Atrazine sorption-desorption hysteresis by sugarcane mulch residue

Sorption and desorption kinetics are essential components for modeling the movement and retention of applied agricultural chemicals in soils and the fraction of chemicals susceptible to runoff. In this study, we investigated the retention characteristics of sugarcane (Saccharum spp. hybrid) mulch residue for atrazine (2-chloro-4-ethylamino-6-isopropylamino-1,3,5-triazine) based on studies of sorption-desorption kinetics. A sorption kinetic batch method was used to quantify retention of the mulch residue for a wide range of atrazine concentrations and reaction times. Desorption was performed following 504 h of sorption using successive dilutions, followed by methanol extraction. Atrazine retention by the mulch residue was well described using a linear model where the partitioning coefficient (K(d)) increased with reaction time from 10.40 to 23.4 cm3 g(-1) after 2 and 504 h, respectively. Values for mulch residue K(d) were an order of magnitude higher than those found for Commerce silt loam (fine-silty, mixed, superactive, nonacid, thermic Fluvaquentic Endoaquepts) where the sugarcane crop was grown. A kinetic multireaction model was successful in describing sorption behavior with reaction time. The model was equally successful in describing observed hysteretic atrazine behavior during desorption for all input concentrations. The model was concentration independent where one set of model parameters, which was derived from all batch results, was valid for the entire atrazine concentration range. Average atrazine recovery following six successive desorption steps were 63.67 +/- 4.38% of the amount adsorbed. Moreover, a hysteresis coefficient based on the difference in the area between sorption and desorption isotherms was capable of quantifying hysteresis of desorption isotherms.     

Experimental and simulated evaluations of airborne contaminant exposure in a room with a modified localized laminar airflow system

Environmental Science and Pollution Research - The traditional mixing ventilation is not an energy effective approach to remove indoor air pollutants, maintain breath zone air quality, and control...     

Chemical and process mineralogical characterizations of spent lithium-ion batteries: An approach by multi-analytical techniques

Mineral processing operation is a critical step in any recycling process to realize liberation, separation and concentration of the target parts. Developing effective recycling methods to recover all the valuable parts from spent lithium-ion batteries is in great necessity. The aim of this study is to carefully undertake chemical and process mineralogical characterizations of spent lithium-ion batteries by coupling several analytical techniques to provide basic information for the researches on effective mechanical crushing and separation methods in recycling process. The results show that the grade of Co, Cu and Al is fairly high in spent lithium ion batteries and up to 17.62 wt.%, 7.17 wt.% and 21.60 wt.%. Spent lithium-ion batteries have good selective crushing property, the crushed products could be divided into three parts, they are Al-enriched fraction (+2 mm), Cu and Al-enriched fraction (?2 + 0.25 mm) and Co and graphite-enriched fraction (?0.25 mm). The mineral phase and chemical state analysis reveal the electrode materials recovered from ?0.25 mm size fraction keep the original crystal forms and chemical states in lithium-ion batteries, but the surface of the powders has been coated by a certain kind of hydrocarbon. Based on these results a flowsheet to recycle spent LiBs is proposed.     

长庆油田4731B型非金属集输管道老化特性实验研究

为推广非金属复合管在油田集输油领域的应用，明确其在集输环境中的老化特性是关键问题。基于集输油现场的工程条件，针对长庆油田试用的4731B型钢丝缠绕增强复合管，以采出原油、采出水为实验介质，通过挂片实验、水压爆破实验，借助电镜扫描、拉伸测试对复合管内衬层老化行为、拉伸性能以及复合管极限承压与老化特性进行研究。结果表明:采出原油与采出水均可渗透扩散进入内衬层内部，还会发生局部深入渗透；采出原油、采出水的局部渗透速率分别可达3.4，10.6 mm/a；在某些工况下，内衬层表面产生裂纹；短时间（168 h）内的介质渗透甚至裂纹对其机械性能影响较小，而光氧老化影响显著；现场服役813 d后，复合管极限承压下降2.79%，表明复合管承压性能稳定。     

Precursors and potential sources of ground-level ozone in suburban Shanghai

• Air masses from Zhejiang Province is the major source of O₃ in suburban Shanghai. • O₃ formation was in VOC-sensitive regime in rural Shanghai. • O₃ formation was most sensitive to propylene in rural Shanghai. A high level of ozone (O₃) is frequently observed in the suburbs of Shanghai, the reason for this high level remains unclear. To obtain a detailed insight on the high level of O₃ during summer in Shanghai, O₃ and its precursors were measured at a suburban site in Shanghai from July 1, 2016 to July 31, 2016. Using the Hybrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model and concentration weighted trajectories (CWT), we found that Zhejiang province was the main potential source of O₃ in suburban Shanghai. When the sampling site was controlled by south-western winds exceeding 2 m/s, the O₃-rich air masses from upwind regions (such as Zhejiang province) could be transported to the suburban Shanghai. The propylene-equivalent concentration (PEC) and ozone formation potential (OFP) were further calculated for each VOC species, and the results suggested that propylene, (m+p)-xylene, and toluene played dominant roles in O₃ formation. The Ozone Isopleth Plotting Research (OZIPR) model was used to reveal the impact of O₃ precursors on O₃ formation, and 4 base-cases were selected to adjust the model simulation. An average disparity of 18.20% was achieved between the simulated and observed O₃ concentrations. The O₃ isopleth diagram illustrated that O₃ formation in July 2016 was in VOC-sensitive regime, although the VOC/NO_x ratio was greater than 20. By introducing sensitivity (S), a sensitivity analysis was performed for O₃ formation. We found that O₃ formation was sensitive to propylene, (m+p)-xylene, o-xylene and toluene. The results provide theoretical support for O₃ pollution treatment in Shanghai.     

Establishment of a comprehensive analysis method for the microfaunal movement in activated sludge

Environmental Science and Pollution Research - Microfaunal identification and analysis are very complex; thus, an image analysis method was utilized in this paper to overcome the shortcomings of...     

Feasibility of nanoscale zerovalent iron-loaded sediment-based biochar (nZVI-SBC) for simultaneous removal of nitrate and phosphate: high selectivity toward dinitrogen and synergistic mechanism

Environmental Science and Pollution Research - In the process of water treatment, excessive nitrogen and phosphorus pollutants are of great concern. Therefore, we prepared nanoscale zerovalent iron...