide variety of food sources and/or exposure pathways, particularly the anthropogenic inputs.     

Improvements of nano-SiO2 on sludge/fly ash mortar

Sewage sludge ash has been widely applied to cementitious materials. In this study, in order to determine effects of nano-SiO(2) additives on properties of sludge/fly ash mortar, different amounts of nano-SiO(2) were added to sludge/fly ash mortar specimens to investigate their physical properties and micro-structures. A water-binding ratio of 0.7 was assigned to the mix. Substitution amounts of 0%, 10%, 20%, and 30% of sludge/fly ash (1:1 ratio) were proposed. Moreover, 0%, 1%, 2%, and 3% of nano-SiO(2) was added to the mix. Tests, including SEM and compressive strength, were carried out on mortar specimens cured at 3, 7, and 28 days. Results showed that sludge/fly ash can make the crystals of cement hydration product finer. Moreover, crystals increased after nano-SiO(2) was added. Hence, nano-SiO(2) can improve the effects of sludge/fly ash on the hydration of mortar. Further, due to the low pozzolanic reaction active index of sludge ash, early compressive strengths of sludge/fly ash mortar were decreased. Yet, nano-SiO(2) could help produce hydration crystals, which implies that the addition of nano-SiO(2) to mortar can improve the influence of sludge/fly ash on the development of the early strength of the mortar.     

Development of a new quality fair access best value performance indicator (BVPI) for recycling services

Recycling schemes are being used worldwide to reduce the impact of municipal waste. Those using public funds are usually obliged to set performance indicators by which the standards of such schemes can be measured. In the UK, a set of statutory Best Value Performance Indicators (BVPI) must be reported annually, such as the Quality of Fair Access, which monitors the public's access to recycling facilities within 1000 m (known as BVPI 91). This work shows that BVPI 91, and performance indicators like it, quantify only very basic recycling services. A much more sensitive performance indicator is developed in this paper, labelled as the Maximum Practicable Recycling Rate Provision (MPRRP) achievable by a local authority. It indicates the percentage of local waste that could be reasonably recycled using the services provided, calculated on the basis of the average composition of the local waste, the local population coverage for collection of any materials, and nationally provided information stating how much of each material stream is generally suitable (practical) for recycling. Evidence for the usefulness of this new quantity is presented. Although this paper refers a particular performance indicator in the UK, its findings are applicable to all urban areas worldwide needing to monitor recycling service. Furthermore, the MPRRP could be used for planning purposes, and for determining the level of performance of an existing service, by comparing its predicted recycling rate to that actually obtained. Further work is now being carried out on this.