A review of measurement methods for peracetic acid (PAA)

• Physical and chemical properties and application of peracetic acid solution. • Determination method of high concentration peracetic acid. • Determination method of residual peracetic acid (low concentration). Peroxyacetic acid has been widely used in food, medical, and synthetic chemical fields for the past several decades. Recently, peroxyacetic acid has gradually become an effective alternative disinfectant in wastewater disinfection and has strong redox capacity for removing micro-pollutants from drinking water. However, commercial peroxyacetic acid solutions are primarily multi-component mixtures of peroxyacetic acid, acetic acid, hydrogen peroxide, and water. During the process of water treatment, peroxyacetic acid and hydrogen peroxide (H₂O₂) often coexist, which limits further investigation on the properties of peroxyacetic acid. Therefore, analytical methods need to achieve a certain level of selectivity, particularly when peroxyacetic acid and hydrogen peroxide coexist. This review summarizes the measurement and detection methods of peroxyacetic acid, comparing the principle, adaptability, and relative merits of these methods.     

A novel sigma coordinate system to simulate abrupt changes of underwater terrain in a hydrodynamic model: application to Lake Mead,USA

The sigma (SIG) coordinate system in ocean circulation simulation models results inevitably in horizontal pressure gradient error. This problem also emerges in models of deep lakes or reservoirs with the same characteristics of underwater terrain mutation. SIG coordinates reflect vertical relative stratification but cannot be used to calculate horizontal pressure gradient force in places with drastic topographic changes; this results in vertical water temperature and circulation errors. In deep lakes or reservoirs, differences in water density caused by the temperature difference between upper and lower water bodies is the primary cause of thermal stratification phenomena. Lake Mead was used as a case study on steep topography based on Environmental Fluid Dynamics Code (EFDC) model in this study. SIG coordinates result in close agreement between the calibrated temperature time series at the top and middle water layers, but disparity in the bottom water layer. The error emerges in the horizontal pressure gradient error due to the SIG coordinate transformation. Neither increasing the vertical resolution nor adjusting the horizontal viscosity coefficient resolve this error. We test the sigma-zed (SGZ) coordinate which combines Z coordinate and SIG coordinate as a replacement for the SIG coordinate to find that they effectively reduce the model’s runtime and simulation efficiency. The vertical temperature distribution in SGZ coordinate mode is more accurate than the distribution in SIG coordinate mode. The Navier-Stokes horizontal gradient and advection diffusion equation results under SIG coordinates are very sensitive to the pressure gradient. The replacement also enhances resolution near the thermocline, facilitates reclosing of the water bottom and the equal sigma surface, lends significant advantages in terms of vertical temperature in the simulation for local deep water with steep terrain, and shortens runtime for 0.14 h. SGZ mixed coordinates are recommended in the simulation of deep lakes or reservoirs wherein the underwater topography is large (with abundant continuous deep trenches or reefs).

     

Integrated factor analysis of water level variation in geographically isolated ponds

Environmental Science and Pollution Research - Small geographically isolated ponds provide a multitude of ecological functions and services, but water table fluctuations alter the magnitude of...     

Soil labile and recalcitrant carbon and nitrogen dynamics in relation to functional vegetation groups along precipitation gradients in secondary grasslands of South China

Environmental Science and Pollution Research - Soil labile and recalcitrant carbon (C) and nitrogen (N) are strongly controlled by plant inputs and climatic conditions. However, the interrelation...     

液膜分离技术处理含Cr6+废水的研究

采用液膜分离技术处理Cr^6＋质量浓度为200—1000mg／L的废水,考察了膜溶剂、载体、内水相、外水相、pH、乳水比（乳液与废水的体积比）等因素对处理效果的影响,通过正交实验得出最佳实验条件。结果表明,在膜溶剂为煤油、载体为三辛胺、内水相为氯氧化钠、氢氧化钠质量分数为2％、pn为1、乳水比为1：4的最佳条件下,Cr^6＋的去除率可达98．4％。     

我国危险废物特性鉴别技术体系研究

详细深入地调查分析了国外危险废物鉴别技术体系的特点和适用条件,以及我国危险废物管理的特点.在借鉴国内外经验与教训的基础上,提出了我国危险废物特性鉴别的技术路线及危险废物鉴别的环境保护目标,建立了危险废物鉴别技术的方法学.在充分研究的基础上,编制完成了全新的<国家危险废物名录>和<危险废物鉴别标准>,以及相应的规范和方法标准.这些技术文件形成了我国独特、完整的危险废物鉴别技术体系,为全面开展危险废物无害化管理提供了有力的技术支持.      

Growth factors, kinetics and biodegradation mechanism associated with Pseudomonas nitroreducens TX1 grown on octylphenol polyethoxylates

The growth properties and biodegradation mechanism of a Gram-negative bacterium, Pseudomonas nitroreducens TX1 that was able to grow on branched octylphenol polyethoxylates (OPEO(n), average n=9.5) as the sole carbon source over a wide concentration range (1-100,000 mgl(-1)) were studied. Analysis of growth factors indicated the highest specific growth rate (micro) of 0.53 h(-1) was obtained at an initial concentration of 5,000 mgl(-1) OPEO(n). An optimal C/N ratio of 12 was obtained for (NH(4))(2)SO(4) as the nitrogen source in a cultivated medium at pH 7. The kinetic analysis demonstrated that bacterial growth and OPEO(n) degradation followed the Monod equation and were based on a substrate concentration inhibition model and pseudo-first-order reaction, respectively. The substrate inhibition coefficient was over 18,000 mgl(-1) and this indicates that the strain has an ability to sustain growth at high concentrations of OPEO(n) and use it as the sole carbon source under such a stress condition. Furthermore, LC-MS analysis showed that the biodegradation mechanism of dodecyl octaethoxylate (AEO8) by P. nitroreducens TX1 was the sequential cleavage of the ethoxylate chain.     

Why Won’t They Come? Stakeholder Perspectives on Collaborative National Forest Planning by Participation Level

Collaboration has taken root in national forest planning, providing expanded opportunities for stakeholder participation in decision-making, but are these processes considered meaningful by key stakeholders? Do the processes result in increased participation by key stakeholders? We present results of a study of stakeholder perspectives of a collaborative planning process on the Grand Mesa, Uncompahgre, and Gunnison National Forests in Western Colorado, U.S.A. The stakeholders were stratified by participation levels in order to explore a possible relationship between participation and perceptions of the collaborative process. We used a Q-methodology approach to compare and contrast perspectives across participant levels in the North Fork Valley Landscape Working Group process. The results demonstrate four distinct perspectives on the collaborative process: 1) The collaborative process is valued by the Forest Service and will directly influence planning decisions; 2) The Forest Service, the collaborative process, and other stakeholders are not to be trusted; 3) The collaborative process is most effective when emphasizing place-specific dialogue that primarily involves stakeholders educating the Forest Service about issues; and 4) Forest planning involves issues requiring the application of scientific knowledge and expertise rather than collaboration. These perspectives were not strongly associated with participation levels, with time constraint being the primary mediating factor affecting participation. There are several possible actions policymakers and planners can take to enhance participation and overcome high rates of nonparticipation.     

再生聚丙烯的洁净化和高质化应用

聚丙烯以其优异的机械性能、高的性价比和多重改性方式成为重要的通用树脂之一,这些产品废弃后产生了种类繁多和数量巨大的再生聚丙烯.通过将再生聚丙烯根据性能和来源进行分类,然后分类阐述各再生聚丙烯物料特点,结合再生聚丙烯改性方式,为高质化应用提出方向.     

河流水质自动监测站选址适宜性评价

为建立和量化适于河流水质自动监测站选址的评价方法体系,提出了河流水质自动监测站选址一致性、可行性和适宜性评价问题,并建立了选址可行性和适宜性评价2套指标体系。以自动站选址与手工断面位置不一致为前提,利用累乘指数判断选址可行性,在可行的基础上利用模糊综合评价进一步分析选址的适宜性。应用案例显示,罗汉大桥断面水质自动站选址于手工断面下游150 m处是可行的,并且此选址高度适宜,在具有水质代表性的同时兼顾成本和运维管理需求。