An alternative supercritical fluid extraction system for aqueous matrices and its application in pesticides residue analysis

Supercritical fluid extraction (SFE) is a rapid and convenient method for the isolation of organic compounds from environmental samples. This paper describes a supercritical carbon dioxide (CO2) extraction system that uses a newly designed extraction cell to recover organic compounds from an aqueous matrix. Analysis of the extracts by gas chromatography-electron capture detector (GC-ECD) indicated that the herbicide trifluralin (2,6-dinitro-N,N-dipropyl-4-trifluoromethylaniline) could be quantitatively extracted by using the SFE system proposed with small amounts of sample. The percentage of recovery obtained with the SFE system described was twice as high as the result obtained using a conventional solid-phase extraction technique. Extraction by SFE was completed in a short period of time using a simple and low-cost home-made system that did not require the use of organic solvents.     

Solventless sample preparation for pesticides analysis in environmental water samples using solid-phase microextraction-high resolution gas chromatography/mass spectrometry (SPME-HRGC/MS)

Solid-phase micro-extraction (SPME) coupled on line with high resolution gas chromatography and mass spectrometric detection is described for the analysis of pesticides in environmental water samples. Experiments were performed in order to optimize the SPME extraction conditions for selected pesticides including tiomethon, trichorfon, dimethoate, diazinon, malathion, dicofol, methidathion, ethion, bromopropylate and pyrazophos from spiked water solutions. To enhance the SPME efficiency, experimental conditions including the fiber composition, stirring rate, temperature, adsorption time, desorption time and salt concentration were optimized. After validation, the SPME-GC/MS methodology was applied to real-world environmental water samples.     

浅水湖泊水生植物适宜生物量评估方法的探讨

总结了水生植物对湖泊生态系统的影响、水生植物生物量控制与收割管理的研究,分析了目前浅水富营养化湖泊恢复过程中水生植物生物量确定方法的不足;立足于水生植物生长特点,提出了基于湖泊生态模型的浅水湖泊大型水生植物在生长期和衰亡期的适宜生物量评估方法的研究框架,本文可为指导湖泊生态修复工程及其后续维护,为完善健康湖泊的综合评价标准和湖泊生态修复理论提供科学支撑.     

Comparison of the effects of aluminum and iron(Ⅲ) salts on ultrafiltration membrane biofouling in drinking water treatment

Coagulation plays an important role in alleviating membrane fouling, and a noticeable problem is the development of microorganisms after long-time operation, which gradually secrete extracellular polymeric substances(EPS). To date, few studies have paid attention to the behavior of microorganisms in drinking water treatment with ultrafiltration(UF)membranes. Herein, the membrane biofouling was investigated with different aluminum and iron salts. We found that Al_2(SO_4)_3·18 H_2O performed better in reducing membrane fouling due to the slower growth rate of microorganisms. In comparison to Al_2(SO_4)_3·18H_2O,more EPS were induced with Fe_2(SO_4)_3·x18H_2O, both in the membrane tank and the sludge on the cake layer. We also found that bacteria were the major microorganisms, of which the concentration was much higher than those of fungi and archaea. Further analyses showed that Proteobacteria was dominant in bacterial communities, which caused severe membrane fouling by forming a biofilm, especially for Fe_2(SO_4)_3·x18H_2O. Additionally, the abundances of Bacteroidetes and Verrucomicrobia were relatively higher in the presence of Al_2(SO_4)_3·18 H_2O,resulting in less severe biofouling by effectively degrading the protein and polysaccharide in EPS. As a result, in terms of microorganism behaviors, Al-based salts should be given preference as coagulants during actual operations.     

基于Logistic方程描述的鱼食和阿特拉津共同作用对铜绿微囊藻生长的影响

在养殖水域中地表径流等可引起水域中除草剂浓度升高,威胁养殖水环境的生态平衡.为评价阿特拉津和鱼食在水环境中的生态风险,以ρ（阿特拉津）（0、5、10、20和40 μg/L）及鱼食（鱼食为MⅡ培养基中的氮、磷营养源）投加量（0.05、0.20 g;d < 0.85 mm）为变量,基于Logistic方程探讨阿特拉津和鱼食共同作用下铜绿微囊藻（Microcystis aeruginosa）的生长,并研究藻类生长对鱼食营养盐的利用.结果表明:在ρ（阿特拉津）为0~40 μg/L范围内,铜绿微囊藻生长曲线均可用Logistic方程描述（R2=0.975~0.996）;一般情况下,基于Logistic方程得到的比生长速率、增殖速率和抑制率拟合公式均可描述相应实测值的变化,相关性分析得到的拟合值与实测值相关系数（R2）分别为0.861~0.992、0.381~0.839和0.621~0.839.相同ρ（阿特拉津）下,鱼食投加量对藻细胞密度有显著影响（P < 0.05）,Logistic方程拟合得到的理论最大藻细胞密度（K）随鱼食投加量的增加而增大.相同鱼食投加量下,ρ（阿特拉津）为5~40 μg/L时对藻类生长有抑制作用,随ρ（阿特拉津）增加,抑制强度逐渐升高,藻细胞密度越低,最大藻细胞密度随ρ（阿特拉津）的增加而减小.藻细胞密度与PO₄3--P利用量之间关系可用方程N=a×△cb描述,R2为0.23~0.99;藻细胞密度与NH₄+-N利用量之间关系可用方程N=a+b×△c描述,R2为0.04~0.99;藻细胞密度与TN/TP、NH₄+-N/TN和PO₄3--P/TP的关系均可用幂函数方程N=a"xb'描述,R2分别为0.72~0.78、0.66~0.83和0.55~0.56.研究显示,Logistic方程可用于分析阿特拉津和鱼食对铜绿微囊藻生长的影响,且藻类生长与营养盐质量浓度之间存在一定的定量关系.      

河谷型城市风场及污染物扩散的CFD数值仿真

为研究河谷型城市地形及其引起的风场和污染物扩散的复杂问题,利用CFD（计算流体力学）方法和复杂地形网格生成技术,建立河谷型城市风场及大气污染分布的数值仿真模型,实现CFD方法在复杂地形空气运动和污染物扩散方面的应用.分别使用LES（large eddy simulation）模型和mixture模型研究兰州市地面风场特征和污染物扩散形态,计算得到的污染物分布结果与实测结果分布一致.结果表明:复杂地形对空气运动的影响很大,如风速因山体屏障作用会呈现带状分布特征,山体后侧易出现弱风区域;同时,风场会密切影响污染物扩散,决定了污染物扩散形态,如幅散能够影响污染物扩散范围及污染水平.而给定西北风条件下,如地面以上10 m、风速为5 m/s、不受地形阻挡情况下,工业区污染物浓度被稀释10倍,约扩散2.2 km;山体阻挡会抑制污染物纵向扩散,表现在山体阻挡情况下污染物稀释100倍时的扩散长度约为相对平坦区域的1/3.此外,不同的入口风向会引起空气运动与山体相互作用发生变化,进而会使得地面风速、局部风场存在差异,造成污染物扩散及分布形态差异.研究显示,CFD方法可行,模型可靠,可以用来研究地形对风场和污染物扩散的影响.      

采用大涡PIV研究Taylor-Couette流及其对混凝过程的影响

采用大涡PIV方法对Taylor-Couette流场的湍动能及湍动能耗散率进行了估算,并利用数值模拟对其进行验证,结合絮凝实验,综合对比速度矢量、湍动能分布、湍动能耗散率分布及对应流场中混凝过程的絮体图像,探究了湍动能与湍动能耗散率对絮凝效能的影响.结果表明,大涡PIV法与数值模拟在雷诺数较高的情况下有较好的一致性,且雷诺数越大一致性越好.在Taylor-Couette涡流场中,随着雷诺数的增大,湍动能与湍动能耗散率数值不断增大,且在流场中的分布由规律有序到紊乱最终趋于各向均匀一致.而混凝过程中湍动能与湍动能耗散率的数值大小及其在流场中的空间分布情况,均对产生絮体的大小和浊度去除率有较大影响.     

河南省冬季3次重污染过程的数值模拟及输送特征分析

利用WRF-Chem模式模拟2015年11月27日—12月1日、12月5—14日、12月19—25日河南3次重污染过程,结合空气污染资料和ERA-Interim再分析资料,对比分析了这3次重污染过程的开始、持续和结束及污染物的输送特征.结果表明,静稳天气有利于污染的发展持续,3次重污染过程的结束均是由西路冷空气入侵造成的.第1次重污染过程平均风场上的风速均为小风或静风,从湖北到河南南部风向为偏南风;而第2和第3次重污染过程平均风场分别以偏东和偏北风为主.第2和第3次重污染过程中均存在明显的由北向南的污染物输送过程.3次重污染过程中,河南省本地排放对本省PM_(2.5)浓度的平均贡献率最大,而河南省周边区域对河南PM_(2.5)浓度的平均贡献率在这3次过程中不一样,第1次重污染过程,河南南部主要受偏南风影响,湖北对河南PM_(2.5)浓度的平均贡献率最大,为20.7%;第2和第3次重污染过程主要受偏东风影响,安徽和江苏对河南PM_(2.5)浓度的平均贡献率最大,分别为17.7%和18.5%.3次重污染过程中,安阳的主要污染输送源均不相同,分别来自河北、江苏和安徽、本省.     

高校学生公寓应急疏散模拟与优化

运用应急疏散软件Pathfinder对某高校学生公寓的人员疏散进行了模拟,结果表明,休息时间段内公寓发生的突发事件更容易造成人员疏散运动时间的延长;同等条件下女生比男生所需要的人员疏散运动时间更长。通过合理规划疏散路线,对原有模型进行了优化,并使用人员疏散运动时间和单位有效疏散宽度使用率两个指标,来定量对比优化前后人员疏散的均衡度和疏散效果,给高校学生公寓的应急和安全管理工作提供参考。     

军用飞机结构类型聚类分析

选取某型飞机16个典型结构,采用温、湿度测量仪测量其局部温、湿度,测量周期为2个月,分别获得673个有效温、湿度实测数据。根据实测数据,采用模糊聚类算法对飞机结构类型进行归并分析,当模糊矩阵阈值λ=0．7时,飞机结构类型可归并为开式、半开式、封闭式3种典型结构形式。