HCI Sorption by Dry NaHCO3 for Incinerator Emissions Control

The sorption of hydrochloric acid (HCI) by thermally decomposed sodium bicarbonate (NaHCO₃) was investigated using a fixed-bed reactor containing sorbent particles dispersed in a bed of spherical glass beads. The gas flow rate (68° F and 760 mm Hg) was 0.039 cfm (1.1 liter/min) and the bed had a cross-sectional area of 0.0055 sq. ft. (5.1 sq. cm). The influence of particle diameter (10, 45 and 163 μm), temperature (225, 275, 375, 455, and 550° F), superficial gas velocity (11 and 21 fpm at reactor conditions, 375° F), and Inlet HCI gas concentration (415 ppm and 760 ppm in N₂, 275 and 455° F) were studied. Results showed that HCI sorption increased strongly with increasing temperature but was only weakly dependent on particle diameter, superficial gas velocity, and HCI gas concentration.     

A Combined Ca(OH)2/NH3 Flue Gas Desulfurization Process for High Sulfur Coal: Results of a Pilot Plant Study

The removal of SO₂ with atomization of a slaked lime slurry and supplemental injection of gaseous NH₃ were tested in a conventional spray dryer/baghouse system for SO₂ concentrations of 2000 ppm and 3000 ppm and a 30° F approach to saturation. Results at 3000 ppm of SO₂ showed an average SO₂ removal efficiency of 90.3 percent at a combined stoichiometric ratio of 0.95-1.10 and an average overall sorbent utilization of 91.6 percent. The overall molal ratio of NH₃/SO₂ reaction was found to be 2:1 under the test conditions Particle size analyses, and EP toxicity tests were conducted on the products of the reactions.     

Comparison of the Annular Denuder System and the Transition Flow Reactor for Measurements of Selected Dry Deposition Species

An intensive field study was conducted in Research Triangle Park, North Carolina in the fall of 1986. Ambient concentrations of the following constituents were obtained: nitric acid, nitrous acid, nitrogen dioxide, sulfur dioxide, ammonia, hydrogen ion, and particulate nitrate, sulfate, and ammonium. Results collected using the annular denuder system (ADS) and the transition flow reactor (TFR) are presented and compared.

Both types of samplers had operational detection limits on daily (22-hour) samples that were generally below 1 μg m_-3 suggesting that both samplers can provide sensitive measurements for most of the constituents of interest. Both the ADS and TFR show reasonable (>25 percent) within-sampler precision for most of the measured species concentrations, except TFR fine particulate nitrate measurements where results were frequently negative (The TFR fine particulate nitrate measurement is calculated using subtraction of positive numbers).

Comparison of ADS and TFR daily results showed good agreement for total particulate sulfate, the sum of total (coarse plus fine) particulate and gaseous nitrate, and ammonia. As a result of different inlet particle collection efficiencies, the ADS fine particulate sulfate exceeded the TFR (5 percent). In the absence of a filter to collect volatilized particulate ammonium in the ADS, the sum of total particulate and gaseous ammonium in the TFR exceeded that in the ADS. Of potentially more importance, ADS measurements of SO₂ and H⁺ exceeded those of the TFR, while TFR measurements of HNO₃ exceeded those of the ADS. Results of this study suggest that the TFR may provide biased measurements of SO₂, H⁺, HNO₃, and Fine NO₃ ^- that cannot be corrected without modifications to the fundamental design of the sampling system.     

The Superfund Remedial Action Decision Process: A Review of Fifty Records of Decision

Abstract

Although the Superfund remedial action decision process is a complex process involving a variety of technical, political, and public health issues, the primary goal of remedial action is the protection of public health. We performed an in-depth analysis of 50 post-SARA Records of Decision in order to characterize the role of risk assessment in the decision-making process and determine whether decisions are being made in an effective and environmentally protective manner. Our findings indicate that the majority of decisions to remediate Superfund sites are based on the existence of contamination per se and not on actual public health risk. Although hypothetical risk is an essential consideration, this gray area is not well-defined in the current decision-making process.

The lack of assessment of the degree of risk reduction associated with the remedial alternatives evaluated and the lack of support indicating the effectiveness of the remedial alternatives selected also constitute major weaknesses in the majority of decisions. These inadequacies undermine rationales regarding the protectiveness and cost-effectiveness of the remedial alternatives selected. The fact that objectives beyond addressing public health risk are often unclear in the decision-making process also weakens rationales for costeffectiveness.     

Indoor Ozone Exposures

Indoor and outdoor ozone concentrations were measured from late May through October at three office buildings with very different ventilation rates. The indoor values closely tracked the outdoor values, and, depending on the ventilation rate, were 20 to 80 percent of those outdoors. The Indoor/outdoor data are adequately described with a mass balance model. The model can also be coupled with reported air exchange rates to estimate indoor/outdoor ratios for other structures. The results from this and previous studies indicate that Indoor concentrations are frequently a significant fraction of outdoor values. These observations, and the fact that most people spend greater than 90 percent of their time indoors, indicate that indoor ozone exposure (concentration × time) is greater than outdoor exposure for many people. Relatively Inexpensive strategies exist to reduce indoor ozone levels, and these could be implemented to reduce the public’s total ozone exposure.     

Evaluation of Regenerative-air Vacuum Street Sweeping on Geological Contributions to PM10

Street sweeping is often proposed as a means of reducing the emissions from paved roads. The objective of this study was to evaluate the effectiveness of street sweeping on ambient particulate matter concentrations and to determine the difference In source contributions to PM10 concentrations between street sweeping and non-street sweeping periods.

Chemically-speciated measurements of PM10 and PM2.5 were taken in the commercial section of Reno, Nevada, for a one-month sampling period. The Chemical Mass Balance (CMB) model was applied to these data and an average of approximately 50 percent of the PM10 was apportioned to resuspended geological material. During half of the sampling period, streets In the vicinity of the sampling site were completely swept with a regenerative-air vacuum sweeper, while no sweeping was performed during the remainder of the experiment. Ratios of primary geological contributions divided by primary motor vehicle contributions to PM10 were compared between sweeping and non-sweeping periods using analysis of variance. This ratio of source contributions minimizes the effects of variations in traffic volume and meteorological dispersion. No significant differences in geological contributions to PM10 were detected as a result of regenerative-air vacuum street sweeping.     

Assessment of Needs for Technical Information in EPA’s Hazardous and Solid Waste Programs

Headquarters managers and Regional staff in the U.S. Environmental Protection Agency’s hazardous and solid waste programs were surveyed to determine priorities for technical information and guidance among EPA Regional staff, state hazardous waste management staff, EPA contractors, and the regulated community. The survey also examined delivery systems effective for EPA Regional staff. The fifteen highest ranked technical needs for RCRA, Superfund, and UST reflect a pervasive interest in hazardous waste remediation. Top priority technical needs focus on establishing cleanup levels, subsurface fate and transport, field monitoring and quality assurance, remedy selection, and most importantly, which remedies work and which do not in specific situations. Technical needs of non- EPA audiences are quite similar to those for EPA field staff. Preferences for technology transfer delivery systems are generally for conventional distribution methods (such as print materials and workshops) rather than electronic or video media. Regional staff report serious problems in utilizing technology transfer because of time constraints, insufficient knowledge of available products, insufficient travel funds, and limited access to and training on computers.