Locking of retractable type fall arresters--test method and stand.

Retractable type fall arresters are very effective personal equipment protecting against falls from a height. These devices are used under different atmospheric conditions and in the presence of various types of industrial pollution. For this reason appropriate locking after conditioning simulating extreme conditions of a worksite is one of the essential characteristics of retractable type fall arresters. This article presents the requirements for locking of the devices. A previously used locking test method and its disadvantages are discussed. The article suggests an improved test method and test equipment. Measurement of the test mass acceleration is the most important improvement introduced into the test method. The article shows laboratory tests used to verify the method, which turned out to be a valuable source of information concerning the performance of retractable type fall arresters.     

Mathematical modeling of biomass fuels formation process

The increasing demand for thermal and electric energy in many branches of industry and municipal management accounts for a drastic diminishing of natural resources (fossil fuels). Meanwhile, in numerous technical processes, a huge mass of wastes is produced. A segregated and converted combustible fraction of the wastes, with relatively high calorific value, may be used as a component of formed fuels. The utilization of the formed fuel components from segregated groups of waste in associated processes of co-combustion with conventional fuels causes significant savings resulting from partial replacement of fossil fuels, and reduction of environmental pollution resulting directly from the limitation of waste migration to the environment (soil, atmospheric air, surface and underground water). The realization of technological processes with the utilization of formed fuel in associated thermal systems should be qualified by technical criteria, which means that elementary processes as well as factors of sustainable development, from a global viewpoint, must not be disturbed. The utilization of post-process waste should be preceded by detailed technical, ecological and economic analyses. In order to optimize the mixing process of fuel components, a mathematical model of the forming process was created. The model is defined as a group of data structures which uniquely identify a real process and conversion of this data in algorithms based on a problem of linear programming. The paper also presents the optimization of parameters in the process of forming fuels using a modified simplex algorithm with a polynomial worktime. This model is a datum-point in the numerical modeling of real processes, allowing a precise determination of the optimal elementary composition of formed fuels components, with assumed constraints and decision variables of the task.     

应用于序半连续式反应器工艺的硝化和反硝化动力学研究

研究了序半连续式反应器中微生物生长、硝化和反硝化动力学.基于活性污泥1号模型(ASM No.1)中的原理和结论,导出了在有氧阶段和缺氧阶段微生物生长速率,铵、硝酸盐、易生物降解基质等的反应速率及它们的物料平衡方程;对模型中的各参数进行了参数估值,即利用龙格-库塔法解常微分方程组和黄金分割法搜索最小误差;得出了数学模型中各动力学参数和化学计量系数;模型计算结果与试验值有较好的吻合.     

Shell deformations in the Baltic clam Macoma balthica from southern Baltic Sea (the Gulf of Gdansk): hypotheses on environmental effects

High-resolution digital photography and graphical image analyses systems have been used to define external morphometric characters of shell deformations in four populations of the Baltic clam Macoma balthica from the Gulf of Gdansk (southern Baltic Sea). The proposed shell deformation indices (SDI), which were based on the relationship of selected dimensions in the posterior and the anterior part of the shell, showed at least three morphological features that provide a distinctive diagnosis of "regular" and "deformed" clams: the presence of flexure on the posterior side (SDI1), elongated posterior region (SDI2), and shell growth (SDI3). The degree and prevalence of deformed clams varied locally over space. Increase in percentage contribution of aberrated shells with depth, corresponding to oxygen depletion profile in the Gulf, suggests low oxygen concentrations as the main agent exerting a deforming influence. The observed morphological aberrations developed with age (size) of a bivalve, suggesting a long-term effect of causal factors, and were accompanied by lightening shell weight, possibly due to decalcification of previously deposited calcareous material during anaerobic metabolism. It is hypothesized that hypoxic/anoxic conditions and a subsequent presence of hydrogen sulfide on a deep organic-rich sea bottom induce shell form alterations that enable the pumping of oxygenated water from above the anoxic layer. Such a morphological modification highlights the functional significance of shell deformations in protective response to the ambient low-oxygen concentrations. Sediment organotin concentrations fall within moderate to high contamination range and, therefore, may also have an adverse impact on the shell form. DNA analyses of the fragment of mitochondrial gene cytochrome oxidase I (COI, 393 base pairs) showed homogenous genetic structure of regular and deformed clams, indicating that shell deformations in M. balthica are primarily driven by acclimatization to the ambient environmental conditions.     

微生物浓度对SFBR工艺去除营养物的影响

采用序半连续式反应器(SequentialFed-batchReactor,简称SFBR,下同。)就不同微生物初始浓度对人工配置废水营养物去除效率的影响进行了研究。探讨了微生物初始浓度对COD、氮化合物(NH4-N和NO3-N)除去和微生物生长的影响。结果表明,当微生物初始浓度为140.4g/L时,COD有最高除去率(69.5%)。当微生物初始浓度≥46.8g/L,总氮除去率可达100%。菌体初始浓度对废水中营养物的去除有利。过高浓度的微生物生长,受营养物和供氧的限制。用一组涉及多个微生物反应的动力学模型,分析了微生物初始浓度对同时去除碳、氮化合物效率和微生物生长的影响。     

Thermal manikin measurements--exact or not?

According to the European prestandard ENV 342:1998, the thermal insulation of cold-protective clothing is measured with a thermal manikin. Systematic studies on the reproducibility of the values, measured with different types of clothing on the commonly used standing and walking manikins, have not been reported in the literature. Over 300 measurements were done in 8 different European laboratories. The reproducibility of the thermal insulation test results was good. The coefficient of variation was lower than 8%. The measured clothing should fit the manikin precisely, because poorly fitting clothing gave an error in the results. The correlation between parallel and serial insulation values was excellent and parallel values were about 20% lower than serial ones. The influence of ambient conditions was critical only in the case of air velocity. The reproducibility of thermal insulation test results in a single laboratory was good, and the variation was lower than 3%.     

The modal low frequency noise of an elastically supported circular plate.

The modal low frequency noise generated by a vibrating elastically supported circular plate embedded into a flat infinite baffle has been examined. The main aim of this study is the analysis of the radiation efficiency. Low frequency approximated formulas have been presented. They are valid for all the limiting boundary conditions of the plate with its edge clamped, guided, simply supported or free as well as for all the intermediate axisymmetric boundary configurations. The formulas are expressed in the elementary form, useful for numerical computations. They are a generalization of some earlier published results. First, they are valid for axisymmetric and asymmetric modes since both kinds of modes play an important role in the low frequency range. Second, a single formula for the radiation efficiency, valid for all the axisymmetric boundary configurations, has been proposed. A numerical example for the sound power radiation has been given for some hatchway covers mounted on a ship deck.     

Heart Rate Variability in Exposure to High Altitude Hypoxia of Short Duration

Abstract

The objective of the study is to attempt an evaluation of heart rate (HR) and heart rate variability (HRV) regulatory mechanisms in the presence of autonomous nervous system (ANS) components in transient exposure to high altitude hypoxia.

During 24 hrs including a stay in hypobaria, the participants had their HR continuously recorded using the Holter method. The following parameters were calculated at rest and during the stay in a thermobarochamber: spectral power in low frequency bands (LF) 0.04-0.15 Hz and high frequency bands (HF) 0.15-0.5 Hz, and the sympathetic-parasympathetic balance index LF/HF.

Under hypobaric conditions, a decrease in mean spectral power of R-R intervals was noted within both frequency ranges, compared with the study performed in normobaria. The observed differences were larger at daytime.     

Effect of coumaphos on cholinesterase activity,hematology, and biochemical blood parameters of bovines in tropical regions of Mexico

To assess the effect of coumaphos [O-(3-chloro-4-methyl-2-oxo-2H-1-benzopyran-7-yl) O,O-diethyl phosphorothioate] exposure on physiological responses during bovine production, acetylcolinesterase (AChE) and butyrylcholinesterase (BuChE) activities were measured in whole blood, erythrocytes, and plasma of healthy male steers (Bos Taurus x Bos indicus) sprayed with coumaphos at a non-lethal dose of 1 mg kg^{? 1} body weight per day once every 14 (in vivo group) or 21 days (southern and central groups). Coumaphos topically administered at 1 mg/kg body weight per day to cattle under normal management practices in tropical areas produced a significant inhibition in erythrocyte (RBC) AChE and BuAChE activities when compared to baseline levels. RBC-AChE activity for the in vivo group decreased 71.3% (P < 0.05) and BuChE activity 59.1% (P < 0.05); RBC-AChE activity decreased 55.1% (P < 0.05) (southern group) and 43.4% (P < 0.05) (central group). Compared to the control specimens, steers from in vivo, southern, and central groups after 150 days of exposure had lower (P < 0.05) leukocyte count, absolute lymphocyte, erythrocyte, and platelet counts. Decreases in RBC-AChE activities correlated with decreased lymphocyte (r = 1.000, p = 0.01), erythrocyte (r = 1.000, p = 0.003), and platelet counts (r = 0.841, p = 0.036). Significantly increased BUN levels (P < 0.05) correlated with the decrease in RBC-AChE activities (r = ? 0.997, p = 0.047) and with the decrease in absolute red blood cell (r = ? 0.883, p = 0.020) and lymphocyte (r = ? 0.825, p = 0.043) counts; increased (P < 0.05) total plasma protein levels correlated with the decrease in RBC-AChE activities (r = ?0.998, p = 0.043), absolute red blood cell (r = ? 0.998, p = 0.040), lymphocyte (r = ? 0.893, p = 0.017), and platelet (r = -0.855, p = 0.030) counts. The physiological responses correlated with the erythrocyte acetylcholinesterase inhibition could be considered as early indicators or warning responses of bovine exposures to organophosphorus pesticides (OPs).     

Deposition and resuspension of selected aerosols particles on electrically charged filter materials for respiratory protective devices.

The primary aim of the study was to analyse the non-steady state of filtration for selected electrostatic filter materials designed for use in respiratory protective devices. The obtained results showed that the filtration process in electrostatic filters was dependent in the main on the following factors: type of the filter material, electrostatic field strength of the material, and the charge of the aerosol. To a lesser degree the filtration process depended on the sign of the charge and the relative humidity of the air. A significant correlation was found between the increase in the penetration and the decrease in breathing resistance while the filter was being loaded. The effect of resuspension (tearing off and re-deposition of dust agglomerates inside the filter) on the filtration process very significant. It was also observed that under certain conditions electrostatic filter materials lost their protection properties.