Influence of various emission scenarios on ozone in Europe

In this study, we investigated the effect of numerous regulations enforced since 1985 to improve air quality on ozone in Europe with the focus on Switzerland, using the Comprehensive Air Quality Model with Extensions (CAMx) for a specific summer period. Several emission scenarios for the year 2010 were also considered. The model results suggest that the emission reductions of ozone precursors should have been effective to reduce ozone production between 1985 and 2000 in northern Switzerland. However, observations do not indicate any significant change in surface ozone levels since early 1990s, except in the region of Zurich where there is a small negative trend. On the other hand, the model predictions match very well the spatial variability of the trends but the calculated trends are around 0.5 ppb year⁻¹ lower than those observed. This difference is similar to the background ozone increase as suggested by the long-term observations at the high Alpine station Jungfraujoch. These results support the hypothesis that the decrease in local ozone production due to emission reductions might have been partly or completely compensated by the simultaneous increase in the background ozone. In 2010, a strict application of the Gothenburg Protocol in Europe would lead to a decrease in peak ozone concentrations by about 5% in Switzerland under the meteorological conditions applied. Our calculations also indicated that emission controls only in Switzerland would not be very effective to improve the air quality in the future. The further development of the background ozone will in any case be very important for the tropospheric ozone levels.     

Necromass production: studies in undisturbed and logged Amazon forests.

Necromass stocks account for up to 20% of carbon stored in tropical forests and have been estimated to be 14-19% of the annual aboveground carbon flux. Both stocks and fluxes of necromass are infrequently measured. In this study, we directly measured the production of fallen coarse necromass (> or = 2 cm diameter) during 4.5 years using repeated surveys in undisturbed forest areas and in forests subjected to reduced-impact logging at the Tapajos National Forest, Belterra, Brazil (3.08 degrees S, 54.94 degrees W). We also measured fallen coarse necromass and standing dead stocks at two times during our study. The mean (SE) annual flux into the fallen coarse necromass pool in undisturbed forest of 6.7 (0.8) Mg x ha(-1) x yr(-1) was not significantly different from the flux under a reduced-impact logging of 8.5 (1.3) Mg x ha(-1) x yr(-1) With the assumption of steady state, the instantaneous decomposition constants for fallen necromass in undisturbed forests were 0.12 yr(-1) for large, 0.33 yr(-1) for medium, and 0.47 yr(-1) for small size classes. The mass weighted decomposition constant was 0.15 yr(-1) for all fallen coarse necromass. Standing dead wood had a residence time of 4.2 years, and approximately 0.9 Mg x ha(-1) x yr(-1) of this pool was respired annually to the atmosphere through decomposition. Coarse necromass decomposition at our study site accounted for 12% of total carbon remineralization, and total aboveground coarse necromass was 14% of the aboveground biomass. Use of mortality rates to calculate production of coarse necromass leads to an underestimation of coarse necromass production by 45%, suggesting that nonlethal disturbance such as branch fall contributes significantly to this flux. Coarse necromass production is an important component of the tropical forest carbon cycle that has been neglected in most previous studies or erroneously estimated.     

Variations in Epilimnion Thickness in Small Boreal Shield Lakes: Relationships with Transparency, Weather and Acidification

We used multiple linear regression analysis to investigate relationships between late-summer epilimnion thickness, transparency, lake area, acidity and summer weather conditions in a large ($n = 116$) multi-year data set for 9 small Boreal Shield lakes. Dissolved organic carbon (DOC) was the best individual predictor of late summer epilimnion thickness ($r^{2} = 0.69$). Total chlorophyll~$a$, the number of days between ice-out and late-summer stratification, and lake area collectively explained an additional 14% of the variation in epilimnion thickness. The three attributes of summer weather that we examined, mean daily temperature, mean daily wind speed, and mean daily hours of bright sunshine, did not add to the predictive ability of our regression model. Lake acidity also did not add directly to the predictive ability of the model, likely because DOC concentrations already reflected the effects of pH. Our study supports an increasing body of evidence indicating that the dominant effects of climate change on lake thermal structure in small lakes will be through effects on processes that affect lake transparency.     

Comparison of soil solution sampling techniques to assess metal fluxes from contaminated soil to groundwater

The unsaturated zone plays a major role in elemental fluxes in terrestrial ecosystems. A representative chemical analysis of soil pore water is required for the interpretation of soil chemical phenomena and particularly to assess Trace Elements (TEs) mobility. This requires an optimal sampling system to avoid modification of the extracted soil water chemistry and allow for an accurate estimation of solute fluxes. In this paper, the chemical composition of soil solutions sampled by Rhizon® samplers connected to a standard syringe was compared to two other types of suction probes (Rhizon®?+?vacuum tube and Rhizon®?+?diverted flow system). We investigated the effects of different vacuum application procedures on concentrations of spiked elements (Cr, As, Zn) mixed as powder into the first 20 cm of 100-cm columns and non-spiked elements (Ca, Na, Mg) concentrations in two types of columns (SiO₂ sand and a mixture of kaolinite?+?SiO₂ sand substrates). Rhizon® was installed at different depths. The metals concentrations showed that (i) in sand, peak concentrations cannot be correctly sampled, thus the flux cannot be estimated, and the errors can easily reach a factor 2; (ii) in sand?+?clay columns, peak concentrations were larger, indicating that they could be sampled but, due to sorption on clay, it was not possible to compare fluxes at different depths. The different samplers tested were not able to reflect the elemental flux to groundwater and, although the Rhizon®?+?syringe device was more accurate, the best solution remains to be the use of a lysimeter, whose bottom is kept continuously at a suction close to the one existing in the soil.     

Methane balance of a bioreactor landfill in Latin America

This paper presents results from a methane (CH4) gas emission characterization survey conducted at the Loma Los Colorados landfill located 60 km from Santiago, Chile. The landfill receives approximately 1 million metric tons (t) of waste annually, and is equipped with leachate control systems and landfill gas collection systems. The collected leachate is recirculated to enable operation of the landfill as a bioreactor. For this study, conducted between April and July 2000, a total of 232 surface emission measurements were made over the 23-ha surface area of the landfill. The average surface flux rate of CH4 emissions over the landfill surface was 167 g x m(-2) x day(-1), and the total quantity of surface emissions was 13,320 t/yr. These values do not include the contribution made by "hot spots," originating from leachate pools caused by "daylighting" of leachate, that were identified on the landfill surface and had very high CH4 emission rates. Other point sources of CH4 emissions at this landfill include 20 disconnected gas wells that vent directly to the atmosphere. Additionally, there are 13 gas wells connected to an incinerator responsible for destroying 84 t/yr of CH4. The balance also includes CH4 that is being oxidized on the surface of the landfill by meth-anotrophic bacteria. Including all sources, except leachate pool emissions, the emissions were estimated to be 14,584 t/yr CH4. It was estimated that less than 1% of the gas produced by the decomposition of waste was captured by the gas collection system and 38% of CH4 generated was emitted to the atmosphere through the soil cover.     

Stochastic Watershed Water Quality Simulation for TMDL Development – A Case Study in the Newport Bay Watershed1

Abstract: Systematic consideration of uncertainty in data, model structure, and other factors is generally unaddressed in most Total Maximum Daily Load (TMDL) calculations. Our previous studies developed the Management Objectives Constrained Analysis of Uncertainty (MOCAU) approach as an uncertainty analysis technique specifically for watershed water quality models, based on a synthetic case. In this study, we applied MOCAU to analyze diazinon loading in the Newport Bay watershed (Southern California). The study objectives included (1) demonstrating the value of performing stochastic simulation and uncertainty analysis for TMDL development, using MOCAU as the technique and (2) evaluating the existing diazinon TMDL and generating insights for the development of scientifically sound TMDLs, considering uncertainty. The Watershed Analysis Risk Management Framework model was used as an example of a complex watershed model. The study revealed the importance and feasibility of conducting stochastic watershed water quality simulation for TMDL development. The critical role of management objectives in a systematic uncertainty assessment was well demonstrated. The results of this study are intuitive to TMDL calculation, model structure improvement and sampling strategy design.     

Mobile measurements of aerosol number and volume size distributions in an Alpine valley: Influence of traffic versus wood burning

The spatial variability of highly time resolved size distributions was investigated in a narrow valley which provides the opportunity to study the impact of different sources on ambient particle concentrations during summer and winter time. The measurements were performed with a Fast Mobility Particle Sizer (FMPS) from TSI, Inc. on a mobile laboratory in Southern Switzerland. The results indicate enhanced number concentrations (between 150 000 and 500 000 cm^?3) along the busy highway A2 which is the main transit route through the Swiss Alps connecting the northern and southern part of Switzerland. Especially the nanoparticles with diameters lower than 30 nm showed strongly increased number concentrations on the highway both in summer and winter. In winter time, high aerosol volume concentrations (PM_0.3) were found in villages where wood burning is often used for heating purposes. Both traffic and wood burning were found to be important sources for particulate mass which accumulates during temperature inversions in winter time. Traffic was the dominant and wood burning a minor source for the nanoparticle number concentration. This is important regarding health impacts and its attribution to different sources because wood burning might contribute most to particulate mass whereas at the same time and place traffic contributes most to particulate number. In addition, during summer time volatility measurements were performed with the FMPS showing that the nucleation mode prevalently seen on the highway was removed by more than 95% by thermal treatment.     

Diamondback terrapins as indicator species of persistent organic pollutants: Using Barnegat Bay, New Jersey as a case study

The diamondback terrapin’s (Malaclemys terrapin) wide geographic distribution, long life span, occurrence in a variety of habitats within the saltmarsh ecosystem, predatory foraging behavior, and high site fidelity make it a useful indicator species for contaminant monitoring in estuarine ecosystems. In this study fat biopsies and plasma samples were collected from males and females from two sites within Barnegat Bay, New Jersey, as well as tissues from a gravid female and blue mussels (Mytilus edulis), which are terrapin prey. Samples were analyzed for persistent organic pollutants (POPs), including polychlorinated biphenyls (PCBs), polybrominated diphenyl ethers (PBDEs), chlorinated pesticides, and methyl-triclosan. Terrapins from the northern site, Spizzle Creek, closest to influences from industrial areas, had higher POP concentrations for both tissues than terrapins from the less impacted Forsythe National Wildlife Refuge. Sex differences were observed with males having higher contaminant concentrations in fat and females in plasma. PCB patterns in terrapin fat and plasma were comparable to other wildlife. An atypical PBDE pattern was observed, dominated by PBDEs 153 and 100 instead of PBDEs 47 and 99, which has been documented in only a few other turtle species. The typical PBDE patterns measured in mussels, terrapin prey, suggests that the terrapin may efficiently biotransform or eliminate PBDE 47 and possibly PBDE 99. Plasma contaminant concentrations significantly and positively correlated with those in fat. This study addresses several aspects of using the terrapin as an indicator species for POP monitoring: site and sex differences, tissue sampling choices, maternal transfer, and biomagnification.     

Effective Efficiency as a Tool for Sustainable Water Resources Management1

Abstract: The sufficiency and usefulness of Effective Efficiency (EE) as a water resources index is shown through conceptual formulation of a generalized EE and practical applications. Two EE models are proposed: one is based on water quantity and the other on quantity and quality, with the possibility of considering water reuse (recycling) in both. These models were developed for two scales: the first is called Project EE and the second Basin EE. The latter gives the influence of the project on the water resources systems of the basin while the former does not make such connection to the whole basin. Such considerations give proper signals as to the adequacy of any intervention to increase efficiency. A crucial distinction is made between depletion and diversion water savings. Classical Efficiency (CE) models are analyzed and compared with the various EE models. CE results in values that are less than EE because of not considering water reuse and water quality in its calculation. Some authors, pointing to these problems – particularly the first problem – have advocated the use of hydrological “fractions” instead of efficiency concepts. This paper defends the use of a proper efficiency model such as EE and suggests putting an end to the use of the CE indicators. To test the models, they are applied to five cases of irrigation and city water use in the United States and Egypt. The analysis of the results demonstrates all the points mentioned above and the potential of the EE models to adequately describe the water resources efficiency and sustainability at a location.